Simulating the fine and coarse inorganic particulate matter concentrations in a polluted megacity

A three dimensional chemical transport model (PMCAMx) is applied to the Mexico City Metropolitan Area (MCMA) in order to simulate the chemical composition and mass of the major PM₁ (fine) and PM_1–10 (coarse) inorganic components and determine the effect of mineral dust on their formation. The aerosol thermodynamic model ISORROPIA-II is used to explicitly simulate the effect of Ca, Mg, and K from dust on semi-volatile partitioning and water uptake. The hybrid approach is applied to simulate the inorganic components, assuming that the smallest particles are in thermodynamic equilibrium, while describing the mass transfer to and from the larger ones. The official MCMA 2004 emissions inventory with improved dust and NaCl emissions is used. The comparison between the model predictions and measurements during a week of April of 2003 at Centro Nacional de Investigacion y Capacitacion Ambiental (CENICA) “Supersite” shows that the model reproduces reasonably well the fine mode composition and its diurnal variation. Sulfate predicted levels are relatively uniform in the area (approximately 3 μg m^?3), while ammonium nitrate peaks in Mexico City (approximately 7 μg m^?3) and its concentration rapidly decreases due to dilution and evaporation away from the urban area. In areas of high dust concentrations, the associated alkalinity is predicted to increase the concentration of nitrate, chloride and ammonium in the coarse mode by up to 2 μg m^?3 (a factor of 10), 0.4 μg m^?3, and 0.6 μg m^?3 (75%), respectively. The predicted ammonium nitrate levels inside Mexico City for this period are sensitive to the physical state (solid versus liquid) of the particles during periods with RH less than 50%.     

Sustainable Cellular Biocomposites from Natural Fibers and Unsaturated Polyester Resin for Housing Panel Applications

Increased environmental awareness and interest in long-term sustainability of material resources has motivated considerable advancements in composite materials made from natural fibers and resins, or biocomposites. In spite of these developments the lower stiffness and strength of biocomposites has limited their applications to non-load-bearing components. This paper presents an overview of a study aimed at showing that the shortcomings of biocomposites can be overcome through hybrid material designs and efficient structural configurations to make them suitable for load bearing structural components. Hybrid blends of natural and synthetic fibers can significantly improve the characteristics of biocomposites with minimal cost and environmental impact, and hierarchical cellular designs can maximize material efficiency in structural components. Periodic and hierarchical cellular plate designs made from natural fibers and unsaturated polyester resin were evaluated experimentally and analytically. Stiffness, strength, and dimensional stability of all-biocomposite and hybrid natural–synthetic material systems were evaluated through material tests while structural performance of cellular plate designs was assessed through flexural tests on laboratory-scale samples. The experimental results were correlated with analytical models for short-fiber composites and cellular structures. The results showed that biocomposites have adequate short-term performance and that they can efficiently compete with housing panels made from conventional structural materials.     

Bioaccumulation of perfluoroalkyl acids in dairy cows in a naturally contaminated environment

Beef and dairy products may be important vectors of human exposure to perfluoroalkyl acids (PFAAs), but the understanding of how PFAAs are accumulated and transferred through agricultural food chains is very limited. Here, the bioaccumulation of PFAAs in dairy cows receiving naturally contaminated feed and drinking water was investigated by conducting a mass balance of PFAAs for a herd of dairy cows in a barn on a typical Swedish dairy farm. It was assumed that the cows were able to reach steady state with their dietary intake of PFAAs. Perfluorooctane sulfonic acid (PFOS) and perfluoroalkyl carboxylic acids (PFCAs) with 8 to 12 carbons were detected in cow tissue samples (liver, muscle, and blood) at concentrations up to 130 ng kg^?1. Mass balance calculations demonstrated an agreement between total intake and excretion within a factor of 1.5 and consumption of silage was identified as the dominant intake pathway for all PFAAs. Biomagnification factors (BMFs) were highly tissue and homologue specific. While BMFs of PFOS and PFCAs with 9 and 10 fluorinated carbons in liver ranged from 10 to 20, perfluorooctanoic acid (PFOA) was not biomagnified (BMF?<?1) in any of the investigated tissues. Biotransfer factors (BTFs; defined as the concentration in tissue divided by the total daily intake) were calculated for muscle and milk. Log BTFs ranged from ?1.95 to ?1.15 day kg^?1 with the highest BTF observed for PFOS in muscle. Overall, the results of this study suggest that long-chain PFAAs have a relatively high potential for transfer to milk and beef from the diet of dairy cows. However, a low input of PFAAs to terrestrial systems via atmospheric deposition and low bioavailability of PFAAs in soil limits the amount of PFAAs that enter terrestrial agricultural food chains in background contaminated environments and makes this pathway less important than aquatic exposure pathways. The BTFs estimated here provide a useful tool for predicting human exposure to PFAAs via milk and beef under different contamination scenarios.     

