Intertidal macroinvertebrate community structure in a subtropical channel is driven by sediment properties across different land-use types

Environmental Science and Pollution Research - Macroinvertebrate community in the intertidal setup plays an important role in coastal ecosystem functions and biogeochemical cycle. However,...     

Fabrication of Bi2O3/TiO2 nanocomposites and their applications to the degradation of pollutants in air and water under visible-light

A nanoheterojunction composite photocatalyst Bi2O3/TiO2working under visible-light(λ 420 nm) was prepared by combining two semiconductors Bi2O3 and TiO2 varying the Bi2O3/TiO2molar ratio. Maleic acid was employed as an organic binder to unite Bi2O3 and TiO2 nanoparticles. The SEM, TEM, XRD and diffuse reflectance spectra were utilized to characterize the prepared Bi2O3/TiO2nanoheterojunction. The nanocomposite exhibited unusual high photocatalytic activity in decomposing 2-propanol in gas phase and phenol in aqueous phase and, evolution of CO2 under visible light irradiation while the end members exhibited low photocatalytic activity. The composite was optimized to 5 mol% Bi2O3/TiO2. The remarkable high photocatalytic efficiency originates from the unique relative energy band position of Bi2O3 and TiO2 as well as the absorption of visible light by Bi2O3.     

Sensor-based control in eddy current separation of incinerator bottom ash

A sensor unit was placed online in the particle stream produced by an eddy current separator (ECS) to investigate its functionality in non-ferrous metals recovery. The targeted feed was the 1–6 mm size fraction bottom ash from a municipal waste incinerator. The sensor unit was attached to the ECS splitter, where it counted in real-time metal and mineral particles and accurately measured the grade of the stream in the metals product. Influence of segregation (e.g. due to particle size or density) on the metals concentrate were detected and studied using the sensor data collected at different splitter distances. Tests were performed in the laboratory and in a bottom ash processing plant with two different types of ECS and two sources of bottom ash with different moisture content. The measured metal grades matched the manual analyses with errors 0%, 1.5% and 3.1% for moist, dry and very wet feed, respectively. For very wet feed the ECS metals recovery dropped, which was observed from the strongly reduced particle counts and the large changes in cumulative particle properties. The measured sample proved representative for the whole metals concentrate if it is collected at a representative position within the metals particle trajectory fan produced by the ECS. ECS-performance proved sensitively dependent on splitter distance, since a 10 mm shift may result in 10% change in metal recovery and 18% change in grade. The main functionalities of the sensor unit are determined as online quality control and facilitation of automatic control over the ECS splitter distance. These functionalities translate in significant improvements in ECS metals recovery which in turn is linked to economic benefits, increased recycling rate of scrap metals and a further reduction of the ecological drawbacks of incinerator bottom ash.     

Different treatment strategies for highly polluted landfill leachate in developing countries

The aim of this research was to determine appropriate treatment technique for effective treatment of heavily polluted landfill leachate. We accomplished several treatment experiments: (i) aerobic biological treatment, (ii) chemical coagulation, (iii) advanced oxidation process (AOP) and (iv) several combined treatment strategies. Efficiency of these treatment procedures were monitored by analysing COD and colour removal. Leachate used for this study was taken from Matuail landfill site at Dhaka city. With extended aeration process which is currently used in Matuail landfill site for leachate treatment, maximum COD and colour removal of 36% and 20%, respectively could be achieved with optimum retention period of 7days. With optimum aluminium sulphate dose of 15,000mg/L and pH value of 7.0, maximum COD and colour removals of 34% and 66%, respectively were observed by using chemical coagulation. With optimum pH of 5.0 and optimum dosages of reagents having H(2)O(2)/Fe(2+) molar ratio of 1.3 the highest removal of COD and colour were found 68% and 87%, respectively with sludge production of 55%. Fenton treatment which is an advanced oxidation process was the most successful between these three separate treatment procedures. Among the combined treatment options performed, extended aeration followed by Fenton method was the most suitable one.     

