Determination of anti-anxiety and anti-epileptic drugs in hospital effluent and a preliminary risk assessment

In this study, an analytical methodology was developed for the determination of psycho-active drugs in the treated effluent of the University Hospital at the Federal University of Santa Maria, RS – Brazil. Samples were collected from point A (Emergency) and point B (General effluent). The adopted methodology included a pre-concentration procedure involving the use of solid phase extraction and determination by liquid chromatography coupled to mass spectrometry. The limit of detection for bromazepam and lorazepam was 4.9 ± 1.0 ng L⁻¹ and, for carbamazepine, clonazepam and diazepam was 6.1 ± 1.5 ng L⁻¹. The limit of quantification was 30.0 ± 1.1 ng L⁻¹, for bromazepam, clonazepam and lorazepam; for carbamazepine was 50.0 ± 1.8 ng L⁻¹ and was 40.0 ± 1.0 ng L⁻¹ for diazepam. The mean concentrations in the Emergency and General effluent treated currents were as follows: for bromazepam, 195 ± 6 ng L⁻¹ and 137 ± 7 ng L⁻¹; for carbamazepine, 590 ± 6 ng L⁻¹ and 461 ± 10 ng L⁻¹; for diazepam, 645 ± 1 ng L⁻¹ and 571 ± 10 ng L⁻¹; for lorazepam, 96 ± 7 ng L⁻¹ and 42 ± 4 ng L⁻¹; and for clonazepam, 134 ± 10 ng L⁻¹ and 57 ± 10 ng L⁻¹. A preliminary risk assessment was conducted: carbamazepine and diazepam require considerable attention owing to their environmental toxicity. The occurrence of these psychoactive-drugs and the environmental risks that they pose demonstrated the need for a more efficient treatment system. As far we are aware, there have been no comparable studies to this on the hazards of hospital effluents in Brazil, and very few that have carried out a risk assessment of psycho-active drugs in hospital effluent in general.     

Development and application of LC–APCI–MS method for biomonitoring of animal and human exposure to imidacloprid

Imidacloprid (IMI) is a relatively new neuro-active neonicotinoid insecticide and nowadays one of the largest selling insecticides worldwide. In the present study a LC–APCI–MS based method was developed and validated for the quantification of imidacloprid and its main metabolite 6-chloronicotinic acid (6-CINA) in urine and hair specimens. The method was tested in biomonitoring of intentionally exposed animals and subsequently applied for biomonitoring of Cretan urban and rural population.     

Activated sludge systems removal efficiency of veterinary pharmaceuticals from slaughterhouse wastewater

The knowledge on the efficiency of wastewater treatment plants (WWTPs) from animal food production industry for the removal of both hormones and antibiotics of veterinary application is still very limited. These compounds have already been reported in different environmental compartments at levels that could have potential impacts on the ecosystems. This work aimed to evaluate the role of activated sludge in the removal of commonly used veterinary drugs, enrofloxacin (ENR), tetracycline (TET), and ceftiofur, from wastewater during a conventional treatment process. For that, a series of laboratory-controlled experiments using activated sludge were carried out in batch reactors. Sludge reactors with 100 μg/L initial drug charge presented removal rates of 68 % for ENR and 77 % for TET from the aqueous phase. Results indicated that sorption to sludge and to the wastewater organic matter was responsible for a significant percentage of drugs removal. Nevertheless, these removal rates still result in considerable concentrations in the aqueous phase that will pass through the WWTP to the receiving environment. Measuring only the dissolved fraction of pharmaceuticals in the WWTP effluents may underestimate the loading and risks to the aquatic environment.     

Measurement of Automobile Exhaust GAS Hydrocarbons

While snowflakes fell and Christmas carols heralded the imminent holiday, over 3000 delegates to the Third National Conference on Air Pollution were told to “Control Now for Clean Air.”

They were told this in many ways by many people—by the Vice President of the United States; by the Secretary of the Department of Health, Education, and Welfare who summoned the Conference; and by senators, congressmen, governors, and mayors.

Then eight panel sessions convened to discuss and to determine how to control now for clean air. Speakers from every section of American life addressed themselves to this subject; when they were finished, the eight session chairmen summarized what had been said, what had been, learned. These summaries appear on the following pages.     

