Anthropogenic influence on surface water quality of the Nhue and Day sub-river systems in Vietnam

In order to investigate the temporal and spatial variations of 14 physical and chemical surface water parameters in the Nhue and Day sub-river systems of Vietnam, surface water samples were taken from 43 sampling sites during the dry and rainy seasons in 2007. The results were statistically examined by Mann–Whitney U-test and hierarchical cluster analysis. The results show that water quality of the Day River was significantly improved during the rainy season while this was not the case of the Nhue River. However, the river water did not meet the Vietnamese surface water quality standards for dissolved oxygen (DO), biological oxygen demand (BOD₅), chemical oxygen demand (COD), nutrients, total coliform, and fecal coliform. This implies that the health of local communities using untreated river water for drinking purposes as well as irrigation of vegetables may be at risk. Forty-three sampling sites were grouped into four main clusters on the basis of water quality characteristics with particular reference to geographic location and land use and revealed the contamination levels from anthropogenic sources.     

Rice straw-base power generation: a potential and economic cost–benefit analysis for a small power plant (10 MWe) in Vietnam

Journal of Material Cycles and Waste Management - The main objective of the study is to explore the economic feasibility of power generation from rice straw, a potential biomass energy resource, in...     

Bioavailability evaluation of naphthalene in soil using persulfate oxidation and ultrasonic extraction method

Bioavailability is defined as the fraction of a soil contaminant readily available for microbial degradation and for naphthalene it could be estimated by conventional exhaustive extraction methods. In this study, a novel method that employed persulfate oxidation in combination with ultrasonic extraction (POUSE) was developed. Three parameters, temperature, duration of persulfate oxidation, and the ratio of persulfate to soil organic matter (2S,082 /SOM; g g-1), were investigated to obtain an optimum operating conditions. Under the condition, naphthalene bioavailability estimated by the POUSE method was verified and compared with other three exhaustive methods i.e. sonicator, supercritical fluid extraction (SFE), and soxhlet extraction (SE). When the S2,O(8)2-/SOM ratio was controlled at 11.6 g g-1, the optimum operating conditions of the POUSE method were 70 degreesC and 3 hr, for the temperature and duration. Under these conditions, the residual naphthalene concentrations were correlated well with the residual naphthalene concentrations for both the cases of freshly spiked and aged soils. By contrast, the sonicator, SFE, and the SE overestimated the naphthalene bioavailability since these three methods extracted naphthalene much more than that of biodegradation test. These results demonstrated that the POUSE could estimate more precisely the naphthalene bioavailability.     

Lead contamination in surface soil on roads from used lead–acid battery recycling in Dong Mai,Northern Vietnam

Used lead–acid battery (ULAB) recycling has caused numerous health and environmental issues in developing countries. Surface soil pollution from ULAB recycling activities has been linked with elevated levels of lead in human blood. We measured surface soil lead in and surrounding the ULAB recycling village of Hung Yen in northern Vietnam in 2011, 2013, and 2014. The data were analyzed statistically and discussed with respect to distance from the contamination source, year of measurement, contamination pathway, and countermeasures against the contamination. Transportation routes from the smelter or collection site displayed the greatest concentration of surface soil lead (median 6400–10,000 mg/kg). Surface soil lead decreased significantly with distance along the road from the ULAB recycling site, although such a decrease was not observed for rice fields, agricultural roads, or garden soil. Re-suspension and adherence by traffic were identified as key pollution pathways. Distance from the source, covering of the surface of roads, construction of walls, and position relative to the source were shown to be the most effective factors in the reduction of surface soil lead pollution. Application of a combination of these measures should result in improvement in the health of residents.     

Plastic waste as a valuable resource: strategy to remove heavy metals from wastewater in bench scale application

Environmental Science and Pollution Research - Single-use plastic waste is gradually considered a potential material for circular economy. Ion exchange resin obtained from polystyrene waste by...     

Assessment of some water quality parameters in the Red River downstream,Vietnam by combining field monitoring and remote sensing method

Environmental Science and Pollution Research - The Red River is the largest river in northern Vietnam, and it serves as the main water source for production and human activities in the Red River...     

