Utilization of a fumigated sediment by two benthic deposit-feeders:Abra alba (Mollusca: Bivalvia) andEupolymnia nebulosa (Annelida: Polychaeta)

The present study tested the utilization of dead microbial biomass by two benthic deposit-feeders:Abra alba (Wood) (Mollusca: Bivalvia) andEupolymnia nebulosa (Montagu) (Annelida: Polychaeta). Clams were collected in the Canet lagoon during spring 1989. Worms were collected in the Port-Vendres harbour during spring 1989. The¹⁴C-labelled (glutamic acid, 24 h) sediment used during the study was sterilized with 1% chloroform, washed with sterile seawater, and dried (60°C; 48 h). This sterilisation procedure, called fumigation is the least harmful to the sediment (Novitsky 1986). Both clams and worms were incubated in the presence of the fumigated sediment for 5, 10, 20, and 50 h. At the end of each experiment we recorded the radioactivity in four compartments: (1) sediment, (2) dissolved organic matter (DOM), (3) CO₂, and (4) animals. The radioactivity of the sediment was subdivided into five fractions: (i) soluble in 2N HCl, (ii) soluble in hot 5% trichloroacetic acid (TCA), (iii) soluble in 1N NaOH, (iv) soluble in hot 6N HCl, (v) residual (after combustion in a Leco carbon analyser). In the first set of experiments, after 20 h of incubation, 5.4 and 4.7% of the total radioactivity was taken up by clams and worms, respectively. However, a model revealed that this uptake could have been correlated with the release of radiolabelled DOM (33% of total radioactivity during the first 5 h). In order to test this assumption, we used the same protocol with three additional washes of the fumigated sediment. This resulted in a significantly lower uptake by the clams (1.9% of the total radioactivity byt = 50 h), whereas the worms exhibited an uptake similar to that in the initial experiment (5.1% of total radioactivity byt = 50 h). These results underline the importance of considering interactions with DOM when applying radiotracer techniques to the study of benthic food chains. The average ingestion rates of fumigated sediment byA. alba andE. nebulosa were 5.2 10^–2 mg sediment dry wt mg^–1 clam h^–1 and 3.5 10^–2 mg sediment dry wt mg^–1 worm h^–1, respectively, which is comparable to previous data reported for other deposit-feeding bivalves and polychaetes feeding on natural sediment or detritus. The low radioactivity recorded for CO₂ together with the similarity of the changes in the partitioning of the radioactivity within the sediment between control experiments and experiments carried out in the presence of clams or worms suggest low assimilation efficiencies. Therefore, the present study supports the fact that dead microbial biomass does not constitute an important food source for benthic deposit-feeders.     

Temperature acclimation of respiration and photosynthesis in the brown algaLaminaria saccharina

Sporophytes of the brown algaLaminaria saccharina (L.) Lamour grown at 15°C contained significantly more chlorophylla (chla) than did similar plants grown at 5°C. The increase in chla in 15°C plants was due to increased numbers of photosystem II reaction centes, and possibly to increased photosynthetic unit size, compared with 5°C plants. These changes were associated with increased values (photosynthetic efficiencies) in 15°C-grownL. saccharina relative to 5°C-grown plants. The changes in together with reduced respiration rates allowed 15°C-grownL. saccharina to achieve net photosynthesis and light-saturated photosynthesis at a lower photon fluence rate (PFR) than 5°C plants when both groups were assayed at the same temperature (15°C). The photon fluence rates necessary to reach the compensation point and achieve light-saturated photosynthesis (I _c andI _k , respectively) increased with increasing incubation temperature inL. saccharina grown at both 5 and 15°C. However, acclimation responses to growth temperature compensated for the short-term effect of temperature onI _c andI _k . Consequently, plants grown at 5 and 15°C were able to achieve similar rates of light-limited photosynthesis, and similarI _c andI _k values at their respective growth temperatures. These responses are undoubtedly important for perennial seaweeds such asL. saccharina, which frequently grow in light-limited habitats and experience pronounced seasonal changes in water temperature.Please address all correspondence and requests for reprints to I.R. Davison     

