Comparison of emission of dioxins and furans from gasohol- and ethanol-powered vehicles

The exhaust emissions of 17 polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDD/Fs) were investigated in two spark-ignition light-duty vehicles, one gasohol-fueled and a flexible-fuel one fueled with hydrated ethanol. Gasohol is a mixture of gasoline and 22% ethanol. The influence of fuel type and quality, lubricant oil type, and use of fuel additives on the formation of these compounds was tested using standardized U.S. Federal Test Procedure (FTP)-75 cycle tests. The sampling of the PCDD/Fs followed the recommendations of a modified U.S. Environmental Protection Agency (EPA) Method 23 (www.epa.gov/ttn/ emc/promgate/m-23.pdf) and the analysis basically followed the U.S. EPA Method 8290 (http://www.epa.gov/osw/ hazard/testmethods/sw846/pdfs/8290a.pdf). Results showed that emission factors of PCDD/Fs for the.gasohol vehicle varied from undetected to 0.068 pg international toxic equivalency (I-TEQ) km(-1) (average of 0.0294 pg I-TEQ km(-1)), whereas in the ethanol vehicle they varied from 0.004 to 0.157 pg (I-TEQ) km(-1) (average of 0.031 pg I-TEQ km(-1)). In the gasohol-powered vehicle, the use of fuel additive diminished the emission of Octachlorodibenzo-p-dioxin (OCDD) significantly, whereas in the ethanol vehicle no significant associations were observed between the investigated variables and the emissions.     

Nondestructive characterization of municipal-solid-waste-contaminated surface soil by energy-dispersive X-ray fluorescence and low-Z (atomic number) particle electron probe X-ray microanalysis

The long-term environmental impact of municipal solid waste (MSW) landfilling is still under investigation due to the lack of detailed characterization studies. A MSW landfill site, popularly known as Dhapa, in the eastern fringe of the metropolis of Kolkata, India, is the subject of present study. A vast area of Dhapa, adjoining the current core MSW dump site and evolving from the raw MSW dumping in the past, is presently used for the cultivation of vegetables. The inorganic chemical characteristics of the MSW-contaminated Dhapa surface soil (covering a 2-km stretch of the area) along with a natural composite (geogenic) soil sample (from a small countryside farm), for comparison, were investigated using two complementary nondestructive analytical techniques, energy-dispersive X-ray fluorescence (EDXRF) for bulk analysis and low-Z (atomic number) particle electron probe X-ray microanalysis (low-Z particle EPMA) for single-particle analysis. The bulk concentrations of K, Rb, and Zr remain almost unchanged in all the soil samples. The Dhapa soil is found to be polluted with heavy metals such as Cu, Zn, and Pb (highly elevated) and Ti, Cr, Mn, Fe, Ni, and Sr (moderately elevated), compared to the natural countryside soil. These high bulk concentration levels of heavy metals were compared with the Ecological Soil Screening Levels for these elements (U.S. Environment Protection Agency) to assess the potential risk on the immediate biotic environment. Low-Z particle EPMA results showed that the aluminosilicate-containing particles were the most abundant, followed by SiO2, CaCO3-containing, and carbonaceous particles in the Dhapa samples, whereas in the countryside sample only aluminosilicate-containing and SiO2 particles were observed. The mineral particles encountered in the countryside sample are solely of geogenic origin, whereas those from the Dhapa samples seem to have evolved from a mixture of raw dumped MSW, urban dust, and other contributing factors such as wind, precipitation, weather patterns, farming, and water logging, resulting in their diverse chemical compositions and the abundant observation of carbonaceous species. Particles containing C and P were more abundant in the Dhapa samples than in the countryside soil sample, suggesting that MSW-contaminated soils are more fertile. However, the levels of particles containing potentially toxic heavy metals such as Cr, Mn, Ni, Cu, Zn, and/or Pb in the Dhapa samples were significant, corroborated by their high bulk concentration levels (EDXRF), causing deep concern for the immediate environment and contamination of the food chain through food crops.     

