Iodine in the soils of North Derbyshire

Derbyshire was one of the best known centres of endemic goitre in Great Britain. Some 160 km from the coast in the direction of the prevailing wind, topsoils in the area are generally low in iodine (mean = 5.44 mg l/kg). Weathered rocks and soils are richer in iodine than the unweathered bedrocks, with soils developed over limestones being richer than those over sandstones, shales and dolomites. Highest iodine contents in soil profiles over limestones occur in the upper horizons while over sandstones, iodine concentrates in the lower horizons. The major cause of endemic goitre in north Derbyshire is likely to be relatively low levels of iodine, while the calcium rich soils of the area may contribute by reducing plant iodine uptake.     

The effect of limestone treatments on the rate of acid generation from pyritic mine gangue

Surface water enters the Haile Gold Mine, Lancaster County, South Carolina by means of a small stream and is ponded behind a dam and in an abandoned pit. This water is affected by acidic drainage. In spite of the large exposures of potentially acid producing pyritic rock, the flux of acid to the water is relatively low. Nevertheless, the resulting pH values of the mine water are low (around 3.5) due to negligible buffering capacity. In view of the observed low release of acidity, the potential for acid drainage abatement by limestone ameliorants appears feasible. This study investigated the effects of limestone treatment on acid generation rates of the Haile mine pyritic rocks through a series of leaching experiments. Below a critical alkalinity threshold value, solutions of dissolved limestone were found consistently to accelerate the rate of pyrite oxidation by varying degrees. The oxidation rates were further accelerated by admixing solid limestone with the pyritic rock. However, after a period of about a month, the pyrite oxidation rate of the admixed samples declined to a level lower than that of untreated pyrite. Leachates produced by the pyrite and limestone mixtures contained little if any iron. Further, in the mixtures, an alteration of the pyrite surface was apparent. The observed behaviour of the treated pyrite appears to be related to the immersion of the pyrite grains within a high alkalinity/high pH environment. The high pH increases the rate of oxidation of ferrous iron which results in a higher concentration of ferric iron at the pyrite surface. This, in turn, increases the rate of pyrite oxidation. Above a threshold alkalinity value, the precipitation of hydrous iron oxides at the pyrite surface eventually outpaces acid generation and coats the pyrite surface, retarding the rate of pyrite oxidation.     

Enhancement of batch waste activated sludge digestion by microwave pretreatment.

Batch anaerobic digesters were used to stabilize microwave (MW)-irradiated waste activated sludge (WAS). A low temperature range (50-96 degrees C) MW irradiation was applied. Effects of pretreatment temperature (T) and intensity (I), concentration (C) and percentage of sludge pretreated (PT) were investigated in a multilevel factorial statistical design containing 54 mesophilic batch reactors by monitoring cumulative biogas production (CBP). Variance analysis (ANOVA) determined that the most important factors affecting WAS solubilization were temperature, intensity, and sludge concentration. Improvements in CBP from WAS were significantly affected by sludge percentage pretreated, temperature, and concentration. Pretreatment resulted in 3.6 +/- 0.6 and 3.2 +/- 0.1 fold increases in soluble to total chemical oxygen demand (SCOD/TCOD) at high and low sludge concentrations, respectively. WAS, microwaved to 96 degrees C, produced the greatest improvement in CBP with 15 +/- 0.5 and 20 +/- 0.3% increases over controls after 19 d of digestion at low and high WAS concentrations. Dewaterability of microwaved sludge was enhanced after anaerobic digestion.     

Characterization of permanent fouling on the surfaces of UV lamps used for wastewater disinfection.

A significant problem with UV disinfection of wastewater is the accumulation of fouling materials at sleeve-water interfaces. It has been shown that automated chemical and/or mechanical cleaning can remove most fouling materials satisfactorily. However, permanent foulants, which cannot be removed completely by typical cleaning operations, always remain on the quartz sleeves. These permanent foulants reduce UV transmittance, in turn reducing disinfecting effectiveness. This research investigated the origins, formation, and composition of permanent fouling. Four instrumental analyses were used: atomic force microscope (AFM), X-ray fluorescence (XRF), scanning electron microscope combined with energy dispersive X-ray microanalysis (SEM/EDX), and sleeve UV transmittance (SUVT). It appeared that permanent foulants were trapped initially by microscale holes and peaks on fresh sleeve surfaces. Based on the topography and roughness measurements from the AFM, after long-term regular chemical and mechanical cleaning, the wipers of cleaning systems damage sleeve surfaces, creating scratches or holes with larger surface areas. Foulants are trapped more easily, and are attached tightly to the surfaces of these scratches or to each other. The results from XRF and SEM/EDX showed that the main fouling components were aluminum, iron, magnesium, calcium, and phosphorus. These could not be related to wastewater quality. For the specific cases studied, chemical plus mechanical cleaning is more effective in removing foulants and avoiding the accumulation of permanent foulants than mechanical cleaning alone; in most cases, SUVT was higher than 90% after chemical plus mechanical cleaning, whereas mechanical cleaning alone achieved only approximately 30% SUVT after long-term usage.     

Studies on the acute toxicity of fluoride ion to stickleback,fathead minnow,and rainbow trout

We have studied the acute toxicity of fluoride ion to $\text{Gasterosteus aculeatus}$, $\text{Pimephales promelas}$, and juvenile $\text{Salmo gairdneri}$. LC50 values varied with species and (due to precipitation) initial water hardness. Exposure to elevated fluoride levels in water resulted in increased blood fluoride levels in $\text{Salmo gairdneri}$.     

