Teachers' conceptions of nature and environment in 16 countries

By using an original framework involving complementary statistical approaches, we investigated the environmental attitudes of 6379 pre-service and in-service teachers in 16 countries of Europe and its neighbourhood. To test hypotheses about the nature of environmental attitudes, we examined the variation across groups of individuals (between-class analysis), investigated the independent effects of several candidate explanatory factors (orthogonal analysis), and finally inspected potential relationships between conceptions on a variety of topics (co-inertia analysis).     

Application of chemical oxidation to remediate HCH-contaminated soil under batch and flow through conditions

This is the first study describing the chemical oxidation of hexachlorocyclohexanes (HCHs) in contaminated soil under water saturated and unsaturated flow through conditions. Soil contaminated with β-HCH (45 mg kg^?1) and γ-HCH (lindane, 25 mg kg^?1) was sampled from former lindane waste storage site. Efficiency of following treatments was tested at circumneutral pH: H₂O₂ alone, H₂O₂/Fe^II, Na₂S₂O₈ alone, Na₂S₂O₈/Fe^II, and KMnO₄. Experimental conditions (oxidant dose, liquid/solid ratio, and soil granulometry) were first optimized in batch experiments. Obtained results revealed that increasing dose of H₂O₂ improved the oxidation efficiency while in Na₂S₂O₈ system, maximum HCHs were removed at 300 mM. However, oxidation efficiency was slightly improved by Fe^II-activation. Increasing the solid/liquid ratio decreased HCH removal in soil samples crushed to 500 μm while an opposite trend was observed for 2-mm samples. Dynamic column experiments showed that oxidation efficiency followed the order KMnO₄ > Na₂S₂O₈/Fe^II > Na₂S₂O₈ whatever the flow condition, whereas the removal extent declined at higher flow rate (e.g., ~50% by KMnO₄ at 0.5 mL/min as compared to ~30% at 2 mL/min). Both HCH removal and oxidant decomposition extents were found higher in saturated columns than the unsaturated ones. While no significant change in relative abundance of soil mineral constituents was observed before and after chemical oxidation, more than 60% of extractable organic matter was lost after chemical oxidation, thereby underscoring the non-selective behavior of chemical oxidation in soil. Due to the complexity of soil system, chemical oxidation has rarely been reported under flow through conditions, and therefore our findings will have promising implications in developing remediation techniques under dynamic conditions closer to field applications.     

Evaluation of ion exchange resins for the removal of dissolved organic matter from biologically treated paper mill effluent

In this study, the efficiency of six ion exchange resins to reduce the dissolved organic matter (DOM) from a biologically treated newsprint mill effluent was evaluated and the dominant removal mechanism of residual organics was established using advanced organic characterisations techniques. Among the resins screened, TAN1 possessed favourable Freundlich parameters, high resin capacity and solute affinity, closely followed by Marathon MSA and Marathon WBA. The removal efficiency of colour and lignin residuals was generally good for the anion exchange resins, greater than 50% and 75% respectively. In terms of the DOM fractions removal measured through liquid chromatography–organic carbon and nitrogen detector (LC–OCND), the resins mainly targeted the removal of humic and fulvic acids of molecular weight ranging between 500 and 1000 g mol^?1, the portion expected to contribute the most to the aromaticity of the effluent. For the anion exchange resins, physical adsorption operated along with ion exchange mechanism assisting to remove neutral and transphilic acid fractions of DOM. The column studies confirmed TAN1 being the best of those screened, exhibited the longest mass transfer zone and maximum treatable volume of effluent. The treatable effluent volume with 50% reduction in dissolved organic carbon (DOC) was 4.8 L for TAN1 followed by Marathon MSA – 3.6 L, Marathon 11 – 2.0 L, 21K-XLT – 1.5 L and Marathon WBA – 1.2 L. The cation exchange resin G26 was not effective in DOM removal as the maximum DOC removal obtained was only 27%. The resin capacity could not be completely restored for any of the resins; however, a maximum restoration up to 74% and 93% was achieved for TAN1 and Marathon WBA resins. While this feasibility study indicates the potential option of using ion exchange resins for the reclamation of paper mill effluent, the need for improving the regeneration protocols to restore the resin efficiency is also identified. Similarly, care should be taken while employing LC–OCND for characterising resin-treated effluents, as the resin degradation is expected to contribute some organic carbon moieties misleading the actual performance of resin.     

