Long-term variation of PM2.5 levels and composition at rural, urban, and roadside sites in Hong Kong: Increasing impact of regional air pollution

Long-term study of air pollution plays a decisive role in formulating and refining pollution control strategies. In this study, two 12-month measurements of PM_2.5 mass and speciation were conducted in 00/01 and 04/05 to determine long-term trend and spatial variations of PM_2.5 mass and chemical composition in Hong Kong. This study covered three sites with different land-use characteristics, namely roadside, urban, and rural environments. The highest annual average PM_2.5 concentration was observed at the roadside site (58.0±2.0 μg m⁻³ (average±2σ) in 00/01 and 53.0±2.7 μg m⁻³ in 04/05), followed by the urban site (33.9±2.5 μg m⁻³ in 00/01 and 39.0±2.0 μg m⁻³ in 04/05), and the rural site (23.7±1.9 μg m⁻³ in 00/01 and 28.4±2.4 μg m⁻³ in 04/05). The lowest PM_2.5 level measured at the rural site was still higher than the United States’ annual average National Ambient Air Quality Standard of 15 μg m⁻³. As expected, seasonal variations of PM_2.5 mass concentration at the three sites were similar: higher in autumn/winter and lower in summer. Comparing PM_2.5 data in 04/05 with those collected in 00/01, a reduction in PM_2.5 mass concentration at the roadside (8.7%) but an increase at the urban (15%) and rural (20%) sites were observed. The reduction of PM_2.5 at the roadside was attributed to the decrease of carbonaceous aerosols (organic carbon and elemental carbon) (>30%), indicating the effective control of motor vehicle emissions over the period. On the other hand, the sulfate concentration at the three sites was consistent regardless of different land-use characteristics in both studies. The lack of spatial variation of sulfate concentrations in PM_2.5 implied its origin of regional contribution. Moreover, over 36% growth in sulfate concentration was found from 00/01 to 04/05, suggesting a significant increase in regional sulfate pollution over the years. More quantitative techniques such as receptor models and chemical transport models are required to assess the temporal variations of source contributions to ambient PM_2.5 mass and chemical speciation in Hong Kong.     

Lock-release gravity currents propagating over roughness elements

Environmental Fluid Mechanics - The influence of bottom roughness on the development of lock-release gravity currents is investigated through laboratory experiments using Particle Image...     

Worldwide cases of water pollution by emerging contaminants: a review

Environmental Chemistry Letters - Water contamination by emerging contaminants is increasing in the context of rising urbanization, industrialization, and agriculture production. Emerging...     

Composition of plastics from waste electrical and electronic equipment (WEEE) by direct sampling

This paper describes a direct analysis study carried out in a recycling unit for waste electrical and electronic equipment (WEEE) in Portugal to characterize the plastic constituents of WEEE. Approximately 3400 items, including cooling appliances, small WEEE, printers, copying equipment, central processing units, cathode ray tube (CRT) monitors and CRT televisions were characterized, with the analysis finding around 6000 kg of plastics with several polymer types. The most common polymers are polystyrene, acrylonitrile-butadiene-styrene, polycarbonate blends, high-impact polystyrene and polypropylene. Additives to darken color are common contaminants in these plastics when used in CRT televisions and small WEEE. These additives can make plastic identification difficult, along with missing polymer identification and flame retardant identification marks. These drawbacks contribute to the inefficiency of manual dismantling of WEEE, which is the typical recycling process in Portugal. The information found here can be used to set a baseline for the plastics recycling industry and provide information for ecodesign in electrical and electronic equipment production.     

Perfluorinated compounds in the Pearl River and Yangtze River of China

A total of 14 perfluorinated compounds (PFCs) were quantified in river water samples collected from tributaries of the Pearl River (Guangzhou Province, south China) and the Yangtze River (central China). Among the PFCs analyzed, perfluorooctane sulfonate (PFOS) and perfluorooctanoic acid (PFOA) were the two compounds with the highest concentrations. PFOS concentrations ranged from 0.90 to 99 ng/l and <0.01–14 ng/l in samples from the Pearl River and Yangtze River, respectively; whereas those for PFOA ranged from 0.85 to 13 ng/l and 2.0–260 ng/l. Lower concentrations were measured for perfluorobutane sulfonate (PFBS), perfluorohexane sulfonate (PFHxS), perfluorooctanesulfoamide (PFOSA), perfluorohexanoic acid (PFHxA), perfluoroheptanoic acid (PFHpA), perfluorononaoic acid (PFNA), perfluorodecanoic acid (PFDA), and perfluoroundecanoic acid (PFUnDA). Concentrations of several perfluorocarboxylic acids, including perfluorododecanoic acid (PFDoDA), perfluorotetradecanoic acid (PFTeDA), perfluorohexadecanoic acid (PFHxDA) and perfluorooctadecanoic acid (PFOcDA) were lower than the limits of quantification in all the samples analyzed. The highest concentrations of most PFCs were observed in water samples from the Yangtze River near Shanghai, the major industrial and financial centre in China. In addition, sampling locations in the lower reaches of the Yangtze River with a reduced flow rate might serve as a final sink for contaminants from the upstream river runoffs. Generally, PFOS was the dominant PFC found in samples from the Pearl River, while PFOA was the predominant PFC in water from the Yangtze River. Specifically, a considerable amount of PFBS (22.9–26.1% of total PFC analyzed) was measured in water collected near Nanjing, which indicates the presence of potential sources of PFBS in this part of China. Completely different PFC composition profiles were observed for samples from the Pearl River and the Yangtze River. This indicates the presence of dissimilar sources in these two regions.     