Lake variability: key factors controlling mercury concentrations in New York State fish

A 4year study surveyed 131 lakes across New York State beginning in 2003 to improve our understanding of mercury and gather information from previously untested waters. Our study focused on largemouth and smallmouth bass, walleye and yellow perch, common piscivorous fish shown to accumulate high mercury concentrations and species important to local fisheries. Fish from Adirondack and Catskill Forest Preserve lakes generally had higher mercury concentrations than those from lakes in other areas of the state. Variability between nearby individual lakes was observed, and could be due to differences in water chemistry, lake productivity or the abundance of wetlands in the watershed. We found the following factors impact mercury bioaccumulation: fish length, lake pH, specific conductivity, chlorophyll a, mercury concentration in the water, presence of an outlet dam and amount of contiguous wetlands.     

Sequential sorption of lead and cadmium in three tropical soils

It is important to examine mechanisms of Pb and Cd sorption in soils to understand their bioavailability. The ability of three tropical soils to retain Pb, Cd, and Ca was evaluated. The objectives of this study were to (1) determine the extent to which soil sorption sites are metal specific, (2) investigate the nature of reactions between metals and soil surfaces, and (3) identify how metals compete for sorption sites when they are introduced to soils sequentially or concurrently. Lead was shown to be much less exchangeable than Cd and inhibited Cd sorption. Cadmium had little effect on Pb sorption, though both Ca and Cd inhibited the adsorption of Pb at exchange sites. Lead appears to more readily undergo inner-sphere surface complexation with soil surface functional groups than either Cd or Ca. Thus, regardless of when Pb is introduced to a soil, it should be less labile than Cd.     

Performance study on evacuated tubular collector coupled solar still in West Texas climate

Experimental study was performed on a single basin active solar distillation system augmented with a solar collector using evacuated solar tubes. Field tests were conducted over several days under the climatic conditions of West Texas to evaluate the effect evacuated solar tubes have on the daily distillate yield rate. To investigate the feasibility of the solar tubes, active and passive solar stills with and without exterior insulation were examined. The maximum daily production rate for the active distillation system using evacuated solar tubes and the passive distillation system was 3.6 and 1.4 kg/m²day, respectively. The results showed the augmentation of the still with evacuated solar tubes increased its production capacity by a factor of 2.63. It also increased the maximum temperature of the water in the still basin by at least 20 °C. Economic analysis shows that it is feasible to use evacuated tubular collector coupled solar still as an alternative means for reclaiming water in farmlands with a payback period of approximately 6 years.     

Lysimeter Test of Coke Plant Effluent Disposal to Land in India

ABSTRACT

From the Indian national point of view, the importance of coal carbonizing industries is great and growing. These industries produce huge quantities of highly polluted effluents and discharge them into rivers without proper treatment. A large coke plant of Bharat Coking Coal Ltd. has been surveyed, and the impact of its effluent on surface water quality is discussed. Approximately 175-200 m³ of effluents are discharged from the plant every day. Land application has been considered as a low-cost means of disposal of coke oven effluents. Column lysimeters were prepared by collecting soil from a nearby agricultural field, putting it layerwise into a column, and compacting it carefully to simulate the original in situ conditions. Raw effluents, diluted effluent, and water (as a blank) were applied to the three lysimeters twice a week with a 5 cm flooding. Upon application of diluted effluent (1:1) into lysimeter No. 2, the leachate collected at 190 cm depth was within the tolerance limit of drinking water standard (IS 10,500). The impact of raw and diluted effluent on groundwater quality and soil are discussed. The renovation efficiency of living filter (lysimeter No. 2) was 99.37% for oil and grease, 86.92% for COD, and 53.22% for TDS, and it is estimated that 2.73 hectares of land can be irrigated with the effluents of the coke plant without deteriorating groundwater and soil quality.     

