Safe speed limits for a safe system: The relationship between speed limit and fatal crash rate for different crash types

Objective: The objective of this article is to provide empirical evidence for safe speed limits that will meet the objectives of the Safe System by examining the relationship between speed limit and injury severity for different crash types, using police-reported crash data.

Method: Police-reported crashes from 2 Australian jurisdictions were used to calculate a fatal crash rate by speed limit and crash type. Example safe speed limits were defined using threshold risk levels.

Results: A positive exponential relationship between speed limit and fatality rate was found. For an example fatality rate threshold of 1 in 100 crashes it was found that safe speed limits are 40 km/h for pedestrian crashes; 50 km/h for head-on crashes; 60 km/h for hit fixed object crashes; 80 km/h for right angle, right turn, and left road/rollover crashes; and 110 km/h or more for rear-end crashes.

Conclusions: The positive exponential relationship between speed limit and fatal crash rate is consistent with prior research into speed and crash risk. The results indicate that speed zones of 100 km/h or more only meet the objectives of the Safe System, with regard to fatal crashes, where all crash types except rear-end crashes are exceedingly rare, such as on a high standard restricted access highway with a safe roadside design.     

Validation of a booted finite element model of the WIAMan ATD lower limb in component and whole-body vertical loading impacts with an assessment of the boot influence model on response

Objective: A novel anthropomorphic test device (ATD) representative of the 50th percentile male soldier is being developed to predict injuries to a vehicle occupant during an underbody blast (UBB). The main objective of this study was to develop and validate a finite element (FE) model of the ATD lower limb outfitted with a military combat boot and to insert the validated lower limb into a model of the full ATD and simulate vertical loading experiments.

Methods: A Belleville desert combat boot model was assigned contacts and material properties based on previous experiments. The boot model was fit to a previously developed model of the barefoot ATD. Validation was performed through 6 matched pair component tests conducted on the Vertically Accelerated Loads Transfer System (VALTS). The load transfer capabilities of the FE model were assessed along with the force-mitigating properties of the boot. The booted lower limb subassembly was then incorporated into a whole-body model of the ATD. Two whole-body VALTS experiments were simulated to evaluate lower limb performance in the whole body.

Results: The lower limb model accurately predicted axial loads measured at heel, tibia, and knee load cells during matched pair component tests. Forces in booted simulations were compared to unbooted simulations and an amount of mitigation similar to that of experiments was observed. In a whole-body loading environment, the model kinematics match those recorded in experiments. The shape and magnitude of experimental force–time curves were accurately predicted by the model. Correlation between the experiments and simulations was backed up by high objective rating scores for all experiments.

Conclusion: The booted lower limb model is accurate in its ability to articulate and transfer loads similar to the physical dummy in simulated underbody loading experiments. The performance of the model leads to the recommendation to use it appropriately as an alternative to costly ATD experiments.     

Motorcycle crashes potentially preventable by three crash avoidance technologies on passenger vehicles

Objective: The objective of this study was to identify and quantify the motorcycle crash population that would be potential beneficiaries of 3 crash avoidance technologies recently available on passenger vehicles.

Methods: Two-vehicle crashes between a motorcycle and a passenger vehicle that occurred in the United States during 2011–2015 were classified by type, with consideration of the functionality of 3 classes of passenger vehicle crash avoidance technologies: frontal crash prevention, lane maintenance, and blind spot detection. Results were expressed as the percentage of crashes potentially preventable by each type of technology, based on all known types of 2-vehicle crashes and based on all crashes involving motorcycles.

Results: Frontal crash prevention had the largest potential to prevent 2-vehicle motorcycle crashes with passenger vehicles. The 3 technologies in sum had the potential to prevent 10% of fatal 2-vehicle crashes and 23% of police-reported crashes. However, because 2-vehicle crashes with a passenger vehicle represent fewer than half of all motorcycle crashes, these technologies represent a potential to avoid 4% of all fatal motorcycle crashes and 10% of all police-reported motorcycle crashes.

