基于大气被动式采样的人体头发中类二(口恶)英多氯联苯暴露的途径

本研究通过分析采集自云南省开远市的13个树皮混合样品和13个相应的头发混合样品中DL-PCBs的水平、同族体分布及相关性,研究了当地人群对DL-PCBs的主要暴露途径.结果表明,云南开远树皮和头发样品中DL-PCBs的含量分别为4.0~88.9 pg·g^-1和4.1~19.3 pg·g^-1,其在当地环境和人体中的污染程度均较轻.树皮和头发样品中主要的DL-PCB同族体均是PCB-118,分别占总含量的48%和61%.树皮样品中DL-PCBs的各同族体具有相同的源,其主要的来源可能是大气的长距离输移.云南开远市居民头发中的PCBs可能来源于内部暴露和外部暴露的综合作用,其中外部暴露对低氯代PCBs的贡献要高于高氯代PCBs.     

紫外消毒对城市污水处理厂耐药菌去除的影响研究

通过选取假单胞杆菌、鲍曼不动杆菌以及芽孢杆菌3种耐药菌作为研究对象,研究紫外光变化对这3种耐药菌的去除效果,得出较好的紫外消毒条件,应用到实际的污水处理厂消毒过程中。结果表明,紫外消毒对3种耐药菌都有很好的灭活效果。     

In-situ synthesis of TiO2 rutile/anatase heterostructure by DC magnetron sputtering at room temperature and thickness effect of outermost rutile layer on photocatalysis

TiO_2 rutile/anatase heterostructure thin films with varying rutile thickness have been in-situ synthesized via DC magnetron sputtering with Ar gas at room temperature. The crystal texture, surface morphology, energy gap and optical properties of the films have been investigated by X-ray diffraction meter, grazing incidence X-ray diffraction meter, Raman spectroscopy, scanning electron microscopy, and UV–visible spectrophotometer, which indicates that the rutile/anatase heterostructure films are successfully fabricated. The further degradation experiments display that the photocatalytic activity can be dramatically affected by the thickness of the outmost rutile layer and the 100 nm thickness exhibits the best performance in all of the TiO_2 thin films. With the increase of the outmost rutile layer, the optical band gap of TiO_2 film displays a systematic decrease slightly. However,the change in photocatalytic activity does not coincide with that in the band gap. The photoresponse and electrochemical properties of the thin films have been characterized to understand the mechanism of the varied photocatalytic activity.     

船用钢板材料在淡水环境中初期腐蚀行为

目的研究船用钢板材料在长江淡水环境中的初期腐蚀行为。方法运用形貌分析、腐蚀质量损失、XRD、开路电位、极化曲线等方法研究Q235B和CCSA两种船用钢板材料在室外长江淡水环境中不同暴露方式(水面大气、半浸、全浸)及不同浸泡时间(0.5,1 a)腐蚀行为;室内长江淡水环境不同暴露方式(半浸、全浸)浸泡768 h内的腐蚀行为;室内长江淡水环境全浸泡下在不同时间(0~14 d)的电化学腐蚀行为。结果两种船用钢板材料在武汉长江淡水中腐蚀严重,半浸泡环境下腐蚀速率最大,达到100μm/a,水面区大气腐蚀速率最小,腐蚀速率为30μm/a左右,全浸区腐蚀速率为80μm/a左右,1 a和0.5 a的腐蚀速率相近,CCSA耐蚀性优于Q235B。室内长江淡水浸泡环境下两种船用钢板材料腐蚀电位随时间而降低,2d后趋于稳定;半浸泡环境下腐蚀速率大于全浸区;极化曲线说明浸泡2 d后,腐蚀速率降低且趋于稳定。结论 CCSA耐蚀性优于Q235B,半浸泡环境下腐蚀最严重,其次为全浸区,水面大气环境腐蚀最小。     

分光光度法测定总氮的准确度研究

采用碱性过硫酸钾消解紫外分光光度法测定水中总氮时常出现空白值偏高、样品平行性较差、实验准确度不高等现象.为此,从总氮的测定过程出发,探讨了影响总氮测定的主要因素,有利于提高水质总氮测定的准确度.结果表明,分析试剂纯度、实验用水水质、器皿的清洗程度等对总氮的测定均有一定影响,适当延长消解时间与提高消解温度也有利于降低总氮的空白值.因此可通过优化各实验条件来提高实验的准确性,以保证实验室的设备仪器、检测人员和环境等条件满足分析要求.     