Environmentally stratified sampling design for the development of Great Lakes environmental indicators

Understanding the relationship between human disturbance and ecological response is essential to the process of indicator development. For large-scale observational studies, sites should be selected across gradients of anthropogenic stress, but such gradients are often unknown for a population of sites prior to site selection. Stress data available from public sources can be used in a geographic information system (GIS) to partially characterize environmental conditions for large geographic areas without visiting the sites. We divided the U.S. Great Lakes coastal region into 762 units consisting of a shoreline reach and drainage-shed and then summarized over 200 environmental variables in seven categories for the units using a GIS. Redundancy within the categories of environmental variables was reduced using principal components analysis. Environmental strata were generated from cluster analysis using principal component scores as input. To protect against site selection bias, sites were selected in random order from clusters. The site selection process allowed us to exclude sites that were inaccessible and was shown to successfully distribute sites across the range of environmental variation in our GIS data. This design has broad applicability when the goal is to develop ecological indicators using observational data from large-scale surveys.     

A classification of freshwater Louisiana lakes based on water quality and user perception data

An index system developed for Louisiana lakes was based on correlations between measurable water quality parameters and perceived lake quality. Support data was provided by an extensive monitoring program of 30 lakes coordinated with opinion surveys undertaken during summer 1984. Lakes included in the survey ranged from 4 to 735 km² in surface area with mean depths ranging from 0.5 to 8.0 m. Water quality data indicated most of these lakes are eutrophic, although many have productive fisheries and are considered recreational assets. Perception ratings of fishing quality and its associated water quality were obtained by distributing approximately 1200 surveys to Louisiana Bass Club Associaton members. The ability of Secchi disc transparency, total organic carbon, total Kjeldahl nitrogen, total phosphorus, and chlorophyll a to discriminate between perception classes was examined using probability distributions and multivariate analyses. Secchi disc and total organic carbon best reflected perceived lake conditions; however, these parameters did not provide the discrimination necessary for developing a quantitative risk assessment of lake trophic state. Consequently, an interim lakes index system was developed based on total organic carbon and perceived lake conditions. The developed index system will aid State officials in interpretating and evaluating regularly collected lake quality data, recognizing potential problem areas, and identifying proper management policies for protecting fisheries usage within the State.     

A plastic container for algal growth potential tests

The substitution of a six ounce plastic cup with snap-cap lid as a growth vessel for a standard algal growth potential test 125 ml glass Erlenmeyer flask has been evaluated. Included are a discussion of desired growth vessel characteristics and the relationship of seven day plastic cup algal growth to maximum (twelve to fourteen day) flask.     

Pollutant sources and flows in a municipal sewage system

The flow of heavy metals (Cu, Ni, Cr, Cd, Zn, Pb) and cyanide in the Kokomo, Indiana collection system and wastewater treatment plant is analyzed. The primary objective is to determine the relative contributions of domestic and non-domestic sources to the total pollutant load in the system, and to assess the levels of discharge control required for the disposal of municipal sludge by landfill or agricultural landspreading. Sampling was conducted at point source locations, in major sewer trunk-and feeder lines, and at the treatment plant. Production and waste treatment data are presented for point sources sampled for the purpose of characterizing metal and cyanide discharges as a function of these parameters. A heavy metal mass balance is attempted for the treatment plant. Metal removal factors are presented for various plant operations. A simple statistical approach is presented for the design of a cost-effective sampling program for correlating point source and trunkline pollutant sampling. The purpose is to minimize the amount of sampling required to account for pollutants seen in trunkline and treatment plant streams in terms of discharges from specific point sources.     

An assessment of the potential adverse properties of fluorescent tracer dyes used for groundwater tracing

The potential ecotoxicity of fluorescent dyes used in tracing, and their possible effects on human health, were evaluated by reviewing available toxicological information for 12 dyes — fluorescein, Lissamine Flavine FF, Rhodamine WT, Rhodamine B, Sulpho Rhodamine G, Sulpho Rhodamine B, eosin, pyranine, Phorwite BBH Pure, Tinopal 5BM GX, Tinopal CBS-X, and Diphenyl Brilliant Flavine 7GFF — and a dye-intermediate, amino G acid. This evaluation used available toxicological information, test data on analogous substances, and mathematical expressions for biological activity. Based on set criteria for human health and acute ecotoxicity, the evaluation indicated that these tracers have low to moderate levels of concern. The use of these tracers for the study of groundwater flow is appropriate if consideration is given to the overall human health and environmental effects. Their use in the environment requires tracer concentrations not exceeding 1–2 mg 1^–1 persisting for a period in excess of 24 h in the groundwater at the point of groundwater withdrawal or discharge. A simple calculated potential dose was used in a comparison of the estimated acute toxicity of Rhodamine WT in rats to the known acute oral toxic dose in humans for several known acutely toxic chemicals. This comparison showed that none of the fluorescent dyes evaluated would present an acutely toxic threat at or substantially above the recommended 2 mg 1^–1 concentration.The U.S. Governments right to retain a non-exclusive, royalty free licence in and to any copyright is acknowledged. Disclaimer: The views of this paper are solely those of the authors and do not necessarily reflect the views or policies of the U.S. Environmental Protection Agency.