Laboratory evaluation of thermophilic-anaerobic digestion to produce Class A biosolids. 1. Stabilization performance of a continuous-flow reactor at low residence time.

There is increasing interest in the United States in producing biosolids from municipal wastewater treatment that meet the criteria for Class A designation established by the U.S. Environmental Protection Agency. Class A biosolids are intended to be free of pathogens and also must meet requirements for reduction of the vector-attraction potential associated with untreated sludge. High-temperature processes are considered to produce Class A biosolids if the combination of operating temperature and treatment time exceeds minimum criteria, but this option is not applicable to mixed, continuous-flow reactors. Such reactors, or any combination of reactors that does not meet the holding time requirement at a specific temperature, must be demonstrated to inactivate pathogens to levels consistent with the Class A criteria. This study was designed to evaluate pathogen inactivation by thermophilic anaerobic digestion in a mixed, continuous-flow reactor followed by batch or plug-flow treatment. In this first of a two-part series, we describe the performance of a continuous-flow laboratory reactor with respect to physical and chemical operating parameters; microbial inactivation in the combined continuous-flow and batch treatment system is described in the second part. Sludges from three different sources were treated at 53 degrees C, while sludge from one of the sources was also treated at 55 and 51 degrees C. Relatively short hydraulic retention times (four to six days) were used to represent a conservative operating condition with respect to pathogen inactivation. Treatment of a fermented primary sludge led to an average volatile-solids (VS) destruction efficiency of 45%, while VS destruction for the other two sources was near or below 38%, the Class A criterion for vector attraction reduction. Consistent with other studies on thermophilic anaerobic digestion of sludges at short residence times, effluent concentrations of volatile fatty acids (VFAs) were relatively high. Also consistent with other studies, the most abundant VFA in the effluent was propionate. Gas production ranged from 0.3 to 0.5 m3/kg VS fed and from 0.8 to 1.3 m3/kg VS destroyed.     

Droplet charging for wet scrubbers

Water droplet charge/mass of wet scrubbers was measured over the direct charging applied potential range of 0-20 kV, 30-70 pounds per square inch gauge (206.8-482.6 kPa) water pressure, and with spiral, impingement, and whirl nozzles. The measured charge/mass ranged from -0.0005 to 0.2 microcoulomb/gm and was directly related to the applied voltage. The water charge/mass was a function of the spray nozzle, with the smaller orifice lower-flow nozzles having the higher charge/mass.     

A qualitative sampling method for monitoring water quality in temporary channels or point sources and its application to pesticide contamination

A water-sampling device to monitor the quality of water periodically and temporarily flowing out of concrete tubes, sewers or channels is described. It inexpensively and easily enables a qualitative characterization of contamination via these point-source entry routes. The water sampler can be reverse engineered with different sizes and materials, once installed needs no maintenance, passively samples the first surge, and the emptying procedure is short. In an agricultural catchment area in Germany we monitored an emergency overflow of a sewage sewer, an outlet of a rainwater sewer and two small drainage channels as input sources to a small stream. Seven inflow events were analysed for 20 pesticide agents (insecticides, fungicides and herbicides). All three entry routes were remarkably contaminated. We found parathion-ethyl concentrations of 0.3 microg l(-1), diuron up to 17.3 microg l(-1), ethofumesate up to 51.1 microg l(-1), metamitron up to 92 microg l(-1) and prosulfocarb up to 130 microg l(-1).     

Partitioning of polychlorinated biphenyls and hexachlorobenzene into human faeces

The dietary absorption of persistent lipophilic organic pollutants (PLOPs) in humans is believed to occur via partitioning of the chemical between the lumen and the wall of the digestive tract. As such, the partitioning properties of the lumen contents are a key factor governing absorption. In this study, the partitioning properties of faeces were measured for 11 polychlorinated biphenyls and hexachlorobenzene (HCB). Four volunteers participated in the study, each of them providing faeces from a normal diet and a vegetarian diet. The faeces/gas equilibrium partition coefficient K(FG) varied by over three orders of magnitude between the different compounds. A linear relationship between log K(FG) and log KOA, the octanol/air partition coefficient, was observed. The slope of the relationship was > 1, indicating that the solvent properties of faeces were less polar than those of octanol. For a given compound, KFG varied up to a factor of 2.8 between the individuals on a normal diet. The influence of the vegetarian diet on K(FG) was negligible for the two volunteers who simply deleted fish and animal products from their normal diet, but K(FG) increased on average by a factor of 2 in the two individuals who increased their consumption of less readily digestible whole grains and vegetables in their vegetarian diet. On the basis of K(FG), the fugacities in the faeces were calculated. They were found to be much lower than the fugacities in blood. It is hypothesised that this is due to a temporary decrease in the fugacity in the wall of the jejunum caused by absorption of dietary lipids that results in equilibration between the lumen contents and the wall of the digestive tract at a fugacity below that present in the blood and the rest of the body.     

Investigation of unrecognized former secondary lead smelting sites: confirmation by historical sources and elemental ratios in soil

Twelve suspected former secondary lead smelting sites were investigated. Ten of the sites were confirmed to be former secondary lead smelters or lead works by historical fire insurance maps and contemporaneous metal industry trade directories. At eight sites sampled, the ratio Sb:Pb was closer to ratios from 10 known lead smelting sites than were the As:Pb and Cd:Pb ratios. Data from the 10 known lead smelting sites showed that the Sb:Pb ratio is most characteristic of secondary lead smelting sites. This is because the primary alloy smelted at such sites is antimonial lead. Lead contamination at the eight sites investigated here can be attributed At least in part to the former smelters because of the association between Sb and Pb.     

