Development of a SWAT Patch for Better Estimation of Sediment Yield in Steep Sloping Watersheds1

Abstract: The watershed scale Soil and Water Assessment Tool (SWAT) model divides watersheds into smaller subwatersheds for simulation of rainfall‐runoff and sediment loading at the field level and routing through stream networks. Typically, the SWAT model first needs to be calibrated and validated for accurate estimation through adjustment of sensitive input parameters (i.e., Curve Number values, USLE P, slope and slope‐length, and so on). However, in some instances, SWAT‐simulated results are greatly affected by the watershed delineation and Digital Elevation Models (DEM) cell size. In this study, the SWAT ArcView GIS Patch II was developed for steep sloping watersheds, and its performance was evaluated for various threshold values and DEM cell size scenarios when delineating subwatersheds using the SWAT model. The SWAT ArcView GIS Patch II was developed using the ArcView GIS Avenue program and Spatial Analyst libraries. The SWAT ArcView GIS Patch II improves upon the SWAT ArcView GIS Patch I because it reflects the topographic factor in calculating the field slope‐length of Hydrologic Response Units in the SWAT model. The simulated sediment value for 321 subwatersheds (watershed delineation threshold value of 25 ha) is greater than that for 43 subwatersheds (watershed delineation threshold value of 200 ha) by 201% without applying the SWAT ArcView GIS Patch II. However, when the SWAT ArcView GIS Patch II was applied, the difference in simulated sediment yield decreases for the same scenario (i.e., difference in simulated sediment with 321 subwatersheds and 43 subwatersheds) was 12%. The simulated sediment value for DEM cell size of 50 m is greater than that for DEM cell size of 10 m by 19.8% without the SWAT ArcView GIS Patch II. However, the difference becomes smaller (3.4% difference) between 50 and 10 m with the SWAT ArcView GIS Patch II for the DEM scenarios. As shown in this study, the SWAT ArcView GIS Patch II can reduce differences in simulated sediment values for various watershed delineation and DEM cell size scenarios. Without the SWAT ArcView GIS Patch II, variations in the SWAT‐simulated results using various watershed delineation and DEM cell size scenarios could be greater than those from input parameter calibration. Thus, the results obtained in this study show that the SWAT ArcView GIS Patch II should be used when simulating hydrology and sediment yield for steep sloping watersheds (especially if average slope of the subwatershed is >25%) for more accurate simulation of hydrology and sediment using the SWAT model. The SWAT ArcView GIS Patch II is available at http://www.EnvSys.co.kr/~swat for free download.     

Characterization of controlled-release KMnO4 (CRP) barrier system for groundwater remediation: a pilot-scale flow-tank study

Release and spreading of permanganate (MnO(4)(-)) in the well-based controlled-release potassium permanganate (KMnO(4)) barrier system (CRP system) was investigated by conducting column release tests, model simulations, soil oxidant demand (SOD) analyses, and pilot-scale flow-tank experiments. A large flow tank (L x W x D=8m x 4m x 3m) was constructed. Pilot-scale CRP pellets (OD x L=0.05 m x1.5m; n=110) were manufactured by mixing approximately 198 kg of KMnO(4) powders with paraffin wax and silica sands in cylindrical moulds. The CRP system (L x W x D=3m x 4m x 1.5m) comprising 110 delivery wells in three discrete barriers was constructed in the flow tank. Natural sands (organic carbon content=0.18%; SOD=3.7-11 g MnO(4)(-)kg(-1)) were used as porous media. Column release tests and model simulations indicated that the CRP system could continuously release MnO(4)(-) over several years, with slowly decreasing release rates of 2.5 kg d(-1) (day one), 109 g d(-1) (day 100), 58 g d(-1) (year one), 22 g d(-1) (year five), and 12 g d(-1) (year 10). Mean MnO(4)(-) concentrations within the CRP system ranged from 0.5 to 6 mg l(-1) during the 42 days of testing period. The continuously releasing MnO(4)(-) was gradually removed by SOD limiting the length of MnO(4)(-) zone in the porous media. These data suggested that the CRP system could create persistent and confined oxidation zone in the subsurface. Through development of advanced tools for describing agent transport and facilitating lateral agent spreading, the CRP system could provide new approach for long-term in situ treatment of contaminant plumes in groundwater.     

