液相色谱/离子阱质谱和飞行时间质谱分析橄榄油中的特丁津除草剂

本文摘要介绍了液相色谱／离子阱质谱和液相／飞行时间质谱对橄榄油中特丁津的定性定量分析．详细介绍了样品处理,包括液-液萃取和以氨基硅胶为基质分散的固相萃取法．样品的净化采用Florisil硅土小柱,用乙腈洗脱溶质．液相色谱／离子阱质谱的MS／MS模式采集特征离子m／z174．而利用液相／飞行时间质谱进行精确质量数分析（[M＋H]^＋,m／z230）,同时得到碎片的精确质量数和特征同位素分布．对于飞行时间质谱测得的质量精度小于ppm．此方法具有高灵敏度、线性好及精度高的优点．液相／离子阱质谱和飞行时间质谱可以作为橄榄油中特丁津的常规方法．[编者按]     

环境样品中杀菌剂的多残留分析

苯并咪唑类化合物(benzimidazoles)如涕必灵(thiabendazole)常作为杀菌剂普遍用在瓜果及农作物上．用液相色谱法分析这些物质比较困难：例如涕必灵,在硅胶基质的色谱柱上会发生严重的拖尾现象,酸性条件下尤为明显。涕必灵和多菌灵(carbendazim)在pH10的情况下使用XTerra MS C18色谱柱会得到较好的峰形,但在较高的pH值下,其它类型杀菌剂或杀虫剂可能不稳定,故难以用适合这些碱性杀菌剂的高pH值条件进行同时分析．     

Consumption of rice and fish in an electronic waste recycling area contributes significantly to total daily intake of mercury

<正>Mercury is a global pollutant due to its widespread use,emission,and long-range transport(Blum,2013;Pacyna et al.,2010).It is considered a priority pollutant due to its neurological toxicity,persistence,and bioaccumulation(Pacyna et al.,2010;Sharma et al.,2015).Mercury pollution can occur when products that contain mercury are improperly disposed of and mercury is released into the air,water,and soil(Zhang and Wong,2007).An estimated 22%of the annual world usage of mercury is in electrical equipment such as batteries,thermometers,and discharge lamps,and electronic devices such as monitors and     

Kinetics of phenol and chlorophenol utilization by Acinetobacter species

Although microbial transformations via cometabolism have been widely observed, the few available kinetic models of cometabolism have not adequately addressed the case of inhibition from both the growth and nongrowth substrates. The present study investigated the degradation kinetics of self-inhibitory growth (phenol) and nongrowth (4-chlorophenol, 4-CP) substrates, present individually and in combination. Specifically, batch experiments were performed using an Acinetobacter isolate growing on phenol alone and with 4-CP present. In addition, batch experiments were also performed to evaluate the transformation of 4-CP by resting, phenol-induced Acinetobacter cultures. The Haldane kinetic model adequately predicted the biodegradation of phenol alone, although a slight discrepancy was noted in cases of higher initial phenol concentrations. Similarly, a Haldane model for substrate utilization was also able to describe the trends in 4-CP transformation by the resting cell cultures. The 4-CP transformation by the Acinetobacter species growing on phenol was modeled using a competitive kinetic model of cometabolism, which included growth and nongrowth substrate inhibition and cross-inhibition terms. Excellent agreement was obtained between the model predictions using experimentally estimated parameter values and the experimental data for the synchronous disappearance of phenol and 4-CP.     

Passive air sampling theory for semivolatile organic compounds

The mathematical modelling underlying passive air sampling theory can be based on mass transfer coefficients or rate constants. Generally, these models have not been inter-related. Starting with basic models, the exchange of chemicals between the gaseous phase and the sampler is developed using mass transfer coefficients and rate constants. Importantly, the inter-relationships between the approaches are demonstrated by relating uptake rate constants and loss rate constants to mass transfer coefficients when either sampler-side or air-side resistance is dominating chemical exchange. The influence of sampler area and sampler volume on chemical exchange is discussed in general terms and as they relate to frequently used parameters such as sampling rates and time to equilibrium. Where air-side or sampler-side resistance dominates, an increase in the surface area of the sampler will increase sampling rates. Sampling rates are not related to the sampler/air partition coefficient (K(SV)) when air-side resistance dominates and increase with K(SV) when sampler-side resistance dominates.     

Volatile nanoparticle formation and growth within a diluting diesel car exhaust

A major source of particle number emissions is road traffic. However, scientific knowledge concerning secondary particle formation and growth of ultrafine particles within vehicle exhaust plumes is still very limited. Volatile nanoparticle formation and subsequent growth conditions were analyzed here to gain a better understanding of "real-world" dilution conditions. Coupled computational fluid dynamics and aerosol microphysics models together with measured size distributions within the exhaust plume of a diesel car were used. The impact of soot particles on nucleation, acting as a condensational sink, and the possible role of low-volatile organic components in growth were assessed. A prescribed reduction of soot particle emissions by 2 orders of magnitude (to capture the effect of a diesel particle filter) resulted in concentrations of nucleation-mode particles within the exhaust plume that were approximately 1 order of magnitude larger. Simulations for simplified sulfuric acid-water vapor gas-oil containing nucleation-mode particles show that the largest particle growth is located in a recirculation zone in the wake of the car. Growth of particles within the vehicle exhaust plume up to detectable size depends crucially on the relationship between the mass rate of gaseous precursor emissions and rapid dilution. Chassis dynamometer measurements indicate that emissions of possible hydrocarbon precursors are significantly enhanced under high engine load conditions and high engine speed. On the basis of results obtained for a diesel passenger car, the contributions from light diesel vehicles to the observed abundance of measured nucleation-mode particles near busy roads might be attributable to the impact of two different time scales: (1) a short one within the plume, marked by sufficient precursor emissions and rapid dilution; and (2) a second and comparatively long time scale resulting from the mix of different precursor sources and the impact of atmospheric chemistry.     