Effects of elevated CO2 concentration on the polyamine levels of field-grown soybean at three O3 regimes

Effects of increased ozone (O3) and carbon dioxide (CO2) on polyamine levels were determined in soybean (Glycine max L. Merr. cv. Clark) grown in open-top field chambers. The chamber treatments consisted of three O3 regimes equal to charcoal filtered (CF), non-filtered (NF), and non-filtered plus 40 nl litre(-1) O3 and CO2 treatments equal to 350, 400 and 500 microl litre(-1) for a total of nine treatments. Leaf samples were taken at three different times during the growing season. Examination of growth and physiological characteristics, such as photosynthesis, stomatal resistance, and shoot weight, revealed that increasing CO2 ameliorated the deleterious effects of increased O3. Results from the initial harvest, at the pre-flowering growth stage (23 days of treatment), showed that increasing O3 at ambient CO2 caused increases in putrescine (Put) and spermidine (Spd) of up to six-fold. These effects were lessened with increased CO2. Elevated CO2 increased polyamines in plants treated with CF air, but had no effect in the presence of ambient or enhanced O3 levels. Leaves harvested during peak flowering (37 days of treatment) showed O3-induced increases in Put and Spd at ambient CO2 concentrations. However, increased CO2 levels inhibited this response by blocking the O3-induced polyamine increase. Leaves harvested during the pod fill stage (57 days of treatment) showed no significant O3 or CO2 effects on polyamine levels. Our results demonstrate that current ambient O3 levels induce the accumulation of Put and Spd early in the growing season and that further increases in O3 could result in even greater polyamine increases. These results are consistent with a possible antiozonant function for polyamines. The ability of increased CO2 to protect soybeans from O3 damage, however, does not appear to involve polyamine accumulation.     

Effect of mecoprop drift on some plant species of conservation interest when grown in standardized mixtures in microcosms

There has been an increasing awareness of potential impacts of herbicide drift on to vegetation in nature reserves and field margin habitats adjacent to treated areas. Previous work using single species bioassays has suggested that the effects of a single drift event are confined close to the sprayer (< 10 m). In the present study eight native dicotyledonous species, with and without a perennial grass (Lolium perenne), were grown in standardized microcosms in order to study (1) the effects of herbicide drift where plants were exposed to competition, and (2) the effects of a second spray application. The microcosms were arranged downwind (0-8 m) of a standard agricultural sprayer applying mecoprop at recommended rates. The effects of the herbicide drift on foliar symptoms of plant damage and end-of-season yield were assessed in each of two years. The main conclusions were that (1) growth of Stachys sylvatica and Lolium perenne (where sown) was enhanced near the sprayer and, (2) six other species (Digitalis purpurea, Galium mollugo, Hypericum hirsutum, Lychnis flos-cuculi, Primula veris and Ranunculus acris) showed some evidence of reduction in either performance (assessed non-destructively after a single exposure) or yield after two exposures. Three species (Lychnis flos-cuculi, Primula veris and Ranunculus acris) showed a reduction in flowering performance. Thus, mecoprop drift affected the aesthetic appearance, possibly the fecundity of some species and the balance between species in these microcosm experiments. The implications of these results for the persistence of attractive plant communities in sensitive areas are discussed.     

