Effect of soil solids concentration in batch tests on the partition coefficients of organic pollutants in landfill liner-soil materials

 The effect of the soil solids concentration in batch tests on the measured values of the partition coefficient (K _p) of organic pollutants in landfill liner-soil material was investigated. Since this study was based on the results of batch and column tests conducted independently, there were limitations to the conclusions derived. The organic compounds tested were benzene, methylene chloride, toluene, trichloroethylene, and p-xylene. The results of this study showed that as soil solids concentrations increased, the measured K _p values of these organic compounds strongly decreased. The observed values of K _p stabilized when the soil solids concentration was above a certain value. Typical K _p values obtained from batch tests conducted under high soil solids concentrations were close to those obtained from column tests. It was concluded that the K _p values of organic compounds measured under low soil solids concentrations, i.e., less than 100 g/l, may not correctly simulate the field situation. Consequently, the values of K _p obtained with low soil solids concentrations can result in an overestimation of the retardation factor of the landfill liner material. Received: March 14, 2002 / Accepted: August 25, 2002     

Evidence for biodegradation and volatilisation of dissolved petroleum hydrocarbons during in situ air sparging in large laboratory columns

Laboratory column experiments run for up to 13 days compared air sparging of groundwater contaminated by dissolved petroleum hydrocarbons in sterile and non-sterile aquifer sediments as well as uncontaminated sediments and groundwater. Loss of dissolved BTEX compounds in the contaminated columns was very rapid, occurring through volatilisation. The majority of the dissolved total organic carbon (TOC) persisted for much longer periods however. A direct comparison between losses from sterile and non-sterile columns suggested a negligible contribution of biodegradation to the removal of TOC. This was difficult to confirm through examination of O₂ utilisation because oxidation of a small amount of reduced sulphur in the aquifer materials was the dominant sink for O₂. Despite this, it was possible to conclude that less than 22% of the removal of TOC was through biodegradation during the first three days of air sparging.     

Management of hazardous waste in Thailand: present situation and future prospects

 This paper deals with the present scenario of hazardous waste management practices in Thailand, and gives some insights into future prospects. Industrialization in Thailand has systematically increased the generation of hazardous waste. The total hazardous waste generated in 2001 was 1.65 million tons. It is estimated that over 300 million kg/year of hazardous waste is generated from nonindustrial, community sources (e.g., batteries, fluorescent lamps, cleansing chemicals, pesticides). No special facilities are available for handling these wastes. There are neither well-established systems for separation, storage, collection, and transportation, nor the effective enforcement of regulations related to hazardous wastes management generated from industrial or nonindustrial sectors. Therefore, because of a lack of treatment and disposal facilities, these wastes find their way into municipal wastewaters, public landfills, nearby dump sites, or waterways, raising serious environmental concern. Furthermore, Thailand does not have an integrated regulatory framework regarding the monitoring and management of hazardous materials and wastes. In addition to the absence of a national definition of hazardous wastes, limited funding has caused significant impediments to the effective management of hazardous waste. Thus, current waste management practices in Thailand present significant potential hazards to humans and the environment. The challenging issues of hazardous waste management in Thailand are not only related to a scarcity of financial resources (required for treatment and disposal facilities), but also to the fact that there has been no development of appropriate technology following the principles of waste minimization and sustainable development. A holistic approach to achieving effective hazardous waste management that integrates the efforts of all sectors, government, private, and community, is needed for the betterment of human health and the environment. Received: February 26, 2001 / Accepted: October 11, 2002     

Drying of granulated wood ash by flue gas from saw dust and natural gas combustion

At the district heating plant of Kalmar, Sweden an on-line unit for production of granulated wood ash for nutrient recycling on forest soils is being applied. Currently, the granules are dried by hot air from an oil-fired burner. The objective of this work was to investigate how drying by flue gas affects the hardening of granules, or impacts their chemical composition and properties. Ninety-six granule samples were treated by flue gas from natural gas combustion in a laboratory pilot scale flue gas generator. CO₂, CO, O₂, C₃H₈ and NO concentrations were varied during the experiment. Additionally, some samples were treated by flue gas from combustion of sawdust at the heating plant in Kalmar. Drying by flue gases did not affect the chemical composition of granules, but minor effects were seen in their mineralogy. The carbonate content was slightly higher in granules treated with flue gas from natural gas combustion compared to the granules dried by hot air only, when measured by wet chemical methods. Results from XRD analysis imply that the calcite content is higher and the portlandite and arcanite content slightly less in granules treated with flue gas from sawdust combustion compared to the granules dried by hot air only. The results from this investigation showed no negative effects on ash granule composition or physical structure by the use of a flue as a drying medium.     

