Evaluation of Regenerative-air Vacuum Street Sweeping on Geological Contributions to PM10

Street sweeping is often proposed as a means of reducing the emissions from paved roads. The objective of this study was to evaluate the effectiveness of street sweeping on ambient particulate matter concentrations and to determine the difference In source contributions to PM10 concentrations between street sweeping and non-street sweeping periods.

Chemically-speciated measurements of PM10 and PM2.5 were taken in the commercial section of Reno, Nevada, for a one-month sampling period. The Chemical Mass Balance (CMB) model was applied to these data and an average of approximately 50 percent of the PM10 was apportioned to resuspended geological material. During half of the sampling period, streets In the vicinity of the sampling site were completely swept with a regenerative-air vacuum sweeper, while no sweeping was performed during the remainder of the experiment. Ratios of primary geological contributions divided by primary motor vehicle contributions to PM10 were compared between sweeping and non-sweeping periods using analysis of variance. This ratio of source contributions minimizes the effects of variations in traffic volume and meteorological dispersion. No significant differences in geological contributions to PM10 were detected as a result of regenerative-air vacuum street sweeping.     

Evaluation of the Use of Solar Irradiation for the Decontamination of Soils Containing Wood Treating Wastes

Laboratory evaluation of the efficacy of soil phase photodegradation of recalcitrant hazardous organic components of wood treating wastes is described. The photodecomposition of anthracene, biphenyl, 9H-carbazole, m-cresol, dibenzofuran, fluorene, pentachlorophenol, phenanthrene, pyrene and quinoline under UV and visible light was monitored over a 50-day reaction period in three test soils. Methylene blue, riboflavin, hydrogen peroxide, peat moss and diethylamine soil amendments were evaluated as to their effect on the enhancement of compound photoreaction rates in the test soil systems. Dark control samples monitored over the entire study period were utilized to quantify non-photo mediated reaction losses. Compounds losses in both the dark control and irradiated samples were found to follow first order kinetics, allowing the calculation of first order photodegradation reaction rate constants for each test soil/compound combination. Degradation due to photochemical activity was observed for all test compounds, with compound photolytic half-lives ranging from 7 to approximately 180 days. None of the soil amendments were found to improve soil phase photodegradation, although photosensitization by anthracene was shown to significantly enhance the rate of photodegradation of the other test compounds. Soil type, and its characteristic of internal reflectance, proved to be the most significant factor affecting compound degradation rates suggesting the necessity for site specific assessments of soil phase photodegradation potential.     

Assessment of Needs for Technical Information in EPA’s Hazardous and Solid Waste Programs

Headquarters managers and Regional staff in the U.S. Environmental Protection Agency’s hazardous and solid waste programs were surveyed to determine priorities for technical information and guidance among EPA Regional staff, state hazardous waste management staff, EPA contractors, and the regulated community. The survey also examined delivery systems effective for EPA Regional staff. The fifteen highest ranked technical needs for RCRA, Superfund, and UST reflect a pervasive interest in hazardous waste remediation. Top priority technical needs focus on establishing cleanup levels, subsurface fate and transport, field monitoring and quality assurance, remedy selection, and most importantly, which remedies work and which do not in specific situations. Technical needs of non- EPA audiences are quite similar to those for EPA field staff. Preferences for technology transfer delivery systems are generally for conventional distribution methods (such as print materials and workshops) rather than electronic or video media. Regional staff report serious problems in utilizing technology transfer because of time constraints, insufficient knowledge of available products, insufficient travel funds, and limited access to and training on computers.     

Polymers as Solid Waste in Municipal Landfills

Abstract

Synthetic polymers reach municipal landfills as components of products such as waste household paints, packaging films, storage containers, carpet fibers, and absorbent sanitary products. Some polymers in consumer products that reach landfills are designed to photodegrade or biodegrade. This article examines the significance of degradable polymers in management of solid waste in municipal landfills. Most landfills are not designed to photodegrade or biodegrade solid waste. Landfill disposal of stable polymers such as polyacrylics and polyethylenes is not associated with significant polymer degradation or mobility. Stability to photodegradation and biodegradation is an advantage when municipal landfills are used for disposal of polymer products as solid waste. Use of landfill disposal can be a responsible means to manage polymer waste and can be part of an overall waste management plan which includes source reduction, recycling, reuse, composting, and waste-to-energy incineration.     

