Two-year follow-up study of nonregulatory recommendations for better air quality in indoor ice arenas

A standardized questionnaire was used in a two-year follow-up study to test the effectiveness of non-regulatory recommendations to improve indoor air quality of 103 ice arenas in Finland. In addition, the performance of a state-of-the-art emission control technology (ECT) on propane-fueled resurfacers was evaluated by measuring the one-week average nitrogen dioxide (NO₂) concentration in a small sample of arenas. The number of retrofitted ECT on propane-fueled resurfacers increased from 6 to 37 (8% to 37% of ice arenas) and the number of electric resurfacers from 7 to 9 (both 9% of arenas) in 1994–1996. At the same time, the prevalence of inadequate ventilation increased among the most susceptible small arenas (volume <30 000 m³) from 11 (31%) to 19 (38%). Combustion-powered resurfacers (88%) and inadequate ventilation (24%) were prevalent also among the 17 new arenas built in 1994–1996. ECT resurfacers significantly decreased the mean indoor NO₂ concentration of eleven arenas from 650 μg/m³ to 147 μg/m³. Thus, retrofitting resurfacers with ECT seems to be a feasible mitigation option to improve indoor air quality in ice arenas, but the ultimate solution is an electric ice resurfacer. Non-regulatory recommendations seem to be partially effective in abatement against the air quality problems, but additional regulatory measures are needed for full compliance in all arenas.     

In vitro estrogenic,cytotoxic, and genotoxic profiles of the xenoestrogens 8-prenylnaringenine,genistein and tartrazine

Environmental Science and Pollution Research - Phytoestrogens have been widely praised for their health-promoting effects, whereas synthetic environmental estrogens are considered a toxicological...     

Improvement of Air Quality in a Small Indoor Ice Arena by Effective Emission Control in Ice Resurfacers

ABSTRACT

The effectiveness of a new emission control system in the ice resurfacer was tested in an exhaust gas emission laboratory, and the improvement of the air quality in a small, enclosed ice arena was demonstrated in a 4.5-month follow-up study. The emission control system consisted of a lambda sensor-controlled fuel supply and a three-way metallic catalyst that were applied to a propane-fueled resurfacer. In the laboratory tests, the engine emissions of carbon monoxide (CO), hydrocarbons (HC), and nitrogen oxides (NO ) reduced simultaneously by 91, 90, and 96%, respectively. During the air quality follow-up the median 1-hour average nitrogen dioxide (N0₂) concentration inside the ice arena decreased from 430 ug/m³ (230ppb) to 58 ug/m³ (31 ppb), and that of CO decreased from 4.4 mg/m³ (3.8 ppm) to 1.5 mg/m³ (1.3 ppm). The new emission control system proved to be a feasible, reliable, and effective means to improve the indoor air quality in the ice arena. However, continuous mechanical ventilation was necessary during all business hours in order to achieve and maintain a fully acceptable air quality with this technology.     

Polychlorinated dibenzo-p-dioxins, dibenzofurans, biphenyls, naphthalenes and polybrominated diphenyl ethers in the edible fish caught from the Baltic Sea and lakes in Finland

A total of 156 fish composite samples were collected from five areas of the Baltic Sea and from three lakes and analysed for polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs), polychlorinated biphenyls (PCBs), polychlorinated naphthalenes (PCNs) and polybrominated diphenyl ethers (PBDEs). The European Union's maximum permissible level for PCDD/Fs, 4 pg WHO-TEQ/g fresh weight (fw), was exceeded in salmon, river lamprey and Baltic herring. In other species from the Baltic Sea, the 90th percentile was 3.42 pg WHO(PCDD/F)-TEQ/g fw. In the lake fish, the concentrations of PCDD/Fs, PCBs and PCNs were only 29-46% of those in the same species caught from the Baltic Sea, whereas the concentrations of PBDEs in the lake fish were as high as in the Baltic Sea fish. Dioxin-like PCBs contributed to the total dioxin-like toxicity of PCBs and PCDD/Fs by 49+/-12% in all the analysed samples.     

