Utilization of waste product (tamarind seeds) for the removal of Cr(VI) from aqueous solutions: Equilibrium, kinetics, and regeneration studies

In the present study, an adsorbent was prepared from tamarind seeds and used after activation for the removal of Cr(VI) from aqueous solutions. The tamarind seeds were activated by treating them with concentrated sulfuric acid (98% w/w) at a temperature of 150 °C. The adsorption of Cr(VI) was found to be maximum at low values of initial pH in the range of 1–3. The adsorption process of Cr(VI) was tested with Langmuir, Freundlich, Redlich–Peterson, Koble–Corrigan, Tempkin, Dubinin–Radushkevich and Generalized isotherm models. Application of the Langmuir isotherm to the system yielded a maximum adsorption capacity of 29.7 mg/g at an equilibrium pH value ranging from 1.12 to 1.46. The adsorption process followed second-order kinetics and the corresponding rate constants obtained were 2.605 × 10⁻³, 0.818 × 10⁻³, 0.557 × 10⁻³ and 0.811 × 10⁻³ g/mg min⁻¹ for 50, 200, 300 and 400 mg/L of initial Cr(VI) concentration, respectively. The regenerated activated tamarind seeds showed more than 95% Cr(VI) removal of that obtained using the fresh activated tamarind seeds. A feasible solution is proposed for the disposal of the contaminants (acid and base solutions) containing high concentrations of Cr(VI) obtained during the regeneration (desorption) process.     

Predicted concentrations of biocides from antifouling paints in Visakhapatnam Harbour

The concentrations of biocides leached from antifouling coatings are monitored in most of the developed countries. However, in India and many other developing countries, there is very little data available on the concentrations of biocides in ports and harbours. The first step was to obtain the order of magnitude levels of concentrations of biocides in the marine environment of the Visakhapatnam Harbour, and the MAM-PEC (Marine Antifoulant Model to Predict Environmental Concentrations) model was used to predict these values. The Visakhapatnam Port lies on the eastern coast of India, roughly halfway between Chennai and Kolkata, and is the largest port in India. This port is a natural harbour; the long and narrow outlet to the open sea makes it a 'poorly flushed' harbour. Predicted concentrations of tributyltin (TBT), copper, dichlofluanid, seanine, irgarol, diuron, tolylfluanid, and zinc pyrithione were computed. The results of the computations indicate that the levels of these biocides are comparable to those in many western countries. This gives credence to the fact that persistence of TBT and some other biocides is a global problem that cannot be ignored.     

Evaluation of the aggressive potential of marine chloride and sulfate salts on mortars applied as renders in the Metropolitan Region of Salvador--Bahia, Brazil

In recent years, growing interest has focused on determining the performance of materials and evaluating the service life of structures exposed to various environmental forces. In this context, the determination of the aggressive potential of marine salts on mortars used as external renders is critical. The present study aimed to evaluate the spatial distribution of marine salts relative to distance from the sea. This was done by monitoring the deposition rate of chlorides and sulfates in wet candle sensors, located at nine stations scattered around the Metropolitan Region of Salvador, state of Bahia, Brazil. The study also determined the effectiveness of water-soluble salts at penetrating three different types of mortars of varying cement content via deposition and diffusion. The methodology employed enabled an evaluation of the efficiency of the monitoring sensors' measurement of the aggressiveness potential of local marine aerosol, and determination of the comparative performance of the three mortars tested, from the standpoint of resistance to salt penetration. The type and amount of salts captured both in solution and in powder samples extracted from the mortars were determined by ion chromatography. The analysis of the various types of mortars tested indicated which types are more resistant to the aggressive potential of the region's marine aerosol and the distance from the shore where local buildings are liable to be most strongly affected.     