海水生物滤器氨氮沿程转化规律模型

生物滤器是海水循环水养殖系统中的核心水处理单元,其主要用于去除对养殖生物有害的氨氮、有机物等.本研究基于吸附原理和一级反应生物膜理论构建了氨氮在生物滤器中沿程转化规律的数学模型,并通过实验加以验证.实验所用生物滤器采用竹制空心生化球填料,装填高度为70 cm,在pH为7.1～7.6,DO为5～7 mg.L-1,气水比20∶1左右,有机负荷约为4g.(m3.h)-1,水力停留时间(HRT)为1 h条件下,生物滤器中氨氮的去除主要发生在填料高度0～10 cm处,10～70 cm处氨氮去除量很少.进水氨氮质量浓度的增大和水力停留时间的降低都会导致出水氨氮质量浓度增大.此外,模型对进水氨氮质量浓度较低时的沿程出水氨氮质量浓度具有很好的预测效果;当进水氨氮质量浓度较高时,预测值略低于实际结果.     

高岭土负载纳米Fe/Ni同时去除水中Cu2+和NO3-

工业废水常含有不同污染物如重金属离子和无机阴离子,而如何有效去除复合污染物就成为环境科学前沿研究的挑战性课题.这些污染物因化学性质不同而导致去除机理和途径也不同.本文采用合成高岭土负载纳米双金属Fe/Ni(K-Fe/Ni)同步去除水中Cu2+和NO-3.结果表明K-Fe/Ni能有效去除水中Cu2+和NO-3,但它们的去除效果却会相互受到影响.在Cu2+浓度为200mg·L-1时,NO-3的去除率达到42.5%;而未加入Cu2+时,NO-3的去除率仅有26.9%,说明Cu2+的存在提高了NO-3降解效率.同样,水中NO-3的存在也影响Cu2+的去除(Cu2+去除率从99.7%降到96.5%).但NO-3浓度对去除Cu2+的影响小于Cu2+浓度对NO-3的影响.通过BET比表面积、X射线衍射(XRD)、扫描电镜(SEM)、X射线能量散射(EDS)和X射线光电分析(XPS)对K-Fe/Ni表征的结果显示,反应后K-Fe/Ni的表面存在铁的氧化物、Ni0和被还原的Cu0.基于以上结果,我们发现K-Fe/Ni同步去除水中Cu2+和NO-3的机理是:高岭土负载下的纳米Fe0作为还原剂,在Ni0的催化产氢作用下将Cu2+还原成Cu0并沉积在K-Fe/Ni上而形成纳米Fe/Ni/Cu三金属催化剂,从而加速催化水中NO-3降解.     

滇池水葫芦规模化控养生态环境效应分析

水葫芦规模化控养是"十二五"期间滇池治理的重要措施之一。首先介绍了滇池水葫芦规模化控养现状,比较了滇池草海和外海在水葫芦控养前后水质的变化情况,指出滇池水葫芦规模化控养对草海水体生态恢复效果显著,可以在滇池选择适宜水葫芦生长的水域继续扩大水葫芦控养面积,使水葫芦在滇池生态治理中发挥更大的作用。     

Interface-mediated synthesis of monodisperse ZnS nanoparticles with sulfate-reducing bacterium culture

We have created a new method of ZnS nanospheres synthesis. By interface-mediated precipitation method (IMPM), monodisperse ZnS nanoparticles was synthesized on the particle surface of sulfate-reducing bacterium nutritious agar culture. Sulfate-reducing bacterium (SRB) was used as a sulfide producer because of its dissimilatory sulfate reduction capability, meanwhile produced a variety of amino acids acting as templates for nanomaterials synthesis. Then zinc acetate was dispersed into nutritious agar plate. Subsequently agar plate was broken into particles bearing much external surface, which successfully mediated the synthesis of monodisperse ZnS nanoparticles. The morphology of monodisperse ZnS nanospheres and SRB were examined by scanning electron microscopy (SEM), and the microstructure was investigated by X-ray diffraction (XRD). The thermostability of ZnS nanoparticles was determined by thermo gravimetric-differential thermo gravimetric (TG-DTG). The maximum absorption wavelengh was analysed with an ultraviolet-visible spectrophotometer within a range of 199–700 nm. As a result, monodisperse ZnS nanoparticles were successfully synthesized, with an average diameter of 80 nm. Maximum absorption wavelengh was 228 nm, and heat decomposed temperature of monodisperse ZnS nanoparticles was 596°C.     

Numerical simulation of alga growth and control in Dalian Bay

WAHMO model was used to simulate the distribution of pollutants in Dalian Bay, China as to predict well as the growth and control of alga. The observed and predicted values of main pollutants showed a good trend at all study locations and the different between them can be ignored. Simulation results illustrated that phosphate was one of limited factors to control algal growth at the location near the sewage outfall, meanwhile, away from the sewage outfall, the synergy of ammonium nitrogen and phosphate was the limited factor.