A large-scale outdoor atmospheric simulation smog chamber for studying atmospheric photochemical processes: Characterization and preliminary application

Understanding the formation mechanisms of secondary air pollution is very important for the formulation of air pollution control countermeasures in China. Thus, a large-scale outdoor atmospheric simulation smog chamber was constructed at Chinese Research Academy of Environmental Sciences (the CRAES Chamber), which was designed for simulating the atmospheric photochemical processes under the conditions close to the real atmospheric environment. The chamber consisted of a 56-m³ fluorinated ethylene propylene (FEP) Teflon film reactor, an electrically-driven stainless steel alloy shield, an auxiliary system, and multiple detection instrumentations. By performing a series of characterization experiments, we obtained basic parameters of the CRAES chamber, such as the mixing ability, the background reactivity, and the wall loss rates of gaseous compounds (propene, NO, NO₂, ozone) and aerosols (ammonium sulfate). Oxidation experiments were also performed to study the formation of ozone and secondary organic aerosol (SOA), including α-pinene ozonolysis, propene and 1,3,5-trimethylbenzene photooxidation. Temperature and seed effects on the vapor wall loss and SOA yields were obtained in this work: higher temperature and the presence of seed could reduce the vapor wall loss; SOA yield was found to depend inversely on temperature, and the presence of seed could increase SOA yield. The seed was suggested to be used in the chamber to reduce the interaction between the gas phase and chamber walls. The results above showed that the CRAES chamber was reliable and could meet the demands for investigating tropospheric chemistry.     

Chemical looping with oxygen uncoupling: an advanced biomass combustion technology to avoid CO2 emissions

Mitigation and Adaptation Strategies for Global Change - Bioenergy with carbon dioxide (CO2) capture and storage (BECCS) technologies represent an interesting option to reach negative carbon...     

莱特生物强化技术处理高浓度有机废水的中试

采用莱特生物强化技术(LTBR—Littoral BioReactor),对兰州石化公司化工园区高浓度有机废水进行了中试试验,进行了正常运行的常规标定、水量冲击标定、浓度冲击标定。结果表明:采用LTBR生物处理工艺,使用特效微生物和营养基质,可以在高COD、高含盐等不利条件下正常进行有机物降解,达到了必须将废水中的COD降至2000mg/L以下的试验要求,为处理高浓度有机化工废水的工程应用开辟了新思路。     

纳米硫化镉对A549细胞的损伤研究

研究纳米硫化镉(Nano-Cd S)材料对肺癌细胞系A549的毒性及氧化损伤作用。培养A549细胞,经传代后接种于6孔板中,每孔2 m L完全培养基,接种次日进行染毒。用直径20~30 nm、长度80~100 nm的Nano-Cd S进行染毒,染毒浓度分别为0、5、10、20、40和80 mg·L~(-1)。染毒24 h后用MTT检测细胞存活率,以存活率在80%左右的浓度为后续实验染毒浓度。应用流式细胞技术,用荧光探针法检测A549细胞的活性氧(reactive oxygen species,ROS)含量,PI-Annexin-V法检测细胞凋亡情况;用试剂盒检测细胞中超氧化物岐化酶(superoxide dismutase,SOD)和过氧化氢酶(catalase,CAT)活性以及丙二醛(malondialdehyde,MDA)含量,判断细胞氧化损伤情况。不同浓度Nano-Cd S处理细胞24 h之后,细胞存活率随剂量的增加而下降,浓度为10、20、40和80μg·L~(-1)时,存活率分别为(88.71%±0.80%)、(81.93%±3.06%)、(75.23%±1.13%)和(70.66%±5.63%),且各组间差异均具有统计学意义(P0.05)。以浓度为10和20 mg·L~(-1)的Nano-Cd S染毒24 h后,胞内ROS含量和细胞凋亡率随染毒剂量的增加而增加(P0.05);浓度为10 mg·L~(-1)时,细胞凋亡率为(6.26%±0.44%)。与对照相比,各染毒组SOD和CAT活性和MDA含量升高,20 mg·L~(-1)染毒组SOD和CAT活性和MDA含量高于10 mg·L~(-1)染毒组(P0.05)。研究表明,纳米硫化镉能引起A549细胞的氧化损伤和细胞凋亡,具有明显的细胞毒性。     

Organochlorine pesticide residue levels in blood serum of inhabitants from Veracruz, Mexico

The objective of the present study was to monitor the levels of organochlorine pesticides HCB; α-, β-, γ-HCH; pp'DDE; op'DDT; and pp'DDT in blood serum of Veracruz, Mexico inhabitants. Organochlorine pesticides were analyzed in 150 blood serum samples that constituted that which remained after clinical analyses, using gas chromatography-electron-capture detection (GC-ECD). The results were expressed as milligrams per kilogram on fat basis and micrograms per liter on wet weight. Only the following pesticides were detected: p,p'-DDE was the major organochlorine component, detected in 100% of samples at mean 15.8 mg/kg and 8.4 μg/L; p,p'-DDT was presented in 41.3.% of monitored samples at mean 3.1 mg/kg and 1.4 μg/L; β-HCH was found in 48.6% of the samples at mean 4.9 mg/kg and 2.7 μg/L; op'DDT was determined to be in only 3.3% of monitored samples at mean 2.7 mg/kg and 1.4 μg/L. The pooled samples divided according to sex showed significant differences of β-HCH and pp'DDE concentrations in females. The samples grouped according to age presented the third tertile as more contaminated in both sexes, indicating age as a positively associated factor with serum organochlorine pesticide levels in Veracruz inhabitants.     