PCDD/Fs and PCBs in Baltic herring during the 1990s

Baltic herring samples caught from the Baltic Sea during the spring periods of 1993-1994 and 1999 were analysed for polychlorinated dibenzo-p-dioxins (PCDD), polychlorinated dibenzofurans (PCDF), and polychlorinated biphenyls (PCB). For analyses, 1570 individual herring were combined to 120 pools. Correlations between concentrations of congeners 1,2,3,7,8-PeCDD, 1,2,3,7,8-PeCDF, 2,3,4,7,8-PeCDF, and 2,3,4,6,7,8-HxCDF, and age of herring were the strongest (r>0.8) followed by correlations between PCB congeners PCB 105, 118, 126, 156, 169 and 180 (r>0.7), and age of herring. Due to higher fat percentage in herring in the Gulf of Bothnia the concentrations of PCDD/Fs and PCBs on fresh weight (fw) basis were higher than in herring in the Gulf of Finland. The concentrations of WHO(PCDD/F)-TEQs ranged from 1 to 27 pg/g fw, depending on the age and catchment area of herring, and concentrations of WHO(PCB)-TEQs reached 32 pg/g fw. Between the two studied time points no clear downward trend in concentrations was observed.     

Effect of combustion condition on cytotoxic and inflammatory activity of residential wood combustion particles

Residential heating is an important local source of fine particles and may cause significant exposure and health effects in populations. We investigated the cytotoxic and inflammatory activity of particulate emissions from normal (NC) and smouldering (SC) combustion in one masonry heater. The PM_1–0.2 and PM_0.2 samples were collected from the dilution tunnel with a high-volume cascade impactor (HVCI). Mouse RAW 264.7 macrophages were exposed to the PM-samples for 24 h. Inflammatory mediators, (IL-6, TNFα and MIP-2), and cytotoxicity (MTT-test), were measured. Furthermore, apoptosis and cell cycle of macrophages were analyzed. The HVCI particulate samples were characterized for ions, elements and PAH compounds. Assays of elemental and organic carbon were conducted from parallel low volume samples. All the samples displayed mostly dose-dependent inflammatory and cytotoxic activity. SC samples were more potent than NC samples at inducing cytotoxicity and MIP-2 production, while the order of potency was reversed in TNFα production. SC-PM_1–0.2 sample was a significantly more potent inducer of apoptosis than the respective NC sample. After adjustment for the relative toxicity with emission factor (mg MJ^?1), the SC-PM emissions had clearly higher inflammatory and cytotoxic potential than the NC-PM emissions. Thus, operational practice in batch burning of wood and the resultant combustion condition clearly affect the toxic potential of particulate emissions.     

Impact of particle emissions of new laser printers on modeled office room

In this study, we present how an indoor aerosol model can be used to characterize particle emitter and predict influence of the source on indoor air quality. Particle size-resolved emission rates were quantified and the source’s influence on indoor air quality was estimated by using office model simulations. We measured particle emissions from three modern laser printers in a flow-through chamber. Measured parameters were used as input parameters for an indoor aerosol model, which we then used to quantify the particle emission rates. The same indoor aerosol model was used to simulate the effect of the particle emission source inside an office model. The office model consists of a mechanically ventilated empty room and the particle source. The aerosol from the ventilation air was a filtered urban background aerosol. The effect of the ventilation rate was studied using three different ventilation ratios 1, 2 and 3 h^?1. According to the model, peak emission rates of the printers exceeded 7.0 × 10⁸ s^?1 (2.5 × 10¹² h^?1), and emitted mainly ultrafine particles (diameter less than 100 nm). The office model simulation results indicate that a print job increases ultrafine particle concentration to a maximum of 2.6 × 10⁵ cm^?3. Printer-emitted particles increased 6-h averaged particle concentration over eleven times compared to the background particle concentration.     

The Decision Analysis Interview Approach in the Collaborative Management of a Large Regulated Water Course

There are always conflicting goals in the management of large water courses. However, by involving stakeholders actively in the planning and decision-making processes, it is possible to work together toward commonly acceptable solutions. In this article, we describe how we applied interactive multicriteria decision analysis (MCDA) in a collaborative process which aimed at an ecologically, socially, and economically sustainable water course regulation policy. The stakeholders' opinions about the alternative regulation schemes and the relative importance of their impacts were elicited with the HIPRE software. Altogether, 20 personal interactive decision analysis interviews (DAIs) were carried out with the stakeholders. Our experience suggests that the DAIs can considerably improve the quality and efficiency of the collaborative planning process. By improving communication and understanding of the decision situation in the steering group, the approach helped to develop a consensus solution in a case having strong conflicts of interest. In order to gain the full benefits of the MCDA approach, interactive preference elicitation is vital. It is also essential to integrate the approach tightly into the planning and decision-making process. The project's home pages are available to the public at http://www.paijanne.hut.fi/.     