Amelioration of physical strength in waste foundry green sands for reuse as a soil amendment

To avoid increasing costs of landfill disposal, it has become increasingly important for U.S. foundries to identify beneficial reuses for the 8 to 12 million tons of waste foundry sand (WFS) generated annually. A major drawback to the reuse of some WFSs as a soil amendment is their high soil strength, under dry conditions, where root growth may be limited. Fifteen WFSs were analyzed for strength to rupture using lab-formed clods, exchangeable cations (Na, Mg, Ca), metal oxide concentration (Fe, Mn, Al, Si), cation exchange capacity (CEC), and % clay. Several WFS samples from gray iron foundries demonstrated high strength to rupture values (> 1.5 MPa), and could potentially restrict root growth in amended soils. The percentage of Na-bentonite exhibited a positive correlation (R(2) = 0.84) with strength to rupture values. When WFSs containing more Na-bentonite were saturated with 1 mol L(-1) Ca ions, strength values decreased by approximately 70%. Waste foundry sands containing less Na-bentonite were saturated with 1 mol L(-1) Na ions and exhibited a threefold increase in strength. Additions of gypsum (up to 9.6 g kg(-1) sand) to high strength waste foundry sands also caused decreases in strength. These results indicate that high strength WFSs have properties similar to hardsetting soils which are caused by high Na(+) clay content and can be ameliorated by the addition of Ca(2+).     

Estimated occupational risk from bioaerosols generated during land application of class B biosolids

Some speculate that bioaerosols from land application of biosolids pose occupational risks, but few studies have assessed aerosolization of microorganisms from biosolids or estimated occupational risks of infection. This study investigated levels of microorganisms in air immediately downwind of land application operations and estimated occupational risks from aerosolized microorganisms. In all, more than 300 air samples were collected downwind of biosolids application sites at various locations within the United States. Coliform bacteria, coliphages, and heterotrophic plate count (HPC) bacteria were enumerated from air and biosolids at each site. Concentrations of coliforms relative to Salmonella and concentrations of coliphage relative to enteroviruses in biosolids were used, in conjunction with levels of coliforms and coliphages measured in air during this study, to estimate exposure to Salmonella and enteroviruses in air. The HPC bacteria were ubiquitous in air near land application sites whether or not biosolids were being applied, and concentrations were positively correlated to windspeed. Coliform bacteria were detected only when biosolids were being applied to land or loaded into land applicators. Coliphages were detected in few air samples, and only when biosolids were being loaded into land applicators. In general, environmental parameters had little impact on concentrations of microorganisms in air immediately downwind of land application. The method of land application was most correlated to aerosolization. From this large body of data, the occupational risk of infection from bioaerosols was estimated to be 0.78 to 2.1%/yr. Extraordinary exposure scenarios carried an estimated annual risk of infection of up to 34%, with viruses posing the greatest threat. Risks from aerosolized microorganisms at biosolids land application sites appear to be lower than those at wastewater treatment plants, based on previously reported literature.     

Co-digestion of animal slurry can increase short-term nitrogen recovery by crops

Co-digestion changes slurry characteristics and is supposed to increase short-term nitrogen (N) uptake by crops after application. A higher N uptake from slurry reduces the need for additional mineral N fertilizer. If farmers apply co-digested slurry (CS), a higher N recovery has to be taken into account to prevent losses to the environment. Since data on the effects of co-digestion on N recovery by crops are scarce, a pot experiment was performed. The apparent N recovery (ANR) of five different co-digested pig slurries was compared with their raw source slurries (RS) during 105 d after a single fertilization of ryegrass (Lolium perenne L.), grown under controlled conditions. Slurry was mixed with sandy soil and grass was cut every 35 d. The results show that co-digestion increased (p < 0.05) the ANR at first cut on average from 39 to 50%, at second cut from 7 to 9% (p < 0.05), and had no effect on ANR at third cut (3%). The ANR increase at first cut was likely due to an increase of the NH(4)-N/total N ratio along with a decrease of the organic C/total N ratio of slurry during co-digestion. Field application may under certain circumstances decrease N fertilizer value of CS, due to a higher NH(3) emission compared to RS. A potential ANR increase may then be reduced, absent, or even become a decrease. Under comparable NH(3) emissions, however, CS can in the short term be more valuable as an N fertilizer than RS, and fertilizer savings can likely be realized.     