Discussion: Refining the ability of passenger vehicle crash avoidance systems to detect motorcycles represents an opportunity to improve motorcycle safety. Expanding the capabilities of these technologies represents an even greater opportunity. However, even fully realizing these opportunities can affect only a minority of motorcycle crashes and does not change the need for other motorcycle safety countermeasures such as helmets, universal helmet laws, and antilock braking systems.     

Effects of Topographical Heterogeneity and Dispersal Limitation on Species Turnover in a Temperate Mountane Ecosystem: a Case Study in the Henan Province,China

Species turnover patterns can be inconsistent due to differences in the dispersal ability of different growth forms. Here, species of trees, shrubs, herbs, and bryophytes in the Xiaoqinling National Nature Reserve in China were analyzed to determine patterns of species turnover along an elevation and spatial gradient. Variance partitioning was used to assess the relative contribution of topographic heterogeneity and dispersal limitation to species turnover. Our results suggest that the effect of dispersal limitation is more important than topographic heterogeneity on species turnover in temperate mountane ecosystems in the study area. Dispersal limitation has a greater effect on trees species turnover than on shrubs, herbs or bryophytes species turnover.     

Ecophysiology of Steppe Mouse Subspecies <Emphasis Type="Italic">Mus spicilegius spicilegus</Emphasis>, Peteni, 1883 (Rodentia,Mammalia) at the South Boundary of its Distribution

Diet, food preferences and main ecophysiological characteristics such like energy requirements and thermoregulation characteristics of Mus spicilegus spicilegus (Petenyi, 1882) were studied. The most preferred foods for the mice were seeds of weed species that composed more than 85% of their diet. The results of food selection experiments shows that the total daily consumption by mice is 2.77 ± 0.76 g/animal/day or 5.5 kJ/g/day or 84.9 kJ/animal/day. From the total daily energy consumption 16.4% go back to nature in the form of feces and urine and the rest 83.6% animals utilized for assimilation. The results of the temperature preferences for Mus s. spicilegus shows preferred temperature zone from around 26 to 36°C where mice spent about 72% of the experimental time. The lowest value of oxygen consumption for resting metabolism rate (RMR) was registered at 30°C–3.20 ± 0.71 cm³ O₂/g/h. It is possible to consider that the thermoneutral zone is around these temperature values. The obtained results give reason to conclude that from an ecophysiologycal point of view the climate in the south boundary of distribution provides optimal conditions for species development. The main cause for population decreasing probably is the loss of open habitats including natural steppe grasslands.     

Assessment of the State of Lung Lichen, <Emphasis Type="Italic">Lobaria pulmonaria</Emphasis> (L.) Hoffm., in Forest Communities with Different Times Since Disturbance in the Northeast of European Russia

Quantitative parameters of cenopopulations of Lobaria pulmonaria, an endangered cyanolichen, have been studied in spruce phytocenoses of Karelia recovering after disturbance through the successional stage of aspen stands for a period ranging from 80 to 450 years. The results show that, as the time since disturbance increases, the total number of L. pulmonaria thalli and the number of colonized substrate units increase as well, with no stabilization of these parameters being observed in the series of communities studied. The total area of thalli in the phytocenoses is restored within approximately 200 years after the last disturbance. In old-growth forests (>400 years), L. pulmonaria thalli colonize a broad spectrum of tree species in different life states, including lower branches of young spruce trees. Even if they serve as temporary substrates, this can markedly strengthen the potential of the species for further expansion within the community in case of shortage in the main phorophyte (aspen). Thus, the proportion of regressive populations decreases, while that of colonizing populations increases, which is indicative of successful reproduction of the species.     

Social justice and mobility in coastal Louisiana,USA

Regional Environmental Change - Louisiana faces extensive coastal land loss which threatens the livelihoods of marginalized populations. These groups have endured extreme disruptive events in the...     

