Sludge fermentation liquid addition attained advanced nitrogen removal in low C/N ratio municipal wastewater through short-cut nitrification-denitrification and partial anammox

• Sludge fermentation liquid addition resulted in a high NAR of 97.4%. • Extra NH₄⁺-N from SFL was removed by anammox in anoxic phase. • Nitrogen removal efficiency of 92.51% was achieved in municipal wastewater. • The novel system could efficiently treat low COD/N municipal wastewater. Biological nitrogen removal of wastewater with low COD/N ratio could be enhanced by the addition of wasted sludge fermentation liquid (SFL), but the performance is usually limited by the introducing ammonium. In this study, the process of using SFL was successfully improved by involving anammox process. Real municipal wastewater with a low C/N ratio of 2.8–3.4 was treated in a sequencing batch reactor (SBR). The SBR was operated under anaerobic-aerobic-anoxic (AOA) mode and excess SFL was added into the anoxic phase. Stable short-cut nitrification was achieved after 46d and then anammox sludge was inoculated. In the stable period, effluent total inorganic nitrogen (TIN) was less than 4.3 mg/L with removal efficiency of 92.3%. Further analysis suggests that anammox bacteria, mainly affiliated with Candidatus_Kuenenia, successfully reduced the external ammonia from the SFL and contributed approximately 28%–43% to TIN removal. Overall, this study suggests anammox could be combined with SFL addition, resulting in a stable enhanced nitrogen biological removal.     

缺氧—好氧—催化臭氧氧化工艺处理石化厂含盐废水

采用缺氧—好氧—催化臭氧氧化工艺处理某石化厂的含盐废水。实验结果表明：在进水COD为200~350 mg/L的条件下,经生化处理后的出水COD稳定在50~60 mg/L,COD去除率稳定在75%左右;在臭氧投加量为4.5 g/L、V（催化剂Ⅱ）∶V（废水）=1.5∶1的条件下,进行连续催化臭氧氧化后出水COD稳定在20 mg/L以下,COD去除率大于70%,满足DB 61/224—2011《黄河流域（陕西段）污水综合排放标准》。表征结果显示,催化剂表面含有铜元素,比表面积为250.815 m²/g,吸水率为60.9%,经过滤可去除废水中残留的催化剂。     

废弃电路板中环氧树脂真空热解规律的研究

真空条件下,应用程序升温管式电炉对废弃电路板中环氧树脂热解规律进行了研究.考察了不同的热解终温(200～700 ℃)、升温速率(5～30 ℃/min)、真空度(以压力表征,3～30 kPa)及保温时间(10～150 min)对热解产物产率的影响.实验结果表明,热解终温是影响热解油产率最重要的因素;选择适当的热解终温(400～550 ℃)、升温速率(15～20 ℃/min)、真空度(15 kPa)及保温时间(30 min)有利于提高热解油产率.     

碳纳米管的免疫毒性研究

碳纳米管已经以各种不同的方式进入我们的生活,因此,对碳纳米管可能给人们的健康与安全带来的影响需要有足够的认识.本文就近年来对碳纳米管引起免疫细胞毒性的研究进展进行综述,为人们进一步认识和更好地应用碳纳米管奠定基础.     

颗粒层除尘器过滤状态压力损失的研究

根据Ｍｅｈｔｅｒ等人提出的过滤状态下颗粒层除尘顺压力梯度比表达式，建立了压力损失数学模型，该模型表明过滤状态下的压力损失与初始压力损失，粉尘在颗粒层中的沉积率和积灰量有关。收石英砂颗粒层的压力损失的实验结果，确定了粉尘沉积率计算公式，最终得出了过滤状态下颗粒层压力损失随过滤时间和粉尘在颗粒层中积灰量的变化规律，从而为合理地选择过滤风速和确定清灰制度提供了依据。     

污泥资源化处置与综合利用

介绍了污泥处理的目的、方法,提出污泥应作为一种资源进行综合利用。并结合实例阐述了我国污泥农用资源化处置现状及未来发展趋势。     

Design and demonstration of a next-generation air quality attainment assessment system for PM2.5 and O3

Due to the increasingly stringent standards, it is important to assess whether the proposed emission reduction will result in ambient concentrations that meet the standards. The Software for Model Attainment Test—Community Edition(SMAT-CE) is developed for demonstrating attainment of air quality standards of O3 and PM2.5. SMAT-CE improves computational efficiency and provides a number of advanced visualization and analytical functionalities on an integrated GIS platform. SMAT-CE incorporates historical measurements of air quality parameters and simulated air pollutant concentrations under a number of emission inventory scenarios to project the level of compliance to air quality standards in a targeted future year. An application case study of the software based on the U.S. National Ambient Air Quality Standards(NAAQS) shows that SMAT-CE is capable of demonstrating the air quality attainment of annual PM2.5and 8-hour O3 for a proposed emission control policy.     