Characterization of summertime coarse particulate matter in the Desert Southwest—Arizona,USA

A year-long study was conducted in Pinal County, AZ, to characterize coarse (2.5 – 10 μm aerodynamic diameter, AD) and fine (< 2.5 μm AD) particulate matter (PMc and PMf, respectively) to further understand spatial and temporal variations in ambient PM concentrations and composition in rural, arid environments. Measurements of PMc and PMf mass, ions, elements, and carbon concentrations at one-in-six day resolution were obtained at three sites within the region. Results from the summer of 2009 and specifically the local monsoon period are presented.

The summer monsoon season (July – September) and associated rain and/or high wind events, has historically had the largest number of PM₁₀ NAAQS exceedances within a year. Rain events served to clean the atmosphere, decreasing PMc concentrations resulting in a more uniform spatial gradient among the sites. The monsoon period also is characterized by high wind events, increasing PMc mass concentrations, possibly due to increased local wind-driven soil erosion or transport. Two PM₁₀ NAAQS exceedances at the urban monitoring site were explained by high wind events and can likely be excluded from PM₁₀ compliance calculations as exceptional events. At the more rural Cowtown site, PM₁₀ NAAQS exceedances were more frequent, likely due to the impact from local dust sources.

PM mass concentrations at the Cowtown site were typically higher than at the Pinal County Housing and Casa Grande sites. Crustal material was equal to 52-63% of the PMc mass concentration on average. High concentrations of phosphate and organic carbon found at the rural Cowtown were associated with local cattle feeding operations. A relatively high correlation between PMc and PMf (R²?=?0.63) indicated that the lower tail of the coarse particle fraction often impacts the fine particle fraction, increasing the PMf concentrations. Therefore, reductions in PMc sources will likely also reduce PMf concentrations, which also are near the value of the 24-hr PM_2.5 NAAQS.

Implications: In the desert southwest, summer monsoons are often associated with above average PM₁₀ (<10 μm AD) mass concentrations. Competing influences of monsoon rain and wind events showed that rain suppresses ambient concentrations while high wind increase them. In this region, the PMc fraction dominates PM₁₀ and crustal sources contribute 52-63% to local PMc mass concentrations on average. Cattle feedlot emissions are also an important source and a unique chemical signature was identified for this source. Observations suggest monsoon wind events alone cannot explain PM₁₀ NAAQS exceedances, thus requiring these values to remain in compliance calculations rather than being removed as exceptional wind events.     

Wood Smoke Contribution to Winter Aerosol in Fresno,CA

Abstract

In an effort to better quantify wintertime particulate matter (PM) and the contribution of wood smoke to air pollution events in Fresno, CA, a field campaign was conducted in winter 2003–2004. Coarse and fine daily PM samples were collected at five locations in Fresno, including residential, urban, and industrial areas. Measurements of collected samples included gravimetric mass determination, organic and elemental carbon analysis, and trace organic compound analysis by gas chromatograph mass spectrometry (GC/MS). The wood smoke tracer levoglucosan was also measured in aqueous aerosol extracts using high-performance anion exchange chromatography coupled with pulsed amperometric detection. Sample preparation and analysis by this technique is much simpler and less expensive than derivatized levoglucosan analysis by GC/MS, permitting analysis of daily PM samples from all five of the measurement locations. Analyses revealed low spatial variability and similar temporal patterns of PM_2.5 mass, organic carbon (OC), and levoglucosan. Daily mass concentrations appear to have been strongly influenced by meteorological conditions, including precipitation, wind, and fog events. Fine PM (PM_2.5) concentrations are uncommonly low during the study period, reflecting frequent precipitation events. During the first portion of the study, levoglucosan had a strong relationship to the concentrations of PM_2.5 and OC. In the later portion of the study, there was a significant reduction in levoglucosan relative to PM_2.5 and OC. This may indicate a change in particle removal processes, perhaps because of fog events, which were more common in the latter period. Combined, the emissions from wood smoke, meat cooking, and motor vehicles appear to contribute ~65–80% to measured OC, with wood smoke, on average, accounting for ~41% of OC and ~18% of PM_2.5 mass. Two residential sites exhibit somewhat higher contributions of wood smoke to OC than other locations.     

