Numerical simulation of an array of fences in Saemangeum reclaimed land

This paper discusses about the quantitative effect of windbreak fences on wind velocity in the reclaimed land at Saemangeum in South Korea. Windbreak fences were constructed in the reclaimed land to reduce the wind velocity to prevent the generation and diffusion of dust. However, up to this time, no in-depth studies were conducted to quantitatively measure the effect of the windbreak fences on wind velocity thus an optimum windbreak structure is not yet determined. Using CFD simulations, the effects of fence porosity, fence height, and the distance between the adjacent fences were investigated. A wind tunnel experiment was initially conducted and data gathered were used to develop the CFD models. From the experiments and CFD simulations, the overall percentage difference of the measured velocities was 7.20% which is generally acceptable to establishing the reliability of the CFD models. The reduction effect on wind velocity was measured in between the adjacent fences up to a height of 0.6 m from the ground surface. In terms of porosity ( = 0, 0.2, 0.4, 0.6), 0.2 was found to be the optimum value. Conversely, the effect of fence height (0.6, 0.8 and 1.0 m) showed no significant difference; therefore, 0.6 m height is recommended. In addition, the reduction effect of distance between the adjacent fences (2, 4 and 6 m) on wind velocity having a 0.2 porosity has decreased to about 75% regardless of the distance. In the case of the reclaimed land in Saemangeum, a decrease of 75% can prevent the generation and diffusion of dusts. However, the source of dusts is very large. Therefore, constructing an array of windbreak with 6 m distance between them is deemed necessary.     

A sensitive monoclonal antibody-based enzyme-linked immunosorbent assay for chlorpyrifos residue determination in Chinese agricultural samples

A monoclonal antibody-based competitive antibody-coated enzyme-linked immunosorbent assay (ELISA) was developed and optimized for determining chlorpyrifos residue in agricultural products. The IC(50) and IC(10) of this ELISA were 3.3 ng/mL and 0.1 ng/mL respectively. The average recoveries in six agricultural products were between 79.5% and 118.0%, with the intra-assay coefficient of variation being less than 8 %. The limit of detection for all tested products was 30 ng/g. To the best of our knowledge, this assay has the best specificity among all the published research on ELISAs for chlorpyrifos.     

Removal of 2-chlorophenol from water using rice-straw derived ash

Removal of 2-chlorophenol from water using rice-straw derived ash (RSDA) was evaluated in this study to compare with commercial activated carbon. RSDA was obtained by burning rice-straw at 400 °C and 700 °C for 1 h. This ash can provide a better adsorbent for 2-chlorophenol. The adsorption capacities of RSDA at 400 °C and 700 °C are 37 and 52 mg g?1 at pH 4, respectively, and decrease to 9.0 and 40 mg g?1 at pH 10. Adsorption of either neutral or anionic 2-cholorphenol by the RSDA are shown as L-shaped nonlinear isotherms, suggesting surface adsorption rather than partitioning is occurring. At higher-burning temperatures, the surface area, porosity, point of zero charge and aromaticity of the resultant RSDA increase, but the oxygen content and surface acidity decrease. The combined effects result in a higher 2-chlorophenol adsorption of RSDA at 700 °C, which shows a slight pH effect on the adsorption of 2-chlorophenol, due to the lower content of oxygen-containing functional groups. Oxygen-containing functional groups contribute to surface acidity and H-bonding sites for adsorbed water, which compromises the interaction between 2-chlorophenol and the adsorbents. Thus, it suggests that rice-straw derived carbon (RSDC) can be used as an effective low-cost substitute material for activated carbon for removal of chlorophenols from wastewater.     

Flotation of metal-loaded clay anion exchangers. Part I: the case of chromates

Synthetic hydrotalcite-like layered materials are known for their ability to remove anions, like the chromates. These sorbents usually exist in powder form, thereby exhibiting high surface area and rapid kinetics for adsorption, but presenting appreciable problems in the subsequent solid/liquid separation process. Almost complete removals were obtained in this paper, from batchwork dispersed-air flotation in presence of a flocculant. Due to the experienced difficulty of flotation of thermally activated (at 500 degrees C) hydrotalcite metal-loaded particles, the application of various surfactants was studied. Continuous-flow laboratory runs certified also the effectiveness of this combined process of sorptive flotation, a promising innovative treatment technology.     