Urbanization and sustainability: challenges and strategies for sustainable urban development in Bangladesh

Like other developing countries, urbanization in Bangladesh is a growing phenomenon, which is steady in nature but fretfully affects urban sustainability in the wake of lacking in good governance. Despite urban authorities are concerned about this issue, they often fail to address the problems due to the fact of uncontrollable and unpredictable rural to urban migration, and negligence of urban poor’s sustainable living and access to basic services. Virtually the rural poverty problem has been transposed to urban areas, particularly in Dhaka City, Bangladesh. Inadequacy of infrastructural services, basic amenities and environmental goods; environmental degradation; traffic jam and accidents; violence and socioeconomic insecurity are the major challenges which are created through rapid urbanization. This paper provides a general understanding of urbanization in Bangladesh and tries to embrace related sustainability issues and challenges hindrance to sustainable urban development in Dhaka city. In addition, it presents a brief case study of water supply in Dhaka city which introduces an issue of ‘system hijack’. The paper concludes providing some strategies that might be helpful to the policy makers in formulating development policies for sustainable urban services.     

Infant and Under-five Mortality in Bangladesh: Discriminant Analysis

Bangladesh is on target for achieving the Millennium Development Goal 4 relating to infant and under-five mortality because of very rapid reduction in mortality in recent years. But this rate of reduction may be difficult to sustain and may hamper the achievement of Millennium Development Goal 4. Therefore,the main objective of this paper is to discuss and compare the different covariates of infant and under-five mortality in the context of overall country, urban and rural levels of Bangladesh using discriminant analysis. For this, the data are taken from Bangladesh Demographic and Health Survey, 2004. In discriminant analysis,the stepwise procedure has been picked up and only the significant variables are ranked according to the rank of Wilk's Lambda values. The canonical discriminant function coefficients (unstandardized and standardized) for the predictor variables have also been calculated. Both the results show that breastfeeding is the most important variable in discriminating the two groups of mothers,i.e., mothers experiencing to infant mortality or not and mothers experiencing to under-five mortality or not. The related results of discriminant function also indicate that the discriminant function is statistically significant and discriminates well. Therefore, improvements in the health system are essential for promoting the breastfeeding practices (both inclusive and exclusive), which may be the effective strategies to reach families and communities with targeted messages and information.     

Conversion of chicken feather waste via hydrothermal carbonization: process optimization and the effect of hydrochar on seed germination of Acacia auriculiformis

Journal of Material Cycles and Waste Management - Using statistical response surface methodology this paper primarily investigates the role of process parameters at different levels (temperature,...     

Trace metals accumulation in soil irrigated with polluted water and assessment of human health risk from vegetable consumption in Bangladesh

Trace metals accumulation in soil irrigated with polluted water and human health risk from vegetable consumption was assessed based on the data available in the literature on metals pollution of water, soil, sediment and vegetables from the cites of Bangladesh. The quantitative data on metal concentrations, their contamination levels and their pollution sources have not been systematically gathered and studied so far. The data on metal concentrations, sources, contamination levels, sample collection and analytical tools used were collected, compared and discussed. The USEPA-recommended method for health risk assessment was used to estimate human risk from vegetable consumption. Concentrations of metals in water were highly variable, and the mean concentrations of Cd, Cr, Cu and As in water were found to be higher than the FAO irrigation water quality standard. In most cases, mean concentrations of metals in soil were higher than the Bangladesh background value. Based on geoaccumulation index (I _geo) values, soils of Dhaka city are considered as highly contaminated. The I _geo shows Cd, As, Cu, Ni, Pb and Cr contamination of agricultural soils and sediments of the cities all over the Bangladesh. Polluted water irrigation and agrochemicals are identified as dominant sources of metals in agricultural soils. Vegetable contamination by metals poses both non-carcinogenic and carcinogenic risks to the public. Based on the results of the pollution and health risk assessments, Cd, As, Cr, Cu, Pb and Ni are identified as the priority control metals and the Dhaka city is recommended as the priority control city. This study provides quantitative evidence demonstrating the critical need for strengthened wastewater discharge regulations in order to protect residents from heavy metal discharges into the environment.