Assessing the recovery of lakes in southeastern Canada from the effects of acidic deposition

Reductions in North American sulfur dioxide (SO2) emissions promoted expectations that aquatic ecosystems in southeastern Canada would soon recover from acidification. Only lakes located near smelters that have dramatically reduced emissions approach this expectation. Lakes in the Atlantic provinces, Quebec and Ontario affected only by long-range sources show a general decline in sulfate (SO4(2-)) concentrations, but with a relatively smaller compensating increase in pH or alkalinity. Several factors may contribute to the constrained (or most likely delayed) acidity response: declining base cation concentrations, drought-induced mobilization of SO4(2-), damaged internal alkalinity generation mechanisms, and perhaps increasing nitrate or organic anion levels. Monitoring to detect biological recovery in southeastern Canada is extremely limited, but where it occurs, there is little evidence of recovery outside of the Sudbury/Killarney area. Both the occurrence of Atlantic salmon in Nova Scotia rivers and the breeding success of Common Loons in Ontario lakes are in fact declining although factors beyond acidification also play a role. Chemical and biological models predict that much greater SO2 emission reductions than those presently required by legislation will be needed to promote widespread chemical and latterly, biological recovery. It may be unrealistic to expect that pre-industrial chemical and biological conditions can ever be reestablished in many lakes of southeastern Canada.     

PCDDs, PCDFs, and PCBs concentrations in breast milk from two areas in Korea: body burden of mothers and implications for feeding infants

We determined breast milk concentration of polychlorinated dibenzo-p-dioxins (PCDDs)/polychlorinated dibenzofurans (PCDFs) and polychlorinated biphenyls (PCBs) in 24 mothers living in Korea, and assessed the maternal body burden based on PCDDs/PCDFs and PCBs concentrations in breast milk and an infant intake rate through breast-feeding based on their concentration in breast milk. PCDDs/PCDFs and PCBs levels in breast milk from primipara mothers were found to be higher than those from multipara mothers. For total PCDDs/PCDFs TEQ level, 2,3,4,7,8-PeCDD was the predominant congener, and the proportion of 2,3,7,8-TCDD was less than 3% of total PCDDs/PCDFs TEQ level. For PCBs TEQ level, PCB-126 was the predominant congener. Maternal body burden levels of PCDDs/PCDFs and PCBs based on their concentrations in breast milk were 268-622 TEQ ng. The daily dioxin intakes of mothers were predicted to be 0.78-2.18 TEQ pg/kg/day for PCDDs/PCDFs and 0.34-0.66 TEQ pg/kg/ day for PCBs. For the first year, the body burden of an infant was predicted to be 212 TEQ ng and the daily intake of an infant was predicted to be 85 TEQ pg/kg/day, assuming the mean dioxin-related compounds concentration (27.54 TEQ pg/g fat).     

Natural attenuation of chlorinated solvents at Area 6, Dover Air Force Base: groundwater biogeochemistry

Monitored natural attenuation (MNA) has recently emerged as a viable groundwater remediation technology in the United States. Area 6 at Dover Air Force Base (Dover, DE) was chosen as a test site to examine the potential for MNA of tetrachloroethene (PCE) and trichloroethene (TCE) in groundwater and aquifer sediments. A "lines of evidence" approach was used to document the occurrence of natural attenuation. Chlorinated hydrocarbon and biogeochemical data were used to develop a site-specific conceptual model where both anaerobic and aerobic biological processes are responsible for the destruction of PCE, TCE, and daughter metabolites. An examination of groundwater biogeochemical data showed a region of depleted dissolved oxygen with elevated dissolved methane and hydrogen concentrations. Reductive dechlorination likely dominated in the anaerobic portion of the aquifer where PCE and TCE levels were observed to decrease with a simultaneous increase in cis-1,2-dichloroethene (cis-DCE), vinyl chloride (VC), ethene, and dissolved chloride. Near the anaerobic/ aerobic interface, concentrations of cis-DCE and VC decreased to below detection limits, presumably due to aerobic biotransformation processes. Therefore, the contaminant and daughter product plumes present at the site appear to have been naturally atteuated by a combination of active anaerobic and aerobic biotransformation processes.     

Effects of invertebrate predators and a pesticide on temporary pond microcosms used for aquatic toxicity testing

The effects of increased trophic complexity, through the addition of predatory notonectids (Anisops deanei), on temporary pond microcosms used for aquatic toxicity testing were studied. Replicate microcosms were established using sediment from a dried temporary pond, and treated with one of four concentrations of the organochlorine pesticide endosulfan (0, 1, 10 or 50 microg/L), in the presence or absence of six A. deanei. The tanks were sampled regularly for nine weeks following the addition of the predators and the entire contents of each tank counted after 12 weeks. Analysis using non-metric multidimensional scaling (MDS) and non-parametric MANOVA showed that both Anisops and endosulfan at concentrations >10 microg/L significantly altered community structure. However, an interaction between the effects of Anisops and the effects of endosulfan was not detected. The addition of Anisops did not increase the variability of response and thus did not reduce the sensitivity of the test method.