CULTURAL EVOLUTION AND WATER MANAGEMENT IN THE SALINAS RIVER VALLEY1

ABSTRACT: This article reports the findings of a case study of a major California water management district's effort to change its management approach. The following key findings and factors have influenced the Salinas basin management plan (BMP) and its progress: (1) the Salinas Valley is an economy dominated by highly sophisticated irrigated agriculture dependent on ground water; (2) a persistent pattern of agricultural overdraft of ground water has hurt growers primarily in the north end of the valley via induced saline intrusion of irrigation wells; (3) a complex set of water institutions, property and water rights, and land lease practices offer little incentive for good stewardship of land and water; and (4) the BMP approach initially may have intensified tension among growers and between growers and other water user groups. Water rules and practices in the Salinas Valley and Monterey County have evolved through a long historical process of adaptations. Therefore, any significant changes in local water use practices need to be understood in terms of cultural change, that is, changes in deeply held values, beliefs, and assumptions. We believe the BMP and the MCWRA are succeeding when evaluated from this evolutionary perspective. The fact that both still exist relatively intact testifies that they are working, albeit slowly.     

A practical approach to steam‐enhanced dual‐phase extraction: A case study

This article presents the results of a pilot test that was conducted to determine the effectiveness of using steam‐enhanced dual‐phase extraction (DPE) at a former industrial site in New York. The pilot test proved that steam‐enhanced DPE was very effective at removing significant contaminant mass from the subsurface in a relatively short time period. Concentrations of volatile organic compounds and semivolatile organic compounds in the vapor stream and groundwater were successfully reduced, in some cases by orders of magnitude. Based on the results of the steam‐enhanced DPE pilot test, the final remedy for the site includes implementing this technology at selected areas as an alternative to DPE alone or other remedial alternatives, such as excavation or groundwater pump and treat. © 2003 Wiley Periodicals, Inc.     

Re‐evaluation of treatment approach for a site contaminated with Freon‐113 and 1,1,1‐trichloroethane

This study demonstrates a remedial approach for completing the remediation of an aquifer contaminated with 1,1,2‐trichlorotrifluoroethane (Freon‐113) and 1,1,1‐trichloroethane (TCA). In 1987, approximately 13,000 pounds of Freon‐113 were spilled from a tank at an industrial facility located in the state of New York. The groundwater remediation program consisted of an extraction system coupled with airstripping followed by natural attenuation of residual contaminants. In the first phase, five recovery wells and an airstripping tower were operational from April 1993 to August 1999. During this time period over 10,000 pounds of CFC‐13 and 200 pounds of TCA were removed from the groundwater and the contaminant concentrations decreased by several orders of magnitude. However, the efficiency of the remediation system to recover residual Freon and/or TCA reduced significantly. This was evidenced by: (1) low levels (< 10 ppb) of Freon and TCA captured in the extraction wells and (2) a slight increase of Freon and/or TCA in off‐site monitoring wells. A detailed study was conducted to evaluate the alternative for the second‐phase remediation. Results of a two‐year groundwater monitoring program indicated the contaminant plume to be stable with no significant increase or decrease in contaminant concentrations. Monitored geochemical parameters suggest that biodegradation does not influence the fate and transport of these contaminants, but other mechanisms of natural attenuation (primarily sorption and dilution) appear to control the fate and transport of these contaminants. The contaminants appear to be bound to the soil matrix (silty and clay units) with limited desorption as indicated by the solid phase analyses of contaminant concentrations. Results of fate and transport modeling indicated that contaminant concentrations would not exceed the action levels in the wells that showed a slight increase in contaminant concentrations and in the downgradient wells (sentinel) during the modeled timeframe of 30 years. This feasibility study for natural attenuation led to the termination of the extraction system and a transaction of the property, resulting in a significant financial benefit for the original site owner. © 2003 Wiley Periodicals, Inc.     

WATERSHED OPTIMIZATION OF AGRICULTURAL BEST MANAGEMENT PRACTICES: CONTINUOUS SIMULATION VERSUS DESIGN STORMS1

ABSTRACT: Nonpoint source (NPS) models and expert opinions are often used to prescribe best management practices (BMPs) for controlling NPS pollution. An optimization algorithm (e.g., a genetic algorithm, or GA) linked with a NPS model (e.g., Annualized AGricultural Nonpoint Source pollution model, or AnnAGNPS), can be used to more objectively prescribe BMPs and to optimize NPS pollution control measures by maximizing pollutant reduction and net monetary return from a watershed. Pollutant loads from design storms and annual loads from a continuous simulation can both be used for optimizing BMP schemes. However, which strategy results in a better solution (in terms of providing water quality protection) for a watershed is not clear. The specific objective of the study was to determine the differences in watershed pollutant loads, in an experimental watershed in Pennsylvania, resulting from optimization analyses performed using pollutant loads from a series of five 2‐yr 24‐hr storm events, a series of five 5‐yr 24‐hr storm events, and cumulative pollutant loads from a continuous simulation of five years of weather data. For each of these three different event alternatives, 100 near optimal solutions (BMP schemes) were generated. Sediment (Sed), sediment nitrogen (SedN), dissolved N (SolN), sediment organic carbon (SedOC), and sediment phosphorus (SedP) loads from a different five‐year period (an evaluation period) suggest that the optimal BMP schemes resulting from the use of annual cumulative pollutant loads from a continuous simulation of five years of weather data provide smaller cumulative NPS pollutant loads at the watershed outlet.     