Recycling of petroleum-contaminated sand

The environmental impact of using petroleum-contaminated sand (PCS) as a substitute in asphalt paving mixtures was examined. An appreciable component of PCS is oily sludge, which is found as the dregs in oil storage tanks and is also produced as a result of oil spills on clean sand. The current method for the disposal of oily sludge is land farming. However, this method has not been successful as an oil content of < 1% w/w is required, and difficulty was encountered in reaching this target. The reuse of the sludge in asphalt paving mixtures was therefore considered as an alternative. Standard tests and environmental studies were conducted to establish the integrity of the materials containing the recycled sludge. These included physical and chemical characterization of the sludge itself, and an assessment of the mechanical properties of materials containing 0%, 5%, 22% and 50% oily sludge. The blended mixtures were subjected to special tests, such as Marshall testing and the determination of stability and flow properties. The experimental results indicated that mixtures containing up to 22% oily sludge could meet the necessary criteria for a specific asphalt concrete wearing course or bituminous base course. To maximize the assay from the recycled material, the environmental assessment was restricted to the 50% oily sludge mixture. Leachates associated with this particular mixture were assayed for total organic residue and certain hazardous metal contaminants. The results revealed that the organics were negligible, and the concentrations of the metals were not significant. Thus, no adverse environmental impact should be anticipated from the use of the recycled product. Our research showed that the disposal of oily sludge in asphalt paving mixtures could possibly yield considerable savings per tonne of asphalt concrete, and concurrently minimize any direct impact on the environment.     

Follow-up to environmental impact assessment: Learning from the Canadian Government experience

The environmental impact assessment procedure for Canadian federal government projects is briefly described. In the non-legislated Canadian system, follow-up to assessments is one of the major means of encouraging and improving the implementation of environmental impact assessment and the quality of environmental work done around development projects. The results of a study on the status of follow-up in the Canadian Government are presented. Factors that limit and that are conducive to follow-up are discussed. The effectiveness of follow-up depends as much on the circumstances surrounding a project and the concerned parties as on the follow-up techniques used; both of these aspects can be addressed in the planning and management of follow-up and of environmental impact assessment overall. Areas for improving the management of follow-up are identified and discussed: planning of follow-up activities, coordination of concerned parties, generation of clear understandings, information management, resource allocation, and maintenance of credibility. A method for planning follow-up activities for specific projects is presented.     

Soil sampling and analysis for volatile organic compounds

Concerns over data quality have raised many questions related to sampling soils for volatile organic compounds (VOCs). This paper was prepared in response to some of these questions and concerns expressed by Remedial Project Managers (RPMs) and On-Scene Coordinators (OSCs). The following questions are frequently asked:

1. Is there a specific device suggested for sampling soils for VOCs?
2. Are there significant losses of VOCs when transferring a soil sample from a sampling device (e.g., split spoon) into the sample container?
3. What is the best method for getting the sample from the split spoon (or other device) into the sample container?
4. Are there smaller devices such as subcore samplers available for collecting aliquots from the larger core and efficiently transferring the sample into the sample container?
5. Are certain containers better than others for shipping and storing soil samples for VOC analysis?
6. Are there any reliable preservation procedures for reducing VOC losses from soil samples and for extending holding times?

Guidance is provided for selecting the most effective sampling device for collecting samples from soil matrices. The techniques for sample collection, sample handling, containerizing, shipment, and storage described in this paper reduce VOC losses and generally provide more representative samples for volatile organic analyses (VOA) than techniques in current use. For a discussion on the proper use of sampling equipment the reader should refer to other sources (Acker, 1974; U.S. EPA, 1983; U.S. EPA, 1986a). Soil, as referred to in this report, encompasses the mass (surface and subsurface) of unconsolidated mantle of weathered rock and loose material lying above solid rock. Further, a distinction must be made as to what fraction of the unconsolidated material is soil and what fraction is not. The soil component here is defined as all mineral and naturally occurring organic material that is 2 mm or less in size. This is the size normally used to differentiate between soils (consisting of sands, silts, and clays) and gravels. Although numerous sampling situations may be encountered, this paper focuses on three broad categories of sites that might be sampled for VOCs:

1. Open test pit or trench.
2. Surface soils (<5 ft in depth).
3. Subsurface soils (>5 ft in depth).

     

Optimal and suboptimal control of anaerobic digesters

Anaerobic digester failure due to entry of inhibitors or sudden changes in the feed substrate concentration may be encompassed beneficially by applying optimal control theory. An almost proportional relationship between the dilution rate and the methane production rate leads to a simple suboptimal control law with only minor loss in performance, after the occurrence of the above mentioned events.