Triazole-induced toxicity in developing rare minnow (Gobiocypris rarus) embryos

Using rare minnow (Gobiocypris rarus) at early-life stages as experimental models, the developmental toxicity of five widely used triazole fungicides (myclobutanil, fluconazole, flusilazole, triflumizole, and epoxiconazole) were investigated following exposure to 1–15 mg/L for 72 h. Meanwhile, morphological parameters (body length, body weight, and heart rate), enzyme activities (superoxide dismutase (SOD), glutathione S-transferase (GST), adenosine triphosphatase (ATPase), and acetyl cholinesterase (AChE)), and mRNA levels (hsp70, mstn, mt, apaf1, vezf1, and cyp1a) were also recorded following exposure to 0.2, 1.0, and 5.0 mg/L for 72 h. Results indicated that increased malformation and mortality, decreased body length, body weight, and heart rate provide a concentration-dependent pattern; values of 72 h LC₅₀ (median lethal concentration) and EC₅₀ (median effective concentration) ranged from 3 to 12 mg/L. Most importantly, the results of the present study suggest that even at the lowest concentration, 0.2 mg/L, five triazole fungicides also caused notable changes in enzyme activities and mRNA levels. Overall, the present study points out that those five triazole fungicides are highly toxic to the early development of G. rarus embryos. The information presented in this study will be helpful in better understanding the toxicity induced by triazole fungicides in fish embryos.     

废聚苯乙烯泡沫塑料的催化裂解

为了对废聚苯乙烯泡沫塑料（WPS）资源化利用,通过对WPS进行催化裂解的方法,研究了催化剂种类和裂解温度对裂解时间、裂解油产率、苯乙烯回收率以及裂解油纯度的影响。研究结果表明,催化剂种类和裂解温度对裂解反应有着重要影响。裂解温度升高,裂解油产率提高,裂解时间缩短,但苯乙烯选择性下降;低于380 ℃时,氧化钙的裂解油产率和裂解时间优于氧化铝和氯化铝,但苯乙烯的选择性劣于氧化铝和氯化铝;高于400 ℃时,氯化铝、氧化铝和氧化钙的催化活性接近。在实验条件下,WPS催化裂解的最佳催化剂为氯化铝,380 ℃下的裂解时间为25 min,裂解油产率为85.48%,裂解油中苯乙烯含量为80.66%（w）,且副产物较少。     

Reduction of nitrobenzene with sulfides catalyzed by the black carbons from crop-residue ashes

In this paper, three types of black carbons (BCs) named R-BC, W-BC, and C-BC were derived from rice straw ashes, wheat straw ashes, and corn straw ashes, respectively. Under room temperature and in an anaerobic aqueous solution, these three types of BCs could catalyze the reduction of nitrobenzene (NB) by sulfides rather than only act as the superabsorbent. The catalytic activities of BCs derived from different crop-residue ashes were very different and in the order of R-BC > W-BC > C-BC, since the reaction rate constants (k _obs) of NB with the BCs in the presence of 3 mM sulfides were 0.0186, 0.0063, and 0.0051 h^?1, respectively. The key catalytic active sites for NB reduction were evaluated, with four types of modified BCs and two types of tailored graphite as the model catalysts. The results indicated that BCs probably had two types of active sites for NB reduction, the microscopic graphene moieties and the surface oxygen functional groups. Since the sulfides and BCs often coexist in the environment, this BC-catalyzed reduction technology of NACs may be applied as an in situ remediation technique without the need for reagent addition.     

不同材料负载Ani/TiO2光降解印染废水

使用常见的工业材料:玻璃、铝片和镍网为载体,苯胺(Ani)作为氮掺杂剂,通过溶胶-凝胶法,制备了不同材料负载Ani/TiO2,并研究其在降解以酸性品红模拟的印染废水的光催化氧化性能。结果表明,玻璃、铝片和镍网负载Ani/TiO2最佳N/Ti值分别为0.250、0.040和0.040,并验证了N掺杂TiO2在日光利用方面的优势,提高了光催化剂的实际应用性;最佳pH值均为6～8;最佳处理初始浓度分别为10、12和12 mg/L;其光催化活性都会随着溶液深度的增加而降低;氧化剂硝酸铁的最佳投加浓度均为0.5×10-5到1.0×10-5mol/L;综合来看,玻璃负载Ani/TiO2的活性最高,铝片负载Ani/TiO2次之,镍网负载Ani/TiO2最差。     

