Comparison of arsenic resistance in Mediterranean woody shrubs used in restoration activities

Myrtus communis, Arbutus unedo and Retama sphaerocarpa are Mediterranean shrubs widely used in revegetation of semiarid degraded soils. The aim of this work is to study the resistance of these plants to arsenic under controlled conditions, in order to evaluate their potential use in revegetation and/or phytoremediation of As-polluted soils. R. sphaerocarpa showed higher resistance to As than M. communis or A. unedo according to its higher EC50, P status and P/As molar ratio in both, roots and shoots, and the lower increases in lipid peroxidation and decrease of chlorophyll levels in response to arsenic, while the highest arsenate sensitivity was obtained for A. unedo. Arsenic was mainly retained in roots, and, although M. communis accumulated higher arsenic amounts than the other two species, R. sphaerocarpa showed the highest root to shoot transfer. Most of the studied parameters (chlorophylls, MDA and total thiols) showed significant correlation with arsenic concentration in roots and leaves of plants, so they can be useful indexes in the diagnosis of arsenic toxicity in these species. According to our results, both M. communis and R. sphaerocarpa could be used in the revegetation of moderately arsenic contaminated sites.     

Use of electrochemical technology to increase the quality of the effluents of bio-oxidation processes. A case studied

In this work, it has been studied the use of conductive-diamond electrochemical oxidation (CDEO) as a refining technology to assure the quality of the effluents of door manufacturing processes (DMP). To do this, the raw effluents of these factories have been treated by a combination of physicochemical, biological and CDEO treatments. CDEO was found to be a feasible alternative to the refinement of a wooden DMP waste. It can successfully decrease the organic load of the effluents of the biological oxidation with low energy requirements. In addition, in case of incidents in the biological process, CDEO can treat successfully the effluents of the coagulation process. The effluents of the biological treatment have also been treated by CDEO in order to check the possible use of electrochemical technology to increase the biodegradability of the effluents and their possible recycle to the biological treatment. Unfortunately, electrochemical technology was found to be not adequate to increase the biodegradability of the effluents of a biological treatment. The hard oxidation conditions generated during CDEO do not lead to the accumulation of intermediates but to the almost direct formation of carbon dioxide. Lowering the current density or changing the electrodes can not enhance the biodegradability of the effluents of an electrochemical cell.     

Construction demolition wastes, Waelz slag and MSWI bottom ash: a comparative technical analysis as material for road construction

The objective of the study is to analyze the technical suitability of using secondary materials from three waste flows (construction and demolition waste (CDW), Waelz slag and municipal solid waste incineration (MSWI) bottom ash), under the regulations and standards governing the use of materials for road construction. A detailed technical characterization of the materials was carried out according to Spanish General Technical Specifications for Road Construction (PG3). The results show that Waelz slag can be adequate for using in granular structural layers, while CDW fits better as granular material in roadbeds. Likewise, fresh MSWI bottom ash can be used as roadbed material as long as it does not contain a high concentration of soluble salts. This paper also discusses the adequacy of using certain traditional test methods for natural soils when characterizing secondary materials for use as aggregates in road construction.     

Eier der Flußseeschwalbe (Sterna hirundo) als Indikator für die aktuelle Belastung von Rhein, Weser und Elbe mit Umweltchemikalien

In 1995, common tern (Sterna hirundo) eggs from the big German rivers, the Rhine, Weser and Elbe were collected to study the contamination with organochlorines and mercury. We found distinct differences between the rivers: common tern eggs from the Rhine had higher concentrations of PCBs and HCHs, while eggs from the Elbe had higher residues of DDT, HCB and mercury. Also toxic PCB congeners had higher residue levels in the Rhine. Considering all organochlorines, samples from the Rhine also had the highest concentrations, while those from the Elbe were the lowest. With 5.7 μg×g^?1 fresh weight, the ΖCBs had a level endangering breeding success. Fish eating birds should be used as indicators of the contamination of the rivers with environmental chemicals and should be included in monitoring programmes.     

Assessment of pesticide residues in freshwater areas affected by rice paddy effluents in Southern Japan

Pesticide residues in five freshwater areas that are directly affected by rice paddy effluents in southern Japan were measured to determine their maximum concentrations and temporal variations. Water samples were collected every week during the 2005 rice planting season in Kagoshima Prefecture and stations were established in Amori River, Sudo River, Nagaida River (that drains into the bigger Kotsuki River), rice paddy drainage canal, and wastewater reservoir (that collects effluents from rice paddy fields). Of the 14 target pesticides examined, a total of 11 were detected in all stations. Mefenacet, fenobucarb, and flutolanil were the three pesticides with the highest maximum concentrations and were also detected frequently. Analysis of temporal variations of pesticides showed that herbicides had relatively higher concentrations in the earlier stages of the rice planting season, while insecticides and fungicides had relatively higher concentrations at the later stages. There was no significant difference among stations with regards to the temporal patterns of the top three pesticides. The calculated toxic units were less than 1 in all stations, implying low or negligible environmental risk of pesticides detected to freshwater organisms.     