Dissociation of Sulfur Hexafluoride Tracer Gas in the Presence of an Indoor Combustion Source

ABSTRACT

As an odorless, nontoxic, and inert compound, sulfur hexafluoride (SF₆) is one of the most widely used tracer gases in indoor air quality studies in both controlled and uncontrolled environments. This compound may be subject to reactions with water vapor under elevated temperature to form acidic inorganic compounds such as HF and H₂SO₄. Thus, in the presence of unvented combustion sources such as kerosene heaters, natural gas heaters, gas log fireplaces, candles, and lamps, the SF₆ dissociation may interfere with measurements of the emissions from these sources. Tests were conducted in a research house with a vent-free natural gas heater to investigate these potential interferences. It was observed that the heater operation caused about a 5% reduction of SF₆ concentration, which can be an error source for the ventilation rate measurement and consequently the estimated pollutant emission rates. Further analysis indicates that this error can be much greater than the observed 5% under certain test conditions because it is a function of the ventilation flow rate. Reducing the tracer gas concentration has no effect on this error. A simple theoretical model is proposed to estimate the magnitude of this error.

The second type of interference comes from the primary and secondary products of the SF₆ dissociation, mainly H₂SO₄, SO₂, HF, and fine particulate matter (PM). In the presence of ~5 ppm SF₆, the total airborne concentrations of these species increased by a factor of 4-10. The tests were performed at relatively high SF₆ concentrations, which is necessary to determine the interferences quantitatively. The second type of interference can be significantly reduced if the SF₆ concentration is kept at a low ppb level.     

Deposition of Mn from Automotive Combustion of Methylcyclopentadienyl Manganese Tricarbonyl beside the Major Highways in the Greater Toronto Area,Canada

ABSTRACT

Methylcyclopentadienyl manganese tricarbonyl (MMT) has been used in Canada since 1976 as an antiknock agent in gasoline, completely replacing Pb in 1990. An early study of much higher Mn concentrations in gasoline showed that the combustion of MMT leads to the formation of inorganic manganese oxides, especially Mn₃O₄. Recent emission testing by Lawrence Livermore National Laboratory for Ethyl Corp. has shown that Mn is primarily emitted as a phosphate or sulfate along with minor amounts of oxides. The main objective of this research was to analyze the deposition of Mn from MMT to the terrestrial environment beside the major highways in the greater Toronto area (GTA), Canada. The results were compared with Pb and other trace elements such as Al, Ca, Fe, Mg, Cu, Zn, Na, and the Cl^- ion (water extractable) to study the behavior of Mn in soil. The study area was located near major Toronto highways 401 (urban) and 400 (rural), at 43° 67′ N and 79° 37′ W (latitude and longitude) (278,560 and 47,835 cars/day), respectively. Surface soil samples (0–5 cm depth) were collected at distances up to 40 m from the roadside. Parameters evaluated included total and available Mn and other trace elements, particle size, pH, organic content, and cation exchange capacity.     

Modeling of Indoor Air Treatment of Polychlorinated Dibenzo-p-Dioxins and Dibenzofurans Using High-Efficiency Particulate Air-Carbon Filtration

Abstract

A high-efficiency particulate air (HEPA)-carbon filtration system was developed by the Access Business Group, LLC, to reduce the indoor levels of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). The HEPA filter removes the particle-bound PCDD/Fs, and the carbon filter removes the gaseous fraction. Because of the toxicity of PCDD/Fs, it is very difficult to handle them in the laboratory. In this study, mathematical modeling was performed to evaluate the performance of the HEPA-carbon filtration system for PCDD/Fs removal and to optimize its design and operation. The model was calibrated with experimental data conducted with toluene in a sealed room. Model simulations with four selected congeners demonstrated that it takes ～1 hr for the indoor air treatment system to reach the maximum removal efficiency and that the carbon air filter has a life time of 10⁷ yr for dioxin removal. Given a zero emission from the HEPA filter, the overall removal efficiency is 78.7% for 2,3,7,8-tetrachloro dibenzo-p-dioxins, 89.8% for octa-chlorodibenzodioxin, 78% for tetra-chlorodibenzofuran, and 89.8% for octachlorodibenzofuran. The larger the mass emission from the HEPA filter, the lower the overall removal efficiency, and the larger the ratio of the filter flow rate (Q_f) to the room flow rate (Q), the higher the overall removal efficiency. When the ratio of Q_f/Q is 15, an overall removal efficiency of 90% can be reached for all four of the selected compounds. The removal of the four selected compounds does not change as the relative humidity increases ≤90%.