Automotive Exhaust Emission Levels by Geographic Area and Vehicle Make A Nationwide Survey

Gross average automotive exhaust emissions data collected by the Atlantic Richfield Clean Air Caravan during the summer of 1970 showed only slight geographical variations when the specific makes were ignored. When considering specific makes, significant differences were found on an average emissions basis. Vehicle population—emission distributions showed wide variations in the 50% population levels and in the percent of vehicles with emissions greater than specified values. Hydrocarbon (HC) and carbon monoxide (CO) data are given on a gross basis for the 1970, 1968-69, 1966-67, and pre-1966 model year group vehicles. Average HC and CO emissions and vehicle population-Idle emissions distribution curves are included for specific make vehicles in selected areas.     

Emissions from Slash Burning and the Influence of Flame Retardant Chemicals

Pollutants sampled during the burning of 30 lb ponderosa pine fuel beds yielded emission factors for CO, hydrocarbon gases, and par-ticulate matter of 146, 8.4, and 9.1 lb/ton of fuel, respectively. When similar beds were treated with diammonium phosphate flame retardant, these factors increased to 166, 11.7, and 19.3 lb/ton of fuel, respectively.

Gas chromatographic analysis of hydrocarbon gases showed that 15-40% of this material was composed of methane and eth-ylene. Ethane and acetylene were the next most abundant materials, with photochemically important materials constituting minor portions of this gaseous component. Fuel beds treated with flame retardant produced more oiefins, and this production lasted throughout the smoldering phase of burning.

These tests showed that the smoldering phase of combustion is of major importance to air pollutant production during slash burning. The initial 80% of the fuel burned accounted for only 20-30% of HC and CO emissions. This suggests that a rapid mop-up of slash burns could substantially reduce air pollutant production.     

The Nationwide Program for Maintenance of Air Quality

The initial state implementation plans concentrated on attainment of the ambient air quality standards in the relatively polluted areas of the country. Many of these plans must now be modified to ensure that the ambient standards will be maintained for the foreseeable future, and to ensure that significant deterioration of air quality in clean areas of the country is prevented.

The existing implementation plans currently contain many measures which are applicable to the maintenance and deterioration efforts, but additional measures must also be developed. Many of these additional measures will involve future planning activities—most common of which will be land use planning activities.

The point is made that, after existing sources have reduced their emissions to the lowest practical level, further air pollution control can only be accomplished by implementing rational planning procedures for management of any new sources of air pollution. This will require extensive cooperation among the air pollution control community; regional, state, and local planning agencies; state and local governments; and the general public in order to ensure that future land use plans include appropriate air quality considerations.     

Stack Sampling of Hygroscopic Particulates In an Entrained Water Environment

Reference methods for the determination of mercury emissions from stationary sources typically include collection of mercury by solutions which are acidic and oxidizing. In the presence of high levels of SO₂ the oxidizing capacity of these absorbing solutions will be degraded and the collection efficiency for mercury compromised. This seriously limits the usefulness of the reference methods as they apply to the mining and smelting industries. In the present work peroxide is used to remove SO₂ and acidic permanganate is used to collect mercury. At a mean sampling rate of 10 L/min concentrations of at least 12 mg/m³ mercury can be satisfactorily collected in the presence of up to 20,000 ppm SO₂.     

Methylcyclopentadienyl Manganese Tricarbonyl as an Antiknock: Composition and Fate of Manganese Exhaust Products

Methylcyclopentadienyl manganese tricarbonyl (MMT) has been marketed as a combustion improver for fuel oil and turbine fuel. Use concentrations for this purpose are about 0.025 g manganese/gal in fuel oil and 0.08 to 0.5 g/gal in turbine fuels. In addition, it has been used to a small extent in gasoline.     

Emission Control in Coking Operations By Use of Stage Charging

At the Clairton Coke Works of the United States Steel Corporation (the world’s largest coke plant), with coal charges of about 30,000 net tons per day, a system designated as “stage charging” has been developed for charging coal into the coke oven chamber without emissions to the atmosphere. The principles of the system are based on controlled sequential flow of the coal from the charging hoppers, during which the oven chamber is maintained under a very slight negative pressure condition by use of steam aspiration in the offtakes for on-the-main charging. The techniques are basic but require knowledge of the coal characteristics, adequate and properly maintained aspirating systems, including clean offtake piping, control of coal volume in the individual hoppers, and last, and probably most important, adherence by the operating crew to specific charging and leveling practices.     

Turbulent Plume in a Turbulent Cross Flow: Comparison of Wind Tunnel Tests with Field Observations

Plume rise downwind of a large stationary gas turbine was measured in the field and the conditions were then scaled in the laboratory. For the laboratory, the plume exit conditions, wind velocity and temperature profiles, and wind direction were matched. It was found that for high temperature exhaust, the buoyancy is best matched by calculating a dimensionless density difference. With properly calculated buoyancy length scales, the plume trajectories were compared and were found to agree quite well. The probability distributions of the entrainment constant and the average values of the entrapment constant with downwind distance were compared. The field data showed about 15% greater plume rise. The median entrainment constant was about 10% greater for the lab test and the shape of the probability distribution matched very closely.     

Ambient Oxidant Exposure andHealth Costs in the United States—1973

The body of information presented in this paper is directed to policy makers and administrators involved in the evaluation and assessment of damages caused by oxidant air pollution on human health and welfare and of possible benefits of control.

To provide a comparison of some of the benefits that can be obtained by reducing photochemical oxidant levels, estimated health costs were derived from data relating adverse health effects to hourly oxidant concentrations. Hourly oxidant or ozone concentrations were measured at approximately 400 monitoring stations scattered throughout the U.S. Most of these sites were located in major urban areas or in other areas where high oxidant concentrations prevailed. Estimates of populations at risk and per capita health costs were generated for those areas where oxidant data was available.

During the period 1971-1973, nearly two-thirds of the U.S. population resided in areas where the hourly primary standard for oxidants of 160 µg/m³ was exceeded. The total annual health cost attributable to oxidants was estimated to range from $120 to over $240 million in the U.S.     

Needed: A National R&D Effort To Develop Individual Air Pollution Monitor Instrumentation

The results from the regional air quality analysis for the Four Corners Study are discussed in this paper. This study was one of five regional studies conducted for the National Commission on Air Quality. Potential regional air quality impacts were evaluated through the year 1995 for alternative energy scenarios under current and alternative regulatory policies. The alternative regulatory policies include emission fees, technology standards, emission ceilings, and prevention of significant deterioration class elimination. The alternatives were compared in terms of their impacts on regional visibility and on the ambient concentrations of SO₂, SO₄, and primary fine particulates. The fate of the pollutants was estimated. The alternative regulatory policies were quite different with respect to their control of SO_X emissions and their impacts on regional visibility. Sources located outside of the study region were estimated to have a major impact on regional air quality within the study region.