Ziziphus spina-christi leaf extract attenuates mercuric chloride-induced liver injury in male rats via inhibition of oxidative damage

Environmental Science and Pollution Research - Heavy metal contamination including mercury (Hg) has become one of the most serious environmental problems facing humans and other living organisms....     

Identification of Sources of Phoenix Aerosol by Positive Matrix Factorization

ABSTRACT

Chemical composition data for fine and coarse particles collected in Phoenix, AZ, were analyzed using positive matrix factorization (PMF). The objective was to identify the possible aerosol sources at the sampling site. PMF uses estimates of the error in the data to provide optimum data point scaling and permits a better treatment of missing and below-detection-limit values. It also applies nonnegativity constraints to the factors. Two sets of fine particle samples were collected by different samplers. Each of the resulting fine particle data sets was analyzed separately. For each fine particle data set, eight factors were obtained, identified as (1) biomass burning characterized by high concentrations of organic carbon (OC), elemental carbon (EC), and K; (2) wood burning with high concentrations of Na, K, OC, and EC; (3) motor vehicles with high concentrations of OC and EC; (4) nonferrous smelting process characterized by Cu, Zn, As, and Pb; (5) heavy-duty diesel characterized by high EC, OC, and Mn; (6) sea-salt factor dominated by Na and Cl; (7) soil with high values for Al, Si, Ca, Ti, and Fe; and (8) secondary aerosol with SO₄ ^-2 and OC that may represent coal-fired power plant emissions.

For the coarse particle samples, a five-factor model gave source profiles that are attributed to be (1) sea salt, (2) soil, (3) Fe source/motor vehicle, (4) construction (high Ca), and (5) coal-fired power plant. Regression of the PM mass against the factor scores was performed to estimate the mass contributions of the resolved sources. The major sources for the fine particles were motor vehicles, vegetation burning factors (biomass and wood burning), and coal-fired power plants. These sources contributed most of the fine aerosol mass by emitting carbonaceous particles, and they have higher contributions in winter. For the coarse particles, the major source contributions were soil and construction (high Ca). These sources also peaked in winter.     

Effect of using limestone fines on the chemical shrinkage of pastes and mortars

Environmental Science and Pollution Research - The main aim of this study is to examine the effect of incorporating limestone fine (LF) on chemical shrinkage of pastes and mortars. For this...     

Nasreya: a treatment and disposal facility for industrial hazardous waste in Alexandria, Egypt: phase I.

A facility for the treatment and disposal of industrial hazardous waste has been established in Alexandria, Egypt. Phase I of the facility encompassing a secure landfill and solar evaporation ponds is ready to receive waste, and Phase II encompassing physico-chemical treatment, solidification, and interim storage is underway. The facility, the Nasreya Centre, is the first of its kind in Egypt, and represents the nucleus for the integration, improvement and further expansion of different hazardous waste management practices and services in Alexandria. It has been developed within the overall legal framework of the Egyptian Law for the Environment, and is expected to improve prospects for enforcement of the regulatory requirements specified in this law. It has been developed with the overall aim of promoting the establishment of an integrated industrial hazardous waste management system in Alexandria, serving as a demonstration to be replicated elsewhere in Egypt. For Phase I, the Centre only accepts inorganic industrial wastes. In this respect, a waste acceptance policy has been developed, which is expected to be reviewed during Phase II, with an expansion of the waste types accepted.     

Assessment of spatial variation of ambient volatile organic compound levels at a power station in Kuwait

Twenty-four-hour integrated ambient air samples were collected in canisters at 10 locations within Kuwait’s major power station: Doha West Power Station to assess the spatial distribution of volatile organic compounds (VOCs) within the perimeter of the station. A total of 30 samples, i.e., three samples per location, were collected during February and March. The samples were analyzed using a gas chromatography with flame ionization detection (GC-FID) system and following the U.S. EPA Method TO-14A with modification. The results reflected the emission activities on the site and the meteorological conditions during sampling. Generally speaking, there was a negative correlation between the ambient temperature and the VOC concentrations, which indicates the sources were local. The halogenated compounds formed the highest proportion (i.e. 50–75 %) of the total VOC concentrations at the ten locations. 1,2,4-Trichlorobenzene and Vinyl Chloride concentrations were the highest amongst the other halogenated compounds. The aromatic compounds formed the least proportion (i.e. 1–4%) of the total VOC levels at all locations with Toluene having the highest concentrations amongst the aromatic compounds at seven locations. Propene, which is a major constituent of the fuel used, was the highest amongst the aliphatic compounds. The findings of this study and other relevant work suggests the measured VOC levels were the highest over the year, nevertheless, further work is required to assess the precisely temporal variation of VOC due to change in meteorological conditions and the emission rates.

Implications: Assessment of VOC concentrations around a power plant in Kuwait during the peak season showed halogenated compounds to be the dominant group. The calculated indoor concentrations were lower than those reported in a residential area about 12 km away.     