Performance evaluation of two commercial chemiluminescence NOx analysers according to European Standard EN 14211

According to Directive 2008/50/EC, all equipment used for NO(x) fixed measurements must comply with the reference method or equivalent by 11 June 2013. Up to that date, non-type-approved equipment can continue to be used in air monitoring networks and will probably also be used in air pollution studies even after that date. In this context, it is advisable to know how these "old" measuring instruments respond to the requirements of European Standard EN 14211: 2005: Ambient Air Quality--Standard method for the measurement of the concentration of nitrogen dioxide and nitrogen monoxide by chemiluminescence. In this work, we carry out a thorough performance evaluation of two commercial NO(x) analysers, both purchased before 2010, according to the mentioned Standard. Results show that water vapour interference is one of the most important disconformities with this Standard. The expanded uncertainty estimation of both analysers was below the quality objective of the above-mentioned Directive (15%); however, this calculation was performed by applying some modifications to the proposed model of Standard EN 14211. These modifications are also discussed in the paper.     

An Air Quality Modeling Study Comparing Two Possible Sites for the New International Airport for Mexico City

Abstract

Using an air quality model, two future urban scenarios induced by the construction of the new international airport for Mexico City are compared at a regional level. The air quality model couples the meteorology model MM5 and state-of-the-art photochemistry. The air quality comparison is made using metrics for the criterion gases selected for the study. From the two urban scenarios compared, the option for Tizayuca is moderately better than the option for Texcoco, because relative reductions in O₃ and other photochemical pollutants are achieved over highly populated areas. Regardless of the site, the air quality for the central region of Mexico in the future will deteriorate. In the region of central Mexico, SO₂ and NO₂ will become important pollutants.     

Use of the Light Absorption Coefficient to Monitor Elemental Carbon and PM2.5—Example of Santiago de Chile

Abstract

The optical absorption coefficient, particulate matter with an aerodynamic diameter <2.5 μm, and elemental carbon (EC) have been measured simultaneously during winter and spring of 2000 in the western part of Santiago, Chile (Pudahuel district). The optical measurements were carried out with a low-cost instrument recently developed at the University of Santiago. From the data, a site-specific mass absorption coefficient of 4.45 ± 0.01 m²/g has been found for EC. In addition, a mass absorption coefficient of 1.02 ± 0.03 m²/g has been obtained for PM_2.5. These coefficients can be used during the colder months (May-August) to obtain EC concentration or PM_2.5 from a measurement of the light absorption coefficient (σ_a). The high correlation that has been found between these variables indicates that σ_a is a good indicator of the degree of contamination of urbanized areas.

The data also show an increase in PM_2.5 and EC concentration during winter and an increase in the ratio of EC to PM_2.5. When the EC/PM_2.5 ratio is calculated during rush hour (7:00 a.m.-11:00 a.m.) and during part of the night (9:00 p.m.-2:00 a.m.), it is found that the increase is caused by higher concentration levels of EC at night. These results suggest that the rise in the EC concentration is caused by emissions from heating and air mass transport of pollution from other parts of the city, while traffic contribution remains approximately constant.     

Evaluating Environmental Parameters for Minimum Ammonium Losses during Composting of Trimming Residues

Abstract

A neural fuzzy system was used to investigate the influence of environmental variables (time, aeration, moisture, and particle size) on composting parameters (pH, organic matter [OM], nitrogen [N], ammonium nitrogen [NH₄ ⁺-N] and nitrate nitrogen [NO₃ ^--N]). This was to determine the best composting conditions to ensure the maximum quality on the composts obtained with the minimum ammonium losses. A central composite experimental design was used to obtain the neural fuzzy model for each dependent variable. These models, consisting of the four independent process variables, were found to accurately describe the composting process (the differences between the experimental values and those estimated by using the equations never exceeded 5–10% of the former). Results of the modeling showed that creating a product with acceptable chemical properties (pH, NH₄ ⁺-N and NO₃ ^--N) entails operating at medium moisture content (55%) and medium to high particle size (3–5 cm). Moderate to low aeration (0.2 L air/min · kg) would be the best compromise to compost this residue because of the scant statistical influence of this independent variable.