Assessing groundwater quality and its sustainability in Joypurhat district of Bangladesh using GIS and multivariate statistical approaches

Sustainable groundwater quality is a key global concern and has become a major issue of disquiets in most parts of the world including Bangladesh. Hence, the assessment of groundwater quality is an important study to ensure its sustainability for various uses. In this study, a combination of multivariate statistics, geographical information system (GIS) and geochemical approaches was employed to evaluate the groundwater quality and its sustainability in Joypurhat district of Bangladesh. The results showed that the groundwater samples are mainly Ca–Mg–HCO₃ type. Principal component analysis (PCA) results revealed that geogenic sources (rock weathering and cation exchange) followed by anthropogenic activities (domestic sewage and agro-chemicals) were the major factors governing the groundwater quality of the study area. Furthermore, the results of PCA are validated using the cluster analysis and correlation matrix analysis. Based on the groundwater quality index (GWQI), it is found that all the groundwater samples belong to excellent to good water quality domains for human consumption, although iron, fluoride and iodide contaminated to the groundwater, which do not pose any significant health hazard according to World Health Organization’s and Bangladesh’s guideline values. The results of irrigation water quality index including sodium adsorption ratio (SAR), permeability index and sodium percentage (Na %) suggested that most of the groundwater samples are good quality water for agricultural uses. The spatial distribution of the measured values of GWQI, SAR, Fe (iron), EC (electrical conductivity) and TH (total hardness) were spatially mapped using the GIS tool in the study area.     

Development and implementation of eco-genomic tools for aquatic ecosystem biomonitoring: the SYNAQUA French-Swiss program

The effectiveness of environmental protection measures is based on the early identification and diagnosis of anthropogenic pressures. Similarly, restoration actions require precise monitoring of changes in the ecological quality of ecosystems, in order to highlight their effectiveness. Monitoring the ecological quality relies on bioindicators, which are organisms revealing the pressures exerted on the environment through the composition of their communities. Their implementation, based on the morphological identification of species, is expensive because it requires time and experts in taxonomy. Recent genomic tools should provide access to reliable and high-throughput environmental monitoring by directly inferring the composition of bioindicators’ communities from their DNA (metabarcoding). The French-Swiss program SYNAQUA (INTERREG France-Switzerland 2017–2019) proposes to use and validate the tools of environmental genomic for biomonitoring and aims ultimately at their implementation in the regulatory bio-surveillance. SYNAQUA will test the metabarcoding approach focusing on two bioindicators, diatoms, and aquatic oligochaetes, which are used in freshwater biomonitoring in France and Switzerland. To go towards the renewal of current biomonitoring practices, SYNAQUA will (1) bring together different actors: scientists, environmental managers, consulting firms, and biotechnological companies, (2) apply this approach on a large scale to demonstrate its relevance, (3) propose robust and reliable tools, and (4) raise public awareness and train the various actors likely to use these new tools. Biomonitoring approaches based on such environmental genomic tools should address the European need for reliable, higher-throughput monitoring to improve the protection of aquatic environments under multiple pressures, guide their restoration, and follow their evolution.     

Contamination of marine fauna by chlordecone in Guadeloupe: evidence of a seaward decreasing gradient

Chlordecone is an organochlorine pesticide, used in the Lesser Antilles from 1972 to 1993 to fight against a banana weevil. That molecule is very persistent in the natural environment and ends up in the sea with runoff waters. The objective of the present study is to evaluate the level of contamination in several trophic groups of marine animals according to their distance from the source of pollution. Samples of suspended matter, macroalgae, herbivorous fishes, detrivorous crustaceans, zooplanktivorous fishes, first- and second-order of carnivorous fishes, and piscivorous fishes have been collected in two sites, located downstream the contaminated sites (Goyave and Petit-Bourg), in three marine habitats (coastal mangroves, seagrass beds located 1.5 km from the shoreline, and coral reefs at 3 km offshore). Animals collected in mangroves were the most contaminated (mean concentrations 193 μg kg^?1 in Goyave and 213 μg kg^?1 in Petit-Bourg). Samples from seagrass beds presented intermediate concentrations of chlordecone (85 μg kg^?1 in Goyave and 107 μg kg^?1 in Petit-Bourg). Finally, samples from coral reefs were the less contaminated (71 μg kg^?1 in Goyave and 74 μg kg^?1 in Petit-Bourg). Reef samples, collected 3 km offshore, were two to three times less contaminated than those collected in mangroves.