Organochlorine pesticide residue levels in blood serum of inhabitants from Veracruz, Mexico

The objective of the present study was to monitor the levels of organochlorine pesticides HCB; α-, β-, γ-HCH; pp'DDE; op'DDT; and pp'DDT in blood serum of Veracruz, Mexico inhabitants. Organochlorine pesticides were analyzed in 150 blood serum samples that constituted that which remained after clinical analyses, using gas chromatography-electron-capture detection (GC-ECD). The results were expressed as milligrams per kilogram on fat basis and micrograms per liter on wet weight. Only the following pesticides were detected: p,p'-DDE was the major organochlorine component, detected in 100% of samples at mean 15.8 mg/kg and 8.4 μg/L; p,p'-DDT was presented in 41.3.% of monitored samples at mean 3.1 mg/kg and 1.4 μg/L; β-HCH was found in 48.6% of the samples at mean 4.9 mg/kg and 2.7 μg/L; op'DDT was determined to be in only 3.3% of monitored samples at mean 2.7 mg/kg and 1.4 μg/L. The pooled samples divided according to sex showed significant differences of β-HCH and pp'DDE concentrations in females. The samples grouped according to age presented the third tertile as more contaminated in both sexes, indicating age as a positively associated factor with serum organochlorine pesticide levels in Veracruz inhabitants.     

Performance evaluation of two commercial chemiluminescence NOx analysers according to European Standard EN 14211

According to Directive 2008/50/EC, all equipment used for NO(x) fixed measurements must comply with the reference method or equivalent by 11 June 2013. Up to that date, non-type-approved equipment can continue to be used in air monitoring networks and will probably also be used in air pollution studies even after that date. In this context, it is advisable to know how these "old" measuring instruments respond to the requirements of European Standard EN 14211: 2005: Ambient Air Quality--Standard method for the measurement of the concentration of nitrogen dioxide and nitrogen monoxide by chemiluminescence. In this work, we carry out a thorough performance evaluation of two commercial NO(x) analysers, both purchased before 2010, according to the mentioned Standard. Results show that water vapour interference is one of the most important disconformities with this Standard. The expanded uncertainty estimation of both analysers was below the quality objective of the above-mentioned Directive (15%); however, this calculation was performed by applying some modifications to the proposed model of Standard EN 14211. These modifications are also discussed in the paper.     

The spatial statistics formalism applied to mapping electromagnetic radiation in urban areas

Determining the electromagnetic radiation levels in urban areas is a complicated task. Various approaches have been taken, including numerical simulations using different models of propagation, sampling campaigns to measure field values with which to validate theoretical models, and the formalism of spatial statistics. In the work, we present here that this latter technique was used to construct maps of electric field and its associated uncertainty from experimental data. For this purpose, a field meter and a broadband probe sensitive in the 100-kHz–3-GHz frequency range were used to take 1,020 measurements around buildings and along the perimeter of the area. The distance between sampling points was 5 m. The results were stored in a geographic information system to facilitate data handling and analysis, in particular, the application of the formalism of spatial statistical to the analysis of the distribution of the field levels over the study area. The spatial structure was analyzed using the variographic technique, with the field levels at non-sampled points being interpolated by kriging. The results indicated that, in the urban area analyzed in the present work, the linear density of sampling points could be reduced to a distance which coincides with the length of the blocks of buildings without the statistical parameters varying significantly and with the field level maps being reproduced qualitatively and quantitatively.     

Sand as a relevant fraction in geochemical studies in intertidal environments

Soil and sediment samples from several intertidal environment exposed to different types of contamination were studied to investigate the importance of grain size in relation to the capacity of the substrates to retain trace metals. The unfractionated samples (referred to as bulk samples) were separated into the following grain/size fractions: fine–coarse sand (2?0.100 mm), very fine sand (0.100?0.050 mm), silt (0.050?0.002 mm), and clay (0.002 mm). The sample into its fractions was carried out was in a glove box under high-purity N₂ atmosphere in order to minimize any alterations to the samples. The bulk samples were characterized in terms of physicochemical properties such as pH, redox potential, and grain size. The total organic carbon (TOC), total sulfur (S), iron (Fe) pyrite, Fe, and manganese (Mn), and trace metals lead (Pb), mercury (Hg), chromium (Cr), and nickel (Ni) were analyzed in the bulk samples and in each fraction. The sand fractions were also examined by scanning electron microscopy (SEM). Comparisons of the above parameters were made between fractions and between each fraction and the corresponding bulk sample. The fine–coarse sand fraction contained high levels of the primary elements of the geochemical processes that occur in marine sedimentary environments such as TOC, total Fe, Mn, and S. The net concentrations of these four elements were higher in the fine-coarse sand fraction than in the very fine sand fraction and were similar to the net concentrations in the silt and clay fractions. Detailed SEM analysis of the sand coarse fraction revealed the presence of Fe and aluminum oxyhydroxide coatings in the oxic layers, whereas the framboidal pyrites and coatings observed in the anoxic layers were Fe sulfides. The presence of the various coatings explains why the trace metal concentrations in the sand fine–coarse fraction were similar to those in the clay fraction and higher than those in the very fine sand fraction. The present results highlight the importance of the sand fraction, which is generally disregarded in geochemical and environmental studies of sedimentary layers.