Ecological scenarios analyzed and evaluated by a shallow lake model

We applied the complex ecosystem model EMMO, which was adopted to the shallow lake Müggelsee (Germany), in order to evaluate a large set of ecological scenarios. By means of EMMO, 33 scenarios and 17 indicators were defined to characterize their effects on the lake ecosystem. The indicators were based on model outputs of EMMO and can be separated into biological indicators, such as chlorophyll-a and cyanobacteria, and hydro-chemical indicators, such as phosphorus. The question to be solved was, what is the ranking of the scenarios based on their characterization by these 17 indicators? And how can we handle high quantities of complex data within evaluation procedures? The scenario evaluation was performed by partial order theory which, however, did not provide a clear result. By subsequently applying the hierarchical cluster analysis (complete linkage) it was possible to reduce the data matrix to indicator and scenario representatives. Even though this step implies losses of information, it simplifies the application of partial order theory and the post processing by METEOR. METEOR is derived from partial order theory and allows the stepwise aggregation of indicators, which subsequently leads to a distinct and clear decision. In the final evaluation result the best scenario was the one which defines a minimum nutrient input and no phosphorus release from the sediment while the worst scenario is characterized by a maximum nutrient input and extensive phosphorus release from the sediment. The reasonable and comprehensive results show that the combination of partial order, cluster analysis and METEOR can handle big amounts of data in a very clear and transparent way, and therefore is ideal in the context of complex ecosystem models, like that we applied.     

Bacterial pretreatment enhances removal of heavy metals during treatment of post-methanated distillery effluent by Typha angustata L

A combination of bacterial pretreatment followed by free water surface flow through wetland plants was investigated to determine its effect on removal of heavy metals in bioremediation of post-methanated distillery effluent (PMDE). The bacterial pretreatment was intended to transform the metal complexes and organic pollutants into simpler, biologically assimilable molecules. The 10% and 30% v/v concentrations of PMDE favored luxuriant bacterial growth; the 50% concentration supported less growth, whereas the undiluted effluent (i.e., 100%) supported very little bacterial growth. The use of bacterial pretreatment combined with the constructed wetland system greatly increase the overall bioaccumulation of all heavy metals by the plants compared with the control treatment. However, the integration of bacterial pretreatment of PMDE with the Typha angustata resulted in enhanced removal of Cd (34.02–61.50% increase), Cr (35.90–57.60% increase), Cu (32.88–54.22% increase), Fe (32.50–51.26% increase), Mn (35.99–82.85% increase), Ni (35.85–59.24% increase), Pb (33.45–59.51% increase) and Zn (31.95–53.70% increase) compared with a control that lacked this pretreatment. In addition to the bioaccumulation of these heavy metals, several physico-chemical parameters also improved at the 30% effluent concentration: color, BOD, COD, phenol and total nitrogen decreased by 98.33%, 98.89%, 98.50%, 93.75% and 82.39%, respectively, after 7 days of free water surface flow treatment. The results suggest that bacterial pretreatment of PMDE, integrated with phytoremediation will improve the treatment process of PMDE and promote safer disposal of this waste.     

Empirical study on voting power in participatory forest planning

Multicriteria decision support systems are applied in natural resource management in order to clarify the planning process for the stakeholders, to make all available information usable and all objectives manageable. Especially when the public is involved in planning, the decision support system should be easy to comprehend, transparent and fair. Social choice theory has recently been applied to group decision-making in natural resources management to accomplish these objectives. Although voting forms the basis of democracy, and is usually taken as a fair method, the influence of voters over the outcome may vary. It is also possible to vote strategically to improve the results from each stakeholder's point of view. This study examines the use of social choice theory in revealing stakeholders' preferences in participatory forest planning, and the influence of different voters on the outcome. The positional voting rules examined were approval voting and Borda count, but both rules were slightly modified for the purposes of this study. The third rule examined, cumulative rule, resembles utilitarian voting rules. The voting rules were tested in a real participatory forest planning situation in eastern Lapland, Finland. All voting rules resulted in a different joint order of importance of the criteria. Yet, the preference orders produced had also a lot in common and the criteria could be divided into three quite distinct groups according to their importance. The influence of individual voters varied between the voting rules, and in each case different voter was the most influential.