Effectiveness of Smokeless Ashtrays

Abstract

Most environmental tobacco smoke (ETS) issues from the tips of smoldering cigarettes between puffs. Smokeless ashtrays are designed to reduce ETS exposure by removing particulate and/or gas-phase contaminants from this plume. This paper describes an experimental investigation of the effectiveness of four smokeless ashtrays: two commercial devices and two prototypes constructed by the authors. In the basic experimental protocol, one or more cigarettes was permitted to smolder in a room. Particulate or gas-phase pollutant concentrations were measured in the room air over time. Device effectiveness was determined by comparing pollutant concentrations with the device in use to those obtained with no control device. A lung deposition model was applied to further interpret device effectiveness for particle removal. The commercial ashtrays were found to be substantially ineffective in removing ETS particles because of the use of low-quality filter media and/or the failure to draw the smoke through the filter. A prototype ashtray using HEPA filter material achieved better than 90% particle removal efficiency. Gasphase pollutant removal was tested for only one prototype smokeless ashtray, which employed filters containing activated carbon and activated alumina. Removal efficiencies for the 18 gas-phase compounds measured (above the detection limit) were in the range of 70 to 95%.     

Air Pollution and Mortality: Issues and Uncertainties

Abstract

Results from 31 epidemiology studies linking air pollution with premature mortality are compared and synthesized. Consistent positive associations between mortality and various measures of air pollution have been shown within each of two fundamentally different types of regression studies and in many variations within these basic types; this is extremely unlikely to have occurred by chance. In this paper, the measure of risk used is the elasticity, which is a dimensionless regression coefficient defined as the percentage change in the dependent variable associated with a 1% change in an independent variable, evaluated at the means. This metric has the advantage of independence from measurement units and averaging times, and is thus suitable for comparisons within and between studies involving different pollutants. Two basic types of studies are considered: time-series studies involving daily perturbations, and cross-sectional studies involving longer-term spatial gradients. The latter include prospective studies of differences in individual survival rates in different locations and studies of the differences in annual mortality rates for various communities.

For a given data set, time-series regression results will vary according to the seasonal adjustment method used, the covariates included, and the lag structure assumed. The results from both types of cross-sectional regressions are highly dependent on the methods used to control for socioeconomic and personal lifestyle factors and on data quality. Amajor issue for all of these studies is that of partitioning the response among collinear pollution and weather variables. Previous studies showed that the variable with the least exposure measurement error may be favored in multiple regressions; assigning precise numerical results to a single pollutant is not possible under these circumstances. We found that the mean overall elasticity as obtained from timeseries studies for mortality with respect to various air pollutants entered jointly was about 0.048, with a range from 0.01 to 0.12. This implies that about 5% of daily mortality is associated with air pollution, on average. The corresponding values from population-based cross-sectional studies were similar in magnitude, but the results from the three recent prospective studies varied from zero to about five times as much. Long-term responses in excess of short-term responses might be interpreted as showing the existence of chronic effects, but the uncertainties inherent in both types of studies make such an interpretation problematic.     

Mapping Odor Sources from Complaint Statistics I: Identifying the Major Source

Odor is acknowledged as a major community air pollution nuisance, but the problems of analysis, particularly in Identifying the origin of odor, are also well recognised. One approach to the problem has been the development of computational schemes which use wind directions at the times of odor observations to locate the likely source of odor. An earlier technique, PONG, has now been superseded by a more sophisticated version, PONG2, which incorporates Gaussian plume modeling techniques. This paper describes the operation of PONG2 in the odor source mapping mode and provides an analysis of the Insensitivity of the technique to errors in input. Then, using specific Australian examples of community odor nuisance emanating from a large sewage treatment complex near Melbourne, and an irrigated golf course within metropolitan Darwin, the paper outlines the utility of PONG2 in resolving problem odor sources at a range of scales and levels of complexity.     

The Cost Estimation of Thermal and Catalytic Incinerators for the Control of VOCs

In an earlier paper, major commercially available incinerator technologies designed to treat dilute waste gas streams containing volatile organic compounds (VOCs) were described in a qualitative comparison. In addition, a simplified procedure was outlined through which important sizing parameters could be calculated given certain information about the waste gas. This paper describes the use of these parameters in developing a study (±30percent) cost estimate for the total capital investment and the total annual costs incurred in treating a waste stream of volatile organic compounds (VOCs). An illustrative problem used in the former paper is completed here in order to contrast some of the economic differences between thermal and catalytic incinerator systems.     

Maximum Ground-Level Concentrations with Downwash

Equations are derived from the Gaussian plume mode! and prescribe the critical downwind distance, wind speed, and plume rise values that result in maximum ground-level concentrations (MGLC) under downwash conditions. The derivations apply to bent-over plumes and encompass the Schulman-Scire and Huber-Snyder building downwash treatments.