Characterization of PM2.5-bound polycyclic aromatic hydrocarbons in Atlanta—Seasonal variations at urban,suburban, and rural ambient air monitoring sites

Twenty-eight polycyclic aromatic hydrocarbons (PAH) and methylated PAHs (Me-PAH) were measured in daily PM_2.5 samples collected at an urban site, a suburban site, and a rural site in and near Atlanta during 2004 (5 samples/month/site). The suburban site, located near a major highway, had higher PM_2.5-bound PAH concentrations than did the urban site, and the rural site had the lowest PAH levels. Monthly variations are described for concentrations of total PAHs (∑PAHs) and individual PAHs. PAH concentrations were much higher in cold months than in warm months, with average monthly ∑PAH concentrations at the urban and suburban-highway monitoring sites ranging from 2.12 to 6.85 ng m^?3 during January–February and November–December 2004, compared to 0.38–0.98 ng m^?3 during May–September 2004. ∑PAH concentrations were found to be well correlated with PM_2.5 and organic carbon (OC) within seasons, and the fractions of PAHs in PM_2.5 and OC were higher in winter than in summer. Methyl phenanthrenes were present at higher levels than their un-substituted homologue (phenanthrene), suggesting a petrogenic (unburned petroleum products) input. Retene, a proposed tracer for biomass burning, peaked in March, the month with the highest acreage and frequency of prescribed burning and unplanned fires, and in December, during the high residential wood-burning season, indicating that retene might be a good marker for burning of all biomass materials. In contrast, potassium peaked only in December, indicating that it might be a more specific tracer for wood-burning.     

Evaluating inter-continental transport of fine aerosols:(2) Global health impact

In this second of two companion papers, we quantify for the first time the global impact on premature mortality of the inter-continental transport of fine aerosols (including sulfate, black carbon, organic carbon, and mineral dust) using the global modeling results of (Liu et al., 2009). Our objective is to estimate the number of premature mortalities in each of ten selected continental regions resulting from fine aerosols transported from foreign regions in approximately year 2000. Our simulated annual mean population-weighted (P-W) concentrations of total PM2.5 (aerosols with diameter less than 2.5 μm) are highest in East Asia (EA, 30 μg m^?3) and lowest in Australia (3.6 μg m^?3). Dust is the dominant component of PM2.5 transported between continents. We estimate global annual premature mortalities (for adults age 30 and up) due to inter-continental transport of PM2.5 to be nearly 380 thousand (K) in 2000. Approximately half of these deaths occur in the Indian subcontinent (IN), mostly due to aerosols transported from Africa and the Middle East (ME). Approximately 90K deaths globally are associated with exposure to foreign (i.e., originating outside a receptor region) non-dust PM2.5. More than half of the premature mortalities associated with foreign non-dust aerosols are due to aerosols originating from Europe (20K), ME (18K) and EA (15K); and nearly 60% of the 90K deaths occur in EA (21K), IN (19K) and Southeast Asia (16K). The lower and higher bounds of our estimated 95% confidence interval (considering uncertainties from the concentration–response relationship and simulated aerosol concentrations) are 18% and 240% of the estimated deaths, respectively, and could be larger if additional uncertainties were quantified. We find that in 2000 nearly 6.6K premature deaths in North America (NA) were associated with foreign PM2.5 exposure (5.5K from dust PM2.5). NA is least impacted by foreign PM2.5 compared to receptors on the Eurasian continent. However, the number of premature mortalities associated with foreign aerosols in NA (mostly occurring in the U.S.) is comparable to the reduction in premature mortalities expected to result from tightening the U.S. 8-h O₃ standard from 0.08 ppmv to 0.075 ppmv. International efforts to reduce inter-continental transport of fine aerosol pollution would substantially benefit public health on the Eurasian continent and would also benefit public health in the United States.     

Temperature dependence of secondary organic aerosol

Temperature was found to have a dramatic effect on secondary organic aerosol formation from two ozonolysis systems, cyclohexene and α-pinene. Isothermal experiments were conducted for both systems where the lowest temperature, 278 K, formed approximately 2.5–3 times and 5–6 times the SOA formed at 300 K and 318 K, respectively. Changing the cyclohexene system temperature to a different isothermal experimental set point after completion of SOA formation did not lead to sufficient condensation/evaporation to reproduce the SOA formation at other temperature set points. When the system temperature was cycled between two set points at the end of an experiment, the α-pinene system showed reversibility between the initial temperature 318 K and 300 K. For temperature cycles between the initial temperature of 300 K–318 K, an irreversible loss of mass is observed after the first heating cycle with reversibility observed between subsequent temperature cycles. The SOA formed at 278 K was reversible over a 22 K range but was unable to evaporate sufficiently to match the SOA mass formed at 300 K. Hygroscopicity measurements, taken after the completion of SOA formation, indicate that hygroscopicity of the aerosol is also a function of temperature and that the aerosol does not continue to be oxidized after initial growth is complete. The differing hygroscopicity of the semi-volatile component of the aerosol is evident during system temperature changes after completion of the experiment.     