Microwave process for volatile organic compound abatement

The CHA Corporation has completed the U.S. Air Force Phase II Small Business Innovation Research program to investigate the feasibility of using a novel microwave-based process for the removal and destruction of volatile organic compounds (VOCs) in effluents from noncombustion sources, such as paint booth ventilation streams. Removal of solvents by adsorption, followed by the regeneration of saturated granular activated carbon (GAC) by microwave energy, was achieved in a single fixed-bed reactor. Microwave regeneration of the fixed-bed-saturated carbon restored the original GAC adsorption capacity. After 20 adsorption/regeneration cycles, the adsorption capacity dropped from 13.5 g methyl ethyl ketone (MEK)/100 g GAC to 12.5 g MEK/100 g GAC. During microwave regeneration of the GAC fixed bed, the concentrated desorbed paint solvent was oxidized by passing the solvent mixture through a fixed bed of an oxidation catalyst mixed with silicon carbide in a microwave reactor. A 98% oxidation efficiency was consistently achieved from the oxidation of VOCs in the microwave catalytic reactor.     

Survival of Escherichia coli in stormwater biofilters

Biofilters are widely adopted in Australia for stormwater treatment, but the reported removal of common faecal indicators (such as Escherichia coli (E. coli)) varies from net removal to net leaching. Currently, the underlying mechanisms that govern the faecal microbial removal in the biofilters are poorly understood. Therefore, it is important to study retention and subsequent survival of faecal microorganisms in the biofilters under different biofilter designs and operational characteristics. The current study investigates how E. coli survival is influenced by temperature, moisture content, sunlight exposure and presence of other microorganisms in filter media and top surface sediment. Soil samples were taken from two different biofilters to investigate E. coli survival under controlled laboratory conditions. Results revealed that the presence of other microorganisms and temperature are vital stressors which govern the survival of E. coli captured either in the top surface sediment or filter media, while sunlight exposure and moisture content are important for the survival of E. coli captured in the top surface sediment compared to that of the filter media. Moreover, increased survival was found in the filter media compared to the top sediment, and sand filter media was found be more hostile than loamy sand filter media towards E. coli survival. Results also suggest that the contribution from the tested environmental stressors on E. coli survival in biofilters will be greatly affected by the seasonality and may vary from one site to another.     

It's a dirty job but someone has to do it: The role of marine benthic macrofauna in organic matter turnover and nutrient recycling to the water column

Benthic macrofaunal populations through their feeding, bioturbation, burrow construction and sediment irrigation activities have profound influences on organic matter inputs to marine sediments (biodeposition) and on the vertical distribution of deposited organic matter within the sediment. These effects in turn influence the rates and pathways of organic matter mineralisation, and element cycles. Similarly, bioturbation, burrow construction and burrow irrigation are major determinants of sediment-water column fluxes of oxygen and nutrients.

In this review, I discuss the influences of the different benthic macrofaunal feeding (functional) groups on mineralisation processes and sediment-water column fluxes of particulate and dissolved nutrients. How these effects influence diagenic processes, the balance between aerobic and anaerobic processes, and the redox status of the surficial sediments. Finally, I discuss some of the limitations of the predominantly laboratory techniques which have been used to study “macrofaunal effects” and how this hinders the inclusion of the effects in quantitative sediment biogeochemical models.     

Prediction of polychlorinated dibenzofuran congener distribution from gas-phase phenol condensation pathways

A model for predicting the distribution of dibenzofuran and polychlorinated dibenzofuran (PCDF) congeners from a distribution of phenols was developed. The model is based on a simplified chemical mechanism. Relative rate constants and reaction order with respect to phenol precursors were derived from experimental results using single phenols and equal molar mixtures of up to four phenols. For validation, experiments were performed at three temperatures using a distribution of phenol and 19 chlorinated phenols as measured in municipal waste incinerator exhaust gas. Comparison of experimental measurements and model predictions for PCDF isomer distributions and homologue pattern shows agreement within measurement uncertainty. The R-squared correlation coefficient exceeds 0.9 for all PCDF isomer distributions and the distribution of PCDF homologues. These results demonstrate that the distribution of dibenzofuran and the 135 PCDF congeners from gas-phase condensation of phenol and chlorinated phenols can be predicted from measurement of the distribution of phenol and the 19 chlorinated phenol congeners.