Workshop on Primary Sulfate Emissions

This article is a summary report on a workshop, Measurement Technology and Characterization of Primary Sulfur Oxides Emission from Combustion Sources, sponsored by the EPA Environmental Sciences Research Laboratory at Research Triangle Park, NC, held in Southern Pines, NC. The objectives of the workshop were: to review and discuss current measurement methods and problem areas for sulfur oxides emission with attention focused on sulfuric acid, sulfates, and sulfur-bearing particulate matter; to review and discuss emission data from various combustion sources operating under different conditions, which include various pollutant controls, fuel composition, excess boiler oxygen, etc.; to delineate and recommend areas in need of research and development effort. Scientists were invited to present the results of their studies on primary sulfate emissions. The 3-day workshop devoted one day to measurement technology, a second to characterization, and a third to critical assessment of the presented papers and development of summary working group reports on each half-day session of the initial 2 days. Thirty-one papers were presented by 29 participants on measurements and characterization. Four working group reports were developed and summarized in the last day. Highlights of the papers and reports are briefly reviewed. Workshop proceedings are available as an EPA publication.     

acid rain and environmental policy

Editor’s note: This paper by Dr. Jacobson was presented at the 74th annual meeting of the Air Pollution Control Association as part of a panel discussion entitled “Acid Rain–1981: An International Issue.” The session was held on June 22, 1981, and was arranged by APCA’s TT-6 Energy-Environmental Interactions Committee.     

Testing and Commercialization of Byproduct Dibasic cids as Buffer Additives for Limestone Flue Gas esulfurization Systems

Pilot plant (0.1 MW) tests and utility boiler full scale demonstration (194 MW) of byproduct organic dibasic acids (DBA) as buffer additives to limestone scrubbers have shown performance improvements equivalent to those achieved by the addition of pure adipic acid. Both SO₂ removal efficiency and limestone utilization increased, and no significant operating problems were observed with three of the four DBA tested. Chemical and biological evaluations of scrubber samples taken during the DBA testing indicated no detectable tOxicity or mutagenicity, and no significant environmental impact is expected as a result of DBA addition. Economic estimates indicate that substitution of DBA for pure adipic acid as a buffer additive will result in additive cost savings of 30 % or greater.     

Municipal solid waste generation in municipalities: quantifying impacts of household structure, commercial waste and domestic fuel

Waste management planning requires reliable data concerning waste generation, influencing factors on waste generation and forecasts of waste quantities based on facts. This paper aims at identifying and quantifying differences between different municipalities' municipal solid waste (MSW) collection quantities based on data from waste management and on socio-economic indicators. A large set of 116 indicators from 542 municipalities in the Province of Styria was investigated. The resulting regression model included municipal tax revenue per capita, household size and the percentage of buildings with solid fuel heating systems. The model explains 74.3% of the MSW variation and the model assumptions are met. Other factors such as tourism, home composting or age distribution of the population did not significantly improve the model. According to the model, 21% of MSW collected in Styria was commercial waste and 18% of the generated MSW was burned in domestic heating systems. While the percentage of commercial waste is consistent with literature data, practically no literature data are available for the quantity of MSW burned, which seems to be overestimated by the model. The resulting regression model was used as basis for a waste prognosis model (Beigl and Lebersorger, in preparation).     

Biodegradable Water Soluble Copolymer for Antimicrobial Applications

Synthesis and characterization of novel biodegradable, water soluble and optically active DL-malic acid (DMA) and citric acid (CA) copolymers were studied for possible use as antibacterial agents. The copolymers were synthesized by direct bulk melt condensation in the absence of a catalyst above 150 °C. Characterization of obtained copolymers was carried out with the help of infrared absorption spectra, differential scanning calorimetry and thermo gravimetric analysis. The antibacterial activity of copolymers against bacteria was investigated. The results obtained shows the above copolymers possess a broad wound dressing activity against different types of bacteria and may be useful as antibacterial agents.     

Looking beyond the average agricultural impacts in defining adaptation needs in Europe

The effects of climate change on agriculture are often characterised by changes in the average productivity of crops; however, these indicators provide limited information regarding the risks associated with fluctuations in productivity resulting from future changes in climate variability that may also affect agriculture. In this context, this study evaluates the combined effects of the risks associated with anomalies reflected by changes in the mean crop yield and the variability of productivity in European agro-climatic regions under future climate change scenarios. The objective of this study is to evaluate adaptation needs and to identify regional effects that should be addressed with greater urgency in the light of the risks and opportunities that are identified. The results show differential effects on regional agriculture and highlight the importance of considering both regional average impacts and the variability in crop productivity in setting priorities for the adaptation and maintenance of rural incomes and agricultural insurance programmes.     

