Interaction effects of metals and salinity on biodegradation of a complex hydrocarbon waste

The presence of high levels of salts because of produced brine water disposal at flare pits and the presence of metals at sufficient concentrations to impact microbial activity are of concern to bioremediation of flare pit waste in the upstream oil and gas industry. Two slurry-phase biotreatment experiments based on three-level factorial statistical experimental design were conducted with a flare pit waste. The experiments separately studied the primary effect of cadmium [Cd(II)] and interaction effect between Cd(II) and salinity and the primary effect of zinc [Zn(II)] and interaction effect between Zn(II) and salinity on hydrocarbon biodegradation. The results showed 42-52.5% hydrocarbon removal in slurries spiked with Cd and 47-62.5% in the slurries spiked with Zn. The analysis of variance showed that the primary effects of Cd and Cd-salinity interaction were statistically significant on hydrocarbon degradation. The primary effects of Zn and the Zn-salinity interaction were statistically insignificant, whereas the quadratic effect of Zn was highly significant on hydrocarbon degradation. The study on effects of metallic chloro-complexes showed that the total aqueous concentration of Cd or Zn does not give a reliable indication of overall toxicity to the microbial activity in the presence of high salinity levels.     

Calcite-seeded crystallization of calcium phosphate for phosphorus recovery

For phosphorus recovery from wastewater, the present paper aims at understanding the crystallization of calcium phosphate by using calcites (Juraperle and Coccolith) as seeds from hard water. Synthetic hard water with 60 mgCl(-1) carbonate and 10 mgPl(-1) phosphate was prepared and used in the batch experiments of calcite-seeded crystallization. The solution composition was measured throughout the batch crystallization process, and the corresponding saturation indices with respect to the minerals were calculated with PHREEQC Program. The surface of the calcite seeds was observed and measured with environmental scanning electron microscopy (ESEM), Fourier transform infrared (FTIR) and BET method. The studies show that both calcites are effective seeds for the crystallization of calcium phosphate from hard water; the used calcites are more efficient than the original ones because newly formed crystals with calcium phosphate have covered their surfaces. The studies show that the calcite seeds can be used for phosphorus recovery from hard waters.     

Fine route for an efficient removal of 2,4-dichlorophenoxyacetic acid (2,4-D) by zeolite-supported TiO2

Zeolites HY, Hbeta and HZSM-5 with different physico-chemical properties were chosen as support for TiO2 to illustrate their adsorption, dispersion and electronic structure in photocatalysis. The extent of TiO2 loading was monitored by XRD and BET surface area measurements. The adsorption capacity of HY zeolite was found to be high and hence chosen for further modification to continue the investigation. Photodegradation kinetics were carried out with 2,4-dichlorophenoxyacetic acid (2,4-D) in aqueous solution. The extent of 2,4-D degradation on TiO2/HY loading revealed the importance of adsorption in photocatalysis. Mineralisation studies on all three zeolites with 1 wt.% TiO2 loading demonstrated the good dispersion properties of TiO2/HY. Its photocatalytic activity was found to be excellent with formulated 2,4-D. Comparison of relative photonic efficiencies demonstrated that supported photocatalysts exhibited higher activity than some of the commercial photocatalysts. The high activity of supported TiO2 is due to synergistic effects of improved adsorption of 2,4-D and efficient delocalisation of photogenerated electrons by zeolite support.     

Sorption of As(V) ions by akaganéite-type nanocrystals

A priority pollution problem, the removal of arsenate oxyanions from dilute aqueous solutions by sorption onto synthetic akaganéite (beta-FeO(OH)) was the aim of the present study. This is an innovative inorganic adsorbent material prepared in the laboratory, following a new method of preparation. The effect of akaganéite and arsenate concentration, the contact time, temperature, solution pH value, and ionic strength variation on the treatment process was mainly investigated during this study. Typical adsorption isotherms were determined, which were found to fit sufficiently the typical Langmuir equation. The mechanism of sorption was examined by electrokinetic, X-ray diffraction, Fourier transmission infrared and scanning electron microscopy measurements. Promising results were obtained, due to the favourite characteristics of the adsorbent applied.     

