基于遥感反演长江中游地区悬浮泥沙研究

悬浮泥沙定量研究对于调查长江的水质、地貌、生态环境等起着至关重要的作用。以长江中游武汉地区2012~2013年14幅不同时相的Landsat ETM+遥感影像为主要数据源,结合野外采样悬浮泥沙浓度数据,分析了悬浮泥沙遥感定量反演方法,数据处理中针对ETM+SLC OFF影像缝隙问题,采用自适应局部回归匹配算法（ALR）进行影像自动恢复处理,在波段选择中对悬浮泥沙浓度和光谱反射率数据进行相关性分析,并运用传统关系建模方法和高斯模型方法对比,比较悬浮泥沙定量反演模型,利用实测验证数据对反演模型精度进行评估。研究结果表明：（1）ALR可以有效的获取悬浮泥沙敏感波段的遥感光谱反射率;（2）ETM+Band3悬浮泥沙浓度的高斯模型相关系数最高,通过对比得到模型反演的验证精度较高,研究证明遥感定量反演适合于长江流域武汉段泥沙含量大范围监测     

Development,validation, and application of a method for the GC-MS analysis of fipronil and three of its degradation products in samples of water,soil, and sediment

A method for the identification and quantification of pesticide residues in water, soil, and sediment samples has been developed, validated, and applied for the analysis of real samples. The specificity was determined by the retention time and the confirmation and quantification of analyte ions. Linearity was demonstrated over the concentration range of 20 to 120 µg L^?1, and the correlation coefficients varied between 0.979 and 0.996, depending on the analytes. The recovery rates for all analytes in the studied matrix were between 86% and 112%. The intermediate precision and repeatability were determined at three concentration levels (40, 80, and 120 µg L^?1), with the relative standard deviation for the intermediate precision between 1% and 5.3% and the repeatability varying between 2% and 13.4% for individual analytes. The limits of detection and quantification for fipronil, fipronil sulfide, fipronil-sulfone, and fipronil-desulfinyl were 6.2, 3.0, 6.6, and 4.0 ng L^?1 and 20.4, 9.0, 21.6, and 13.0 ng L^?1, respectively. The method developed was used in water, soil, and sediment samples containing 2.1 mg L^?1 and 1.2% and 5.3% of carbon, respectively. The recovery of pesticides in the environmental matrices varied from 88.26 to 109.63% for the lowest fortification level (40 and 100 µg kg^?1), from 91.17 to 110.18% for the intermediate level (80 and 200 µg kg^?1), and from 89.09 to 109.82% for the highest fortification level (120 and 300 µg kg^?1). The relative standard deviation for the recovery of pesticides was under 15%.     

Effects of TiO2 based photocatalytic paint on concentrations and emissions of pollutants and on animal performance in a swine weaning unit

The beneficial effect of a TiO2-based photocatalytic treatment on the indoor air purification of a swine farm has been evaluated in a trial performed in two identical mechanically ventilated traditional weaning units, with 391 animals lodged in each of them. One unit was used as reference, whereas the walls of the second unit (260 m2) were coated with ca. 70 g m(-2) of TiO2 and irradiated with ten UV-A lamps. The environmental parameters (i.e. the ventilation rate, the internal and external temperature and relative humidity), together with NH3, CH4, CO2 and N2O concentrations in the exhaust ducts and PM10 emissions, were monitored in the two units throughout all of the production cycle (75 days). Significant decreases in CH4 concentration (ca. 27%, P < 0.05) and PM10 emission (ca. 17%, P < 0.01) were observed, together with an increase of the piglets' productive performance in the treated unit with respect to the reference one. Indeed, the ADG (Average Daily Gain of piglets) was 424 g vs. 414 g for the piglets lodged in the two units, respectively, with a significantly better feed conversion ratio (FCR, ratio between the food ingested by the animals and their weight gain) of 2.18 vs. 2.44 (P < 0.001). Therefore, the photocatalytic treatment with TiO2 coating had positive effects not only on methane concentration and particulate matter concentration and emission, but also significantly improved the feed conversion ratio of growing piglets, very likely due to the increased quality of indoor air, with positive economic repercussions for the farmer. Internal photocatalytic treatment in swine husbandry could thus be considered as a potential Best Available Technology (BAT).     

