Use of constructed wetland systems with Arundo and Sarcocornia for polishing high salinity tannery wastewater

Treatment of tannery wastewater is problematic due to high and variable concentrations of complex pollutants often combined with high salinity levels. Two series of horizontal subsurface flow constructed wetlands (CWs) planted with Arundo donax and Sarcocornia fruticosa were set up after a conventional biological treatment system operating at a tannery site. The aim of the CWs was polishing organics and nitrogen from the high salinity effluent (2.2-6.6?g Cl(-)?L(-1)). Both plant species established and grew well in the CW. Arundo, however, had more vigorous growth and a higher capacity to take up nutrients. The CWs were efficient in removing COD and BOD(5) with removal efficiencies varying between 51 and 80% for COD (inlet: 68-425?mg?L(-1)) and between 53 and 90% for BOD(5) (inlet: 16-220?mg?L(-1)). Mass removal rates were up to 615?kg COD ha(-1)?d(-1) and 363 BOD(5) kg?ha(-1)?d(-1). Removal efficiencies were 40-93% for total P, 31-89% for NH(4)(+) and 41-90% for Total Kjeldahl Nitrogen. CW systems planted with salt tolerant plant species are a promising solution for polishing saline secondary effluent from the tannery industry to levels fulfilling the discharge standards.     

Influence of Oxygenated Fuels on the Emissions from Three Pre-1985 Light-Duty Passenger Vehicles

Tailpipe and evaporative emissions from three pre-1985 passenger motor vehicles operating on an oxygenated blend fuel and on a nonoxygenated base fuel were characterized. Emission data were collected for vehicles operating over the Federal Test Procedure at 40,75, and 90°F to simulate ambient driving conditions. The two fuels tested were a commercial summer grade regular gasoline (the nonoxygenated base fuel) and an oxygenated fuel containing 9.5 percent methyl tert-butyl ether (MTBE), more olefins, and fewer aromatics than the base fuel. The emissions measured were total hydrocarbons (THCs), speciated hydrocarbons, speciated aldehydes, carbon monoxide (CO), oxides of nitrogen (NO_x), benzene, and 1,3-butadiene.

This study showed no pattern of tailpipe regulated emission reduction when oxygenated fuel was used. Tailpipe emissions from the 1984 Buick Century without a catalyst and the 1977 Mustang with catalyst decreased with the MTBE fuel. However, emissions from the 1984 Buick Century and the 1980 Chevrolet Citation, both fitted with catalysts increased. The vehicles emitted more 1,3- butadiene and, in general, more NO_x when operated with the base fuel.

THC, CO, benzene, and 1,3-butadiene emissions from both fuels and all vehicles, in general, decreased with increasing test temperature, whereas NO_x emissions, in general, increased with increasing test temperature. Formaldehyde, acetaldehyde, and total aldehydes also showed a decrease in emissions as test temperature increased. More formaldehyde was emitted when the MTBE fuel was used.

Evaporative, diurnal, and hot soak emissions from the base fuel were greater than those from the MTBE fuel. The evaporated emissions from both fuels increased with increasing test temperatures. Diurnal data indicate that canister conditioning (bringing the evaporative charcoal canister to equilibrium) is required before testing.     

Evaluation of surface water quality using an ecotoxicological approach: a case study of the Alqueva Reservoir (Portugal)