Effect of some xenobiotics on kynurenine hydrolase and kynurenine aminotransferase of mouse liver

The effects of some xenobiotics on the activity of the B6-dependent kynurenine hydrolase (KH) and kynurenine aminotransferase (KATE) in mouse liver, were investigated. Polychlorinated biphenyl (Aroclor 1254) (400mg/kg/day x4) markedly decreased the activity of both enzymes. Benzo(a)pyrene (BP) and 3-methylcholanthrene (3-MC) (40mg/Kg/day x1) as well as phenobarbital (PB) (75mg/kg/day x3) did not alter the activity of KH, while that of KATE was mildy reduced. The response of the two enzymes to treatment with chlorpromazine (CPZ) (5mg/Kg/day x5) were opposite with marked elevation of KH and inhibition of KATE activities. Treatment with B-naphthoflavone (B-NF) (80mg/Kg/day x2), Pyrazole (200mg/Kg/day x1) or indole (400mg/kg/day x1) produce no change in the activity of either enzyme. It, seems therefore, that Aroclor (1254) and chlorpromazine may cause disordered kynurenine metabolism through alterations in the activities of its metabolizing enzymes. This, in turn, might affect nicotinamide adenine dinucleotide biosynthesis and/or the accumulation of some tryptophan metabolites suspected of being carcinogenic or co-carcinogenic.     

Inhalation exposure to volatile organic compounds in the printing industry

ABSTRACT

This study reports on the occupational inhalation exposure to VOCs of workers in the Kuwaiti printing industry. Using the evacuated canister methodology, we targeted 72 VOCs in three printeries and compared the concentrations to previous reports and relevant occupational exposure levels (OELs). We found that recent efforts in the printing industry to reduce VOC usage had been successful, as concentrations of key hazardous VOCs were substantially lower than anticipated. On the other hand, nearly all target VOCs were found. Non-production areas were sampled along with the offset printing areas, another strength of this study, and revealed exposures to hazardous VOCs among administers and digital printer and CTP operators. Exposure to ototoxic VOCs amounted to 1–3% of the OEL, consisting mostly of ethylbenzene, which was likely in use in two of the study printeries. Exposure to carcinogenic or probably carcinogenic VOCs was 15–20% of the OEL at four locations across the three printeries, consisting mostly of vinyl chloride and benzyl chloride. Vinyl chloride VOC was partially sourced from outdoors, but was also likely used inside the study printeries. Interestingly, concentrations of vinyl chloride were similar in most sampling locations to that of CFC-114, a CFC banned by the Montreal Protocol and not commonly used as a refrigerant. This unexpected finding suggests further study is warranted to identify the use of these VOCs in printeries. Exposure to hazardous VOCs up to nearly 50% of the OEL, consisting largely of bromoform and vinyl chloride. Bromoform was found in all the study printeries, sourced partially from outdoor air. The higher concentrations found inside the study printeries likely resulted from the use of the desalinated water for washing. This finding raises of emissions from sources other than blanket washes, and inks, etc. adding to the total VOC load in printery indoor air.

Implications: Results from this study indicate that efforts to reduce worker exposure to VOCs particularly dangerous to human health in recent years have been successful, but there is still much to be done to protect workers. Exposures to ototoxic and carcinogenic VOCs were identified, among both production and non-production workers. Unexpected findings included the apparent use in printing activities of the carcinogen vinyl chloride and CFC-114, banned under the Montreal Protocol. Observed lapses in safety procedures included failure to utilize ventilation systems and closing doors between work areas, indicating management and worker education should remain a priority.     

Monitoring of bisphenol A diglycidyl ether (BADGE) and some derivatives in fish products in the Turkey market

The exposure to bisphenols and their derivatives was assessed in 33 fish products sold in Turkey using high-performance liquid chromatography-tandem mass spectrometry (LC–MS/MS). BADGE was determined in only four samples at concentrations ranging between 0.06 and 0.22 mg/kg. As the most abundant bisphenol groups, BADGE-hydrolyzed products such as BADGE·H₂O and BADGE·2H₂O were present in nine and fourteen samples in the range between 0.06–0.16 and 0.06–0.72 mg/kg, respectively. The total concentration of BADGE and hydrolyzed products was below the specific migration limit (SML) value of 9 mg/kg food, which in the European Union stated as tolerable. Chlorinated derivatives of BADGE were detected in fewer samples compared with hydrolyzed ones. BADGE·H₂O·HCl was the predominant migrant among chlorinated derivatives and was present in seven samples in a range between 0.02 and 0.06 mg/kg. All other samples contained less than or equal to 0.03 mg/kg of BADGE·HCl and BADGE·2HCl. The sum of these derivatives was lower than the SML value (1 mg/kg) of BADGE chlorohydrins legislated by the European Union. Besides these migrants, the analyzed samples did not contain any BFDGE and 3R-NOGE, which are prohibited in manufacturing food contact materials.