Whole Effluent Toxicity (WET) Tests on Wastewater Treatment Plants with Daphnia magna and Selenastrum capricornutum

Whole effluent toxicity (WET) tests, with Daphnia magna and Selenastrum capricornutum, were introduced to evaluate the biological toxicities of effluents from the wastewater treatment plants (WWTPs) in Korea. In WET tests of WWTPs effluents, 33.3% (33/99) for D. magna and 92.6% (75/81) for S. capricornutum revealed greater than 1 toxic unit (TU), even though all the treatment plants investigated were operating in compliance with the regulations, as assessed using conventional monitoring methods (i.e., BOD and total concentration of N or P, etc). There were only minor differences in toxicities according to the types of influents (municipal and agro-industrial) in all treatment plants. However, the effluents treated by an activated sludge treatment process were found to exhibit significantly lower toxicity than those treated by rotating biological contactor (RBC) and extended aeration processes. The seasonal variations in the toxicity were lower in the summer compared to winter, which may have been due to the rainfall received to the sewage intake system during the former period. The impact of WET on river water was also investigated based on the discharge volume. At sites A and B, the total impact of toxicity to stream and river waters was observed to be 70.9% and 90.4% for D. magna and S. capricornutum, respectively. The other four small treatment plants (sites F, G, H and I), with relative discharging volumes between 0.001 and 0.002, contribute less than 1% to the total toxicity.     

Enhancement of aerobic biodegradation in an oxygen-limiting environment using a saponin-based microbubble suspension

This study investigated the ability of a saponin-based microbubble suspension to enhance aerobic biodegradation of phenanthrene by subsurface delivery. As the microbubble suspension flowed through a sand column pressure buildup and release was repeatedly observed, which delivered oxygen to the less permeable regions. Burkholderia cepacia RPH1, a phenanthrene-degrading bacterium, was mainly transported in a suspended form in the microbubble suspension. When three pore volumes of the microbubble suspension containing B. cepacia RPH1 was introduced into a column contaminated with phenanthrene (100 mg/kg), the oxygen content declined to 5% from an initial value of 20% within 5 days and correspondingly, 34.4% of initial phenanthrene was removed in 8 days. The addition of two further three pore volumes enhanced the biodegradation efficiency by a factor of 2.2. Our data suggest that a saponin-based microbubble suspension could be a potential carrier for enhancing the aerobic biodegradation under an oxygen-limiting environment.     

Effects of copper (I) oxide on growth and biochemical compositions of two marine microalgae

In copper based antifouling (AF) paints Cu (I) oxide was largely used as booster biocide. In this study effect of Cu (I) oxide on two marine microalgae, Tetraselmis suecica and Dunaliella tertiolecta was demonstrated. EC50 (96 hr) concentrations estimated for T. suecica and D. tertiolecta were 1.3 mg l(-1) and 1.34 mg l(-1), respectively. Copper (I) oxide induced changes in growth, chlorophyll, carbohydrate and protein contents were observed in T. suecica and D. tertiolecta. At low concentration of 0.0625 mg l(-1), 3-26% and 1-16% growth stimulation was observed in T. suecica and T. tertiolecta respectively. Increasing Cu (I) oxide concentrations proportionately decreased the carbohydrate and protein contents. This study clearly indicates the toxicity of excessive Cu (I) oxide on growth and biochemical compositions of T. suecica and D. tertiolecta.     

