Spectrophotometric method for the determination of chromium (VI) in water samples

A simple and sensitive spectrophotometric method for the determination of chromium has been developed. The method is based on the diazotization of Dapsone in hydroxylamine hydrochloride medium and coupling with N-(1-Napthyl) Ethylene Diamine Dihydrochloride by electrophilic substitution to produce an intense pink azo-dye, which has absorption maximum at 540 nm. The Beer's law is obeyed from 0.02-1.0 microg mL(-1) and the molar absorptivity is 3.4854 L mol(-1) cm(-1). The Limits of quantification and Limit of detection of the proposed method are 0.0012 microg mL(-1) and 0.0039 microg mL(-1) respectively. The method has been successfully applied for the determination of chromium in water samples and the results were statistically evaluated with that of the reference method.     

Butyltin levels in several Portuguese coastal areas

This work aimed to report present levels (2007–2008 sampling) of tri- (TBT), di- (DBT), and monobutyltin (MBT) in surface sediments from 11 Portuguese coastal sites and discuss the evolution of BTs contamination in the last two decades. All the samples revealed quantifiable values of TBT, DBT, and MBT with total butyltin concentrations between 1 and 565 ng/g (of Sn in dry sediment). Maximum level of TBT, 66 ng/g, was observed in Sado estuary, at Lisnave site, in the proximity of a big shipyard. MBT decreased site by site by the same order as DBT and TBT did, but its concentrations were much higher in many cases, denoting that TBT contamination was much higher in the past. A comparison with the available previous data confirmed a marked decrease of TBT contamination all over the last years, indicating that the main sources of TBT in Portuguese coastwise stopped effectively.     

Predicting Water Quality Impaired Stream Segments using Landscape-Scale Data and a Regional Geostatistical Model: A Case Study in Maryland

In the United States, probability-based water quality surveys are typically used to meet the requirements of Section 305(b) of the Clean Water Act. The survey design allows an inference to be generated concerning regional stream condition, but it cannot be used to identify water quality impaired stream segments. Therefore, a rapid and cost-efficient method is needed to locate potentially impaired stream segments throughout large areas. We fit a set of geostatistical models to 312 samples of dissolved organic carbon (DOC) collected in 1996 for the Maryland Biological Stream Survey using coarse-scale watershed characteristics. The models were developed using two distance measures, straight-line distance (SLD) and weighted asymmetric hydrologic distance (WAHD). We used the Corrected Spatial Akaike Information Criterion and the mean square prediction error to compare models. The SLD models predicted more variability in DOC than models based on WAHD for every autocovariance model except the spherical model. The SLD model based on the Mariah autocovariance model showed the best fit (r² = 0.72). DOC demonstrated a positive relationship with the watershed attributes percent water, percent wetlands, and mean minimum temperature, but was negatively correlated to percent felsic rock type. We used universal kriging to generate predictions and prediction variances for 3083 stream segments throughout Maryland. The model predicted that 90.2% of stream kilometers had DOC values less than 5 mg/l, 6.7% were between 5 and 8 mg/l, and 3.1% of streams produced values greater than 8 mg/l. The geostatistical model generated more accurate DOC predictions than previous models, but did not fit the data equally well throughout the state. Consequently, it may be necessary to develop more than one geostatistical model to predict stream DOC throughout Maryland. Our methodology is an improvement over previous methods because additional field sampling is not necessary, inferences about regional stream condition can be made, and it can be used to locate potentially impaired stream segments. Further, the model results can be displayed visually, which allows results to be presented to a wide variety of audiences easily.     