The stable carbon isotope composition of PM2.5 and PM10 in Mexico City Metropolitan Area air

The sources and distribution of carbon in ambient suspended particles (PM_2.5 and PM₁₀) of Mexico City Metropolitan Area (MCMA) air were traced using stable carbon isotopes (¹³C/¹²C). Tested potential sources included rural and agricultural soils, gasoline and diesel, liquefied-petroleum gas, volcanic ash, and street dust. The complete combustion of LP gas, diesel and gasoline yielded the lightest δ¹³C values (?27 to ?29‰ vs. PDB), while street dust (PM₁₀) represented the isotopically heaviest endmember (?17‰). The δ¹³C values of rural soils from four geographically separated sites were similar (?20.7 ± 1.5‰). δ¹³C values of particles and soot from diesel and gasoline vehicle emissions and agricultural soils varied between ?23 and ?26‰. Ambient PM samples collected in November of 2000, and March and December of 2001 at three representative receptor sites of industrial, commercial and residential activities had a δ¹³C value centered around ?25.1‰ in both fractions, resulting from common carbon sources. The predominant carbon sources to MCMA atmospheric particles were hydrocarbon combustion (diesel and/or gasoline) and particles of geological origin. The significantly depleted δ¹³C values from the industrial site reflect the input of diesel combustion by mobile and point source emissions. Based on stable carbon isotope mass balance, the carbon contribution of geological sources at the commercial and residential sites was approximately 73% for the PM₁₀ fraction and 54% for PM_2.5. Although not measured in this study, biomass-burning emissions from nearby forests are an important carbon source characterized by isotopically lighter values (?29‰), and can become a significant contributor (67%) of particulate carbon to MCMA air under the prevalence of southwesterly winds. Alternative sources of these ¹³C-depleted particles, such as cooking fires and municipal waste incineration, need to be assessed. Results show that stable carbon isotope measurements are useful for distinguishing between some carbon sources in suspended particles to MCMA air, and that wind direction has an impact on the distribution of carbon sources in this basin.     

Evaluation of the aggressive potential of marine chloride and sulfate salts on mortars applied as renders in the Metropolitan Region of Salvador--Bahia, Brazil

In recent years, growing interest has focused on determining the performance of materials and evaluating the service life of structures exposed to various environmental forces. In this context, the determination of the aggressive potential of marine salts on mortars used as external renders is critical. The present study aimed to evaluate the spatial distribution of marine salts relative to distance from the sea. This was done by monitoring the deposition rate of chlorides and sulfates in wet candle sensors, located at nine stations scattered around the Metropolitan Region of Salvador, state of Bahia, Brazil. The study also determined the effectiveness of water-soluble salts at penetrating three different types of mortars of varying cement content via deposition and diffusion. The methodology employed enabled an evaluation of the efficiency of the monitoring sensors' measurement of the aggressiveness potential of local marine aerosol, and determination of the comparative performance of the three mortars tested, from the standpoint of resistance to salt penetration. The type and amount of salts captured both in solution and in powder samples extracted from the mortars were determined by ion chromatography. The analysis of the various types of mortars tested indicated which types are more resistant to the aggressive potential of the region's marine aerosol and the distance from the shore where local buildings are liable to be most strongly affected.     

Global warming and environmental production efficiency ranking of the Kyoto Protocol nations

This paper analyzes the United Nations Organization's Kyoto Protocol nations to address two questions. First, what are the environmental production efficiency rankings of these nations? Second, is there a relationship between a nation's ratification status and its environmental production efficiency ranking? Our findings suggest that the nations that have ratified the Kyoto Protocol are more likely to be environmentally production efficient as compared to the nations that have not ratified the Protocol.     