Regional Variations in the Implementation of the Local Air Quality Management Process within Great Britain

The UK National Air Quality Strategy has required local authorities to review and assess air quality in their area of jurisdiction and determine locations in their areas where concentrations of specific air quality pollutants are predicted to exceed national air quality objectives in the future. Statutory air quality management areas (AQMAs) are designated where air quality is predicted to be above specified objective concentrations by specific target dates, and statutory air quality action plans will be necessary to improve the local air quality within these areas. Over 124 local authorities in England (including London), Wales and Scotland anticipate declaring AQMAs following the conclusion of the statutory air quality review and assessment process. However, other influences are being exerted on the local air quality management process and AQMA decision-making processes. Such influences include regional and sub- regional collaborative working between local authorities and government agencies and wider political decision-making processes. Some regions of Great Britain (encompassing England (including London), Scotland and Wales) anticipate many AQMA designations, whilst other regions are not anticipating any such designations despite apparently similar air quality circumstances. Evidence for regional or sub-regional variations in the locations of anticipated AQMAs are examined through an evaluation of the outcomes of the scientific review and assessment process undertaken by local authorities declaring AQMAs, and through a local authority survey to identify influences on decision-making processes at a level above that of the local authority. Regional variation is reported in the type of pollutant causing AQMAs to be declared, in the numbers of AQMAs in regions and in the spatial distribution of AQMAs across Great Britain.     

STREAM DISCHARGE PREDICTION VIA A GRID BASED SOIL WATER ROUTING WITH PADDY FIELDS1

ABSTRACT: A grid based daily hydrologic model for a watershed with paddy fields was developed to predict the stream discharge. ASCII formatted elevation, soil, and land use data supported by the GRASS Geographic Information System are used to generate distributed results such as surface runoff and subsurface flow, soil water content, and evapotranspiration. The model uses a single flow path algorithm and simulates a water balance at each grid element. A linear reservoir assumption was used to predict subsurface runoff components. The model was applied to a 75.6 km² watershed located in the middle of South Korea, and observed stream flow hydrographs from 1995 and 1996 were compared to model predictions. The stream flow predictions of 1995 and 1996 generally agreed with the observed flow, resulting in a Nash‐Sutcliffe efficiency R² of 0.60 and 0.62, respectively. The hydraulic conductivity for percolating water through the saturated layer affected baseflow generation. The levee height of the paddy influenced the time and magnitude of the surface runoff, depending on irrigation management. The model will be used for making low flow management decisions by evaluating the role of each land use to stream flow, especially in case of paddy decrease by gradual urbanization of a watershed.     

Paradise Threatened: Land Use and Erosion on St. John, US Virgin Islands

2 /yr, respectively. Geomorphic evidence indicates that plantation agriculture during the 18th and 19th centuries did not cause severe erosion. Since about 1950 there has been rapid growth in roads and development due to increasing tourism and second-home development. Our field investigations identified the approximately 50 km of unpaved roads as the primary source of anthropogenic sediment. Field measurements of the road network in two catchments led to the development of a vector-based GIS model to predict road surface erosion and sediment delivery. We estimate that road erosion has caused at least a fourfold increase in island-wide sediment yields and that current sedimentation rates are unprecedented. Paving the dirt roads and implementing standard sediment control practices can greatly reduce current sediment yields and possible adverse effects on the marine ecosystems surrounding St. John.     

Comparing Environmental Conditions Using Indicators of Pollution Hazard

/ Land use/land cover classifications for 1973 and 1991, derived from the interpretation of satellite imagery, are quantified on the basis of biophysical land units in a study area in southeastern Australia. Nutrient export potentials are estimated for each land unit based on their composition of land use/land cover classes. Spatial and temporal comparisons are made of the land units based on the calculated pollution hazard indicators to provide an insight into changes in the state of the environment and the regional significance of land use changes. For example, one ecosystem, unique to the study, showed a large increase in pollution hazard over the study period as a manifestation of an 11-fold rise in cleared area and an expansion of cropping activities. The benefits to environmental management in general are discussed.KEY WORDS: Land cover change; Nutrient export; Environmental condition; Pollution hazard; Agricultural pollution; Nonpoint source pollution; Diffuse pollution; Environmental degradation     

A Sensitivity Analysis of Nitrogen Losses from Dairy Farms

International attention has focused on agricultural production systems as non-point sources of pollution affecting the quality of streams, estuaries and ground water resources. The objective of the current study was to develop a model of nitrogen management on the dairy farm, and to perform sensitivity analyses in order to determine the relative importance of manipulating herd nutrition, manure management and crop selection in reducing nitrogen (N) losses from the farm. The importance of the method of N input to the farm (purchased feed, legume fixation, inorganic fertilizer, imported manure) was investigated, and the potential to reduce N losses from dairy farms was evaluated. Nitrogen balance equations were derived, and related efficiency coefficients were set to reference values representing common management practices. Total farm N efficiency (animal product N per N input), and N losses per product N were determined for different situations by solving the set of simultaneous equations. Improvements in animal diet and management that increase the conversion of feed N to animal product by 50% would increase total farm N efficiency by 48% and reduce N losses per product by 36 to 40%. In contrast, reducing losses from manure collection, storage and application to improve the percentage of manure N that becomes available in soil by 100% would only improve total farm N efficiency by 13% and reduce total N losses by 14%. Selecting crops and management that can use soil nutrients 50% more efficiently would improve total farm efficiency by up to 59% and reduce N losses by up to 41% depending on the predominant nitrogen sources to the farm. Legume production would reduce N losses per product compared with non-legumes. There was more than a five fold difference in N losses per animal product N between the most extreme scenarios suggesting considerable opportunity to reduce N losses from dairy farms.