Protection of the vehicle cab environment against bacteria, fungi and endotoxins in composting facilities

Microbial quality of air inside vehicle cabs is a major occupational health risk management issue in composting facilities. Large differences and discrepancies in protection factors between vehicles and between biological agents have been reported. This study aimed at estimating the mean protection efficiency of the vehicle cab environment against bioaerosols with higher precision. In-cab measurement results were also analysed to ascertain whether or not these protection systems reduce workers' exposure to tolerable levels. Five front-end loaders, one mobile mixer and two agricultural tractors pulling windrow turners were investigated. Four vehicles were fitted with a pressurisation and high efficiency particulate air (HEPA) filtration system. The four others were only equipped with pleated paper filter without pressurisation. Bacteria, fungi and endotoxins were measured in 72 pairs of air samples, simultaneously collected inside the cab and on the outside of the cab with a CIP 10-M sampler. A front-end loader, purchased a few weeks previously, fitted with a pressurisation and high efficiency particulate air (HEPA) filtration system, and with a clean cab, exhibited a mean protection efficiency of between 99.47% CI 95% [98.58-99.97%] and 99.91% [99.78-99.98%] depending on the biological agent. It is likely that the lower protection efficiency demonstrated in other vehicles was caused by penetration through the only moderately efficient filters, by the absence of pressurisation, by leakage in the filter-sealing system, and by re-suspension of particles which accumulated in dirty cabs. Mean protection efficiency in regards to bacteria and endotoxins ranged between 92.64% [81.87-97.89%] and 98.61% [97.41-99.38%], and between 92.68% [88.11-96.08%] and 98.43% [97.44-99.22%], respectively. The mean protection efficiency was the lowest when confronted with fungal spores, from 59.76% [4.19-90.75%] to 94.71% [91.07-97.37%]. The probability that in-cab exposure to fungi exceeded the benchmark value for short-term respiratory effects suggests that front-end loaders and mobile mixers in composting facilities should be fitted with a pressurisation and HEPA filtration system, regardless of whether or not the facility is indoors or outdoors. Regarding the tractors, exposure inside the cabs was not significantly reduced. However, in this study, there was a less than 0.01% risk of exceeding the bench mark value associated with fungi related short-term respiratory effects during an 1-h per day windrow turning operation. Pressurisation and a HEPA filtration system can provide safe working conditions inside loaders and mobile mixer with regard to airborne bacteria, fungi and endotoxins in composting facilities. However, regular thorough cleaning of the vehicle cab, as well as overalls and shoes cleaning, and mitigation of leakage in the filter-sealing system are necessary to achieve high levels of protection efficiency.     

Surface functional characteristics (C, O, S) of waste tire-derived carbon black before and after steam activation

The effects of steam activation on the surface functional characteristics of waste tire-derived carbon black were investigated. Two carbon-based materials, powdered carbon black (PCB) and PCB-derived powdered activated carbon (PCB-PAC), were selected for this study. A stainless steel tubular oven was used to activate the PCB at an activation temperature of 900 degrees C and 1 atm using steam as an activating reagent. X-ray photoelectron spectroscopy (XPS) was adopted to measure the surface composition and chemical structure of carbon surface. Various elemental spectra (C, O, and S) of each carbon sample were further deconvoluted by peak synthesis. Results showed that the surfaces of PCB and PCB-PAC consisted mainly of C-C and C-O. The PCB-PAC surface had a higher percentage of oxygenated functional groups (C=O and O-C=O) than PCB. The O1s spectra show that the oxygen detected on the PCB surface was mainly bonded to carbon (C-O), whereas the oxygen on the PCB-PAC surface could be bonded to hydrogen (O-H) and carbon (C-O). Sulfur on the surface of PCB consisted of 58.9 wt% zinc sulfide (ZnS) and 41.1 wt% S=C=S, whereas that on the surfaces of PCB-PAC consisted mainly of S=C=S. Furthermore, the increase of oxygen content from 9.6% (PCB) to 11.9% (PCB-PAC) resulted in the increase of the pH values of PCB-PAC after steam activation.     

Primary biosorption mechanism of lead (II) and cadmium (II) cations from aqueous solution by pomelo (Citrus maxima) fruit peels

Environmental Science and Pollution Research - The present work investigates the primary adsorption mechanisms of lead (II) and cadmium (II) cations onto pomelo fruit peel (PFP) from aqueous...     

皇天畈试验场地下水的砷、铁污染及自净作用

研究了中国水稻研究所皇天畈试验场被砷、铁污染的地下深井水的自净作用。结果表明,其自净机制是地下深井水抽出地面后,由于体系的氧化还原势瞬时提高,Fe~(2+)氧化成Fe~(3+),As~(3+)氧化成As~(5+)。Fe~(3+)水解后,形成Fe(OH)_3,并聚合,水中的As~(5+)被氢氧化铁吸附后,形成共沉淀,沉降在底部。实验证明,若提高深井水的氧化势,则能加速自净的进程。