Polycyclic aromatic hydrocarbons in the bulk precipitation and surface waters of Northern Greece

Bulk (wet and dry) precipitation and surface water sampling was undertaken in the main plain of central Macedonia in Northern Greece. Fourteen polycyclic aromatic hydrocarbons (PAHs) included in the US EPA's priority pollutant list were analysed. The concentrations determined in bulk precipitation were in general within the range of values worldwide reported. Concentrations were highest in the cold months. Deposition fluxes of PAHs were of the same order of magnitude as reported data. The greatest values were found when high concentrations of PAHs in precipitation coincided with large precipitation amounts. The concentrations of PAHs in surface waters (main rivers, tributaries, ditches, etc) were in general lower than those in bulk precipitation, and among the lowest reported for European rivers, excepting Np and Ph. Bulk deposition and domestic effluents are suggested as being the main PAH sources into surface waters.     

Nitrogen oxides from waste incineration: control by selective non-catalytic reduction

An experimental study of the selective non-catalytic reduction (SNCR) process was carried out to determine the efficiency of NOx removal and NH3 mass balance, the NOx reducing reagent used. Experimental tests were conducted on a full-scale SNCR system installed in a hospital waste incineration plant. Anhydrous NH3 was injected at the boiler entrance for NOx removal. Ammonia was analyzed after each flue-gas treatment unit in order to establish its mass balance and NH3 slip in the stack gas was monitored as well. The effective fraction of NH3 for the thermal NOx reduction was calculated from measured values of injected and residual NH3. Results show that a NOx reduction efficiency in the range of 46.7-76.7% is possible at a NH3/NO molar ratio of 0.9-1.5. The fraction of NH3 used in NOx removal was found to decrease with rising NH3/NO molar ratio. The NH3 slip in the stack gas was very low, below permitted limits, even at the higher NH3 dosages used. No direct correlation was found between the NH3/NO molar ratio and the NH3 slip in the stack gas since the major part of the residual NH3 was converted into ammonium salts in the dry scrubbing reactor and subsequently collected in the fabric filter. Moreover, another fraction of NH3 was dissolved in the scrubbing liquor.     

Mechanisms of lead, copper, and zinc retention by phosphate rock

The solid-liquid interface reaction between phosphate rock (PR) and metals (Pb, Cu, and Zn) was studied. Phosphate rock has the highest affinity for Pb, followed by Cu and Zn, with sorption capacities of 138, 114, and 83.2 mmol/kg PR, respectively. In the Pb-Cu-Zn ternary system, competitive metal sorption occurred with sorption capacity reduction of 15.2%, 48.3%, and 75.6% for Pb, Cu, and Zn, respectively compared to the mono-metal systems. A fractional factorial design showed the interfering effect in the order of Pb>Cu>Zn. Desorption of Cu and Zn was sensitive to pH change, increasing with pH decline, whereas Pb desorption was decreased with a strongly acidic TCLP extracting solution (pH = 2.93). The greatest stability of Pb retention by PR can be attributed to the formation of insoluble fluoropyromorphite [Pb(10)(PO(4))(6)F(2)], which was primarily responsible for Pb immobilization (up to 78.3%), with less contribution from the surface adsorption or complexation (21.7%), compared to 74.5% for Cu and 95.7% for Zn. Solution pH reduction during metal retention and flow calorimetry analysis both supported the hypothesis of retention of Pb, Cu, and Zn by surface adsorption or complexation. Flow calorimetry indicated that Pb and Cu adsorption onto PR was exothermic, while Zn sorption was endothermic. Our research demonstrated that PR can effectively remove Pb from solutions, even in the presence of other heavy metals (e.g. Cu, Zn).     