Metal ion removal from water by sorption on paper mill sludge

Chromatographic columns packed with paper mill sludge are employed for metal ion recovery from water. The breakthrough curves show that cadmium, copper, lead and silver are removed from acid solutions (pH 2, 4); the affinity series is Pb(II)>Cu(II)>Ag(I)>Cd(II). Both the amount of metal retained and the metal-matrix interaction are pH dependent; the sorptive capacity increases with increasing pH. When the metals are present together at the same initial concentrations a competition among the different ions occurs although the affinity order remains unchanged. In metal recovery from the paper mill sludge column, the total amount of the cadmium and copper is displaced by HCl 1.0 M, 65% of the lead by HCl 0.1 M and 75% of the silver by HNO(3) 0.1 M. More than 95% of copper and lead and less than 20% of cadmium were recovered with HCl 0.1 M when the metals were present at the same time.     

Removal of biocide pentachlorophenol in water system by the spent mushroom compost of Pleurotus pulmonarius

Pentachlorophenol (PCP) has been widely used as a wood preservative since 1980s. Although it has been banned worldwide, residues of PCP are still commonly found. The spent compost of oyster mushroom Pleurotus pulmonarius (SMC) which was a degraded paddy straw-based substrate, contained 25% chitin. Five percentage of the SMC could remove 89.0 +/- 0.4% of 100 mg PCPl(-1) within 2 days at room temperature predominantly by biodegradation. The maximum removal capacity was 15.5 +/- 1.0 mg g(-1) SMC. The sorption kinetics of PCP by SMC can be described by the Freundlich monolayer model with a theoretical sorption capacity similar to that found for chitin. A PCP-degradative bacterium was isolated from the SMC. Yet, biodegradation was predominantly contributed by the immobilized ligninolytic enzymes secreted by the mushroom to the SMC. Degradation of PCP involves dechlorination, methylation, carboxylation and ring cleavage as verified by GC-MSD and ion chromatography. Thus, the SMC has a potential for treating PCP-contaminated water.     

Negative effects of humic acid addition on phytoremediation of pyrene-contaminated sediments by mangrove seedlings

Vegetated (with Kandelia candel seedlings) and non-vegetated mangrove microcosms were employed to remove pyrene from contaminated sediments, and the effects of adding 6.7% humic acid (HA) on such removal were investigated. At the end of 6-month treatment, residual pyrene concentrations in surface sediments (0-2 cm) of the contaminated microcosms reduced from an initial 5.82 to 0.63 microg g(-1) dw, and the reduction was less in HA amended microcosms with the residual pyrene concentration remained at 3.12 microg g(-1) dw. The pyrene removal percentages in microcosms with HA amendment were 29% for surface aerobic sediments and 41% for bottom (anaerobic) sediments, while the respective removal percentages in microcosms without HA amendment were 89% (surface sediments) and 53% (bottom sediments). Microcosms planted with K. candel seedlings had a significantly higher pyrene removal when compared to the non-vegetated ones, and the average removal percentages were 70.9% and 61.4%, respectively. However, when humic acid was added, no significant difference was found between vegetated and non-vegetated microcosms in pyrene removal, both had less than 40% removal, probably because plant growth in humic acid amended contaminated microcosms, in terms of total biomass, was reduced by 50%. Roots of K. candel could accumulate pyrene from contaminated microcosms, and pyrene concentrations in roots harvested from microcosms with and without humic acid addition were 6.01 and 3.46 microg g(-1) dw, respectively. These results suggest that the addition of HA to contaminated sediments decreased the mangrove microcosm's ability to remove pyrene as pyrene was more tightly bound to the organic matter and plant growth was reduced.     

Determination of microbiological contamination,antibacterial and antioxidant activities of natural plant hazelnut (Corylus avellana L.) pollen

