Characterization of Fine Particulate Matter Produced by Combustion of Residual Fuel Oil

ABSTRACT

Combustion experiments were carried out on four different residual fuel oils in a 732-kW boiler. PM emission samples were separated aerodynamically by a cyclone into fractions that were nominally less than and greater than 2.5 |j.m in diameter. However, examination of several of the samples by computer-controlled scanning electron microscopy (CCSEM) revealed that part of the PM_2.5 fraction consists of carbonaceous cenospheres and vesicular particles that range up to 10 |j.m in diameter. X-ray absorption fine structure (XAFS) spectroscopy data were obtained at the S, V, Ni, Fe, Cu, Zn, and As K-edges and at the Pb L-edge. Deconvolution of the X-ray absorption near edge structure (XANES) region of the S spectra established that the dominant molecular forms of S present were sulfate (26-84% of total S) and thiophene (13-39% of total S). Sulfate was greater in the PM_2.5 samples than in the PM₂₅₊ samples. Inorganic sulfides and elemental sulfur were present in lower percentages. The Ni XANES spectra from all of the samples agreed fairly well with that of NiSO₄, while most of the V spectra closely resembled that of vanadyl sulfate (VO?SO₄?xH₂O). The other metals investigated (i.e., Fe, Cu, Zn, and Pb) also were present predominantly as sulfates. Arsenic was present as an arsen-ate (As⁺⁵). X-ray diffraction patterns of the PM_2.5 fraction exhibit sharp lines due to sulfate compounds (Zn, V, Ni, Ca, etc.) superimposed on broad peaks due to amorphous carbons. All of the samples contain a significant organic component, with the loss on ignition (LOI) ranging from 64 to 87% for the PM_2.5 fraction and from 88 to 97% for the PM_2.5+ fraction. Based on ¹³C nuclear magnetic resonance (NMR) analysis, the carbon is predominantly condensed in graphitic structures. Aliphatic structure was detected in only one of seven samples examined.     

An Environmental Decision-Making Tool for Evaluating Ground-Level Ozone-Related Health Effects

Abstract

A computer model called the Ozone Risk Assessment Model (ORAM) was developed to evaluate the health effects caused by ground-level ozone (O₃) exposure. ORAM was coupled with the U.S. Environmental Protection Agency’s (EPA) Third-Generation Community Multiscale Air Quality model (Models-3/CMAQ), the state-of-the-art air quality model that predicts O₃ concentration and allows the examination of various scenarios in which emission rates of O₃ precursors (basically, oxides of nitrogen [NO_x] and volatile organic compounds) are varied. The principal analyses in ORAM are exposure model performance evaluation, health-effects calculations (expected number of respiratory hospital admissions), economic valuation, and sensitivity and uncertainty analysis through a Monte Carlo simulation. As a demonstration of the system, ORAM was applied to the eastern Tennessee region, and the entire O₃ season was simulated for a base case (typical emissions) and three different emission scenarios. The results indicated that a synergism occurs when reductions in NO_x emissions from mobile and point sources were applied simultaneously. A 12.9% reduction in asthma hospital admissions is expected when both mobile and point source NO_x emissions are reduced (50 and 70%, respectively) versus a 5.8% reduction caused by mobile source and a 3.5% reduction caused by point sources when these emission sources are reduced individually.     

Investigation of an Escherichia coli environmental benchmark for waterborne pathogens in agricultural watersheds in Canada

Canada's National Agri-Environmental Standards Initiative sought to develop an environmental benchmark for low-level waterborne pathogen occurrence in agricultural watersheds. A field study collected 902 water samples from 27 sites in four intensive agricultural watersheds across Canada from 2005 to 2007. Four of the sites were selected as reference sites away from livestock and human fecal pollution sources in each watershed. Water samples were analyzed for Campylobacter spp., Salmonella spp., Escherichia coli O157:H7, Cryptosporidium spp., Giardia spp., and the water quality indicator E. coli. The annual mean number of pathogen species was higher at agricultural sites (1.54 ± 0.07 species per water sample) than at reference sites (0.75 ± 0.14 species per water sample). The annual mean concentration of E. coli was also higher at agricultural sites (491 ± 96 colony-forming units [cfu] 100 mL(-1)) than at reference sites (53 ± 18 cfu 100 mL(-1)). The feasibility of adopting existing E. coli water quality guideline values as an environmental benchmark was assessed, but waterborne pathogens were detected at agricultural sites in 80% of water samples with low E. coli concentrations (<100 cfu 100 mL(-1)). Instead, an approach was developed based on using the natural background occurrence of pathogens at reference sites in agricultural watersheds to derive provisional environmental benchmarks for pathogens at agricultural sites. The environmental benchmarks that were derived were found to represent E. coli values lower than geometric mean values typically found in recreational water quality guidelines. Additional research is needed to investigate environmental benchmarks for waterborne pathogens within the context of the "One World, One Health" perspective for protecting human, domestic animal, and wildlife health.     