Comparative studies on toluene removal and pressure drop in biofilters using different packing materials

To select the best available packing material for malodorous organic gases such as toluene and benzene, biofilter performance was compared in biofilters employed different packing materials including porous ceramic (celite), Jeju scoria (lava), a mixture of granular activated carbon (GAC) and celite (GAC/celite), and cubic polyurethane foam (PU). A toluene-degrading bacterium, Stenotrophomonas maltophilia T3-c, was used as the inoculum. The maximum elimination capacities in the celite, lava, and GAC/celite biofilters were 100, 130, and 110 gm(-3) hr(-1), respectively. The elimination capacity for the PU biofilter was approximately 350 g m(-3) hr(-1) at an inlet loading of approximately 430 g m(-3) hr(-1), which was 2 to 3.5 times higher than for the other biofilters. The pressure drop gradually increased in the GAC/ celite, celite and lava biofilters after 23 day due to bacterial over-growth, and the toluene removal efficiency remarkably decreased with increasing pressure drop. Backwashing method was not effective for the control of biomass in these biofilters. In the PU biofilter however, backwashing allowed maintenance of a pressure drop of 1 to 3 mm H2O m(-1) and a removal efficiency of > 80%, indicating that the PU was the best packing material for toluene removal among the packing materials tested.     

Seasonal variation in heavy metal contamination in water and sediments of river Sabarmati and Kharicut canal at Ahmedabad, Gujarat

The objective of the study is to reveal the seasonal variations in the river water and sediment quality with respect to heavy metal contamination. To get the extent of trace metals contamination, water and sediment samples were collected from five different sites along the course of Sabarmati River and its tributary Kharicut canal in pre-monsoon, monsoon and post-monsoon seasons. The concentration of trace metals such as chromium, copper, lead, nickel and zinc was determined using inductively coupled plasma spectroscopy. The concentrations of heavy metals were found to be higher in the pre-monsoon season than in the monsoon and post-monsoon seasons in water samples. The pollution load index, contamination factor and degree of contamination (C _d) in sediments were calculated to know the extent of anthropogenic pressures. The values of C _d clearly indicated very high degree of contamination at Kharicut canal (S-4: 32.25 and S-5: 54.52) and considerable degree of contamination at three sites of Sabarmati river viz; S-1, S-2 and S-3 with values 14.30, 14.42 and 17.21, respectively. Lead and nickel could not be traced in any of the river water samples.     

Vertical structure of very nearshore larval fish assemblages in a temperate rocky coast

Small-scale vertical patterns of larval distribution were studied at a very nearshore larval fish assemblage, during the spring–summer period of several years, at two depth strata (surface and bottom) using sub-surface and bottom trawls. A total of 4,589 larvae (2,016 from surface samples and 2,573 from bottom samples) belonging to 62 taxa included in 22 families were collected. Most larvae belonged to coastal species. Although inter-annual variations in larval density and diversity could be found, total larval abundance was always higher near the bottom whereas diversity was higher at the surface. A marked distinction between the structure of surface and bottom assemblages was found. Sixteen taxa explained 95% of the similarity among surface samples. Larvae which contributed most to this similarity included species like clupeiformes, sparids and serranids, and also blenniids, tripterygiids and some labrids. In the bottom samples, fewer species were present, with only six taxa, almost exclusively from species which lay demersal eggs, contributing to 95% of the similarity between samples. Larvae present at the surface were significantly smaller than at the bottom. For some of the most abundant species found at the bottom, only small larvae occurred at the surface while the whole range of sizes was present at the bottom, indicating that larvae may be completing the entire pelagic phase near the adults’ habitat. These results indicate that larval retention near the reefs probably occurs for these species, although for others dispersal seems to be the prevailing mechanism.