Variations in exposure to in-vehicle particle mass and number concentrations in different road environments

Road environments significantly affect in cabin concentration of particulate matter (PM). This study conducted measurements of in-vehicle and on-road concentrations of PM10, PM2.5, PM1, and particle number (PN) in size of 0.02–1 µm, under six ventilation settings in different urban road environments (tunnels, surface roads and elevated roads). Linear regression was then used to analyze the contributions of multiple predictor variables (including on-road concentrations, temperature, relative humidity, time of day, and ventilation settings) to measured variations. On-road measurements of PM2.5, PM1, and PN concentrations from the open surface roads were 5.5%, 3.7%, and 16% lower, respectively, than those measured in tunnels, but 7.6%, 7.1% and 24% higher, respectively, than those on elevated roads. The highest on-road PM10 concentration was observed on surface roads. The time series pattern of in-vehicle particle concentrations closely tracked the on-road concentrations outside of the car and exhibited a smoother profile. Irrespective of road environment, the average I/O ratio of particles was found to be the lowest when air conditioning was on with internal recirculation, the highest purification efficiency via ventilation was obtained by switching on external air recirculation and air conditioning. Statistical models showed that on-road concentration, temperature, and ventilation setting are common factors of significance that explained 58%-80%, 64%-97%, and 87%-98% of the variations in in-vehicle PM concentrations on surface roads, on elevated roads, and in tunnels, respectively.

Implications: Inside vehicles, both driver and passengers will be exposed to elevated particle concentrations. However, for in-vehicle particles, there has been no comprehensive comparative study of the three-dimensional traffic environment including tunnels surface roads and elevated roads. This study focuses on the analysis of the trends and main influencing factors of particle concentrations in different road environments. The results can provide suggestions for the driver's behavior, and provide data support for the environmental protection department to develop pollutant concentration limits within the vehicle.     

重金属污染土壤中提高植物提取修复功效的探讨

随着对重金属超积累植物研究的加深 ,用植物提取修复技术来改良重金属污染的土壤已逐步进入实用阶段。本文所探讨的提高此技术功效的方法基于两个方面 :提高土壤溶液中重金属的浓度 ,促进植物对重金属的吸收 ;根据已了解的超积累的生理机制可能采取的一些措施     

Multiple copper adsorption and regeneration by zeolite 4A synthesized from bauxite tailings

Copper ions were first adsorbed by zeolite 4A synthesized from bauxite tailings, the desorption of Cu(II) using Na₂EDTA solutions was performed, and the recycling of zeolite 4A in adsorption and desorption was systematically investigated. It was observed that the Cu(II) removal efficiency was directly dependent on the initial pH value. The maximum removal efficiency of Cu(II) was 96.2% with zeolite 4A when the initial pH value was 5.0. Cu(II) was completely absorbed in the first 30 min. It was also observed that the desorption efficiency and zeolite recovery were highly dependent on the initial pH and concentration of Na₂EDTA in the solution. The desorption efficiency and percent of zeolite recovered were 73.6 and 85.9%, respectively, when the Na₂EDTA solution concentration was 0.05 mol L^?1 and the pH value was 8. The recovered zeolites were pure single phase and highly crystalline. After 3 cycles, the removal efficiency of Cu(II) was as high as 78.9%, and the zeolite recovery was 46.9%, indicating that the recovered zeolites have good adsorption capacity and can repeatedly absorb Cu(II).

     

液体旋流分离器分离效率的研究

液体旋流分离器是水环境污染治理的主要设备之一.分离效率是衡量液体旋流分离器分离过程进行完善程度的最重要的技术指标,它能从质与量两方面反映出设备性能的优劣.当前液体旋流分离器设计过程还缺少具体量化的理论依据,为了给液体旋流分离器的设计提供理论依据,通过液体旋流分离器从水中分离固体粒子的性能实验,得出了液体旋流分离器各部结构尺寸、形状、相对比例对分离效率的不同影响程度,提出了结构参数的最佳取值范围.按照本研究提出的设计原则和方法,可以制造出性能优良的液体旋流分离器.     