Probabilistic impacts of climate change on flood frequency using response surfaces II: Scotland

This paper uses a sensitivity framework approach to look at the probabilistic impacts of climate change on 20-year return period flood peaks, by applying a set of typical response surfaces alongside the probabilistic UK Climate Projections (UKCP09) for 10 river-basin regions over Scotland. The first paper of the pair used the same approach for 10 river-basin regions over England and Wales. This paper develops the methodology for Scotland, by first enabling better estimation of the response type of Scottish catchments. Then, as for England and Wales, the potential range of impacts is shown for different types of catchment in each river-basin region in Scotland, and regional average impact ranges are estimated. Results show clear differences in impacts between catchments of different types and between regions. The Argyll and West Highland regions show the highest impacts, while the North-East Scotland region shows the lowest impacts. The overall ranges are generally smaller for Scotland than England and Wales.     

Fuel efficiency improvement of a dual-fuel engine fuelled with Honge oil methyl ester (HOME)–bioethanol and producer gas

Renewable and alternative fuels have numerous advantages compared with fossil fuels as they are renewable and biodegradable and provide food and energy security and foreign exchange savings besides addressing environmental concerns and socio-economic issues (Yaliwal et al. 2013. International Journal of Sustainable Engineering, doi:10.1080/19397038.2013.801530. Zhu et al. 2011a, Applied Thermal Engineering 31 (14–15): 2271–2278; Zhu et al. 2011b, Fuel 90: 1743-1750; Banapurmath, Tewari, and Hosmath 2008, Renewable Energy 33: 2007-2018; Banapurmath 2009, “Performance, Combustion and Emission Characteristics of a Single Cylinder Direct Injection CI Engine Operated on Dual Fuel Mode Using Honge Oil and Producer Gas.” PhD thesis, 1–195; Banapurmath et al. 2011, Waste and Biomass Valorization 2: 1–11). In this context, the main objective of the present work is to study methods of biofuel production such as Honge oil methyl ester (HOME) using a conventional transesterification process and bioethanol from the Calliandra calothyrsus shrub using a new pretreatment method known as hydrothermal explosion. Further, experimental investigations were carried out on a single-cylinder, four-stroke, direct-injection stationary diesel engine operating in a dual-fuel mode using HOME, bioethanol and producer gas combinations to determine its performance, combustion and emission characteristics. The performance of the dual-fuel engine was analyzed at optimized engine conditions. HOME-Bioethanol (BE) blends such as HOME+ 5% bioethanol (BE5), HOME+ 10% bioethanol (BE10) and HOME+ 15% bioethanol (BE15) were prepared by adding bioethanol to HOME (on volume basis) in different proportions ranging from 5 to 15% with an increment of 5%. In this present work, the effect of different BE blends on the performance of producer gas fuelled dual fuel engine was studied. Experimental investigation on dual fuel engine using BE5-Producer gas operation resulted in up to 4–9% increased brake thermal efficiency with decreased hydrocarbon (HC), carbon monoxide (CO) and marginally increased nitric oxide (NOx) emission levels compared to HOME-Producer gas, BE10-producer gas and BE15-producer gas mode of operation. However, it was observed that, the overall performance of BE-producer gas operation was found to be lower compared to diesel-producer gas operation.     

Adaptation options for marine industries and coastal communities using community structure and dynamics

Identifying effective adaptation strategies for coastal communities dependent on marine resources and impacted by climate change can be difficult due to the dynamic nature of marine ecosystems. The task is more difficult if current and predicted shifts in social and economic trends are considered. Information about social and economic change is often limited to qualitative data. A combination of qualitative and quantitative models provide the flexibility to allow the assessment of current and future ecological and socio-economic risks and can provide information on alternative adaptations. Here, we demonstrate how stakeholder input, qualitative models and Bayesian belief networks (BBNs) can provide semi-quantitative predictions, including uncertainty levels, for the assessment of climate and non-climate-driven change in a case study community. Issues are identified, including the need to increase the capacity of the community to cope with change. Adaptation strategies are identified that alter positive feedback cycles contributing to a continued decline in population, local employment and retail spending. For instance, the diversification of employment opportunities and the attraction of new residents of different ages would be beneficial in preventing further population decline. Some impacts of climate change can be combated through recreational bag or size limits and monitoring of popular range-shifted species that are currently unmanaged, to reduce the potential for excessive removal. Our results also demonstrate that combining BBNs and qualitative models can assist with the effective communication of information between stakeholders and researchers. Furthermore, the combination of techniques provides a dynamic, learning-based, semi-quantitative approach for the assessment of climate and socio-economic impacts and the identification of potential adaptation strategies.