Historical pollution trends in coastal environments of India

Seventeen sediment cores were collected from different coastalecosystems of Tamil Nadu, India that include coastal lagoon (Pulicat), polluted rivers in Chennai (Adyar and Cooum), Coral reef (Gulf of Mannar) and a perennial river (Tamiraparani).Radiometric dating has been used to determine the modern sedimentation rates in these ecosystems. The Pulicat Lake and thepolluted rivers (Adyar and Cooum) yield an average sediment accumulation rate of 12.34 and 7.85 mm yr^-1, respectively. Inthe Gulf of Mannar coral reef, the sedimentation rate averages 17.37 mm yr^-1, while the rate in Tamiraparani River is 11.00 mm yr^-1. In the Tamiraparani River basin, the deposition rates were an order of magnitude higher when compared to the erosion rates, which may be due to bank erosion and the intense human activity. In general high rates of sedimentation observed in the coastal ecosystems not only reflect the capacity of the coastal regions as sinks for trace metals but also denoteincreased input of pollutants into the coastal environments in the recent past. The deposition rates of heavy metals – Fe, Mn,Zn, Cu, Cr and Ni in the depth profiles have been computed using sedimentation rates and their distribution is discussed. It can be seen that the mean deposition rates of all the measured elements in the Tamil Nadu coastal ecosystems are high compared with rates determined for the sediments of the deltaic regions ofIndia and the Bay of Bengal.     

Attachment behavior and health: relationships at work and home

This article examines the relationships between interpersonal attachment orientations, health, and social support. Four hypotheses specified relationships between three interpersonal attachment orientations (interdependent, counterdependent, and overdependent), physical and psychological symptoms, and social support. Data were collected from 297 students, the majority of whom were also full-time employees. An interdependent orientation was negatively related to social dysfunction. Counterdependent and overdependent orientations were negatively related to health. A counterdependent orientation was negatively related to social support, while an overdependent orientation was positively related to social support from co-workers and family. Copyright © 1999 John Wiley & Sons, Ltd.     

Efforts to Reduce Mortality to Hydroelectric Turbine-Passed Fish: Locating and Quantifying Damaging Shear Stresses

Severe fluid forces are believed to be a source of injury and mortality to fish that pass through hydroelectric turbines. A process is described by which laboratory bioassays, computational fluid dynamics models, and field studies can be integrated to evaluate the significance of fluid shear stresses that occur in a turbine. Areas containing potentially lethal shear stresses were identified near the stay vanes and wicket gates, runner, and in the draft tube of a large Kaplan turbine. However, under typical operating conditions, computational models estimated that these dangerous areas comprise less than 2% of the flow path through the modeled turbine. The predicted volumes of the damaging shear stress zones did not correlate well with observed fish mortality at a field installation of this turbine, which ranged from less than 1% to nearly 12%. Possible reasons for the poor correlation are discussed. Computational modeling is necessary to develop an understanding of the role of particular fish injury mechanisms, to compare their effects with those of other sources of injury, and to minimize the trial and error previously needed to mitigate those effects. The process we describe is being used to modify the design of hydroelectric turbines to improve fish passage survival.     

Suggested Guidelines for Use of Avian Species as Biomonitors

An animal’s suitability as a biomonitor of environmental change can be determined by biological, reproductive and ecological characteristics determined at the class, order and species level. The animal’s habitat where the research is to be performed and the form, function and structure of the environmental change being studied within that habitat also determines suitability. Non-threatened populations of large, non-migratory, long-lived, seasonally-breeding tertiary avian predators, whose dietary preferences are narrow and known, can be useful as monitors of environmental chemical contaminants. If chemicals are being monitored, a quantifiable endpoint effect must be demonstrated in the species, or a similar species under experimental laboratory conditions. Logistical and economic issues as well as public and regulatory authority acceptance should also be considered when assessing the suitability of a species as a biomonitor.     

Testing personal inhalable aerosol samplers: a suggested improved protocol based on new scientific knowledge

In 2002 the Comité Européen Normalisation (CEN) published its document Workplace atmospheres-assessment of performance of instruments for measurement of airborne particle concentrations (EN 13205) that describes a standard protocol by which to carry out the testing and validation of personal aerosol samplers of the type widely used for occupational aerosol exposure assessment. It emerged from more than a decade of discussion and a large body of research experience involving several laboratories. The protocol that is described, however, still poses significant technical and economic challenges, not least because it involves laborious-and hence costly-procedures in large, specialized wind tunnel facilities. More recent research has identified a number of areas by which the protocol may be improved and made more accessible to testing laboratories, including a set of validated aerosol sampler scaling laws, a better understanding of the reduced role of the bluff body of the wearer on sampler performance, and the availability of new options for rapid sampler testing methods. Taking these into account, a dummy new protocol is offered for discussion.