A Comparison of Mass,Lead, Sulfate,and Nitrate Concentrations in a Field Study Using Dichotomous,Size-Selective,and Standard Hi-Vol Samplers

Air monitoring In the San Francisco Bay Area was carried out to measure outdoor community air concentrations of poly cyclic aromatic hydrocarbons (PAH) and mutagenlc activity (mutagenlclty) In participate organic matter (POM). Monitoring began In 1979 and Is currently conducted at six stations. PAH and mutagenlclty tests were performed on organic extracts prepared from high volume (hl-vol) filters composited every four months, by meteorological season. PAH were determined by high pressure liquid chromatography (HPLC) with fluorescence and ultraviolet detection. Mutagenlclty was measured In the Ames Salmonella bloas-say using strain TA98 with and without metabolic activation. The nine-year mean concentration of benzo(a)pyrene (BaP) was 0.4 ng/m³. The mutagenlcfty of this amount of BaP accounted for only about 0.2% of the observed mutagenicity In POM and other measured PAH accounted for even less. Concentrations of PAH and mutagenlclty were three to nine times higher during the winter than during other seasons. Year-to-year wintertime trends In several PAH were also seen. Early In the 1980s, winter concentrations of BaP and benzo (g,h,i)perylene Increased. However since the mld-1980’s, their concentrations have fallen. The decrease In PAH concentrations may be the result of an Increasing proportion of vehicles with relatively low organic emissions. In contrast to PAH, mutagenlcfty did not show significant year-to-year time trends.     

Interregional Exchanges of Air Pollution: Model Types and Applications

Regional scale air quality simulation models covering spatial scales of thousands of kilometers are finding increasing applications in studies of acid deposition and other air pollution problems. The purpose of this paper is to familiarize the nonexpert with the characteristics of the major types of interregional air quality models currently in use: Eulerian grid, statistical trajectory, and Lagrangian trajectory. The basic features, advantages, and disadvantages of each of these modeling approaches are summarized, as are the important limitations and problems associated with interregional modeling in general. Typical applications are illustrated using examples from the use of a representative Lagrangian trajectory model, ENAMAP, over the eastern North American area.     

Formaldehyde Release from Simulated Wall Panels Insulated with Urea-Formaldehyde Foam Insulation

An important potential source of formaldehyde in the home is ureaformaldehyde foam insulation (UFFI). This study measures the long-term release of formaldehyde through the interior wall of test panels foamed with commercial urea-formaldehyde insulation. The measurements, made approximately 16 mo after initial foaming, were conducted under both static and dynamic air conditions with air flow selected to simulate a typical air exchange found in houses. Estimated room concentrations based on a simple model of uniform mixing within a room and measured emission rates are presented. Measurements of formaldehyde in the air from within the UFFI cavities are also reported.     

Use of Energy Scenarios in Addressing the CO2 Question

A reference scenario for CO₂ emissions was developed using a model of world energy supply and demand. In the reference scenario, world GNP and world energy demand increase at average rates of 2.1 percent per year and 1.5 percent per year, respectively during the period 1975-2100. The corresponding annual CO₂ emissions rise to a maximum of 16 gigatons of carbon around 2050 and then decline as a result of a transition to nonfossil fuel energy systems. A modified scenario for high CO₂ emissions was obtained by assuming an abundant supply of low cost coal, thus eliminating the transition. A low case was developed in which the low cost of alternative energy (i.e., solar, nuclear) induces an earlier shift away from fossil fuels.

Annual emissions of the three scenarios were used as input to a global carbon cycle model and the CO₂ buildup in the atmosphere during the period 1980-2100 was determined by the model. All three scenarios showed continuous rises in atmospheric CO₂ concentration. The reference scenario reached 775 ppm by 2100. The high CO₂ case resulted in concentrations of over 1040 ppm, and for the low case the 2100 concentration was just under 700 ppm. If the climate theory is correct, even 700 ppm is sufficient to give significant climate warming, but by experiencing the change gradually over a century, adaptation may not be painful. An early transition to nonfossil fuel supplies makes the problem less severe but does not eliminate it.     

An Assessment of the Economic Effects of Ozone on U.S. Agriculture

Past attempts to measure the economic consequences of ozone on agriculture have been based on limited plant science information. This paper reports on an economic assessment of ozone on U.S. agriculture using recent crop response data from the National Crop Loss Assessment Network (NCLAN). The results are derived from a U.S. agricultural sector model that includes major crop and livestock production as well as domestic consumption, livestock feeding and export uses. The economic effects of four hypothetical ambient ozone levels are investigated. The analysis Indicates that the benefits to society of moderate (25%) ozone reductions are approximately $1.7 billion. A 25% Increase in ozone pollution results in costs (negative benefits) of $2.1 billion. These estimates do not reflect compliance costs of achieving the ozone changes and hence are not net benefits.     