Comparison of inclined plate sedimentation and dissolved air flotation for the minimisation of subsequent nitrogenous disinfection by-product formation

The formation of disinfection by-products (DBPs), including both nitrogenous disinfection by-products (N-DBPs) and carbonaceous disinfection by-products (C-DBPs), was investigated upon chlorination of water samples following two treatment processes: (i) coagulation-inclined plate sedimentation (IPS)-filtration and (ii) coagulation-dissolved air flotation (DAF)-filtration. The removal of algae, dissolved organic nitrogen (DON), dissolved organic carbon (DOC) and UV₂₅₄ by coagulation-DAF-filtration was superior to coagulation-IPS-filtration. On average, 53%, 53% and 31% of DOC, DON and UV₂₅₄ were removed by coagulation-DAF-filtration process, which were higher than 47%, 31% and 27% of that by coagulation-IPS-filtration process. Additionally, coagulation-IPS-filtration performed less well at removing the low molecular weight organics than coagulation-DAF-filtration process. The concentrations of chloroform, dichloroacetamide (DCAcAm) and dichloroacetonitrile (DCAN) formed during chlorination after coagulation-DAF-filtration reached their maximum values of 13, 1.5 and 4.7 μg L⁻¹, respectively, and were lower than those after coagulation-IPS-filtration with the maximum detected levels of 17, 2.9 and 6.3 μg L⁻¹. However, the trichloronitromethane (TCNM) concentration after the two processes was similar, suggesting that DON may have less of a contribution to TCNM formation than DCAcAm and DCAN.     

The influence of EDDS and EDTA on the uptake of heavy metals of Cd and Cu from soil with tobacco Nicotiana tabacum

Phytoextraction, the use of plants to extract contaminants from soils and groundwater, is a promising approach for cleaning up soils contaminated with heavy metals. In order to enhance phytoextraction the use of chelating agents has been proposed. This study aims to assess whether ethylene diamine disuccinate (EDDS), a biodegradable chelator, can be used for enhanced phytoextraction purposed, as an alternative to ethylene diamine tetraacetate (EDTA). EDDS revealed a higher toxicity to tobacco (Nicotiana tabacum) in comparison to EDTA, but no toxicity to microorganisms. The uptake of Cu was increased by the addition of EDTA and EDDS, while no increase was observed in the uptake of Cd. Both chelating agents showed a very low root to shoot translocation capability and the translocation factor was lower than the one of the control. Heavy metals where significantly more phytoavailable than in the control, even after harvesting, resulting in a high heavy metal leaching possibility, probably owing to a low biodegradation rate of EDDS. New seedlings which were transplanted into the EDDS treated pots 7d after the phytoextraction experiment, showed signs of necrosis and chlorosis, which resulted in a significantly lower biomass in comparison to the control. The seedlings on the EDTA treated pots showed no toxicity signs. Contrary to previous opinions the results of this study revealed the chelating agents EDTA and EDDS as unsuitable for enhanced phytoextraction using tobacco.     

Method to assess component contribution to toxicity of complex mixtures: Assessment of puberty acquisition in rats exposed to disinfection byproducts

A method based on regression modeling was developed to discern the contribution of component chemicals to the toxicity of highly complex, environmentally realistic mixtures of disinfection byproducts(DBPs). Chemical disinfection of drinking water forms DBP mixtures.Because of concerns about possible reproductive and developmental toxicity, a whole mixture(WM) of DBPs produced by chlorination of a water concentrate was administered as drinking water to Sprague–Dawley(S–D) rats in a multigenerational study. Age of puberty acquisition,i.e., preputial separation(PPS) and vaginal opening(VO), was examined in male and female offspring, respectively. When compared to controls, a slight, but statistically significant delay in puberty acquisition was observed in females but not in males. WM-induced differences in the age at puberty acquisition were compared to those reported in S–D rats administered either a defined mixture(DM) of nine regulated DBPs or individual DBPs. Regression models were developed using individual animal data on age at PPS or VO from the DM study. Puberty acquisition data reported in the WM and individual DBP studies were then compared with the DM models. The delay in puberty acquisition observed in the WM-treated female rats could not be distinguished from delays predicted by the DM regression model, suggesting that the nine regulated DBPs in the DM might account for much of the delay observed in the WM. This method is applicable to mixtures of other types of chemicals and other endpoints.     

Predicting Satisfaction with Smart Irrigation Controllers and Their Long‐Term Use among Homeowners in Central Florida

Studies throughout Florida have shown smart controllers can substantially reduce irrigation under residential high‐water use conditions. However, successful promotion requires understanding the link between controller performance and the mechanisms by which they are adopted. This article compares irrigation water‐use and survey data collected from households installed with soil moisture sensor and evapotranspiration controllers. The study investigated whether the relative change in irrigation use between two years preceding and two years following installation was a reliable predictor of a homeowner's satisfaction with the device and likelihood of continuing to use it. Results indicated relative changes in irrigation use were only significantly associated with the quality of controller programming. Satisfaction with the controller was largely attributable to satisfaction with the appearance of the landscape and the perceived water‐saving effectiveness of the controller whereas the likelihood of its continued use was only significantly predicted by the level of technical knowledge regarding its functioning and whether or not challenges were experienced with it. Targeting homeowners with supplemental user‐friendly information may best support their long‐term adoption of smart controllers while providing irrigation contractors with training in implementation techniques would represent an integrated strategy for added reductions in residential outdoor water use.