Optimization-Based Atmospheric Plume Source Identification

This work applies optimization and an Eulerian inversion approach presented by Bagtzoglou and Baun in 2005 in order to reconstruct contaminant plume time histories and to identify the likely source of atmospheric contamination using data from a real test site for the first time. Present-day distribution of an atmospheric contaminant plume as well as data points reflecting the plume history allow the reconstruction and provide the plume velocity, distribution, and probable source. The method was tested to a hypothetical case and with data from the Forest Atmosphere Transfer and Storage (FACTS) experiment in the Duke experimental forest site. In the scenarios presented herein, as well as in numerous cases tested for verification purposes, the model conserved mass, successfully located the peak of the plume, and managed to capture the motion of the plume well but underestimated the contaminant peak.     

A hybrid biological process of indoor air treatment for toluene removal

Bioprocesses, such as biofiltration, are commonly used to treat industrial effluents containing volatile organic compounds (VOCs) at low concentrations. Nevertheless, the use of biofiltration for indoor air pollution (IAP) treatment requires adjustments depending on specific indoor environments. Therefore, this study focuses on the convenience of a hybrid biological process for IAP treatment. A biofiltration reactor using a green waste compost was combined with an adsorption column filled with activated carbon (AC). This system treated a toluene-micropolluted effluent (concentration between 17 and 52 µg/m³), exhibiting concentration peaks close to 733 µg/m³ for a few hours per day. High removal efficiency was obtained despite changes in toluene inlet load (from 4.2 × 10^?3 to 0.20 g/m³/hr), which proves the hybrid system’s effectiveness. In fact, during unexpected concentration changes, the efficiency of the biofilter is greatly decreased, but the adsorption column maintains the high efficiency of the entire process (removal efficiency [RE] close to 100%). Moreover, the adsorption column after biofiltration is able to deal with the problem of the emission of particles and/or microorganisms from the biofilter.

ImplicationsIndoor air pollution is nowadays recognized as a major environmental and health issue. This original study investigates the performance of a hybrid biological process combining a biofilter and an adsorption column for removal of indoor VOCs, specifically toluene.     

Model projected heat extremes and air pollution in the eastern Mediterranean and Middle East in the twenty-first century

The eastern Mediterranean and Middle East, a region with diverse socioeconomic and cultural identities, is exposed to strong climatic gradients between its temperate north and arid south. Model projections of the twenty-first century indicate increasing hot weather extremes and decreasing rainfall. We present model results, which suggest that across the Balkan Peninsula and Turkey climate change is particularly rapid, and especially summer temperatures are expected to increase strongly. Temperature rise can be amplified by the depletion of soil moisture, which limits evaporative cooling, prompted by the waning of large-scale weather systems that generate rain. Very hot summers that occurred only rarely in the recent past are projected to become common by the middle and the end of the century. Throughout the region, the annual number of heat wave days may increase drastically. Furthermore, conditions in the region are conducive for photochemical air pollution. Our model projections suggest strongly increasing ozone formation, a confounding health risk factor particularly in urban areas. This adds to the high concentrations of aerosol particles from natural (desert dust) and anthropogenic sources. The heat extremes may have strong impacts, especially in the Middle East where environmental stresses are plentiful.     

Nutrient and enzymatic changes of hydrolysed tannery solid waste treated with epigeic earthworm Eudrilus eugeniae and phytotoxicity assessment on selected commercial crops

Animal fleshing (ANFL) is the predominant proteinaceous solid waste generated during processing of leather and it is confronting disposal problems. The aim of this study was to assess the potential of epigeic earthworm Eudrilus eugeniae to utilize and transform the fermented ANFL in the solid state (SSF) and submerged state (SmF) into a value added product along a low residence period (25 days). A total of six treatment units containing different waste mixture compositions were established. Fifty healthy and non-clitellated earthworms were introduced in three different treatment containers: control, SSF, and SmF (+worm). Another set of treatment mixtures (control, SSF, SmF) was established without earthworms (?worm) to compare the results. The products were characterized for physico-chemical, enzymatic analysis and seedling growth parameters to compare the differences in the process with and without earthworms. The changes observed in the analytical parameters were in the following order: SSF > SmF > control mixtures (p?<?0.05). The vermicompost showed a significant reduction in heavy metals, total organic carbon and an increase in total Kjeldhal nitrogen as compared to the product untreated by earthworms. The maximum enzymatic activities were observed after 21 days of vermicomposting. The relative seed germination of vermicompost extracts were in the order of tomato (Lycopersicon esculentum) > green gram (Vigna radiata) > cucumber (Cucumis sativus) > bottle gourd (Lagenaria siceraria (Mol.) Standl.) and showed no phytotoxicity effects. The results indicated that the combination of both ANFL hydrolysis through fermentation and vermicomposting is a good alternative to the management of this kind of waste.     