Comparative Metal Distribution in Hair of Pakistani and Libyan Population and Source Identification by Multivariate Analysis

Using nitric acid-perchloric acid wet digestion based FAAS method ten selected metals (Cd, Co, Cr, Fe, K, Mn, Na, Ni, Pb and Zn) were determined in the scalp hair of male Pakistani and Libyan donors (n = 62), between 3–54 years age and residing in typical urban areas. The study was taken up to identify sources of metal distribution in two diverse population segments exposed to different environments. Sodium emerged with the highest mean hair concentration of 511.0 μg/g and 496.9 μg/g for Libyan and Pakistani donors respectively, followed by K, at 266.2 μg/g and 242.4 μg/g for the two donor categories. Cadmium showed the lowest mean hair concentration for both Pakistani (0.380 μg/g) and Libyan (0.530 μg/g) donors. Levels of Na, K, Pb, Cr and Cd were higher in hair of Libyan donors compared with Pakistani counterparts which showed higher comparative levels of Zn, Fe, Co, Ni and Mn. Strong metal-to-metal correlations were found between Na–K (r = 0.638) and Cd–Co (r = 0.574) for Pakistani donors, while for Libyan donors, Na–K (r = 0.680) and Fe–Mn (r = 0.624) correlations emerged as strongly significant. Only K was found to have a strong positive correlation (r = 0.611) with age for Pakistani donors while this correlation was significantly negative (r = −0.500) for Libyan donors, probably arising from individual food habits. Other metals showed no viable relationship with age. Principal Component Analysis (PCA) and Cluster Analysis (CA) of the data evidenced food, industrial emissions and automobile emissions as possible sources of metal distribution. The results of the present study are compared with those reported for subjects from other regions of the world.     

Little Egrets (Egretta Garzetta) and Trace-Metal Contamination in Wetlands of China

The rapidly developing Asian countries may face threatening environmental contamination, that however remains largely unassessed. We studied persistent trace elements in three wetlands, Poyang Lake, relatively unpolluted, and Tai Lake, and Pearl River Delta, selected as hotspots of pollution in Central China. We adopted as indicator the Little Egret, a widespread colonial waterbird, and during 1999 and 2000 we collected and analysed the same samples as for a parallel study we conducted in Pakistan, e.g. eggs, body feathers of chicks, prey spontaneously regurgitated by the chicks, and sediments at the areas most used by foraging egrets. The levels of trace-metals at our three study areas were similar, or within the range, of those found in the few other studies for East Asia, with few exceptions. The concentrations of the various elements were below the threshold that may affect the survival or reproduction of the birds, and even the highest concentrations relative to background, i.e. Se in eggs, and Hg in feathers at Pearl Delta, do not pose toxic hazards. In sediments, the levels of trace elements were lower than the critical levels assumed for contaminated soil, except for alarming high levels of As at Poyang. These results do not confirm our expectation, that Poyang was relatively uncontaminated, while Tai and Pearl were polluted. Although trace metal concentration differed significantly among the three study areas, these differences were minor and were not consistent among elements and samples. The bioaccumulation ratios from sediments through prey, feather and egg, were consistent with our previous findings for Pakistan. Only Hg exhibited high bioaccumulation, while Se and Zn had low accumulation, and the other elements no accumulation. This reasserts that feathers of predators such as egrets, may be more sensitive indicators of environmental contamination for the elements subject to bioaccumulation, whereas the sediments or the organisms low in the food chain are better indicators for the other elements.     

Fruit Stones from Industrial Waste for the Removal of Lead Ions from Polluted Water

Lead, one of the earliest metals recognized and used by humans, has a long history of beneficial use. However, it is now recognized as toxic and as posing a widespread threat to humans and wildlife. Treatment of lead from polluted water and wastewater has received a great deal of attention. Adsorption is one of the most common technologies for the treatment of lead-polluted water. This technique was evaluated here, with the goal of identifying innovative, low-cost adsorbent. This study presents experiments undertaken to determine the suitable conditions for the use of peach and apricot stones, produced from food industries as solid waste, as adsorbents for the removal of lead from aqueous solution. Chemical stability of adsorbents, effect of pH, adsorbents dose, adsorption time and equilibrium concentration were studied. The results reveal that adsorption of lead ions onto peach stone was stronger than onto apricot stone up to 3.36% at 3 h adsorption time. Suitable equilibrium time for the adsorption was 3–5 h (% Pb adsorption 93% for apricot and 97.64% for peach). The effective adsorption range for pH in the range was 7–8. Application of Langmuir and Freundlich isotherm models show high adsorption maximum and binding energies for using these adsorbents for the removal of lead ions from contaminated water and wastewater.     