中国省域森林公园旅游产业竞争力的时空演化特征及影响因素

分析我国各省森林公园旅游产业竞争力演变及其影响因素,有助于为处于不同发展阶段和不同发展水平的省份提供产业竞争力方面的指导。首先构建我国港澳台外31省（市、自治区）森林公园的旅游产业竞争力指标体系,然后计算各省旅游产业竞争力得分并分析其时空演变特征,最后采用分位数回归研究影响森林公园旅游产业竞争力空间差异的主要因素。结果表明：中国森林公园旅游产业平均竞争力值较低,区域差异较大,呈现东部向中西部递减的状态;2004~2014年期间西部各省森林公园旅游产业竞争力进步较小,主要原因是受到“短板效应”的制约,表现为西部各省在产业效益方面与东、中部省份存在较大差距;中国的森林公园存在东北和东南两个高层次旅游产业竞争力集聚中心,并存在逐渐向周边地区扩散,带动周边省份提升发展的趋势;回归表明,国家扶持力度、管理投入、资源禀赋、经济基础、品牌效应和交通便利性会在不同分位点上对各省森林公园旅游产业竞争力产生影响。森林公园旅游产业竞争力在不同分位点上影响因素的差异为有针对性的提高各地区竞争力提供了良好的参考。     

Increasing collaboration between China and India in the environmental sciences to foster global sustainability

As the two largest countries by population, China and India have pervasive effects on the ecosphere. Because of their human population size and long international boundary, they share biodiversity and the threats to it, as well as crops, pests and diseases. We ranked the two countries on a variety of environmental challenges and solutions, illustrating quantitatively their environmental footprint and the parallels between them regarding the threats to their human populations and biodiversity. Yet we show that China and India continue to have few co-authorships in environmental publications, even as their major funding for scientific research has expanded. An agenda for collaboration between China and India can start with the shared Himalaya, linking the countries’ scientists and institutions. A broader agenda can then be framed around environmental challenges that have regional patterns. Coordinated and collaborative research has the potential to improve the two countries’ environmental performance, with implications for global sustainability.     

切圆燃烧煤粉炉的空气分级燃烧改造

阐述了分级燃烧抑制NOx形成的基本原理,介绍了切圆燃烧煤粉炉的空气分级燃烧改造的基本特点,考察了轴向和径向空气分级、炉内空气浓度等因素对NOx排放量的影响;控制适当条件,使脱氮效率达到30％－50％,对煤粉炉的空气分级燃烧改造进行了费用效益分析。     

可用于水体污染控制的氨氮转化菌筛选及部分降解特性的实验研究

从南京禄口水产养殖基地淡水鱼塘取淤泥作为分离菌株的土源,采用选择性富集培养法,从中分离到能以硫酸铵为氮源的菌株7株,对7个菌株进行氨氮降解实验,它们氨氮转化率分别为14.8%、19.7%、53.4%、94.2%、29.1%、63.5%和41.7%,其中AN-4菌株的转化率最高且生长良好。通过AN-4菌株16S rRNA基因序列分析以及生理生化方法,鉴定此菌株为克雷伯氏菌属(Klebsiellasp.)。对菌株AN-4转化氨氮的特性及温度、pH值、氨氮初始浓度和菌株接种量对其氨氮转化率的影响研究,结果表明,菌株AN-4降解氨氮的最适条件为:温度为30℃和pH值为8.0;当氨氮初始浓度为30mg/L时,AN-4菌株在24 h内的氨氮降解率可达85%以上,且能耐受高达200 mg/L的氨氮浓度;AN-4活化菌液浓度为108cfu/mL,当接种量为3×106cfu/mL时,AN-4菌株在24 h内的氨氮降解率为87.75%。综合上述结果,符合淡水养殖水环境条件,说明AN-4菌株适合在水产养殖中应用,为将菌株AN-4应用于水产养殖环境修复提供了理论依据。     

H2O2处理酸性大红GR染料废水的研究

通过对废水pH值、H2O2用量、催化剂用量、反应时间、反应温度等工艺条件的考察,确定了H2O2催化氧化处理酸性大红染料废水的最佳工艺条件pH 4、H2O2用量6 mL/L、催化剂用量3 g/L、反应时间100 min、反应温度70℃.在该条件下,COD和色度的去除率分别为76.7%和99.4%;通过反应前后的紫外-可见光光谱分析表明,H2O2催化氧化处理酸性大红GR染料废水有比较好的效果,为该工艺处理酸性大红GR染料废水提供了科学依据.     

污水深度处理流程对污染物去除效果评价方法

城市污水再生处理流程大多采用几种深度处理单元组合而成,由单个处理单元对污染物的去除效果来准确评价组合流程整体的处理效率对于工艺方案的确定和实际运行具有重要意义。在对处理过程中污染物浓度分布变化分析的基础上,建立了污水深度处理流程污染物去除效果的评价分析方法,并根据3种常用再生处理单元的实验结果,以总大肠菌群为例,评价了混凝沉淀过滤与生物活性炭和超滤联用处理流程对总大肠菌群的去除效果,计算结果表明,这种评价分析方法是准确可行的。