Background, aim, and scope  

Freshwater reservoirs can be impacted by several hazardous substances through inputs from agricultural activity, sewage discharges, and groundwater leaching and runoff. The water quality assessment is very important for implementation of the monitoring and remediation programs to minimize the risk promoted by hazardous substances in aquatic ecosystems. Evaluation of the degree of contamination of aquatic environments must not take in account only its chemical characterization but it must be complemented with biological assays, which determine potential toxic effects and allows an integrated evaluation of its effects in populations and aquatic ecosystem communities. The application of this type of strategy has clear advantages allowing a general evaluation of the effects from all the water components, including those due to unknown substances and synergic, antagonistic, or additive effects. There are only a few studies that reported ecotoxicological acute end points, for the assessment of surface water quality, and the relationship among toxicity results and the anthropogenic pollution sources and the seasonal period. The aim of this study was to assess the ecotoxicological characterization of the surface water from Alqueva reservoir (South of Portugal) and to evaluate the influence of anthropogenic sources of pollution and their seasonal variation in its toxicity. The construction of Alqueva reservoir was recently finished (2002) and, to our knowledge, an ecotoxicological assessment of its surface water has not been performed. Because of that, no information is available on the possible impact of pollutants on the biota. The surface water toxicity was assessed using acute and chronic bioassays. The results are to be used for developing a monitoring program, including biological methods.     

Climate Change and Water Resources in Arid Mountains: An Example from the Bolivian Andes

Climate change is projected to have a strongly negative effect on water supplies in the arid mountains of South America, significantly impacting millions of people. As one of the poorest countries in the region, Bolivia is particularly vulnerable to such changes due to its limited capacity to adapt. Water security is threatened further by glacial recession with Bolivian glaciers losing nearly half their ice mass over the past 50 years raising serious water management concerns. This review examines current trends in water availability and glacier melt in the Bolivian Andes, assesses the driving factors of reduced water availability and identifies key gaps in our knowledge of the Andean cryosphere. The lack of research regarding permafrost water sources in the Bolivian Andes is addressed, with focus on the potential contribution to mountain water supplies provided by rock glaciers.     

Brominated flame retardants in the Australian population: 1993-2009

Brominated flame retardants, including hexabromocyclododecane (HBCD) and polybrominated diphenyl ethers (PBDEs) are used to reduce the flammability of a multitude of electrical and electronic products, textiles and foams. The use of selected PBDEs has ceased, however, use of decaBDE and HBCD continues. While elevated concentrations of PBDEs in humans have been observed in Australia, no data is available on other BFRs such as HBCD. This study aimed to provide background HBCD concentrations from a representative sample of the Australian population and to assess temporal trends of HBCD and compare with PBDE concentrations over a 16 year period. Samples of human milk collected in Australia from 1993 to 2009, primarily from primiparae mothers were combined into 12 pools from 1993 (2 pools); 2001; 2002/2003 (4 pools); 2003/2004; 2006; 2007/2008 (2 pools); and 2009. Concentrations of ∑HBCD ranged from not quantified (nq) to 19 ng g(-1)lipid while α-HBCD and γ-HBCD ranged from nq to 10 ng g(-1)lipid and nq to 9.2 ng g(-1)lipid. β-HBCD was detected in only one sample at 3.6 ng g(-1)lipid while ∑(4)PBDE ranged from 2.5 to 15.8 ng g(-1)lipid. No temporal trend was apparent in HBCD concentrations in human milk collected in Australia from 1993 to 2009. In comparison, PBDE concentrations in human milk show a peak around 2002/03 (mean ∑(4)PBDEs=9.6 ng g(-1)lipid) and 2003/04 (12.4 ng g(-1)lipid) followed by a decrease in 2007/08 (2.7 ng g(-1)lipid) and 2009 (2.6 ng g(-1)lipid). In human blood serum samples collected from the Australian population, PBDE concentrations did not vary greatly (p=0.441) from 2002/03 to 2008/09. Continued monitoring including both human milk and serum for HBCD and PBDEs is required to observe trends in human body burden of HBCD and PBDEs body burden following changes to usage.     