Wood bison population recovery and forage availability in northwestern Canada

Forage availability was assessed to determine sustainable stocking rates for eight broadly defined vegetation types (Treed Uplands, Treed Lowlands, Mixed Tall Shrub/Sedge, Closed-canopied Willow, and Open-canopied Willow, Meadow, Wetland Grass, Wetland Sedge) for use by wood bison (Bison bison athabascae), a threatened subspecies, in the Canadian boreal forest of northern Alberta. Clip plots (n=108) were used to sample peak availability of herbs and current annual growth of Salix spp. in late summer. Graminoid wetlands dominated by Carex atherodes, Carex aquatilis, Carex utriculata, Scolochloa festucacea, or Calamagrostis stricta produced 1975-4575 kg ha(-1) of fair to good quality forage, whereas treed stands produced < 250 kg ha(-1) of forb-dominated forage (>85% content), which was below a published 25% foraging efficiency threshold of 263 kg ha(-1) for bison. Upland forests that dominate the region produced < or = 1 animal unit day (AUD) of forage per hectare in summer. Most forest understory plants were of poor forage value, suggesting the potential sustainable stocking rate of such areas was actually < or = 0.3 AUD ha(-1), with even lower rates during winter due to snow cover. Herbaceous wetlands contained approximately 78 AUD ha(-1) of forage, but were considered largely unavailable in summer because of flooding and soft organic soils that make access difficult. Conversion of prime foraging habitat to agricultural land, forest expansion due to fire control, and a warmer and wetter climatic regime after the mid-1900s likely contributed to a regional reduction in carrying capacity. It is hypothesized that substantial recovery of the wood bison population toward historical levels will be constrained in northern Alberta by the availability of summer forage, and the limited extent of graminoid wetlands that provide winter foraging habitat.     

How good is GLASOD?

The Global Assessment of Soil Degradation (GLASOD) has been the most influential global appraisal of land quality in terms of environmental policy. However, its expert judgments were never tested for their consistency and could not be reproduced at unvisited sites, while the relationship between the GLASOD assessments of land degradation and the social and economic impact of that degradation remains unclear. Yet, other methodologies that could respond to urgent calls for an updated assessment of the global environmental quality are not operational or, at best, in progress. Therefore, we evaluate the reliability and social relevance of the GLASOD approach and assess its candidacy for new global environmental assessments. The study concentrates on the African continent, capitalizing on new GIS data to delineate and define the characteristics of GLASOD map units. Consistency is tested by comparing expert judgments on soil degradation hazard for similar combinations of biophysical conditions and land use. Reproducibility is evaluated by estimating an ordered logit model that relates the qualitative land degradation classes to easily available information on explanatory variables, the results of which can be used to assess the land degradation at unvisited sites. Finally, a cross-sectional analysis investigates the relation between GLASOD assessments and crop production data at sub-national scale and its association with the prevalence of malnutrition. The GLASOD assessments prove to be only moderately consistent and hardly reproducible, while the counter-intuitive trend with crop production reveals the complexity of the production-degradation relationship. It appears that increasing prevalence of malnutrition coincides with poor agro-productive conditions and highly degraded land. The GLASOD approach can be improved by resolving the differences in conceptualization among experts and by defining the boundaries of the ordered classes in the same units as independent, quantitative land degradation data.     

The influence of use-related,environmental, and managerial factors on soil loss from recreational trails

Recreational uses of unsurfaced trails inevitably result in their degradation, with the type and extent of resource impact influenced by factors such as soil texture, topography, climate, trail design and maintenance, and type and amount of use. Of particular concern, the loss of soil through erosion is generally considered a significant and irreversible form of trail impact. This research investigated the influence of several use-related, environmental, and managerial factors on soil loss on recreational trails and roads at Big South Fork National River and Recreation Area, a unit of the U.S. National Park Service. Regression modeling revealed that trail position, trail slope alignment angle, grade, water drainage, and type of use are significant determinants of soil loss. The introduction of individual and groups of variables into a series of regression models provides improved understanding and insights regarding the relative influence of these variables, informing the selection of more effective trail management actions. Study results suggest that trail erosion can be minimized by avoiding “fall-line” alignments, steep grades, and valley-bottom alignments near streams, installing and maintaining adequate densities of tread drainage features, applying gravel to harden treads, and reducing horse and all-terrain vehicle use or restricting them to more resistant routes.     

Characterising the landscape of state environmental review policies and procedures in the United States: a national assessment

Following the intent of the National Environmental Policy Act of 1969, many states have adopted policies and procedures directing state agencies and local government units to evaluate the potential environmental impacts of development projects prior to their undertaking. In contrast to a rich literature on federal requirements, current understanding of state environmental review is narrowly focused and outdated. This paper seeks to provide information on the landscape of state environmental review policy frameworks. The paper identifies 37 states with formal environmental review requirements through a document review of state statutes, administrative rules and agency-prepared materials, and confirms this finding through a survey of state administrators. A two-tier classification is used to distinguish states based on the approach taken to address environmental review needs and the scope and depth of relevant policies and procedures implemented. This paper also provides a discussion of policy and programme attributes that may contribute to effective practice, and of the potential for adopting relevant legislation in states where environmental review is currently lacking.