Quantitative–spatial assessment of soil contamination in S. Francisco de Assis due to mining activity of the Panasqueira mine (Portugal)

Through the years, mining and beneficiation processes produces large amounts of As-rich mine wastes laid up in huge tailings and open-air impoundments (Barroca Grande and Rio tailings) that are the main source of pollution in the surrounding area once they are exposed to the weathering conditions leading to the formation of AMD and consequently to the contamination of the surrounding environments, in particularly soils. In order to investigate the environmental contamination impact on S. Francisco de Assis (village located between the two major impoundments and tailings) agricultural soils, a geochemical survey was undertaken to assess toxic metals associations, related levels and their spatial distribution, and to identify the possible contamination sources. According to the calculated contamination factor, As and Zn have a very high contamination factor giving rise to 65.4 % of samples with a moderate to high pollution degree; 34.6 % have been classified as nil to very low pollution degree. The contamination factor spatial distribution put in evidence the fact that As, Cd, Cu, Pb, and Zn soils contents, downstream Barroca Grande tailing, are increased when compared with the local Bk soils. The mechanical dispersion, due to erosion, is the main contamination source. The chemical extraction demonstrates that the trace metals distribution and accumulation in S. Francisco de Assis soils is related to sulfides, but also to amorphous or poorly crystalline iron oxide phases. The partitioning study allowed understanding the local chemical elements mobility and precipitation processes, giving rise to the contamination dispersion model of the study area. The wind and hydrological factors are responsible for the chemical elements transport mechanisms, the water being the main transporter medium and soils as one of the possible retention media.     

Traffic and catalytic converter - related atmospheric contamination in the metropolitan region of the city of Rio de Janeiro, Brazil

In this work, 24-h PM10 samples were collected in Rio de Janeiro, Brazil, and analysed for trace elements (Cd, Ce, Cu, La, Mo, Ni, Pb, Pd, Rh, Sb and Sn). The sampling was carried out at five locations (Bonsucesso; Centro, downtown city; Copacabana; Nova Igua?u and Sumaré) with different traffic densities and anthropogenic activities. An analytical method based on the EPA method for the determination of trace elements in airborne particulate matter (PM), using ultrasonic-assisted extraction and inductively coupled plasma mass spectrometry (ICP-MS) was applied. Our results suggest that vehicular traffic is the most important source of environmental pollution at the studied sites. The presence of Mo, Pd and Rh in the analysed filters reflects an additional source of pollution caused by the erosion and deterioration of automotive catalytic converters.     

Effect of modified Fenton treatment on the thermal behavior of contaminated harbor sediments

This study presents the results of experimental Fenton-like treatments conducted on marine sediment slurries (2g sediment vs. 20 ml liquid). The sediment was collected in a harbor situated in a high density industrial area, characterized by a great hydrocarbon C>12 and PAHs contamination. The investigated parameters were: the H(2)O(2) dose, the reagent's pH and the effect of a phosphate salt and ferrous iron addition. To evaluate sediment's characteristics COD, particle size, thermogravimetric and differential thermal analyses were performed under N(2) and O(2) atmosphere while dissolved organic carbon and COD analyses were performed on the filtrate. Results indicate that the treatment was able to change the organic matter to a less hydrophobic state, to destroy part of the organic carbon (up to 78% decrease of the 200-400 degrees C labile organic matter), to lower the COD of the sediment (60% COD removal maximum) and to increase the cumulated distribution undersize. In addition as the treated sediment showed easier-to-handle characteristics, reduced caking and lower aggregation capacity, the modified Fenton treatment could also be considered a pre-treatment of a successive thermal treatment.     