Modeling rhizofiltration: heavy-metal uptake by plant roots

The discovery of phytoaccumulation potential of plant species has led to its application for remediation of heavy-metal-contaminated soil and wastewater, which is termed as phytoextraction/rhizofiltration. For prediction, analysis, planning and cost-effective design of such systems, mathematical models not only are used as a screening tool but also provide optimal parameters like harvesting time, irrigation schedule, etc. Several laboratory and field scale studies have been carried out in the past, and mathematical expressions have been developed by various researchers for different phenomena like metal adsorption in soil, plant root growth with time, moisture and metal uptake by plant root, moisture movement in unsaturated zone, soil moisture relationship, etc. The complete design of any such phytoremediation program would require the knowledge of behavior of heavy-metal movement in soil, water and plant root system. In this paper, a model for simulating heavy-metal dynamics in soil, water and plant root system is developed and discussed. The governing non-linear partial differential equation is solved numerically by implicit finite difference method using Picard's iterative technique, and the formulation has been illustrated using a characteristic example. The source code is written in MATLAB.     

Influence of the geomembrane on time-lapse ERT measurements for leachate injection monitoring

Leachate recirculation is a key process in the operation of municipal waste landfills as bioreactors. To quantify the water content and to evaluate the leachate injection system, in situ methods are required to obtain spatially distributed information, usually electrical resistivity tomography (ERT). However, this method can present false variations in the observations due to several parameters. This study investigates the impact of the geomembrane on ERT measurements. Indeed, the geomembrane tends to be ignored in the inversion process in most previously conducted studies. The presence of the geomembrane can change the boundary conditions of the inversion models, which have classically infinite boundary conditions. Using a numerical modelling approach, the authors demonstrate that a minimum distance is required between the electrode line and the geomembrane to satisfy the good conditions of use of the classical inversion tools. This distance is a function of the electrode line length (i.e. of the unit electrode spacing) used, the array type and the orientation of the electrode line. Moreover, this study shows that if this criterion on the minimum distance is not satisfied, it is possible to significantly improve the inversion process by introducing the complex geometry and the geomembrane location into the inversion tools. These results are finally validated on a field data set gathered on a small municipal solid waste landfill cell where this minimum distance criterion cannot be satisfied.     

游离氨对热水解联合中温厌氧消化处理剩余污泥的影响

热水解预处理强化了污泥厌氧消化过程,但同时增加了微生物受游离氨抑制的风险.对比传统工艺,在有机容积负荷率1.74~4.27gVS/(L·d)条件下,研究了游离氨(FA)对热水解联合中温厌氧消化工艺性能的影响.结果表明,组合工艺甲烷产量较传统反应器提高89%~121%,有机去除率提高1.21~1.46倍.但同时导致系统中游离氨浓度达89~382mgN/L,显著高于传统工艺中37~84mgN/L的范围.游离氨毒性测试显示,传统工艺中FA浓度从43mgN/L升至84mgN/L,没有抑制解乙酸产甲烷途径,而组合工艺中FA升至264mgN/L时,表现出抑制作用,尽管厌氧菌对高浓度FA表现更强的驯化趋势.结合氮负荷试验, FA浓度与基质利用能力,解乙酸产甲烷途径抑制程度和挥发性有机酸积累的关系表明,高有机负荷条件下组合工艺效率可通过控制氮负荷优化.     

Molecular Transport of Xylene Through Palm Pressed Fibre Filled Low Density Polyethylene: Role of Fibre Content,Alkali Treatment and Particle Size

We report in this paper the transport of an aromatic solvent, xylene through palm pressed fibre filled low density polyethylene composites studied at three different temperatures (40, 60, and 80 °C) by conventional weight-gain method. The diffusion parameters were investigated with special reference to the effect of fibre content, temperature and particle size. The effect of alkali treatment on solvent uptake was also analyzed. The transport coefficients of diffusion, permeation and sorption were determined to evaluate the influence of interface bonding on transport properties. The van’t Hoff relationship was used to determine the thermodynamic parameters and was found that the estimated free energies of sorption were all positive, indicating non-spontaneity of the solubility of PPF/LDPE composites. The first order kinetic rate constant and swelling parameters were also evaluated.