Determination of biodegradation potential by two culture-independent methods in PAH-contaminated soils

Biodegradation potentials of polycyclic aromatic hydrocarbons (PAHs) were determined with soil samples collected from various depths of a PAH-contaminated site and of a site nearby where PAHs were not found. Putative dioxygenase genes were amplified by a primer set specific for initial dioxygenases and identified by web-based database homology search. They were further categorized into several groups of which four dioxygenases were selected as probes for DNA hybridization. The hybridization signals according to the presence of putative dioxygenases were positively related to the extent of PAH contamination. However, the signal intensities varied depending on the probes hybridized and moreover were not consistent with PAH biodegradation activities determined by CO2 evolution. Despite widely accepted advantages of molecular biodegradation assessment, our data clearly present the variations of assessment results depending on the genetic information used and suggest that the methodology may tend to underestimate the real biodegradation capacity of a site probably due to the limited dioxygenase database available at the moment. Therefore, the molecular assessment of biodegradation potential should involve a very careful primer and probe design and an extensive microbiological examination of a site of interest to accurately delineate the biodegradation potential of the site.     

Study of aerosol optical properties at two urban areas in the north of Vietnam with the implication for biomass burning impacts

Environmental Science and Pollution Research - The spatiotemporal distribution and characterization of aerosol optical properties in the north of Vietnam were investigated extensively using the...     

Sorption of selenium anionic species on apatites and iron oxides from aqueous solutions

The sorption of selenite and selenate ions from aqueous solutions was investigated on hydroxyapatite, fluorapatite, goethite and hematite, in order to simulate the behavior of radioactive selenium in natural or artificial sorbing media. Correlation studies with acido-basic properties and solubility of the solids were also performed. The sorption is pH dependant, but these solids are very efficient for retaining selenite at pH values generally encountered in natural waters, with however higher K(d) values for oxides than apatites. Selenate ions are much less sorbed than selenite. Several methods such as electron microscopy and spectroscopic techniques were used to identify the sorption mechanisms. In the case of hydroxyapatite, sorption proceeds by substitution of phosphate groups in the lattice of the apatite crystal in the superficial layers of the solid. In the case of goethite and hematite, sorption can be interpreted and modeled by a surface complexation process, but there is a discrepancy between sorption site densities for selenite and for protons.     

Possible Routes for Lead Accumulation in Feral Pigeons (Columba Livia)

This study examined possible routes for lead (Pb) accumulation in resident pigeons collected from rural, urban, and four industrial sites in Korea. The accumulation pattern of Pb was comparable to the study sites. The highest Pb concentration was found in the bone, followed by kidney, liver, and lung of pigeons. Highest Pb residues in bones were found in urban (Seoul), and two industrial complex areas (Busan and Ulsan), which were about 15 times higher than rural area (Duckjuk island), and followed by Ansan and Yochon industrial areas. Regional Pb variations in liver, kidney, and lung tissues were also similar pattern with the bone Pb difference. These findings indicate that Pb accumulation in tissues of pigeons may be affected by the Pb exposure in their respective habitats. Crop contents and gizzard materials were investigated as representing the ingested items. No difference of Pb concentration was observed in major foods (maize and/or wheat) of crop contents in the study sites except Busan, whereas variations of Pb levels in gizzard materials were indicative of a similar pattern with tissue Pb differences. The Pb concentration in tissues of pigeons did not correspond well to the atmospheric Pb levels. With regard to possible Pb sources, ingested items especially materials present in the gizzard are important sources for Pb contamination to pigeons because Pb-containing sources may be expected to present in roadside particles, dusts, paint chips and building flakes. However, air Pb value being low may not affect significant as the regional variations in tissues of pigeons.     

Optimal water quality monitoring network design for river systems

Typical tasks of a river monitoring network design include the selection of the water quality parameters, selection of sampling and measurement methods for these parameters, identification of the locations of sampling stations and determination of the sampling frequencies. These primary design considerations may require a variety of objectives, constraints and solutions. In this study we focus on the optimal river water quality monitoring network design aspect of the overall monitoring program and propose a novel methodology for the analysis of this problem. In the proposed analysis, the locations of sampling sites are determined such that the contaminant detection time is minimized for the river network while achieving maximum reliability for the monitoring system performance. Altamaha river system in the State of Georgia, USA is chosen as an example to demonstrate the proposed methodology. The results show that the proposed model can be effectively used for the optimal design of monitoring networks in river systems.