Butyltins in estuarine sediments two years after tributyltin use was restricted

The highly toxic compound tributyltin (TBT) is the active agent in many effective antifouling paints. In 1988 the U.S. regulated its use in such paints. Sediments taken from four sites in Boston Harbor, MA., USA in the summer of 1990 were assayed for organotins. There was significantly less TBT at all sites in 1990 than there was in 1988. Dibutyltin (DBT) and monobutyltin (MBT), were also detected, confirming that TBT degradation occurs in the estuary. It is suggested that the decreases are due to biological and/or chemical mechanisms rather than to photochemical reactions or transport away from the sites on resuspended particulate matter.     

Determination of PCDDs and PCDFs in PCB oil from a hazardous waste site

This paper describes the analysis of hazardous waste oil samples with procedures that were developed primarily to clean up and analyze biological samples. Details of the cleanup procedure and the results from the analysis of several waste PCB oil samples are presented.     

Impact of engine lubricant properties on regulated gaseous emissions of 2000-2001 model-year gasoline vehicles

The impact of the sulfur (S) content in lubricating oil was evaluated for four ultra-low-emission vehicles and two super-ultra-low-emission vehicles, all with low mileage. The S content in the lube oils ranged from 0.01 to 0.76%, while the S content of the gasoline was fixed at 0.2 ppmw. Vehicles were configured with aged catalysts and tested over the Federal Test Procedure, at idle and at 50-mph cruise conditions. In all testing modes, variations in the S level of the lubricant did not significantly affect the regulated gas-phase tailpipe emissions. In addition to the regulated gas-phase emissions, a key element of the research was measuring the engine-out sulfur dioxide (SO2) in near-real-time. This research used a new methodology based on a differential optical absorption spectrometer (DOAS) to measure SO2 from the lubricants used in this study. With the DOAS, the contribution of SO2 emissions for the highest-S lubricant was found to range from less than 1 to 6 ppm on a gasoline S equivalent basis over the range of vehicles and test cycles used. The development and operation of the DOAS is discussed in this paper.     

Computation of the interfacial area for two-fluid porous medium systems

We develop a method to compute interfacial areas from three-dimensional digital representations of multiphase systems. We approximate the interfaces with the isosurface generated by the standard marching-cube algorithm from the discrete phase distribution. We apply this approach to two-fluid pore-scale simulations by (1) simulating a random packing of spheres that obeys the grain-size distribution and porosity of an experimental porous medium system, and (2) using a previously developed pore-morphology-based model in order to predict the phase distribution for a water-wet porous medium that undergoes primary drainage. The predicted primary drainage curve and interfacial areas are in good agreement with the experimental values reported in the literature, where interfacial areas were measured using interfacial tracers. The energy dissipation during Haines jumps is significant: thus, the mechanical work done on the system is not completely converted into surface energy, and interfacial areas may not be deduced from the primary drainage curve.     

In situ diffusion experiment in granite: phase I

A program of in situ experiments, supported by laboratory studies, was initiated to study diffusion in sparsely fractured rock (SFR), with a goal of developing an understanding of diffusion processes within intact crystalline rock. Phase I of the in situ diffusion experiment was started in 1996, with the purpose of developing a methodology for estimating diffusion parameter values. Four in situ diffusion experiments, using a conservative iodide tracer, were performed in highly stressed SFR at a depth of 450 m in the Underground Research Laboratory (URL). The experiments, performed over a 2 year period, yielded rock permeability estimates of 2 x 10(-21) m(2) and effective diffusion coefficients varying from 2.1 x 10(-14) to 1.9 x 10(-13) m(2)/s, which were estimated using the MOTIF code. The in situ diffusion profiles reveal a characteristic "dog leg" pattern, with iodide concentrations decreasing rapidly within a centimeter of the open borehole wall. It is hypothesized that this is an artifact of local stress redistribution and creation of a zone of increased constrictivity close to the borehole wall. A comparison of estimated in situ and laboratory diffusivities and permeabilities provides evidence that the physical properties of rock samples removed from high-stress regimes change. As a result of the lessons learnt during Phase I, a Phase II in situ program has been initiated to improve our general understanding of diffusion in SFR.     

