两点短时游离氯后转氯胺的顺序氯化消毒工艺研究

基于顺序氯化消毒工艺的原理,采用两点短时游离氯后转氯胺的两点顺序氯化消毒工艺,即在过滤和清水池前的两点分别加氯,并在清水池加氯后立即加氨转化为氯胺消毒的工艺,该工艺在常规处理工艺的给水厂进行了消毒试验.结果表明,加氯点的适当提前,不仅有利于控制消毒副产物的生成量,而且有效抑制了滤池中的生物膜滋生.两点顺序氯化消毒工艺中生成的卤代消毒副产物比相同条件下一次性加入等量的氯消毒剂的消毒方法产生的三卤甲烷(THMs)平均减少了51.6％,卤乙酸(HAAs)平均减少了46.7％.细菌学指标HPC的结果也显示出了该工艺在保障水质的微生物安全方面的优势.     

安全文化学课程内容及其教材框架设计研究

为构建安全文化学课程内容体系,进而为安全文化学教材编著奠定基础,分析安全文化学的内涵及课程地位与性质。基于此,从风险社会视阈与“大安全—大文化”视角介入,建立安全文化学课程内容体系的逻辑结构图,并构建安全文化学课程内容体系结构。在此基础上,对安全文化学课程教材编著从指导思想及内容深度与广度2方面进行思考。结果表明:安全文化学课程内容体系建构及其教材编著意义重大且急需,该研究为安全文化学教材编著,以及高等院校安全工程专业人才培养中开设安全文化学课程奠定了基础。     

Status of air pollution in Beijing

A study has been made on elements organic constituents, TSP, SO2,NO2 of atmospheric pollutants in Beijing. 17 elements, and some PAHs, e. g. B(a)P, B(b, j, k)P, and B(g, h, i)P, in airborne particles by X-ray fluorescence spectroscopy and HPLC, GC/MS, have been determined respectively. It has been shown that the elements Pb, Zn, S and Cu were more enriched in fine particles and different valence states of sulfur at various sites. It was found that the concentrations of S6+ and S2-were more than 85% and less than 15% of the total sulfur respectively. Concentrations of major PAHs and sulfur-containing compounds increased in winter and in urban area. High values for Pb and Zn in city, Fe and Mn at industrial area and Cu, Al rural sites were obtained respectively. This implies the functions of different elemental sources of various sites. Thus, elements can be from distingushed anthropogenic and natural sources.The main contribution of SO2 was found of to have same seasonal variation as the anthropogenic el     

新烟碱类农药的污染现状及转化行为研究进展

新烟碱类(neonicotinoids)农药自在20世纪80年代中期引入以来,便发展成为世界上使用最广泛的一类杀虫剂。近年来,该类化合物在环境中被不断检出,并通过饮用水和食物等方式进入食物链,给人类健康带来极大的安全隐患。文章综述了新烟碱类杀虫剂在空气、土壤、水相、生物体和人体中的暴露浓度,以及这类农药在环境中的转化行为。目前针对新烟碱类杀虫剂的环境暴露研究仍十分有限,需要更全面调查其在多环境介质中的暴露状况以综合评价其生态风险。关于新烟碱类化合物的毒理学研究主要集中在急性毒性试验,而对于其他形式的毒性效应有待进一步研究。最后对新烟碱农药未来的研究重点和方向提出了展望。     

粘土防渗尾矿库地震永久位移数值模拟

我国目前的防渗尾矿库数量越来越多,但对其动力分析相对较少。结合工程实际,使用FLAC2D软件建立了有限差分数值模型,对采用粘土垫层防渗的尾矿库进行二维地震动力响应分析,并将计算得到的坝顶最大水平位移与传统简化方法的计算结果进行了对比分析。计算结果表明,由于数值分析考虑了尾矿坝对地震波的放大效应,通过有限差分数值模型计算的水平位移比简化方法的计算结果大60%。参数分析表明:防渗垫层的抗剪强度对于尾矿库动力响应影响较大,其虽有一定隔震作用,使得防渗层上部的最大水平加速度低于其下部的最大水平加速度约5%~30%,但随着防渗垫层抗剪强度的降低,尾矿库的失稳模式由经过尾矿内部的圆弧形滑动向经过防渗层的楔形滑动转变,尾矿库的屈服加速度显著降低,永久水平位移从小于5cm增加到近70cm,可能造成震陷等灾害。该分析方法和结果对于地震区防渗尾矿库工程的设计有一定的参考价值。     

储罐钢08MnNiVR和SPV490Q在石油沉积水中腐蚀性能对比

采用电化学试验、浸泡试验和慢应变速率拉伸试验研究储罐钢08MnNiVR和SPV490Q在石油沉积水中的腐蚀性能差异。电化学试验结果表明,08MnNiVR在石油沉积水中的自腐蚀电流比SPV490Q略大。浸泡试验结果表明,中短期试验时,08MnNiVR的腐蚀率略大;较长期试验时,SPV490Q的腐蚀率略大。慢应变速率拉伸试验结果表明,08MnNiVR和SPV490Q在石油沉积水中均具有高应力腐蚀抗力。     

Influence of tobacco smoke on carcinogenic PAH composition in indoor PM10 and PM2.5

