Making spatial development scenario for south of Bushehr province,Iran, based on strategic foresight

In recent years, the science of foresight has been entered into planning activities by urban and regional planners and this science has impacted on planning activities. This study discusses spatial development in the south of Bushehr province using the foresight approach. The general aim of this research is to compile scenarios for the development of the mentioned study area which comprises the southern part of Bushehr province including four counties of Dayyer, Jam, Kangan and Asaluyeh. The main reason for selecting this region is their direct impressibility by major changes in the country’s oil and gas industry. This research has extremely made use of the Delphi and cross-impact analysis methods to develop foresight scenarios. Using the Delphi method, 30 initial factors were identified in the economic, political-security, linkages, science and technology, manufacturing, natural, social, infrastructural and residential issues and then the cross-impact matrix was used to investigate the impact of factors on each other. In the next step, the ranking of direct and indirect factors was determined by Micmac software and on this basis, the final refining in the selection of drivers was done. In the final stage, axes of future scenarios were presented and then the future scenarios were drawn. Results of this research indicate that two main drivers namely Iran’s international relations and energy resources are the main axes of scenarios. These two drivers have more uncertainty and higher importance than other factors and the results in four scenarios showing the possibility of each situation’s occurrence.     

Synthesis,Characterization and Environmental Applications of a New Bio-Composite Gelatin-Zr(IV) Phosphate

Gelatin-Zr(IV) phosphate composite (GT/ZPC) was synthesized by sol–gel method. Different techniques viz. Fourier transform infrared spectroscopy (FTIR), thermogravimetric analysis (TGA), X-ray powdered diffraction (XRD), scanning electron microscopy (SEM) and transmission electron microscopy (TEM) were used for the characterisation of GT/ZPC composite ion exchanger. The ion exchange capacity (IEC) of GT/ZPC was observed to be better (1.04 meq g^?1) than its inorganic counterpart (0.64 meq g^?1). The pH studies revealed the monofunctional nature of GT/ZPC with one inflection point. The distribution studies showed that the GT/ZPC was highly selective for Cd²⁺ as compare to other metal ions. The environmental applicability of ion exchanger has been analysed for binary separations of metal ions using column method. Cd²⁺ was effectively removed from synthetic mixture of metal ions (Zn²⁺, Pb²⁺, Ni²⁺, Co²⁺ and Cu²⁺).     

The effects of using reprocessable material on the durability and mechanical properties of landfill leachate collection HDPE pipes

This paper investigated the durability and mechanical properties of landfill leachate collection HDPE pipes which had been made of different weight percent amounts of virgin and reprocessable HDPE compounds (VC and RC). Durability is reported base on the chemical properties, obtained through oxidative induction time (OIT) and melt flow index (MFI) measurements, at the temperature of 50 °C and over a period of 12 months immersion in a synthetic leachate. Mechanical properties are also described according to tensile and pressure tests which had been conducted on the pipes samples. All of the factors were examined had been affected by the addition of RC, but for the special combination the antioxidant depletion was significantly affected by the experimental aging condition and no important changes had been observed in the other pipe properties. The results from OIT tests indicate that the rate of antioxidant depletion is reduced by an increase in the weight percent amounts of RC, during the experimental aging condition. This reduction is probably attributed to the extraction of antioxidants from RC in their recovery process. Finally, although these results are related to the particular HDPE compound, antioxidant formulation and condition examined, but it can be said that the use of clean own reprocessable material for the production of landfill leachate pipes shall be permitted without limitations.     

Assessing stress response of Stylophora pistillata towards oil and phosphate pollution in the Gulf of Aqaba,using molecular and biochemical markers

Crude oil (from oil terminal) and raw phosphate (from phosphate port) pollution are responsible for the lowered health conditions of coral reefs at their vicinity in the Jordanian coast of the Gulf of Aqaba. Both in situ incubations and ex situ laboratory exposure experiments were used to study the effects of those pollutants on corals, by using molecular and biochemical biomarkers in the coral Stylophora pistillata. For ex situ part of the experiment, crude oil and raw phosphate were added to a final concentration of 500?ppm for both pollutants. The DNA damage was assessed by Comet assay, while biochemical stress markers were reassessed by lipid peroxidation (LPO) test. Although the corals looked healthy from outside, the use of stress biomarkers indicated that they are under high pressure at the cellular level. The corals incubated with oil and phosphate had more DNA damage and LPO in comparison with the control samples. The results obtained suggest that the use of stress biomarkers can be used as important prognostic tools for examining the sub-lethal stress on corals before their death.     