The reliability of experts' opinions in constructing a composite environmental index: The case of ESI 2005

The complexity of the environment demands a well-constructed composite environmental index (CEI) to provide a useful tool to draw attention to environmental conditions and trends for policy purposes. Among the common difficulties in constructing a proper CEI are uncertainties due to the selection of the most representative underlying variables or indicators. A degree of uncertainty accompanies experts' judgments, and to deal with vague, subjective or inconsistent information, logic other than classic is required. This study analyzes a procedure that uses different experts' opinions in constructing a CEI, with the use of paraconsistent annotated logic. For this, a sensitivity analysis of the Environmental Sustainability Index (ESI 2005) was used as an example to assess the reliability of experts' opinions. The uncertainty due to the disagreement in experts' opinions clearly indicates that the forms we presently use to measure and monitor the actual environment are insufficient, that is, there is a lack of a “science of sustainability”.     

Impact of European legislation on marketed pesticides — A view from the standpoint of health impact assessment studies

The very significant impact of European legislation (Directive 91/414/EEC) on the authorization of plant protection products is reviewed herein, which has resulted in withdrawal of 704 active substances (AS) out of 889 assessed so far. The list of currently approved 276 AS includes 194 AS “existing” in the market before 1993 and 82 “new” AS introduced during the last 15 years. Results of toxicity characterization of the approved AS are also summarized, utilizing several well-known databases. Although significant data gaps exist for a rather large part of the approved AS, it is found that 84 AS are positive for at least one health effect (after chronic and/or acute exposure) including carcinogenicity, reproductive and neuro-developmental disorders, as well as endocrine disruption. The toxicity characterization results of this study are compared to those of recent assessments by other organizations (KemI, the Swedish Chemicals Agency, and the Pesticide Safety Directorate of the UK), where interpretation and use is made of AS “cut-off” criteria foreseen in new EU legislation. These studies report a comparatively smaller AS number with positive toxicity characterization. The possibility of some additional AS withdrawal in the near future, combined with the rather small rate of new AS introduction (approx. 5 per year) suggest that the list of approved AS over the next 10–15 years may not change very drastically. Consideration of the above trends is necessary and instructive in evaluating results of existing health impact assessment (HIA) studies, as well as in planning new ones. Due to the very drastic change in the number and type of marketed AS, that took place within the past 8–9 years, it is suggested that new HIA studies (based on epidemiological data after year 2000) should focus on a rather short time frame and, therefore, on appropriate cohort groups, e.g. young children. For the same reason, results of epidemiological studies of the past (involving banned AS) should be carefully interpreted and used with caution.     

Sediment integrative assessment of the Bay of Cádiz (Spain): An ecotoxicological and chemical approach

This study consisted of the sediment toxicity assessment of the Bay of Cádiz based on two endpoints: growth inhibition for Cylindrotheca closterium (benthic microalgae) and fecundity inhibition for Tisbe battagliai (harpacticoid copepod). A new methodology to eliminate (but not as storage technique) the autochthonous biota present in the sediment samples by immersing them in liquid nitrogen (? 196 °C) was also assessed. Sediment toxicity data showed different toxicity levels for both organisms. In general, T. battagliai was more sensitive; however a good correlation (r = 0.75; p  < 0.05) between sediment toxicity results for both species was found. Data in pore water (pH, redox potential, and toxicity for microalgae and copepod) and sediment (pH, redox potential, organic carbon, and metal concentrations) demonstrated that ultra-freezing did not alter sample characteristics; thus, this technique can be adopted as a pre-treatment in whole-sediment toxicity tests in order to avoid misleading results due to presence of autochthonous biota. Multivariate statistical analysis such as cluster and principal component analysis using chemical and ecotoxicological data were employed. Silt and organic matter percentage and lead concentration were found to be the factors that explain about 77% of sediment toxicity in the Bay of Cádiz. Assay methodology determined in this study for both assayed species is considered adequate to be used in sediment toxicity monitoring programs. Results obtained using both species show that the Bay of Cádiz can be considered a moderately polluted zone.     