On-line real-time measurements at incineration plants: PAHs and a PCDD/F surrogate compound at stationary combustion conditions and during transient emission puffs

Laser mass spectrometry has been applied for on-line monitoring of traces of aromatic compounds from flue gas of incineration plants. The experiments have been carried out at two sampling sites in an industrial hazardous-waste incinerator. With laser mass spectrometry resonance-enhanced multiphoton ionization (REMPI) with time-of-flight mass spectrometry (TOFMS) (REMPI-TOFMS), using the group selective multi-component monitoring approach, aromatic compounds are selectively ionized from the complex flue-gas matrix. In this case, the result of an REMPI-TOFMS on-line measurement is a distinct pattern of aromatic compounds. These patterns are dependent on: (i) the point of measurement, (ii) the incineration plant, (iii) the temperature, and (iv) the fuel. This contribution focuses on the fuel dependence of the pattern. The most transient behavior can be observed when containers filled with hazardous waste are burnt, leading to puffs. Real-time monitoring results of puffs are given. Furthermore, as an approach towards on-line monitoring of the TEQ (PCDD/F toxicity equivalent), REMPI-TOFMS on-line analysis results of chlorobenzene are presented.     

The Henry's law coefficient of 2-nitrophenol over the temperature range 278-303 K

Although 2-nitrophenol has been identified as an important environmental chemical there is scarcity in the literature regarding the temperature dependence of its Henry's law coefficient, H. Here a bubble purge method was used to measure H for 2-nitrophenol over the temperature range 278-303 K. A novel approach in the data treatment allowed correction of the data for non-equilibrium partitioning in the apparatus to obtain the true equilibrium H value. The experimentally derived temperature-dependent expression for H of 2-nitrophenol is lnH (M atm(-1)) = (6290/T (K)) - 16.6. The standard enthalpy and entropy of gas-to-liquid transfer for 2-nitrophenol in aqueous solution are -52.3 +/- 8.1 kJ mol(-1) and -138 +/- 28 J mol(-1) K(-1), respectively. (Errors are 95% confidence intervals.)     

Content of aliphatic hydrocarbons in limpets as a new way for classification of species using artificial neural networks

It is demonstrated that biological species like limpets can be classified according to their level of n-alkanes when artificial neural networks are applied. Marine intertidal and subtidal limpets of the Canary Islands (Spain), Patella piperata, Patella candei crenata and Patella ulyssiponensis aspera were selected as bioindicator organisms. Samples were collected at four stations on the coasts of Fuerteventura. Concentration of n-alkanes in the soft tissues of the limpets has been determined by gas chromatography. Data were treated with artificial neural networks (ANNs) and it was found that using suitable architecture of a supervised artificial neural network, the limpets can be successfully distinguished (classified) up to 98%.     

Heavy metal accumulation, heat shock protein expression and cytogenetic changes in Tetrix tenuicornis (L.) (Tetrigidae, Orthoptera) from polluted areas

The orthopteran insect Tetrix tenuicornis, collected from polluted and unpolluted areas, was used to study heavy metal accumulation and its impact on stress protein levels and on changes in the number and morphology of chromosomes in mitotic and meiotic cells. During two consecutive years, insects were collected from polluted areas of zinc-lead mine spoils near Boles?aw (Poland) and from unpolluted areas near Busko and Staszów (Poland). T. tenuicornis from the polluted area showed 1.5, 4.03, 4.32 and 41.73 times higher concentrations of copper (Cu), zinc (Zn), lead (Pb) and cadmium (Cd), respectively, than insects of the same species collected from unpolluted areas. Insects exposed to heavy metals showed only small changes, and rather a decrease in the concentration of constitutive and inducible heat shock proteins Hsp70, the level of which increases under stress conditions. A cytogenetic study of T. tenuicornis revealed intra-population anomalies in chromosome number and morphology in mitotic and meiotic cells and the presence of an additional B chromosome in germinal cells. In 50% of females collected from polluted areas, mosaic oogonial mitotic chromosome sets and diploid, hypo- or hypertetraploid, tetraploid, and octoploid chromosome numbers were detected. In turn, 14.6% of males showed a heterozygous deficiency of chromatin in L2 and M3 bivalents in addition to the presence of B chromosomes.     

Detection of organic pollutants in sandy soils via TDR and eigendecomposition

In this study, organic pollutants in sandy soils are detected using a time domain relectrometry (TDR) probe system and eigendecomposition technique. As a demonstration, four types of organic fluids (motor oil, diesel oil, methanol and ethanol) were examined. Samples were prepared with different combinations of deionized water and organic fluid contents. For each experiment, reflected signals were captured by an oscilloscope, and their characteristics were identified using eigendecomposition technique. Autoregressive modeling and singular value decomposition methods were utilized for calculating the eigenvalues. The most significant eigenvalues were then identified based on their relative magnitude. Experimental results indicated that the presented system is sensitive to both water and pore fluid organic contents. For saturated conditions, signature curves were determined for identification of organic and/or water contents in soil pore fluids.