Toward a robust analytical method for separating trace levels of nano-materials in natural waters: cloud point extraction of nano-copper(II) oxide

Cloud point extraction (CPE) factors, namely Triton X-114 (TX-114) concentration, pH, ionic strength, incubation time, and temperature, were optimized for the separation of nano-sized copper(II) oxide (nCuO) in aqueous matrices. The kinetics of phase transfer was studied using UV–visible spectroscopy. From the highest separation rate, the most favorable conditions were observed with 0.2 %?w/v of TX-114, pH?=?9.0, ionic strength of 10 mM NaCl, and incubation at 40 °C for 60 min, yielding an extraction efficiency of 89.2?±?3.9 % and a preconcentration factor of 86. The aggregate size distribution confirmed the formation of very large nCuO–micelle assemblies (11.9 μm) under these conditions. The surface charge of nCuO was also diminished effectively. An extraction efficiency of 91 % was achieved with a mixture of TX-100 and TX-114 containing 30 wt.% of TX-100. Natural organic and particulate matters, represented by humic acid (30 mg/L) and micron-sized silica particles (50 mg/L), respectively, did not significantly reduce the CPE efficiency (<10 %). The recovery of copper(II) ions (20 mg/L) in the presence of humic acid was low (3–10 %). The spiked natural water samples were analyzed either directly or after CPE by inductively coupled plasma mass spectrometry following acid digestion/microwave irradiation. The results indicated the influence of matrix effects and their reduction by CPE. A delay between spiking nCuO and CPE may also influence the recovery of nCuO due to aggregation and dissolution. A detection limit of 0.04 μg Cu/L was achieved for nCuO.     

Limitations of recreational camera traps for wildlife management and conservation research: A practitioner’s perspective

The availability of affordable ‘recreational’ camera traps has dramatically increased over the last decade. We present survey results which show that many conservation practitioners use cheaper ‘recreational’ units for research rather than more expensive ‘professional’ equipment. We present our perspective of using two popular models of ‘recreational’ camera trap for ecological field-based studies. The models used (for >2 years) presented us with a range of practical problems at all stages of their use including deployment, operation, and data management, which collectively crippled data collection and limited opportunities for quantification of key issues arising. Our experiences demonstrate that prospective users need to have a sufficient understanding of the limitations camera trap technology poses, dimensions we communicate here. While the merits of different camera traps will be study specific, the performance of more expensive ‘professional’ models may prove more cost-effective in the long-term when using camera traps for research.     

Review of environmental aspects and waste management of stone cutting and fabrication industries

Iran is the second largest stockholder of construction stones with 10 % of world production ;and there are more than 4000 stone cutting and fabrication industries (SCFIs). In the processing of raw stones, a considerable part of stone is turned into waste. Generated wastes include excess parts of different stones and sludge. The present paper reviews the state of SCFIs waste management using multiple data sources including site, analysis of effluent and sludge samples, and conducting interviews with people who are involved in 286 SCFIs in Qom and Tabriz. The results revealed that currently almost 35 to 52.5 % of raw stones were converted to solid wastes depending on stone cutting and processing methods, type of stones and their quality, which seemed a high percentage. Also, the effluents between 0.8 and 2.8 m³ were generated per ton of processed stone. Based on the analysis of heavy metals with atomic absorption spectroscopy, sludge samples contained a considerable amount of Pb, Cu, Cr, and Cd. It was also found that the lack of specific recycling, reuse and disposal programs and suitable supervision has led to uncontrolled disposal of stone wastes and sludge in different areas. However, there are good opportunities for reuse and recycling of the SCFIs wastes.     

Hydrogen sulfide ameliorates lead-induced morphological, photosynthetic, oxidative damages and biochemical changes in cotton

Poisonous lead (Pb), among heavy metals, is a potential pollutant that readily accumulates in soils and thus adversely affects physiological processes in plants. We have evaluated how exogenous H₂S affects cotton plant physiological attributes and Pb uptake under Pb stress thereby understanding the role of H₂S in physiological processes in plants. Two concentrations (0 and 200 μM) of H₂S donor sodium hydrosulfide (NaHS) were experimented on cotton plants under Pb stress (0, 50, and 100 μM). Results have shown that Pb stress decreased plant growth, chlorophyll contents, SPAD value, photosynthesis, antioxidant activity. On the other hand, Pb stress increased the level of malondialdehyde (MDA), electrolyte leakage (EL), and production of H₂O₂ and uptake of Pb contents in all three parts of plant, viz. root, stem, and leaf. Application of H₂S slightly increased plant growth, chlorophyll contents, SPAD value, photosynthesis, and antioxidant activity as compared to control. Hydrogen sulfide supply alleviated the toxic effects of lead on plant growth, chlorophyll contents, SPAD value, photosynthesis, and antioxidant activity in cotton plants. Hydrogen sulfide also reduced MDA, EL, and production of H₂O₂ and endogenous Pb levels in the three mentioned plant parts. On the basis of our results, we conclude that H₂S has promotive effects which could improve plant survival under Pb stress.