Ammonium excretion in a temperate-reef community by a planktivorous fish,Chromis punctipinnis (Pomacentridae), and potential uptake by young giant kelp,Macrocystis pyrifera (Laminariales)

The blacksmith Chromis punctipinnis, an abundant planktivorous damselfish off southern California, USA, shelters along rocky reefs at night. While sheltered, blacksmiths excrete ammonium that could, in turn, be utilized by nearby benthic macrophytes. Laboratory experiments during the summer and fall of 1983 and 1984 indicate that ammonium excretion at night ranged from 18.1 mol h^-1 by a 8.5 g (dry) fish, to 89.1 mol h^-1 by a 27.3 g fish; excretion rates generally declined throughout the night. Field measurements at night indicate that ammonium concentrations were significantly higher in rocky crevices occupied by blacksmiths than in unoccupied shelters, and the ammonium level in one shelter dropped after a blacksmith was experimentally removed. Young kelp plants (Macrocystis pyrifera) are capable of taking up ammonium at night. Ammonium levels in chambers containing both a blacksmith and a young kelp plant were significantly lower than in chambers containing only a fish, and ammonium levels dropped in ammoniumspiked chambers that contained kelp plants. Nighttime ammonium uptake rates by young kelp plants, which averaged 1.6 mol g^-1 (dry) h^-1, were only slightly lower than those during the day. Daytime excretion by blacksmiths occasionally results in elevated ammonium levels in the water column. On two of six days, ammonium concentrations in midwater foraging aggregations were slightly but significantly higher than in upcurrent controls; since blacksmiths typically aggregate at the incurrent margin of kelp beds, the ammonium is swept downcurrent and may be utilized by large M. pyrifera that extend through the water column. Thus, the activities of blacksmiths may results in the importation of extrinsic, inorganic nitrogen to primary producers on temperate reefs.     

Some biologically important low molecular weight organic acids in the sediments of Loch Eil

The isolation of biologically important low molecular weight organic acids from organically enriched sediments in Loch Eil, Scotland, was carried out by extraction of pore water with acidified ethyl acetate. High concentrations of acetic acid, up to 1.8 mg g^-1 dry weight of sediment were found at Station E-24. Propionate, butyrate, valerate, lactate and traces of succinate were also found. Succinate was present in significant amounts, 42.2 g g^-1 dry weight of sediment at Station E-70, which received a higher input of organic matter than E-24. Both propionate and succinate were absent from a control station in the Lynn of Lorne where the sediment was low in carbon compared with Loch Eil. In experimental tanks, acetate levels increased as the input of organic carbon (as cellulose) was increased up to a load level of 1.5 g m^-2 day^-1. Above this, acetate decreased and succinate appeared. Succinate was not detected in low-loaded tanks. Experiments with sieved mud showed a vertical distribution of the different acids with depth. Lactate and succinate reached highest concentration in the 0 to 3 cm layer, acetate at 3 to 6 cm and propionate at 6 to 9 cm. The results are discussed in relation to the role of these acids as food sources and as indicators of biochemical pathways taking place in sediments with different carbon input levels.     

Sperm transfer,displacement and precedence in Ischnura graellsii (Odonata : Coenagrionidae)

Summary Copulation in Ischnura graellsii may be divided into three stages, according to the movements and position of the male's abdomen. We measured sperm volumes in males and females interrupted at different phases of copulation in laboratory-reared and field specimens. The results showed that males remove sperm from the female during stage I, and do not transfer sperm until stage Il of the copulation. In the field females interrupted during stage I of copulation had less sperm than postcopula females, and the volume of sperm in laboratory females mated once or twice was similar. These results suggest that males can remove most of the sperm during stage I of copulation. Preparations of in-copula specimens showed the horns of the penis (used to remove sperm) inside the bursa copulatoox and the spermatheca. Therefore males can remove sperm from both organs, in contrast to the other Ischnura species so far studied, where males can empty only the bursa. The length of these horns is positively correlated with male body length, and there are significant differences in length between the left and right horns of individual males. This suggests great variability in the male's ability to remove sperm. On the other hand, ejaculate volume is positively related to male and female size, and negatively to male age. Males are likely to be able to detect the presence of sperm in females: if the effect of population density and time of start of copulation are taken into account, copulations are longer with mated than with virgin females. Using genetic markers, sperm precedence was studied by rearing the female offspring of 6 females mated with two males of different genotype. In 5 out of 6 crosses, the second male fertilized all the eggs laid by the female in her first clutch. On average, the following clutches were progressively more fertilized by the first male, but there were striking differences between crosses. These differences are probably due to the variability in the amount of sperm transferred and/or removed. Offprint requests to: A. Cordero