水田土壤中水溶性有机物的产生动态及对土壤中重金属活性的影响:田间微区试验

采用田间微区试验研究不同施肥处理对土壤水溶性有机物 (DOM)的动态变化及其对土壤Cd活性的影响 结果表明 ,与施化肥对照处理相比 ,施用有机肥后土壤中DOM含量明显增加 .但随着水稻的生长DOM呈不断下降的趋势 ,而对照处理的变幅不大 ;在水稻整个生长过程中根际DOM含量不断增加且都高于对应时期土壤DOM的含量 ,并至水稻扬花期最大 ,此时 ,3种处理的根际产生DOM浓度 (DOM浓度以水溶性有机碳 (DOC)计 ,以下同 )分别为 :绿肥与化肥配施处理组 (GM) ( 14 0 2mg·L-1) >猪粪与化肥配施处理组 (PM) ( 11 12mg·L-1) >对照处理组 (F) ( 10 8mg·L-1) .水稻扬花期后 ,各处理的DOM含量不断下降 .试验还指出 ,有机肥施用后根际及土体土壤中交换态及有机结合态Cd含量显著增加 ,是对照处理的 2倍之多 ,同时发现 ,水稻收获后土壤交换态Cd的含量与此时的土壤DOM含量呈明显的正相关 (r土体 =0 92 6 6 ,n =8;r根际 =0 9389 ,n =8) .施用有机肥改良重金属污染土壤应该谨慎     

Impact of Construction Waste Disposal Charging Scheme on work practices at construction sites in Hong Kong

Waste management in the building industry in Hong Kong has become an important environmental issue. Particularly, an increasing amount of construction and demolition (C&D) waste is being disposed at landfill sites. In order to reduce waste generation and encourage reuse and recycling, the Hong Kong Government has implemented the Construction Waste Disposal Charging Scheme (CWDCS) to levy charges on C&D waste disposal to landfills. In order to provide information on the changes in reducing waste generation practice among construction participants in various work trades, a study was conducted after 3 years of implementation of the CWDCS via a structured questionnaire survey in the building industry in Hong Kong. The study result has revealed changes with work flows of the major trades as well as differentiating the levels of waste reduced. Three building projects in the public and private sectors were selected as case studies to demonstrate the changes in work flows and the reduction of waste achieved. The research findings reveal that a significant reduction of construction waste was achieved at the first 3 years (2006–2008) of CWDCS implementation. However, the reduction cannot be sustained. The major trades have been influenced to a certain extent by the implementation of the CWDCS. Slight improvement in waste management practices was observed, but reduction of construction waste in the wet-finishing and dry-finishing trades has undergone little improvement. Implementation of the CWDCS has not yet motivated subcontractors to change their methods of construction so as to reduce C&D waste.     

Electronic waste management approaches: An overview

Electronic waste (e-waste) is one of the fastest-growing pollution problems worldwide given the presence if a variety of toxic substances which can contaminate the environment and threaten human health, if disposal protocols are not meticulously managed. This paper presents an overview of toxic substances present in e-waste, their potential environmental and human health impacts together with management strategies currently being used in certain countries. Several tools including Life Cycle Assessment (LCA), Material Flow Analysis (MFA), Multi Criteria Analysis (MCA) and Extended Producer Responsibility (EPR) have been developed to manage e-wastes especially in developed countries. The key to success in terms of e-waste management is to develop eco-design devices, properly collect e-waste, recover and recycle material by safe methods, dispose of e-waste by suitable techniques, forbid the transfer of used electronic devices to developing countries, and raise awareness of the impact of e-waste. No single tool is adequate but together they can complement each other to solve this issue. A national scheme such as EPR is a good policy in solving the growing e-waste problems.     

Consequences of paternal care on pectoral fin allometry in a desert-dwelling fish

Positive static allometry is a scaling relationship where the relative size of traits covaries with adult body size. Traditionally, positive allometry is thought to result from either altered physiological requirements at larger body size or from strongly condition-dependent allocation under sexual selection. Yet, there are no theoretical reasons why positive allometry cannot evolve in fitness-related traits that are solely under the influence of natural selection. We investigated scaling and sexual dimorphism of a naturally selected trait, pectoral fin size, in comparison to a trait important in male–male combat, head width in natural populations of a fish, the desert goby Chlamydogobius eremius. Male desert gobies provide uniparental care and use their pectoral fins to fan the brood (often under hypoxic conditions); hence, larger fins are expected to be more efficient. Male pectoral fins do not appear to fulfil a signalling function in this species. We found that, for both pectoral fin size and head width, males exhibited positive allometric slopes and greater relative trait size (allometric elevation) than females. However, for head width, females also showed positive allometry, albeit to a lesser degree than males. Because fin locomotory function typically does not result in positive allometry, our findings indicate that other naturally selected uses, such as paternal care, can exaggerate trait scaling relationships.     

Do national levels of individualism and internal locus of control relate to well‐being: an ecological level international study

Data were collected from managers in 24 nations/territories on work locus of control (LOC), individualism–collectivism (I–C), and well‐being (job satisfaction, absence of psychological strain, and absence of physical strain). There were significant mean differences across samples on all five of these measures, and consistent with our hypothesis, at the ecological or sample mean level well‐being was associated with an internal locus of control. However, contrary to our hypothesis, well‐being was not associated with I–C, despite a strong correlation between I–C and LOC. Findings at the ecological level were consistent with the literature concerning the salutary effects of control on well‐being. Copyright © 2001 John Wiley & Sons, Ltd.     

Repeated use of two Chlorella species, C. vulgaris and WW1 for cyclic nickel biosorption.

Two living Chlorella species were used to remove nickel from solution containing 30 micrograms Ni ml-1 in 10 successive cycles. The present study also examined the continued viability of these two algal species after repeated exposure to nickel. The two species of Chlorella were Chlorella vulgaris (commercially available) and WW1 (indigenous species isolated from domestic sewage and was tentatively identified as Chlorella miniata). The nickel removal percentage of WW1 cells was maintained at around 85% in the first five cycles, then declined slightly from the fifth cycle onwards, and finally achieved around 70% removal at the end of the 10th cycle. On the contrary, the removal efficiency of C. vulgaris declined from 50 to 30% during the 10 cycles of nickel bisorption. At the end of these 10 successive cycles, WW1 accumulated a substantial amount of Ni2+ (the cumulative cellular Ni concentration was 0.92% dry w.), while the value was only 0.17% in the case of C. vulgaris. These results suggest that the local isolate, WW1, had more consistent and satisfactory ability for removing Ni than the commercial C. vulgaris. Both algal species were still capable of dividing after each nickel treatment cycle, suggesting that the cells were not killed even when significant amounts of nickel were adsorbed/absorbed. However, Ni exposure adversely affected the physiological activity of algal cells as reflected by the decline in division rate and chlorophyll-a activity in both species. Such negative effects became more obvious as the number of cyclic treatments was increased. Nevertheless, WW1 cells appeared to recover from nickel treatment when re-cultivated in commercial medium for 2 weeks.     

Systematic study on the relationship between particulate matter and microbial counts in hospital operating rooms

Environmental Science and Pollution Research - In this study, a systematic procedure for establishing the relationship between particulate matter (PM) and microbial counts in four operating rooms...