Because of the mutagenic and/or carcinogenic properties, Polycyclic Aromatic Hydrocarbons (PAH), have a direct impact on human population. Consequently, there is a widespread interest in analysing and evaluating the exposure to PAH in different indoor environments, influenced by different emission sources. The information on indoor PAH is still limited, mainly in terms of PAH distribution in indoor particles of different sizes; thus, this study evaluated the influence of tobacco smoke on PM₁₀ and PM_2.5 characteristics, namely on their PAH compositions, with further aim to understand the negative impact of tobacco smoke on human health. Samples were collected at one site influenced by tobacco smoke and at one reference (non-smoking) site using low-volume samplers; the analyses of 17 PAH were performed by Microwave Assisted Extraction combined with Liquid Chromatography (MAE–LC). At the site influenced by tobacco smoke PM concentrations were higher 650% for PM₁₀, and 720% for PM_2.5. When influenced by smoking, 4 ring PAH (fluoranthene, pyrene, and chrysene) were the most abundant PAH, with concentrations 4600–21 000% and 5100–20 800% higher than at the reference site for PM₁₀ and PM_2.5, respectively, accounting for 49% of total PAH (Σ_PAH). Higher molecular weight PAH (5–6 rings) reached concentrations 300–1300% and 140–1700% higher for PM₁₀ and PM_2.5, respectively, at the site influenced by tobacco smoke. Considering 9 carcinogenic PAH this increase was 780% and 760% in PM₁₀ and PM_2.5, respectively, indicating the strong potential risk for human health. As different composition profiles of PAH in indoor PM were obtained for reference and smoking sites, those 9 carcinogens represented at the reference site 84% and 86% of Σ_PAH in PM₁₀ and PM_2.5, respectively, and at the smoking site 56% and 55% of Σ_PAH in PM₁₀ and PM_2.5, respectively. All PAH (including the carcinogenic ones) were mainly present in fine particles, which corresponds to a strong risk for cardiopulmonary disease and lung cancer; thus, these conclusions are relevant for the development of strategies to protect public health.     

Isoprene emissions and climate

Biogenic volatile organic compounds (BVOCs) play an important role in atmospheric chemistry and the carbon cycle. Isoprene is quantitatively the most important of the non-methane BVOCs (NMBVOCs), with an annual emission of about 400–600 TgC; about 90% of this is emitted by terrestrial plants. Incorporating a mechanistic treatment of isoprene emissions within land-surface schemes has recently become a focus for the modelling community, the aim being to quantify the potential magnitude of associated climate feedbacks. However, these efforts are hampered by major uncertainties about why plants emit isoprene and the relative importance of different environmental controls on isoprene emission. The availability and reliability of observations of isoprene fluxes from different types of vegetation is limited, and this also imposes constraints on model development. Nevertheless, progress is being made towards the development of mechanistic models of isoprene emission which, in conjunction with atmospheric chemistry models, will ultimately allow improved quantification of the feedbacks between the terrestrial biosphere and climate under past and future climate states.     

The stable isotope signature of methane emitted from plant material under UV irradiation

Recent experiments have shown that dry and fresh leaves, other plant matter, as well as several structural plant components, emit methane upon irradiation with UV light. Here we present the source isotope signatures of the methane emitted from a range of dry natural plant leaves and structural compounds. UV-induced methane from organic matter is strongly depleted in both ¹³C and D compared to the bulk biomass. The isotopic content of plant methoxyl groups, which have been identified as important precursors of aerobic methane formation in plants, falls roughly halfway between the bulk and CH₄ isotopic composition. C3 and C4/CAM plants show the well-established isotope difference in bulk ¹³C content. Our results show that they also emit CH₄ with different δ¹³C value. Furthermore, δ¹³C of methoxyl groups in the plant material, and ester methoxyl groups only, show a similar difference between C3 and C4/CAM plants. The correlation between the δ¹³C of emitted CH₄ and methoxyl groups implies that methoxyl groups are not the only source substrate of CH₄.Interestingly, δD values of the emitted CH₄ are also found to be different for C3 and C4 plants, although there is no significant difference in the bulk material. Bulk δD analyses may be compromised by a large reservoir of exchangeable hydrogen, but no significant δD difference is found either for the methoxyl groups, which do not contain exchangeable hydrogen. The δD difference in CH₄ between C3 and C4 plants indicates that at least two different reservoirs are involved in CH₄ emission. One of them is the OCH₃ group, the other one must be significantly depleted, and contribute more to the emissions of C3 plants compared to C4 plants. In qualitative agreement with this hypothesis, CH₄ emission rates are higher for C3 plants than for C4 plants.     

A 50 MW concentrating solar power plant for Jordan

The potential of concentrating solar power plant (CSPP) technology in Jordan is assessed and the next steps for development of the first CSPP in the country are presented. For this purpose, a prototype of a 50 MW CSPP for electricity generation in Jordan is proposed and analysis of its economic feasibility has been performed. Moreover, a calculation model – using the concept design of the proposed CSPP, and the solar irradiation data – was developed to estimate the energy yield of the plant. Based on the analyzed solar irradiation data, it was found that Jordan has an outstanding potential for CSPP, especially in the southern locations of the country such as Quweira. At the same time Jordan's energy master plan is seeking for independent energy supply and for an increasing share of renewable energies. Furthermore, Jordan's demand curve over a day closely matches the electricity production of the proposed plant. Combination of these factors creates a very favorable situation. Therefore, establishment of the proposed 50 MW CSPP is highly recommended not only in Jordan, but also in many other countries, which have similar political and economical conditions such as those countries located in the Middle East and North Africa (MENA) region.