The aim of our study is to determine microbial contamination, antibacterial and antioxidant activities of 14 pollen samples of Corylus avellana collected from different locations in Slovakia. Microbiological analysis was carried out in two steps: microbiological assays and studies of antibacterial activity of pollen extracts. The antimicrobial properties of pollen extracts were carried out with the disc-diffusion method. Methanol (70%), ethanol (70%) and distilled water were used for pollen extracts. Five strains of bacteria such as gram-negative (Salmonella enterica subsp. enterica CCM 3807, Escherichia coli CCM 2024, and Yersinia enterocolitica CCM 5671) and gram-positive (Staphylococcus aureus CCM 2461 and Bacillus thuringiensis CCM 19T) were tested. Antioxidant activity of pollen extracts was determined by the DPPH method. Bacterial analysis includes the determination of the total bacterial count ranged from 4.08 to 4.61 log CFU g^?1, mesophilic aerobic bacteria ranged from 3.40 to 4.89 log CFU g^?1, mesophilic anaerobic bacteria ranged from 3.20 to 4.52 log CFU g^?1, coliform bacteria ranged from 3.30 to 4.55 log CFU g^?1, yeasts and filamentous fungi ranged from 3.00 to 3.56 log CFU g^?1. Microscopic filamentous fungi Aspergillus spp., Alternaria spp., Penicillium spp., Cladosporium spp., Rhizopus spp., and Paecylomyces spp. were isolated from hazelnut pollen. Yersinia enterocolitica was the most sensitive strain among ethanolic and methanolic pollen hazelnut extracts. Staphylococcus aureus was the most sensitive strain against aqueous hazelnut pollen extracts. We determined the following sensitivity against ethanol pollen extracts respectively: Yersinia enterocolitica?>?Salmonella enterica?>?Staphylococcus aureus?>?Bacillus thuringiensis?>?Escherichia coli. Methanol pollen extracts had shown following sensitivity: Yersinia enterocolitica?>?Salmonella enterica?>?Escherichia coli?>?Staphylococcus aureus?>?Bacillus thuringiensis. Aqueous extracts had shown the following sensitivity: Staphylococcus aureus?>?Salmonella enterica?>?Escherichia coli?>?Bacillus thuringiensis?>?Yersinia enterocolitica. Hazelnut pollen extracts have over 82% antioxidant capacity in samples from non-urban zones. An elevated level of antioxidant potential in the pollen is determined by its biological properties conditioned by biologically active substances. DPPH method allowed characterizing pollen as a source of antioxidants.     

Carbon monoxide emission rates from roasted whole bean and ground coffee

Carbon monoxide (CO) emitted from roasted coffee is a potential occupational respiratory exposure hazard to workers within the coffee industry. The current study objective was to estimate CO emission factors from commercially available roasted whole bean and ground coffee measured in loose form, not packaged, and to assess the utility of CO monitoring in nonventilated storage spaces such as within coffee roasting and packaging facilities, transport vessels, and cafés. Determinants affecting CO emissions from coffee were investigated, including form (whole bean vs. ground), roast level (light, medium, medium-dark, dark), and age (time since the package was opened). CO emission factors were estimated for roasted coffee samples from a variety of manufacturers purchased from local grocery stores and online. Emission tests were performed on 36 brands of coffee, some with more than one sample per brand and with various roast levels. Decaying source equations or smoothing functions were fitted to the CO concentration measurements. Maximum observed emission factors at the peak of the predicted concentration curve were adjusted by the time required to reach the maximum CO concentration and reported as emission factors (EF_buildup). Ground coffee had a significantly increased EF_buildup (P < 0.0001) compared with whole bean. Roast level did not significantly affect emissions for whole bean (P = 0.72) but did for ground (P < 0.001) coffee. For ground coffee, medium-dark and dark roasts had significantly higher emissions than medium and light roasts. Worst-case emission factors from commercially available whole bean and ground coffee measured in loose form, not packaged, showed that roasted coffee can rapidly emit CO. CO concentrations should be monitored in storage spaces in service and manufacturing facilities as well as transport vessels to ensure exposures do not exceed occupational exposure limits. Storage spaces may need to be ventilated to control CO concentrations to safe levels.

Implications: Emission rates of carbon monoxide (CO) from roasted coffee showed that unventilated or underventilated storage spaces should be monitored and ventilated, if necessary, to control CO concentrations to safe levels.     

Predicting logP of pesticides using different software

We compared experimental and calculated logP values using a data set of 235 pesticides and experimental values from four different sources: The Pesticide Manual, Hansch Manual, ANPA and KowWin databases. LogP were calculated with four softwares: HyperChem, Pallas, KowWin and TOPKAT. Crossed comparison of the experimental and calculated values proved useful, especially for pesticides. These are harder to study than simpler organic compounds. Structurally they are complex, heterogeneous and similar to drugs from a chemical point of view. They offer an interesting way to verify the goodness of the different methods. Other studies compared several logP predictors using a single set of experimental values taken as a reference. Here we discuss the utility of the different logP predictors, with reference to experimental data found in different databases. This offers three advantages: (1) it avoids bias due to the assumption that one single data set is correct; (2) a given predictor can be developed on the same data set used for evaluation; (3) it takes account of experimental variability and can compare it with the predictor's variability. In our study Pallas and KowWin gave the best results for prediction, followed by TOPKAT.