Determination of the utility of groundwater with respect to the geochemical parameters: a case study from Tuticorin District of Tamil Nadu (India)

In modern living, rapid development has created an increase in demand for groundwater. An endeavor has been made to understand the hydrogeochemical parameters to determine the utility of groundwater. This situation is severe in coastal hard rock aquifers due to the influence of salinity ingression and other anthropogenic influence. A total of 135 groundwater samples were collected from the coastal aquifer of the Tuticorin district and analyzed for major cations and anions during premonsoon (PRM) and postmonsoon (POM). The ions analyzed were used to determine the drinking, agricultural and domestic utility of groundwater. The electrical conductivity (EC) contour shows that the groundwater quality is poor along the coast. The parameters were compared with WHO (Guidelines for drinking water quality recommendations, WHO, Geneva, 2004) standard for drinking purpose. A groundwater classification method has been developed for groundwater in the area using a dynamic water quality index (WQI). On the basis of the WQI so computed, groundwater in the area has been spatially classified into “excellent,” “good,” “poor” and “very poor” to “Unsuitable” water types variation lithologywise. Corrosivity ratio and hardness were noted to be higher and found to be unsuitable in majority of the regions for domestic purpose. Higher fluoride concentration was noted in the central part of the study area represented by complex geology comprising of the hornblende biotite gneiss and charnockite. Sodium percentage (Na%), sodium absorption ratio, residual sodium carbonate, Wilcox (Classification and use of irrigation waters, US Department of Agriculture, Washington, 1955), permeability index, residual sodium bicarbonate, magnesium hazard, Kelly’s ratio and potential salinity also indicate that most of the groundwater samples are not suitable for irrigation purposes.     

Progress in High-Temperature Electrostatic Precipitation

Current-voltage relationships for negative corona are given for a pilot-scale electrostatic precipitator with 3-in. electrode spacing at 80°–1500°F and 35–80 psig. Direct comparison is made with the electrical characteristics for a 1-in. spacing at 1200°F over the same pressure range. Experimental results on both spacing agree well with electrostatic theory. Initial dust removal efficiencies for the pilot-scale precipitator ranged from 90 to 98% at 1460°F and 80 psig, but continuous operation was not achieved owing to excessive thermal expansion of the internal parts of the unit.     

A Multivariable Model for Atmospheric Dispersion Predictions

In conjunction with a 15-month air quality survey of Jacksonville, Fia., a mathematical model has been developed to describe the dispersion of atmospheric pollutants. The source inventory used with the model was compiled, in part, from the data obtained from the sampling of all major sources within the area. The major sources were considered separately from the one-mile square area sources which accounted for the remainder of the emissions. Meteorological data was recorded continuously in the city including vertical temperature observations to 750 ft. The model was compiled in FORTRAN and can be used for both gaseous and particulate pollutants, by utilizing proper decay rates. The variant nature of meteorological parameters and emission rates are considered. The ground level concentrations of several pollutants which were determined for 24 hr periods at 11 sites and continuously at two other sites were used to check the model. A limited tracer study was carried out in conjunction with the project.     

Investigation to Determine the Possible Need for a Regulation on Organic Compound Emissions from Stationary Sources in the San Francisco Bay Area

The problem of an investigation of the need for a regulation on organic compound emissions in the San Francisco Bay Area can be divided into two major areas: 1. Is there a need for a regulation on organic compound emissions? What is the extent of photochemical smog effects? How much control is necessary to achieve the desired effects?

2. (2) If the need exists for an organic compound regulation, can a performance type regulation be written for all types of organic compound emissions? Must the regulation be directed toward specific industries or types of emissions? Can the regulation be adequately enforced—both practically and legally?

This paper will describe the studies undertaken by the District Staff to answer the first set of questions. Work covering the second group of questions is now under investigation.     

enforcement of diesel smoke emissions for the state of new jersey

This paper reports on the research program undertaken by the State of New Jersey to determine those tests and instruments which can be used by authorized state agencies for the enforcement of diesel smoke emissions. The state agencies under consideration for the enforcement of diesel smoke emissions are the following: (1) The Division of Motor Vehicles, in its system of state owned inspection stations, will be able to inspect all diesel-powered trucks, and tractors which are registered in New Jersey. (2) The Public Utilities Commission will be able to inspect at their home garages all buses registered in the State. (3) The New Jersey State Police will be able to inspect diesel-powered vehicles on the road. It was decided that the maximum inspection time for each vehicle was not to exceed one minute. On the basis of the one minute per vehicle requirement, eight different tests were evaluated to determine which ones correlated well with normal vehicle operation. These tests included acceleration of a fixed external inertia, free acceleration of only the moving parts of the engine, three ramp tests, a test in which a heavy vehicle was towed, and a driving test in which the vehicle being tested was actually accelerated. The results of tests demonstrated that the modified free acceleration method correlates reasonably well with a loaded steady state cycle, distinguishes the high emitters and is simple to perform. Consequently, the free acceleration test method is recommended for use in inspection stations and on the road. Finally, nearly two hundred vehicles have been tested by this procedure to determine present and potential levels of diesel smoke emissions. Another phase of the program consisted of the determination of smoke measuring techniques and instrumentation. The use and design of smokemeters were extensively investigated, as well as the use of the visual and photographic techniques. Of the various smokemeters tested for this application, several measured smoke satisfactorily in the laboratory, but none were found adequate for field use; they either lacked portability or were unstable due to the deposition of soot on the optics. At the time of writing, specifications for the necessary smokemeter have been drafted and published for bid to interested manufacturers.     

The Number-Size Distribution of Atmospheric Particles During Temperature Inversions

Instruments capable of measuring in situ numbers of particles within specific size ranges covering a particle-diameter spectrum of approximately 0.001 – 10 microns have been employed to continuously monitor the concentration and size-distribution of atmospheric aerosols. The monitoring site was a television tower located on the boundary between Minneapolis and St. Paul, Minnesota. Air samples were drawn from 70, 170, and 500 feet above ground level and analyzed with optical, electrical, and condensation particle counters to obtain a number-size distribution within the 0.001 – 10 micron size range. In addition to the measurement of particle number and size, several micrometeorological parameters were simultaneously monitored. Particle number-size distributions which were measured during periods of temperature inversion are reported