西安国际化大都市生态环境建设研究

生态环境建设是城市可持续健康发展的重要途径,也是建设国际化大都市的内在要求。结合西安市创建国际化大都市的实际情况,阐述了西安市生态城市建设现状和发展中出现的问题、生态建设的优势和制约因素等,建立了国际化大都市城市生态建设指标体系,提出了西安市建成生态城市的相关对策和措施。对西安市生态建设提出了系统的设想,阐明国际化大都市建设对改善人居环境及创建和谐社会的重要意义。     

广州地区秋冬季细颗粒物PM_(2.5)化学组分分析

本文对广州地区2009~2010年秋冬季节大气中PM2.5进行采样,并分析PM2.5样品的水溶性离子、重金属元素、有机碳/元素碳(OC/EC)、有机酸、多环芳烃浓度和粒径分布。通过分析初步掌握了广州地区秋冬季节大气中PM2.5的化学组分和特点:广州地区秋冬季PM2.5呈现城区高于城郊,PM2.5中有机质(OM)是最主要的成分,其次是硫酸根离子、硝酸根离子和铵根;PM2.5中有机碳和元素碳的空间分布特征相似,并受一次源排放影响;PM2.5中铝、锌、铅是含量最高的重金属,且城区重金属浓度高于城郊;PM2.5中17种多环芳烃、苯并a芘(BaP)均为城郊浓度最高。     

东临复线增输后的安全低耗输油

分析了输油管线增输后的新特点,采取了实现安全低耗输油的对策：增设水击超前保护系统、合理安排管线启停顺序。     

化固定化Methylibium petroleiphilum PM1细胞降解MTBE及动力学特性分析

采用海藻酸钙包埋固定化高效降解菌Methylobium petroleiphilum PM1降解水相中的甲基叔丁基醚(MTBE),考察了不同强化方法对凝胶颗粒机械强度和降解活性的影响.响应面结果表明,交联剂和培养基中Ca2+浓度分别为0.2 mol·L-1和1.38mmol·L-1,化学交联剂聚乙烯亚胺(PEI)浓度为...     

化固定化Methylibium petroleiphilum PM1细胞降解MTBE及动力学特性分析

采用海藻酸钙包埋固定化高效降解菌Methylobium petroleiphilum PM1降解水相中的甲基叔丁基醚(MTBE),考察了不同强化方法对凝胶颗粒机械强度和降解活性的影响.响应面结果表明,交联剂和培养基中Ca2+浓度分别为0.2 mol·L-1和1.38mmol·L-1,化学交联剂聚乙烯亚胺(PEI)浓度为0.1%时,强化固定化细胞具有较高的降解活性.在此条件下,凝胶颗粒在24h内机械破碎率仅为5.98%,并能连续使用400 h以上,未出现颗粒溶解破碎现象,降解速率较为稳定.扫描电镜观察,PEI处理后的凝胶颗粒表面形成一层薄膜,能有效防止细胞泄漏,并能维持PM1细胞良好的生长繁殖.动力学分析表明,降解的限速步骤为生化反应,直径3 mm凝胶颗粒对底物的扩散限制最弱;而高浓度的PEI能引起严重的扩散限制现象.     

不同磷石膏添加量与接种菌根对玉米生长及磷、砷、硫吸收的影响

通过盆栽模拟试验研究了不同磷石膏（PG）添加量（0、20、40g·kg-1）和接种3种丛枝菌根真菌（Glomus mosseae（GM）、Glomus aggregatum（GA）、Diversispora spurcum（DS））对玉米生长及其磷、硫、砷吸收的影响.试验结果表明：随磷石膏添加量的提高,土壤有效磷、有效...     

好氧及厌氧/好氧序批式工艺中磷化氢的释放

采用二次冷阱富集-气相色谱法作为磷化氢的检测方法,以高纯氮吹脱取样的方式,对好氧序批式工艺及厌氧/好氧序批式工艺中磷化氢的存在及其在工艺中的变化规律进行了研究。结果表明,两种工艺中均检测到磷化氢的存在。好氧序批式工艺中,磷化氢呈递减趋势,运行后期可间断性的检测到低水平（〈0.4 ng/L）磷化氢。厌氧/好氧序批式工艺中...     

Control of membrane fouling during hyperhaline municipal wastewater treatment using a pilot-scale anoxic/aerobic-membrane bioreactor system

Membrane fouling limits the effects of long-term stable operation of membrane bioreactor (MBR). Control of membrane fouling can extend the membrane life and reduce water treatment cost effectively. A pilot scale anoxic/aerobic-membrane bioreactor (A/O-MBR, 40 L/hr) was used to treat the hyperhaline municipal sewage from a processing zone of Tianjin, China. Impact factors including mixed liquid sludge suspension (MLSS), sludge viscosity (μup), microorganisms, extracellular polymeric substances (EPS), aeration intensity and suction/suspended time on membrane fouling and pollution control were studied. The relationships among various factors associated with membrane fouling were analyzed. Results showed that there was a positive correlation among MLSS, sludge viscosity and trans-membrane pressure (TMP). Considering water treatment efficiency and stable operation of the membrane module, MLSS of 5 g/L was suggested for the process. There was a same trend among EPS, sludge viscosity and TMP. Numbers and species of microorganisms affected membrane fouling. Either too high or too low aeration intensity was not conducive to membrane fouling control. Aeration intensity of 1.0 m³/hr (gas/water ratio of 25:1) is suggested for the process. A long suction time caused a rapid increase in membrane resistance. However, long suspended time cannot prevent the increase of membrane resistance effectively even though a suspended time was necessary for scale off particles from the membrane surface. The suction/suspended time of 12 min/3 min was selected for the process. The interaction of various environmental factors and operation conditions must be considered synthetically.     

Analysis of bacterial community in bulking sludge using culture-dependent and -independent approaches

Combination of 16S rRNA gene clone library and cultivation for assessing of bacterial diversity of the microflora in bulking sludge was evaluated in the study.     

Comparison of bacterial community structures in two systems of a sewage treatment plant using PCR-DGGE analysis

Bacterial community was investigated during sludge bulking period using combination of PCR amplification of 16sRNA genes with DGGE analysis.