Arsenic speciation in human hair: a new perspective for epidemiological assessment in chronic arsenicism

The analysis for arsenic in hair is commonly used in epidemiological studies to assess exposure to this toxic element. However, poor correlation between total arsenic concentration in hair and water sources have been found in previous studies. Exclusive determination of endogenous arsenic in the hair, excluding external contamination has become an analytical challenge. Arsenic speciation in hair appears as a new possibility for analytical assessing in As-exposure studies. This study applied a relative simple method for arsenic speciation in human hair based on water extraction and HPLC-HG-ICP-MS. The concentration of arsenic species in human hair was assessed in chronically As(V)-exposed populations from two villages (Esqui?a and Illapata) of the Atacama Desert, Chile. The arsenic concentrations in drinking water are 0.075 and 1.25 mg L(-1), respectively, where As(V) represented between 92 and 99.5% of the total arsenic of the consumed waters. On average, the total arsenic concentrations in hair from individuals of Esqui?a and Illapata were 0.7 and 6.1 microg g(-1), respectively. Four arsenic species, As(III), DMA(V), MMA(V) and As(V), were detected and quantified in the hair extracts. Assuming the found species in extracts represent the species in hair, more than 98% of the total arsenic in hair corresponded to inorganic As. On average, As(III) concentrations in hair were 0.25 and 3.75 microg g(-1) in Esqui?a and Illapata, respectively; while, the As(V) average concentrations were 0.15 and 0.45 microg g(-1) in Esqui?a and Illapata, respectively. Methylated species represent less than 2% of the extracted As (DMA(V)+ MMA(V)) in both populations. As(III) in hair shows the best correlation with chronic exposure to As(V) in comparison to other species and total arsenic. In fact, concentrations of As(total), As(III) and As(V) in hair samples are correlated with the age of the exposed individuals from Illapata (R= 0.65, 0.69, 0.57, respectively) and with the time of residence in this village (R= 0.54, 0.71 and 0.58, respectively).     

不同区域城市空气O3和PM2.5累积速率时序模型

利用2017—2018年全国7个区域10个典型城市环境空气O₃和PM_2.5浓度数据，统计污染物累积速率，进而采用回归方法拟合污染物浓度及其累积速率的时间序列模型，分析不同区域污染物时序变化特征差异。结果表明：不同区域O₃浓度时序曲线拟合程度总体高于PM_2.5，石家庄O₃拟合程度最高，西安PM_2.5拟合程度最高。以07：00、14：00分别作为O₃、PM_2.5模拟起点是24 h中的最优模型。不同城市夏季O₃小时浓度时序变化曲线均为单峰形态，O₃浓度及累积速率峰值出现时间可能由城市所处经度决定，太原O₃累积最快，西安O₃消解最快。各城市间冬季PM_2.5小时浓度及其累积速率时序变化曲线形态差异较大，沈阳PM_2.5累积和消解均最快。与浓度相比，城市环境空气O₃和PM_2.5累积速率与光照、扩散条件等有更好的时间相关性。     

南水北调东平湖水质变化趋势分析研究

采用了季节性肯达尔法水质趋势分析方法,分析了1984～2000年东平湖水质的变化情况,目前东平湖水质一般为Ⅴ类、Ⅵ类,个别年份为超Ⅴ类,氨氮平均值历年变化不大,一般均符合Ⅰ Ⅲ类水质,挥发酚和砷含量甚小,各年均符合Ⅰ类水。     

深圳市几种空气污染物浓度日变化特征分析

通过对深圳市2002年8月至2003年8月五种空气污染物浓度日变化特征、相互关系及不同天气条件下的变化,与人们活动的关系等进行分析,试图找出深圳空气污染的主要成因及变化规律,为环境规划决策提供科学依据。     

Pollen allergy related to the area of residence in the city of Córdoba,south-west Spain

The aim of this study was to analyse the relationship between the distribution of hay-fever patients in the city of Córdoba, south-western Iberian Peninsula, and the specific atmospheric biological content originating from local sources. Four different districts were established in the metropolitan area of the city, according to vegetational and urbanistic characteristics. Air samples were taken in each area using portable Hirst-type samplers (Lanzoni VPPS 1000) and the spectrum of biological content was defined. Patients attending the Allergy Unit at Córdoba Teaching Hospital in 2000 with allergic rhinitis and/or asthma, and displaying a positive reaction to aeroallergen extracts, were distributed within the areas as a function of their district of residence. Aerobiological results revealed differences in pollen content between areas, in terms of both quantity and number of pollen types recorded. These differences were largely due to proximity to rural areas, prevalence of pollen from typically urban species and the possible effect of urban architecture as a barrier to the dispersal/ concentration of particles and other pollutants. Patients were not uniformly distributed within the city. The majority lived in districts in which pollen from rural species was mixed with pollen from ornamentals. Patients living in typically urban districts displayed a higher prevalence of allergy to pollen from ornamentals. It is concluded that a high degree of exposure to the same environment may influence the development of sensitisation to the particular pollen load associated with that area.     