Estimating contaminant mass discharge: a field comparison of the multilevel point measurement and the integral pumping investigation approaches and their uncertainties

In this field study, two approaches to assess contaminant mass discharge were compared: the sampling of multilevel wells (MLS) and the integral groundwater investigation (or integral pumping test, IPT) that makes use of the concentration-time series obtained from pumping wells. The MLS approached used concentrations, hydraulic conductivity and gradient rather than direct chemical flux measurements, while the IPT made use of a simplified analytical inversion. The two approaches were applied at a control plane located approximately 40m downgradient of a gasoline source at Canadian Forces Base Borden, Ontario, Canada. The methods yielded similar estimates of the mass discharging across the control plane. The sources of uncertainties in the mass discharge in each approach were evaluated, including the uncertainties inherent in the underlying assumptions and procedures. The maximum uncertainty of the MLS method was about 67%, and about 28% for the IPT method in this specific field situation. For the MLS method, the largest relative uncertainty (62%) was attributed to the limited sampling density (0.63 points/m(2)), through a novel comparison with a denser sampling grid nearby. A five-fold increase of the sampling grid density would have been required to reduce the overall relative uncertainty for the MLS method to about the same level as that for the IPT method. Uncertainty in the complete coverage of the control plane provided the largest relative uncertainty (37%) in the IPT method. While MLS or IPT methods to assess contaminant mass discharge are attractive assessment tools, the large relative uncertainty in either method found for this reasonable well monitored and simple aquifer suggests that results in more complex plumes in more heterogeneous aquifers should be viewed with caution.     

Engineered nanomaterials in rivers--exposure scenarios for Switzerland at high spatial and temporal resolution

Probabilistic material flow analysis and graph theory were combined to calculate predicted environmental concentrations (PECs) of engineered nanomaterials (ENMs) in Swiss rivers: 543 river sections were used to assess the geographical variability of nano-TiO₂, nano-ZnO and nano-Ag, and flow measurements over a 20-year period at 21 locations served to evaluate temporal variation. A conservative scenario assuming no ENM removal and an optimistic scenario covering complete ENM transformation/deposition were considered. ENM concentrations varied by a factor 5 due to uncertain ENM emissions (15%-85% quantiles of ENM emissions) and up to a factor of 10 due to temporal river flow variations (15%-85% quantiles of flow). The results indicate highly variable local PECs and a location- and time-dependent risk evaluation. Nano-TiO₂ median PECs ranged from 11 to 1′623 ng L⁻¹ (conservative scenario) and from 2 to 1′618 ng L⁻¹ (optimistic scenario). The equivalent values for nano-ZnO and nano-Ag were by factors of 14 and 240 smaller.     

Parts-per-trillion LC-MS(Q) analysis of herbicides and transformation products in surface water

The goal of this study was to develop a robust method of analyzing surface water samples for S-triazine herbicides, chloroacetanilide herbicides, and their transformation products (TPs) using solid-phase extraction (SPE) followed by liquid chromatograph-mass spectrometry (LC-MS) with electrospray ionization (ESI) by in-source collision-induced dissociation (ISCID) capability of an orthogonal electrospray ionization probe on a single quadrupole LC-MS system. The method developed here met the goals of the study and yielded estimated method detection limits (EMDLs) averaging 0.3 ± 0.1 ng L(-1) for S-triazines and their TPs and 0.7 ± 0.4 ng L(-1) for chloroacetanilides and TPs. Spiked filtered river water yielded SPE recoveries ranging from 94.2 % ± 4.8 % for S-triazines and TPs after eliminating three compounds with less that 65 % recovery from analysis and 95.9 % ± 19 % for chloroacetanilides and their TPs. The method was field-tested with filtered water samples collected from four sites over a four-month period. Detectible values of S-triazines and TPs ranged from 0.3 to 1540 ng L(-1) with a mean of 79.3 and a median of 19.4 ng L(-1). Detectible values for chloroacetanilides and TPs ranged from 0.31 to 3780 ng L(-1) with a mean of 252 and a median of 25.6 ng L(-1). An additional goal was to determine if the method was useful for microbial degradation studies using native bacterial communities. The bacteria transformed atrazine (2-chloro-4-ethylamino-6-isopropylamino-S-triazine) solely into 2-hydroxy atrazine (2-hydroxy-4-ethylamino-6-isopropylamino-S-triazine) with concentrations of 78.4, 63.3 and 32.5 ng L(-1) after 12 days of incubation compared with 6.3 and 7.1 ng L(-1) for control dark and control sunlight respectively.     

Investigation on gene transfer from genetically modified corn (Zea mays L.) plants to soil bacteria

Knowledge about the prevalence and diversity of antibiotic resistance genes in soil bacteria communities is required to evaluate the possibility and ecological consequences of the transfer of these genes carried by genetically modified (GM) plants to soil bacteria. The neomycin phosphotransferase gene (nptII) conferring resistance to kanamycin and neomycin is one of the antibiotic resistance genes commonly present in GM plants. In this study, we investigated kanamycin-resistant (Km(R)) and neomycin-resistant (Nm(R)) soil bacterial populations in a 3-year field trial using a commercial GM corn (Zea mays L.) carrying the nptII gene and its near isogenic line. The results showed that a portion (2.3 - 15.6 %) of cultivable soil bacteria was naturally resistant to kanamycin or neomycin. However, no significant difference in the population level of Km(R) or Nm(R) soil bacteria was observed between the GM and non-GM corn fields. The nptII gene was not detected in any of the total 3000 Km(R) or Nm(R) isolates screened by PCR. Further, total soil bacterial cells were collected through Nycodenz gradient centrifugation and bacterial community DNA was subjected to PCR. Detection limit was about 500 cells per gram of fresh soil. Our study suggests that the nptII gene was relatively rare in the soil bacterial populations and there was no evidence of gene transfer from a GM corn plant to soil bacteria based on the data from total soil bacterial communities.