Water pressure head and temperature impact on isoxaflutole degradation in crop residues and loamy surface soil under conventional and conservation tillage management

Laboratory incubations were performed in order to evaluate the dissipation of the proherbicide isoxaflutole in seedbed layer soil samples from conventional and conservation tillage systems and in maize and oat residues left at the soil surface under conservation tillage. The effects of temperature and water pressure head on radiolabelled isoxaflutole degradation were studied for each sample for 21 d. Mineralisation of isoxaflutole was low for all samples and ranged from 0.0% to 0.9% of applied ¹⁴C in soil samples and from 0.0% to 2.4% of applied ¹⁴C in residue samples. In soil samples, degradation half-life of isoxaflutole ranged from 9 to 26 h, with significantly higher values under conservation tillage. In residue samples, degradation half-life ranged from 3 to 31 h, with significantly higher values in maize residues, despite a higher mineralisation and bound residue formation than in oat residues. Whatever the sample, most of the applied ¹⁴C remained extractable during the experiment and, after 21 d, less than 15% of applied ¹⁴C were unextractable. This extractable fraction was composed of diketonitrile, benzoic acid derivative and several unidentified metabolites, with one of them accounting for more than 17% of applied ¹⁴C. This study showed that tillage system design, including crop residues management, could help reducing the environmental impacts of isoxaflutole.     

An improved method to study the impact of pesticide sprays on small song birds

Abstract

Four test groups of small songbirds (Zebra Finch, Poephila guttata) were sprayed in a chamber with varying concentrations of fenitrothion. Exposure levels were assessed by monitoring air concentrations, deposits of the active ingredient (AI) on glass plates and droplets/cm² on Kromekote® cards. All indices of exposure were linearly correlated and the mean AI deposit on glass plates for the four groups tested were equivalent to 38, 51, 139 and 255 g/ha or 14%, 18%, 50% and 91% of the highest permissible emitted rate for broadscale forest spraying in Canada. Significant depression in body weights and brain acetylcholinesterase levels were noted only for the highest exposure group. Fenitrothion residues in blood were detectable only at the highest exposure level, and in liver at the two higher levels. Carcass and feather residues were much higher than those in blood and liver, and were detectable at all exposure levels but the residues did not increase linearly with exposure. For one of the spray groups, we were able to compute an equivalent acute oral dose based on matching acetylcholinesterase inhibition.     

A multibiomarker approach on the Atlantic tomcod (Microgadus tomcod) in the St. Lawrence Estuary

A multibiomarker approach was developed on juvenile Atlantic tomcod (Microgadus tomcod) to evaluate the pertinence of this approach for low-cost screening assessment of the environmental quality of various coastal sites within estuaries. Several biometric indices and biomarkers (ethoxyresorufin-O-deethylase (EROD) activity, metallothionein concentration, and immune responses) were investigated on immature and maturing tomcods (≤31 months) collected in four environmentally contrasted sites in the St. Lawrence Estuary (SLE). Simultaneous examination of various age classes provides the opportunity to detect short-term responses in sensitive young-of-the-year fish (e.g., EROD induction) and longer-time effects associated with chronic exposure and bioaccumulation (e.g., metallothionein induction). Principal component analysis was helpful to discriminate between responses possibly related to contaminant exposure (EROD, metallothionein) and responses that could be affected by upstream–downstream gradient (immune response, biometric indices). Measurement of a battery of biomarkers in young tomcods at several sites along the shore of the SLE is a low-cost screening investigation useful to identify hot spots requiring further investigation with chemical analysis and additional reference sites.     

The influence of the level of definition of functional specifications on the environmental performances of a complex system. EcoCSP approach

The tendency towards a homogenous mode of development modelled on that of Western countries means that sustainable development has become increasingly urgent. It is necessary to thoroughly redefine products and their expected performances in such a way that the consequences are compatible with sustainable development. In the domain of product design, this means that it is no longer sufficient to use assessment tools “after the fact” to check the impact of products whose functional unit (FU) was defined prior to production; it is now necessary to rethink the definition of the FU itself. This article aims to present an approach based on a combination of life cycle analysis methods and problem-solving by constraint satisfaction. This original approach makes it possible to vary the design of the different dimensions of the FUs of a complex system and thus to make it easier to identify the best architecture along with the best functional definition of the system. In this study, the EcoCSP approach is applied to define the functional performances of an ecological passenger ferry. The complexity of couplings between subsystems and the sheer number of those subsystems mean that the designer has to use “intelligent” tools. These simulate a great number of scenarios and help him/her to fine-tune the system and make the right technological choices with regard to the right functional specifications.