Discriminating the pH toxicity to Poecilia reticulata Peters, 1859 in the Dunas Lake (Camaçari, BA, Brazil)

Toxic potential of the pH reduction to fingerlings of Poecilia reticulata, through acute toxicity bioassays, as well as the influence of increased pH on the toxicity were assessed. Acid lake samples (Dunas Lake) were collected during 19 months, and assessed with following treatments: water at local pH (+/-3.0) and samples with modified pH to 3.5, 3.8, 4.0, 4.3, 4.6, 5.0, 5.5, 6.0, and 6.5. Culture water samples with pH reduced to 3.0 were also assessed. Newborn P. reticulata were exposed during 96h, and dead/immobile organisms were counted at various time intervals during exposure (short intervals in the beginning and long towards the end). Mean results of LT(50) and confidence intervals from the Dunas Lake and control water with reduced pH were 1.36 (+/-0.48)h, and 1.03 (+/-0.50)h, respectively, with no statistical difference. Samples with increased pH showed a significant reduction in toxicity, with no toxicity detected at pH 6.0 and higher. Relationship between pH and lethal toxicity for fingerlings of P. reticulata demonstrated that pH exerted a strong effect on the survival of this species at the Dunas Lake, explaining about 80% of the toxicity observed.     

Model approach for estimating potato pesticide bioconcentration factor

We presented a model that estimates the bioconcentration factor (BCF) of pesticides in potatoes supposing that the pesticide in the soil solution is absorbed by the potato by passive diffusion, following Fick's second law. The pesticides in the model are nonionic organic substances, traditionally used in potato crops that degrade in the soil according to a first-order kinetic equation. This presents an expression that relates BCF with the pesticide elimination rate by the potato, with the pesticide accumulation rate within the potato, with the rate of growth of the potato and with the pesticide degradation rate in the soil. BCF was estimated supposing steady state equilibrium of the quotient between the pesticide concentration in the potato and the pesticide concentration in the soil solution. It is suggested that a negative correlation exists between the pesticide BCF and the soil sorption partition coefficient. The model was built based on the work of Trapp et al. [Trapp, S., Cammarano, A., Capri, E., Reichenberg, F., Mayer, P., 2007. Diffusion of PAH in potato and carrot slices and application for a potato model. Environ. Sci. Technol. 41 (9), 3103-3108], in which an expression to calculate the diffusivity of persistent organic substances in potatoes is presented. The model consists in adding to the expression of Trapp et al. [Trapp, S., Cammarano, A., Capri, E., Reichenberg, F., Mayer, P., 2007. Diffusion of PAH in potato and carrot slices and application for a potato model. Environ. Sci. Technol. 41 (9), 3103-3108] the hypothesis that the pesticide degrades in the soil. The value of BCF suggests which pesticides should be monitored in potatoes.     

Mutagenic and recombinagenic activity of airborne particulates, PM10 and TSP, organic extracts in the Drosophila wing-spot test

The genotoxicity associated with air pollution in the city of Canoas, Rio Grande do Sul (Brazil), was assessed in November (spring) and January (summer). We applied the somatic mutation and recombination test (SMART) in Drosophila melanogaster in its standard version with normal bioactivation (ST) and in its variant with increased cytochrome P450-dependent biotransformation capacity (HB). The data indicated the genotoxicity of TSP and PM10 collected in November, in both ST and HB crosses. The genotoxic activity of the PM10 material in the spring sample was exclusively associated with the induction of mitotic recombination, whereas the TSP genetic toxicity was due to both recombinational as well as point and/or chromosomal mutation events. Considering PM10 collected in January, a positive response--100% (17.10 m3/ml) concentration--was observed in the HB cross, which was not detected in the ST cross.     

Urban daytime traffic noise prediction models

An evaluation was made of the acoustic environment generated by an urban highway using in situ measurements. Based on the data collected, a mathematical model was designed for the main sound levels (L _eq, L ₁₀, L ₅₀, and L ₉₀) as a function of the correlation between sound levels and between the equivalent sound pressure level and traffic variables. Four valid groups of mathematical models were generated to calculate daytime sound levels, which were statistically validated. It was found that the new models can be considered as accurate as other models presented in the literature to assess and predict daytime traffic noise, and that they stand out and differ from the existing models described in the literature thanks to two characteristics, namely, their linearity and the application of class intervals.