高效脱硫菌的筛选及其性能研究

从高硫污染的活性污泥中富集培养,分离纯化得到一株可以降解噻吩的菌株s_4,并对该菌株的形态特征进行观察。应用Design—Expert8．0．5b软件进行响应面优化实验,研究了反应时间、噻吩浓度、微生物浓度3个因素的组合对菌株s_4脱硫效果的影响,并拟合得到多元二次回归方程,得出最佳实验条件。拟合结果表明,当反应时间27．46h,噻吩浓度为1．04％,微生物浓度4．04％时,预测噻吩降解率为14．8％,通过验证得最佳条件下的降解率为14．3％,与预测值相符。     

As（V）在金红石TiO2颗粒表面吸附特性及机理

通过静态动力学和热力学吸附实验,研究了温度、共存离子以及溶质的初始浓度对As（V）在金红石TiO2颗粒表面吸附的影响,探讨了As（V）在金红石TiO2颗粒表面吸附特性及机理。结果表明,在As（V）初始浓度为10mg／L,pH为7的条件下,25℃时的吸附量0．41mg／g高于30℃时的吸附量0．31mg／g,As（V）在金红石TiO,上的吸附为放热过程。CaCl2和MgCl2的添加对As（V）在金红石TiO2表面吸附起到明显的促进作用。T=25℃,Ca2＋或Mg2＋浓度为10mmol／L时,As（V）吸附量分别为0．64和0．56mg／g,Ca2＋比Mg2＋对As（V）吸附促进作用强。As（V）在金红石TiO2的吸附等温线符合Frendlich方程,Lagergren二级动力学方程能较好地描述As（V）在金红石TiO2颗粒表面吸附的动力学过程。     

西安市及周边地区MODIS气溶胶光学厚度与PM10浓度关系模型研究

西安是空气污染监控和防治有代表性的西部大型城市。研究了西安市及周边地区上空气溶胶光学厚度与PM10浓度的关系模型。利用2011—2012年MODIS卫星气溶胶光学厚度（AOD）遥感产品,通过数据匹配,利用地面气象观测站点的能见度数据和相对湿度数据对AOD产品进行垂直标高订正和湿度订正,2项订正显著提高了AOD和地面PM10浓度的相关性,相关系数从0．36提高到0．65,按季节分类统计和订正春至冬四季的相关系数分别为0．57、0．71、0．62和0．87,夏季和冬季的订正更为有效,可用性更高,这可能由于受到不同季节气溶胶来源和特征的影响。为研究中国西部大型城市,特别是西安市空气环境监测和区域联防联控提供了一种有效方法。     

Planning of methane emission control from hoggery using an inexact two-stage optimization model

This study aims to develop an inexact two-stage optimization model to gather manure distributed over the southwest Taiwan and convert it into bioenergy. In the method, local optimization of each hauling zone is performed first using a gray mixed-integer programming model. Then, the hauling zones are prioritized by its performance on four gray scenarios. Although the biogas yield and the manure generation rate are ambiguous, one can easily evaluate his opportunity and risk by gray interval, which is a group of values within the lower and upper bounds. The analyses reveal that the biogas yield dominates the profit in this project, and it leads to the failure of the project when the biogas yield is below the level of 0.2 m³ kg^?1. With the goal of reducing 45% of methane emissions from pig farms, seven hauling zones are required to be developed. The farmers living in these zones from the project get carbon credits ranging from 478 to 3269 ton CO_2eq per year, and the investors own the carbon credits in the range of 3264–11820 ton CO_2eq per year. Through the carbon trading, both the investors and pig farmers are able to make profits by trading their carbon credits.

Implications:Biogas recovered from hoggery can be used as a bioenergy source and mitigate the atmospheric greenhouse effect and global warming. This research develops an inexact two-stage optimization model to evaluate the potential of gathering manure for biogas and converting it into bioenergy. The analyses reveal that the biogas yield dominates the profit in this project, and it leads to the failure of the project when the biogas yield is below the level of 0.2 m³ kg^?1. This study has provided a useful reference for the management of biogas production and carbon trading from hoggery for bioenergy.     

Effects of water-emulsified fuel on a diesel engine generator’s thermal efficiency and exhaust

Water-emulsified diesel has proven itself as a technically sufficient improvement fuel to improve diesel engine fuel combustion emissions and engine performance. However, it has seldom been used in light-duty diesel engines. Therefore, this paper focuses on an investigation into the thermal efficiency and pollution emission analysis of a light-duty diesel engine generator fueled with different water content emulsified diesel fuels (WD, including WD-0, WD-5, WD-10, and WD-15). In this study, nitric oxide, carbon monoxide, hydrocarbons, and carbon dioxide were analyzed by a vehicle emission gas analyzer, and the particle size and number concentration were measured by an electrical low-pressure impactor. In addition, engine loading and fuel consumption were also measured to calculate the thermal efficiency. Measurement results suggested that water-emulsified diesel was useful to improve the thermal efficiency and the exhaust emission of a diesel engine. Obviously, the thermal efficiency was increased about 1.2 to 19.9%. In addition, water-emulsified diesel leads to a significant reduction of nitric oxide emission (less by about 18.3 to 45.4%). However, the particle number concentration emission might be increased if the loading of the generator becomes lower than or equal to 1800 W. In addition, exhaust particle size distributions were shifted toward larger particles at high loading. The consequence of this research proposed that the water-emulsified diesel was useful to improve the engine performance and some of exhaust emissions, especially the NO emission reduction.