Automated evaluation of the effect of ionic liquids on catalase activity

An automated assay for the evaluation of the influence of ionic liquids on the activity of catalase was developed. The activity and inhibition assays were implemented in a sequential injection analysis (SIA) system and intended to contribute for the estimation of the toxicity of the tested compounds. The fast developed methodology was based on the oxidation of the non-fluorescent probe amplex red, in the presence of H₂O₂, to produce resorufin, a strong fluorescent compound. Catalase activity was monitored by the decreased of the fluorescence intensity due to the consumption of H₂O₂ by the enzyme. The activity assays were performed in strictly aqueous media and in the presence of increasing concentrations of seven commercially available ionic liquids and sodium azide, a strong inhibitor of catalase. IC₅₀ values between 0.15 and 2.77 M were obtained for the tested compounds, revealing distinct inhibitory effects. This allowed us to perform some considerations about the toxicity of the tested cations and anions. The developed SIA methodology showed to be robust and exhibited good repeatability in all the assay conditions. On the other hand, it proved to be in good agreement with the actual concerns of “Green Chemistry” since it involved the consumption of less than 200 μL of reagents and the production of only 1.7 mL of effluent (per cycle) and at the same time reduced the operator exposure resulting in increased environmental and human safety.     

Concentrations of polychlorinated biphenyls in water from US Lake Ontario tributaries between 2004 and 2008

Research on the environmental fate and transport of PCBs in Lake Ontario basin depends, among other aspects, on the availability of representative data sets for upstream sources, but data are lacking for most US Lake Ontario tributaries. In this study, water samples were collected between September 2004 and October 2008 from five tributaries and were analyzed for 209 polychlorinated biphenyls (PCB) with high-resolution gas chromatography/high resolution mass spectrometry (HRGC/HRMS) following EPA Method 1668A. Total PCB concentrations ranged between 0.31 and 42.75 ng L⁻¹. Congeners between Di and Hexa PCBs accounted between 70 and 99% of the total PCB. The tributary with highest PCB concentrations presented similar pattern and percentage levels to Aroclor 1242. Total average loads for the sampling events ranged between 1.85 g d⁻¹ and 59.08 g d⁻¹. PCB concentrations were evaluated against other variables and other studies (including different matrices) to better understand their transport. The methodology used is reliable to assess PCB contamination in surface water.     

The use of sedimentary %C, %N, delta(15)N, and Pb concentrations to assess historical changes in anthropogenic influence on Portuguese estuaries

Vertical profiles of C, N, delta(15)N and Pb were measured in the Mondego and Mira estuaries as markers that conveyed notions as to the relative influence of anthropogenic influence over the past decades. Recent carbon changes in both estuaries may reflect changes in estuarine productivity, probably as a consequence of sediment reworking and erosion, and also of losses in salt marsh area and dwarf eelgrass beds. delta(15)N values began to diverge considerably before the %C and %N and were higher in Mondego. delta(15)N signatures detected N enrichment at relatively low rates, and indicated that Mondego received more enriched N than Mira. Lead concentrations differed between estuaries, with higher concentrations in Mondego. The secular increase in %N, Pb, and delta(15)N signatures was significantly related to human density in the watersheds of the estuaries and were sensitive indicators of anthropogenic activity.     

Atmospheric levels of aldehydes and BTEX and their relationship with vehicular fleet changes in Rio de Janeiro urban area

A comprehensive monitoring campaign to assess aldehydes and BTEX concentrations was performed during 12 months, in the Tijuca district (Rio de Janeiro), an area with commercial activities and a high flux of vehicles. The mean concentrations of formaldehyde and acetaldehyde were 151 and 30 ppb, respectively. The high formaldehyde/acetaldehyde ratio was attributed to extensive use of compressed natural gas (CNG). The number of CNG vehicles in the metropolitan Region of Rio de Janeiro increased from 23000 in January 2001 to 161000 in January 2005. Monitoring data show that, for the same period, methane and formaldehyde concentrations increased while NO(x) and CO levels diminished. Mean concentrations for benzene, toluene, ethylbenzene, m,p-xylene and o-xylene, were 1.1, 4.8, 3.6, 10.4 and 3.0 micro gm(-3), respectively. Benzene and toluene concentrations were lower than the values determined in 1996, for the same location. The levels of ethylbenzene and xylenes determined in this work are similar to values obtained in 1996. This fact may be explained as a consequence of changes in the gasoline composition.