Evaluation of resin and fatty acid concentration levels by online sample enrichment followed by atmospheric pressure chemical ionization-mass spectrometry (APCI-MS)

Background, aim, and scope  In papermaking, there is a continuous interest both to minimize fresh water consumption and to reduce discharges into the environment. These general trends mean an increase in the amounts of detrimental substances, such as resin and fatty acids, in papermaking process waters. Resin acids, in particular, are responsible for much of the toxicity typically present in paper mill effluents and, for this reason, the routine and rapid monitoring of these compounds in various process streams is necessary. This also means that there is a continuous need to develop straightforward offline and online techniques to clarify problems occurring, for example, as a result of the introduction of more intensively closed systems of water circulation. In the present study, we describe the use of a novel, online, sample enrichment technique followed by atmospheric pressure chemical ionization–mass spectrometry (APCI-MS) suitable for monitoring the concentration levels of common resin and fatty acids in papermaking process waters. Materials and methods  The representative process water samples were taken from the grinding zone of a thermomechanical pulping mill. The samples were first preconcentrated in a precolumn C18, and the analytes were transferred online to MS. The high intensive [M–H]⁻ ion was used for the identification of each analyte since, according to the present ionization method, no other fragmentation was observed. Laboratory-scale, online measurements with an online sample feed were carried out by connecting a centrifugal pump and a ceramic filter to the APCI-MS. Results  Quality parameters, such as repeatability, linearity, and limit of detection (LOD), were determined by using dehydroabietic acid (DHAA) in order to evaluate the suitability of the method for the rapid screening of concentration levels. This method provided satisfactory linearity and a good correlation between analyte concentration and peak area. The suitability of the system for the continuous analysis of the same acids was evaluated in laboratory-scale, online experiments. In all cases, the response to changes in the analyte concentration was linear, and the repeatability of the system was also satisfactory. Discussion  Only a few studies have been published on the analysis of resin and fatty acids with MS techniques. The present method was applied to the monitoring of dehydroabietic, oleic, and stearic acids. The quality parameters were highly comparable with those reported earlier, and the LOD values of the DHAA were below the levels usually encountered in process waters. The quality parameters were only slightly higher than those obtained by the traditional methods of analysis, probably due to the absence of an effective sample clean-up before analysis. Conclusions  The results of the laboratory-scale, online experiments indicated that the online enrichment APCI-MS system is a suitable alternative for monitoring the concentration levels of selected resin and fatty acids in papermaking process waters. The method can be used, for example, to provide useful information about the concentration levels of these acids in different stages of the process, thus signaling possibly impending problems. In general, faster and simpler measurements are needed to meet the requirements for a reduction in fresh water usage in papermaking. Recommendations and perspectives  Compared to the conventional methods used for this purpose, the main benefits of the method are rapidity of measurement, simplicity of use, and absence of the need for multistage sample treatments (short analysis time). For this reason, this online method is more suitable for the control of papermaking by analyzing the concentration levels of interfering substances (i.e., selected resin and fatty acids) than an offline analysis detailing all the individual extractives-based compounds in process streams. It is also obvious that the technique can easily be modified for other environmental pollutants as well.     

Human dietary intake of organochlorines from Baltic herring: implications of individual fish variability and fisheries management

This study examines the extent to which Finnish human dietary intake of organochlorines (PCDD/Fs and PCBs) originating from Northern Baltic herring can be influenced by fisheries management. This was investigated by estimation of human intake using versatile modeling tools (e.g., a herring population model and a bioenergetics model). We used a probabilistic approach to account for the variation in human intake of organochlorines originating from the variation among herring individuals. Our estimates were compared with present precautionary limits and recommendation for use. The results show that present consumption levels and frequencies of herring give a high probability of exceeding recommended intake limits of PCDD/Fs and PCBs. Furthermore, our results clearly demonstrate that in the risk management of dioxinlike organochlorines, regulating fishing (in this case increasing fishing pressure) is a far less effective way to decrease the risk than regulating the consumption of herring. Increased fishing would only slightly decrease organochlorine concentrations of herring in the Finnish fish market.