Implications:The accumulated test results provide a good basis to resolve the corresponding pollutants emitted from a light-duty diesel engine generator. By measuring and analyzing transforms of exhaust pollutant from this engine generator, the effects of water-emulsified diesel fuel and loading on emission characteristics might be more clear. Understanding reduction of pollutant emissions during the use of water-emulsified diesel helps improve the effectiveness of the testing program. The analyzed consequences provide useful information to the government for setting policies to curb pollutant emissions from a light-duty diesel engine generator more effectively.     

粉末活性炭对三烯丙基异氰脲酸酯的吸附性能简

用静态吸附法考察粉末活性炭对水中三烯丙基异氰脲酸酯（CAIC）的吸附行为,采用单因素分析法对活性炭吸附化工废水中TAIC的工艺条件进行研究。实验结果表明,在TAIC模拟废水中,其TAIC初始浓度为800 mg/L,pH为7,在温度为298 K、转速为150 r/min的条件下,当活性炭的投加量达到4.4 g/L,吸附反应时间为50 min时,TAIC的去除效率最高为96.17%;对于实际废水,其TAIC初始浓度为1 500 mg/L,溶液pH为3,在温度为298 K、转速为150 r/min的条件下,当活性炭投加量达到10 g/L,吸附反应时间为2 h时,TAIC的去除效率最高为46.8%。这也是由于实际废水组分复杂,其他有机物存在一定的吸附竞争机制。     

气升回流一体化工艺处理生活污水简

针对分散型生活污水处理开发了气升回流一体化工艺,以校园生活污水为对象,研究其对生活污水中污染物的去除效果。该系统由好氧区、厌氧区、沉淀区和气升室组成,以曝气的剩余气体的气升作用实现混合液的回流,节省动力消耗。结果表明,本工艺对COD、氨氮及悬浮物（SS）有较好的去除效果,去除率分别达到80%、90%和75%左右,出水COD、NH₄⁺-N及SS平均浓度在40 mg/L、6.5 mg/L和10 mg/L左右。当进水COD在100~1 000 mg/L之间波动时,出水水质稳定。该工艺有较强的抗冲击负荷能力,且可实现剩余污泥的自消解。本工艺具有结构紧凑、占地少,运行费用低,维护简单的特点。     

基于白碳黑的水化硅酸钙制备及其磷回收特性简

以白碳黑、硅灰、硅藻土和硅胶筛选硅质原料,并与钙质原料电石渣制备了水化硅酸钙。借助XRF、BET、FTIR等表征手段,通过多次重复除磷实验,研究了硅质原料特性对水化硅酸钙回收磷性能的影响。结果表明,白碳黑具有极高的反应活性,因此可作为制备具有磷回收特性的水化硅酸钙的硅质原料。结合XRD等表征发现,白碳黑的有效利用率是影响水化硅酸钙回收磷性能的关键,该利用率取决于白碳黑与电石渣的摩尔配比以及水热反应温度。当电石渣与白碳黑的摩尔比为1.6：1,反应温度为170℃时,白碳黑具有最佳的利用效率。该条件制备的水化硅酸钙可作为晶种,在其表面结晶形成羟基磷灰石,从而达到磷回收的目的,磷回收后固体物质中的磷含量为19.05%。     

Toxicity of sediment cores from Yangtze River estuary to zebrafish (<Emphasis Type="Italic">Danio rerio</Emphasis>) embryos

Toxicity evaluation is an important segment in sediment quality monitoring in order to protect aquatic organisms and human health. The purpose of this study is to assess the toxicity of sediments from three sediment cores in Yangtze River Estuary, China, using the zebrafish (Danio rerio) embryo tests. Fertilized zebrafish eggs were exposed to both whole sediments and sediment organic extracts prepared from collected sediments, in order to provide a comprehensive and realistic insight into the bioavailable toxicity potential of the sediments. As end points, development parameters (mortality, hatching rate, and abnormality) in the developing embryos were recorded during the 96-h exposure. The results showed that some samples increased mortality, inhibited the hatching of embryos, and induced morphological abnormalities. The embryonic toxicities presented serrated changes and irregular distribution with depth, which may be related to hydrodynamic effect and unstable environmental input. However, lethal and sub-lethal effects were more significant at the sub-surface sediments (10～40 cm), which indicated that the pollution is more serious in recent decades.     

纳米TiO2-石墨烯光催化剂的水热合成及其光催化性能

以钛酸四正丁酯和石墨为原料,通过水热法制备了锐钛矿型为主的纳米TiO2复合光催化剂（纳米TiO2-石墨烯）,并采用XRD,FTIR,FESEM,TEM技术对其进行了表征。通过紫外光照射降解溶液中的罗丹明B（RhB）研究了TiO2-石墨烯的光催化活性,分析了初始罗丹明B质量浓度、催化剂加入量、溶液pH和催化剂使用次数等影响降解效果的因素。实验结果表明：在初始RhB质量浓度为20 mg/L、溶液pH为7.10、催化剂加入量为1.000 g/L的条件下,紫外光照射30 min时,纳米TiO2-石墨烯对RhB的降解率高达98.69%,明显高于纳米TiO2的44.69%;纳米TiO2-石墨烯稳定性较强,可多次重复使用。