Optimization of a multielement sequential extraction method employing an experimental design approach for metal partitioning in soils and sediments

The optimisation of a simple multielement extraction method employing an experimental design approach is described. The method uses centrifugation to pass one extractant solution at varying pH through a contaminated soil sample. The nature and concentration of the acid, rate of centrifugation and time, number of sequential leachates and the ratio of extractant volume: sample weight have been studied in order to obtain the optimum conditions for extraction. A fractional factorial experimental design was performed, and the results were used to identify significance which was then evaluated by carrying out a central composite experimental approach. Once optimum conditions had been obtained, sequential leaches were analysed by ICP-AES and chemometrics were employed to identify the composition of each component. Comparisons have been made with previous studies and tentative assignments, based on well defined separated fractions and percentage compositions for individual elements, used to identify the different physico-chemical components in the sample.     

Preliminary air pollution monitoring in San Miguel, Buenos Aires

Passive diffusion samplers were employed in San Miguel(Buenos Aires Metropolitan Area) for a preliminary airpollution monitoring. The highest loads were observedin downtown, compared with an urban background site.Total suspended particulate matter (TSPM) varied from0.257 to 0.033 mg cm^-2 month^-1; dust was examinedfor particle nature and size distribution. A similartrend was observed for nitrogen dioxide (NO₂) andTSPM spatial distribution, suggesting that traffic isthe major pollution source. Sulphur dioxide (SO₂)values were low and rather homogeneous. Levels for theinvestigated pollutants are below EPA's guide linevalues. Geographic (flat area, near to Rio de LaPlata) and climatologic factors (rainfalls andvariable wind directions) contribute to disperse pollutants.     

Study of Meteorological Aspects and Urban Concentration of SO2 in Atmospheric Environment of La Plata, Argentina

This article presents and discusses SO₂ (ppbv) concentration measurements combined with meteorological data (mainly wind speed and direction) for a five-year campaign (1996 to 2000), in a site near an oil refinery plant close to the city of La Plata and surroundings (aprox. 740.000 inh.), considered one of the six most affected cities by air pollution in the country. Since there is no monitoring network in the area, the obtained results should be considered as medium term accumulated data that enables to determine trends by analyzing together gas concentrations and meteorological parameters. Preliminary characterization of the behaviour of the predominant winds of the region in relation with potential atmospheric gas pollutants from seasonal wind roses is possible to carry out from the data. These results are complemented with monthly averaged SO₂ measurements. In particular, for year 2000, pollutant roses were determined which enable predictions about contamination emission sources. As a general result we can state that there is a clear increase in annual SO₂ concentration and that the selected site should be considered as a key site for future survey monitoring network deployment. Annual SO₂ average concentration and prevailing seasonal winds determined in this work, together with the potential health impact of SO₂ reveals the need for a comprehensive and systematic study involving particulate matter an other basic pollutant gases.     

A study of the distribution of lead, cadmium and copper between water and kaolin, bentonite and a river sediment

Experiments were carried out to monitor the equilibrium distribution of lead, cadmium and copper between an aqueous phase modelling natural water and a solid phase modelling natural sediment, under varying conditions. The aqueous phase was analysed using ETAAS and differential pulse anodic stripping voltammetry (DPASV), whereas XRD and FTIR were used to study the solid phase. Sorption isotherms at constant pH were measured. Conditional distribution constants were calculated as functions of the pH, the time of equilibration and the amount of solid material. The results obtained stress the need for standardization of the approaches to the study of water-sediment interactions in order to be able to evaluate and compare the extensive data from field measurements and to predict these interactions.     

Improvement of the BCR three step sequential extraction procedure prior to the certification of new sediment and soil reference materials

The Standards, Measurements and Testing Programme (formerly BCR) of the European Commission proposed a three-step sequential extraction procedure for sediment analysis, following extensive expert consultations and two interlaboratory studies. This scheme was recently used to certify the extractable trace element contents of a sediment reference material (CRM 601). Although this procedure offers a means to ensure the comparability of data in this field, some difficulties concerning the interlaboratory reproducibility still remain, and a new project is currently being conducted to determine the causes of poor reproducibility in the extraction scheme. The final objective of the project is the certification of new sediment and soil reference materials for their extractable contents of Cd, Cr, Cu, Ni, Pb and Zn. This paper presents the results of a small-scale interlaboratory study, which aimed to test a revised version of the extraction schemes by comparing the original and the modified protocols using the CRM 601 sample. This work offers an improvement to the BCR sequential extraction procedure through intercomparison exercises. This improved procedure will allow the obtaining of CRMs to validate analytical data in the analysis of soils and sediments, and it will also facilitate comparability of data in the European Union.