Vertical distribution of anthropogenic radionuclides in cores from contaminated floodplains of the Yenisey River

The Mining and Chemical Industrial Combine, Zheleznogorsk (MCIC, previously known as Krasnoyarsk-26) on the River Yenisey has contaminated the surrounding environment with anthropogenic radionuclides as a result of discharges of radioactive wastes. The purpose of this study was to investigate the vertical distribution of anthropogenic contamination (¹³⁷Cs and plutonium) within floodplain areas at different distances from the discharge point. Sites were chosen that display different characteristics with respect to periodic inundation with river water. Cs-137 activity concentrations were in the range 23–3770 Bq/kg (dry weight, d.w.); Pu-239,240 activity concentrations were in the range <0.01–14.2 Bq/kg (d.w.). Numerous sample cores exhibited sub-surface maxima which may be related to the historical discharges from the MCIC. Possible evidence indicating the deposition of earlier discharges at MCIC in deeper core layers was observed in the ²³⁸Pu:^239,240Pu activity ratio data: a Pu signal discernible from global fallout could be observed in numerous samples. Cs-137 and Pu-239,240 activity concentrations were correlated with the silt fraction (% by mass <63 μm) though no significant correlation was observed between (grain-size) normalised ¹³⁷Cs activity concentrations and distance downstream from the MCIC.     

Spatial distribution of uranium and thorium in the surface soil around proposed uranium mining site at Lambapur and its vertical profile in the Nagarjuna Sagar Dam

The understanding and evaluation of the possible interactions of various naturally occurring radionuclides in the world's third largest man-made dam, Nagarjuna Sagar located in Andhra Pradesh, India and built on river Krishna assumed significance with the finding of uranium deposits in locations near the dam. For the present work, surface soil samples from the mineralized area of Lambapur, Mallapuram, Peddagattu and sediment core samples from the Nagarjuna Sagar dam were analyzed for naturally occurring radionuclides namely uranium and thorium using gamma spectrometric technique. Also toxic elements lead and chromium were analysed by the Energy Dispersive X-ray Fluorescence Spectrometer (EDXRF) technique. Surface soil samples show a variation from 25 to 291 Bq/kg (2.02–23.5 mg/kg) for ²³⁸U and 32–311 Bq/kg (7.9–76.9 mg/kg) for ²³²Th. U/Th concentration ratio in surface soil samples ranged from 0.19 to 0.31 and was found comparable with the nation wise average of 0.26. The study of sediment core samples reflected higher U/Th concentration ratio of 0.30–0.33 in the bottom section of the core as compared to 0.22–0.25 in the upper section. The concentration ratio in the upper section of the core was similar to the ratio 0.23 found in the western Deccan Basalt region through which the river originates. A higher concentration of lead and chromium was observed in the upper section of the core compared to bottom section indicating the impact of river input on the geochemical character of dam sediment.     

Deposition rates of unattached and attached radon progeny in room with turbulent airflow and ventilation

In this paper deposition rate coefficients for unattached and attached radon progeny were estimated according to a particle deposition model for turbulent indoor airflow described by Zhao and Wu [2006. Modeling particle deposition from fully developed turbulent flow in ventilation duct. Atmos. Environ. 40, 457–466]. The parameter which characterizes turbulent indoor airflow in this model is friction velocity, u*. Indoor ventilation changes indoor airflow and friction velocity and influences deposition rate coefficients. Correlation between deposition and ventilation rate coefficients in the room was determined. It was shown that deposition rate coefficient increases with ventilation rate coefficient and that these parameters of the Jacobi room model cannot be assumed to be independent. The values of deposition rate coefficients were presented as functions of friction velocity and ventilation rate coefficient. If ventilation rate coefficient varies from 0.1 up to 1 h⁻¹, deposition rate coefficients for unattached and attached fractions were estimated to be in the range 3–110 h⁻¹ and 0.015–0.35 h⁻¹, respectively.