SH型输油泵轴套密封泄漏原因及解决方法

针对目前中国石化管道储运分公司黄岛油库输油二队个别SH型输油泵接连出现轴套端面密封大量泄漏原油的情况,分析了轴套端面密封泄漏的原因,并从密封材料、密封形式等方面着手,寻找解决密封泄漏的方法,确保输油泵的运行安全.     

甘肃东部旱作区不同气候类型麦田水分供需平衡研究

甘肃东部旱作地区干旱区年降水量小于300mm,半干旱区为300～450mm,半湿润区为450～600mm,湿润区大于600 mm4种气候类型1989～1992年14个测站0～2m深的土壤湿度实测资料,从降水土壤水作物系统观点出发,分析研究旱作小麦的实际耗水指标和耗水特点,探讨麦田水分供需平衡,为发展旱作区小麦高产稳产的栽培管理措施提供科 学依据。     

共存阳离子对砷、硒和钒毒性效应的影响及预测模型研究

为探明并量化共存阳离子存在下含氧阴离子型金属在生物体中的毒性效应,以模式植物小麦(Triticum aestivumL.)为研究对象,通过单一变量控制实验,探究了4种阳离子(Ca⁽²⁺⁾、Mg(2+)、Mg⁽²⁺⁾、Na(2+)、Na⁺和K+和K⁺)对3种典型含氧阴离子型金属(AsO_4+)对3种典型含氧阴离子型金属(AsO_4^(3-)、SeO_3(3-)、SeO_3^(2-)和VO_4(2-)和VO_4^(3-))毒性的影响,并构建了静电作用模型来预测和评估As、Se和V的生态毒性效应与风险。结果表明,Ca(3-))毒性的影响,并构建了静电作用模型来预测和评估As、Se和V的生态毒性效应与风险。结果表明,Ca⁽²⁺⁾对As、Se和V毒性的影响呈现出3种不同的趋势：在相同设计浓度范围内Ca(2+)对As、Se和V毒性的影响呈现出3种不同的趋势：在相同设计浓度范围内Ca⁽²⁺⁾的增加显著引起了As毒性的减弱(Adj.R(2+)的增加显著引起了As毒性的减弱(Adj.R²=0.76,P<0.05)、V毒性的加剧(Adj.R2=0.76,P<0.05)、V毒性的加剧(Adj.R²=0.81,P<0.05),而对Se毒性却没有显著影响。当Mg2=0.81,P<0.05),而对Se毒性却没有显著影响。当Mg⁽²⁺⁾从0.20 mmol·L(2+)从0.20 mmol·L^(-1)增加到2.73 mmol·L(-1)增加到2.73 mmol·L^(-1)时,Se主导形态的半数有效活度值(EC_(50){HSeO+3(-1)时,Se主导形态的半数有效活度值(EC_(50){HSeO+3^-})从40.40 μmol·L-})从40.40 μmol·L^(-1)显著下降为27.98 μmol·L(-1)显著下降为27.98 μmol·L^(-1),即Se毒性增强到原来的1.44倍(Adj.R(-1),即Se毒性增强到原来的1.44倍(Adj.R²=0.79,P<0.05)。静电作用理论能够很好地解释Ca2=0.79,P<0.05)。静电作用理论能够很好地解释Ca⁽²⁺⁾(或Mg(2+)(或Mg⁽²⁺⁾)在显著增强V(或Se)毒性中发挥的作用,将这种静电作用影响纳入考虑成功构建了可以定量预测V(Adj.R(2+))在显著增强V(或Se)毒性中发挥的作用,将这种静电作用影响纳入考虑成功构建了可以定量预测V(Adj.R²=0.88)和Se(Adj.R2=0.88)和Se(Adj.R²=0.95)毒性的静电作用模型。研究结果弥补了目前含氧阴离子型金属生态毒性研究的不足,为含氧阴离子型金属的土壤污染生态风险评估提供了指导与参考。