The Moral Philosophy of Automobiles

The ethics of technology use has tended to arise from the theory of the role of technology in human life and society and thus introduces a bias into moral assessment of such use. I propose a dialectical method of morally assessing a technology use without such a preset notion. Instead the assumption is that the moral agent is as responsible for use of a technology as for any other moral action of the agent, that is, the individual’s use of a technology is a moral action that can be morally assessed. I apply this outlook to automobile use, weighing its moral pros and cons, such as in terms of autonomy, environmental degradation, land use, health hazards, and other moral drawbacks arising from the technology’s use or non-use. Although the conclusion leaves the final moral assessment undecided, the method points to a way fairly to assess morally the use of technologies in terms of human betterment and environmental and health concerns, minimizing biases from assumptions of the role or nature of technologies.     

Diflubenzuron residue and persistence on an oak forest after aerial application

Abstract

A twenty hectare forest block in central Pennsylvania was aerially sprayed with diflubenzuron (Dimilin 25W®) at the dose of 33.23g A.I./ha in 9.4 litres/ha. Leaf samples were collected from the upper and lower canopies of 27 oaks and understory within this block on the day of spray, May 29, 1991. Canopy leaves were also collected on May 31, June 10, July 29 and September 26, 1991.

Recovery of diflubenzuron residues on fortified canopy‐leaf and litter‐leaf samples using analytical techniques employed in this study averaged 87.4% (SE = 7.5%) and 66.2% (SE = 8.2%), respectively.

On the day of spray, diflubenzuron residues on the upper canopy, lower canopy and understory averaged 81.18, 39.65 and 8.35 ng/cm², respectively. Diflubenzuron residues on canopy‐leaf samples collected 2, 12, 61 and 120 days post‐spray averaged 14.83 (SE = 10.19), 16.75 (SE = 9.95), 12.84 (SE = 8.25) and 11.20 (SE = 7.52) ng/cm², respectively. Diflubenzuron residues on litter‐leaf samples collected after leaf senescence ‐ 169 and 323 days post spray contained measurable amounts of diflubenzuron in 51 and 59% of the samples, respectively. Of the samples with measurable amounts of diflubenzuron, residues averaged 1.36 (SE = 2.44) and 0.65 ng/cm² (SE = 0.73) respectively.     

Report on International Affairs Committee

This is a report on Meetings of Representatives of National Air Pollution Preventions Associations to Consider the Establishment of an International Union, held in Washington, D. C, June 18–19, 1964 and Houston, Texas, June 21–22, 1964.     

A Note on Comparison of Statistical and Analytical Results for Calculating Oxides of Nitrogen Concentrations

A question often asked about analytical diffusion models is “How do the analytical results for calculating pollution concentrations compare with those obtained by statistical techniques?” Miller and Holzworth (1967) have developed a simple analytical diffusion model that yields relative pollution concentrations, x/Q, as a function of afternoon mixing depth, mean transport wind speed, and city size. This analytical model may also be used in reverse to determine apparent afternoon source strengths from observed afternoon pollution concentrations. The apparent source strengths may then be used with the model on independent data to estimate pollution concentrations. It is the purpose of this note to compare results of calculating average afternoon concentrations of oxides of nitrogen (NO_x) by use of the Miller-Holzworth model with those obtained from statistical regression equations.     

An Atmospheric Diffusion Model for Metropolitan Areas

An urban diffusion model, which does not require the use of an electronic computer, is presented. The main simplifying assumptions are that continuous pollutant sources are uniformly distributed over the urban area and vertical diffusion occurs until the effluent from each line source reaches the top of the mixing layer, after which the effluent is uniformly distributed through the mixing layer. After the appropriate vertical diffusion coefficient is specified, the calculated concentration is a function of source strength, linear dimension of the metropolis, mixing depth, and wind speed. The calculated concentration is interpreted either as a representative maximum concentration or, through integration, as the average concentration over the metropolitan area. When a representative pollutant concentration is known, the model may be used to determine the apparent “uniform” source strength.     

Ozone Dosage Response of Ponderosa Pine Seedlings

Photochemical oxidant injury to ponderosa pine (Pinus ponderosa Laws) is a severe problem in the southern California mountains. Three-year-old ponderosa pines fumigated in controlled environment chambers with ozone at 0.15, 0.30, or 0.45 ppm had apparent photosynthesis rates reduced by 10, 70, and 85%, respectively, after 30 days exposure. A fumigation with 0.30 ppm ozone for 33 days depressed the cold perchloric acid extracted polysaccharides of both current and one-year-old needles by 40%. The 80% ethanol soluble sugar concentration of current year, ozone-injured needles increased 16% and that of the one-year-old needles decreased slightly. Both carbohydrate fractions of control trees in carbon-filtered air increased moderately. Higher, endogenous concentrations of ascorbic acid in needles did not protect the tissue from ozone injury. Apparent photosynthesis rate was a sensitive index for ozone dosage response. Needle carbohydrate depletion probably induces premature abscission.     

The Removal of Particulate Matter from Fluid Bed Catalytic Cracking Unit Stack Gases

The application of a high-efficiency centrifugal type of separator to fluid bed catalytic cracking units is described in which most of the catalyst particles often lost to the atmosphere are concentrated into a small part of the stack gas (2%). A further separation can then be made on this small stream by an auxiliary separator which further concentrates the catalyst particle into 0.1% of the initia stream. Performance of the main and auxiliary separators are such as to reduce the loss of catalyst particles in the stack gas from 800 ppm to less than 60 ppm in a typical unit. Large amounts of power can be recovered by application of expander turbines to catalytic cracking plants employing this system of separation.