A multi-process phytoremediation system for removal of polycyclic aromatic hydrocarbons from contaminated soils

To improve phytoremediation processes, multiple techniques that comprise different aspects of contaminant removal from soils have been combined. Using creosote as a test contaminant, a multi-process phytoremediation system composed of physical (volatilization), photochemical (photooxidation) and microbial remediation, and phytoremediation (plant-assisted remediation) processes was developed. The techniques applied to realize these processes were land-farming (aeration and light exposure), introduction of contaminant degrading bacteria, plant growth promoting rhizobacteria (PGPR), and plant growth of contaminant-tolerant tall fescue (Festuca arundinacea). Over a 4-month period, the average efficiency of removal of 16 priority PAHs by the multi-process remediation system was twice that of land-farming, 50% more than bioremediation alone, and 45% more than phytoremediation by itself. Importantly, the multi-process system was capable of removing most of the highly hydrophobic, soil-bound PAHs from soil. The key elements for successful phytoremediation were the use of plant species that have the ability to proliferate in the presence of high levels of contaminants and strains of PGPR that increase plant tolerance to contaminants and accelerate plant growth in heavily contaminated soils. The synergistic use of these approaches resulted in rapid and massive biomass accumulation of plant tissue in contaminated soil, putatively providing more active metabolic processes, leading to more rapid and more complete removal of PAHs.     

An assessment of endocrine disrupting activity changes during wastewater treatment through the use of bioassays and chemical measurements.

The objective of this study was to assess the removal efficiencies of secondary wastewater treatment processes for compounds causing endocrine disrupting activity. The study used bioassays and chemical measurements, such as gas chromatography with mass spectrometry and enzyme immunosorbent assays. A total of seven full-scale water reclamation facilities using different unit operations and two pilot-scale membrane bioreactors were examined. Findings of this study imply that estrogenic disrupting activity in primary effluent is mainly caused by two steroidal hormones (17beta-estradiol and estriol) and, to a lesser extent, by synthetic chemicals, such as bisphenol A, 4-nonylphenol, and 4-tert-octylphenol. During secondary treatment, steroidal hormones were removed to a higher degree than nonylphenol and bisphenol A. The total estrogenic activity was removed by an average of 96%. The remaining concentrations of targeted steroids in secondary effluents, except for estriol, still had the potential to elicit a positive response in the human breast cell cancer assay. For the majority of facilities, the remaining activity was likely attributed to residual concentrations of two steroidal hormones (17beta-estradiol and estriol).     

Ecological literacy and beyond: Problem-based learning for future professionals

Ecological science contributes to solving a broad range of environmental problems. However, lack of ecological literacy in practice often limits application of this knowledge. In this paper, we highlight a critical but often overlooked demand on ecological literacy: to enable professionals of various careers to apply scientific knowledge when faced with environmental problems. Current university courses on ecology often fail to persuade students that ecological science provides important tools for environmental problem solving. We propose problem-based learning to improve the understanding of ecological science and its usefulness for real-world environmental issues that professionals in careers as diverse as engineering, public health, architecture, social sciences, or management will address. Courses should set clear learning objectives for cognitive skills they expect students to acquire. Thus, professionals in different fields will be enabled to improve environmental decision-making processes and to participate effectively in multidisciplinary work groups charged with tackling environmental issues.     

Multivariate statistical and GIS-based approach to identify heavy metal sources in soils

The knowledge of the regional variability, the background values and the anthropic vs. natural origin for potentially harmful elements in soils is of critical importance to assess human impact and to fix guide values and quality standards. The present study was undertaken as a preliminary survey on soil contamination on a regional scale in Piemonte (NW Italy). The aims of the study were: (1) to determine average regional concentrations of some heavy metals (Cr, Co, Ni, Cu, Zn, Pb); (2) to find out their large-scale variability; (3) to define their natural or artificial origin; and (4) to identify possible non-point sources of contamination. Multivariate statistic approaches (Principal Component Analysis and Cluster Analysis) were adopted for data treatment, allowing the identification of three main factors controlling the heavy metal variability in cultivated soils. Geostatistics were used to construct regional distribution maps, to be compared with the geographical, geologic and land use regional database using GIS software. This approach, evidencing spatial relationships, proved very useful to the confirmation and refinement of geochemical interpretations of the statistical output. Cr, Co and Ni were associated with and controlled by parent rocks, whereas Cu together with Zn, and Pb alone were controlled by anthropic activities. The study indicates that background values and realistic mandatory guidelines are impossible to fix without an extensive data collection and without a correct geochemical interpretation of the data.