复合型异质结催化剂AgI-BiOI/ZSM-5可见光催化氧化NO

采用液相浸渍沉淀法制备AgI-BiOI/ZSM-5异质结催化剂,通过X-射线衍射(XRD)、紫外-可见光漫反射光谱(DRS)、扫描电镜(SEM)和交流阻抗(EIS)等表征技术对样品进行表征分析,研究AgI-BiOI/ZSM-5催化剂在可见光条件(λ＞ 420 nm)下催化氧化NO的可行性及异质结催化剂的稳定性.研究结果表明,所制备的AgI-BiOI/ZSM-5催化剂在可见光下催化氧化NO的效率达到90％,表现出良好的催化活性,而且AgI-BiOI/ZSM-5在反复使用5次后其催化活性基本保持不变.EIS测试结果表明,AgI-BiOI/ZSM-5异质结的形成有利于光生电子和空穴的分离,从而提高了AgI-BiOI/ZSM-5的催化活性和稳定性.     

改性蜂窝煤渣吸附Cr(Ⅵ)的动力学和热力学性能

利用碳酸钡对蜂窝煤渣进行改性,通过粉末X射线衍射光谱（XRD）和扫描电镜（SEM）对改性前后蜂窝煤渣的物质组成和形貌进行表征,研究了改性蜂窝煤渣吸附Cr（Ⅵ）的动力学和热力学性能。实验结果表明,改性蜂窝煤渣对Cr（Ⅵ）具有良好的吸附能力,吸附过程符合准二级吸附动力学模型。分别用Langmuir、Freundlich、D-R和Tempkin等4种吸附等温线模型对实验数据进行拟合,Langmuir方程拟合效果最好,25、35和45℃下的饱和吸附量分别为2.985、2.562和2.630 mg/g。D-R和Tempkin模型研究表明,吸附过程属于物理吸附。热力学研究表明,改性蜂窝煤渣对Cr（Ⅵ）的吸附是一个自发的、放热过程。     

多酚原位固化茶渣对水中Cr（Ⅵ）的吸附

通过甲醛与茶渣中多酚类组分的反应制备了多酚原位固化茶渣吸附材料,并将其用于对水中Cr（Ⅵ）的吸附。表征结果显示：茶渣多酚的原位固化提高了其热稳定性,同时对茶渣粒料起到了修补增强作用。固化茶渣对Cr（Ⅵ）的吸附量随溶液pH的减小而增大。在吸附温度303 K、初始Cr（Ⅵ）质量浓度60 mg/L、吸附剂投加量1.0 g/L、吸附时间300 min、溶液pH为2的条件下,固化茶渣对Cr（Ⅵ）的吸附量为56.56 mg/g,去除率达94.3%。固化茶渣对Cr（Ⅵ）的吸附符合Langmuir等温吸附模型和准二级动力学方程,吸附是一个自发的、吸热过程,303,318,333 K下的Langmuir饱和吸附量分别为83.26,107.64,129.20 mg/g。     

污泥膜覆盖好氧发酵堆乍流场模拟及应用研究

运用Gambit软件建立了污泥好氧发酵堆体的多孔介质模型,通过自行设计的实验装置获得了堆体的通风粘性阻力系数和惯性阻力系数以及功能膜压差与透气量之间的关系,用Fluent软件分析了堆体不同截面形状及底部通风管数量对堆体通风均匀性的影响,为确定合理的通风管数量及截面几何形状提供理论依据。对上海奉贤区城镇污水厂污泥处理工程发酵仓进行堆体流场模拟,确定堆体采用小拱形截面形状,堆高2m,宽8m,底部设置4条通风管,实际运行效果良好。     

分段进水SBR短程生物脱氮过程中N2O产生及控制

利用SBR,控制曝气量为60 L/h,利用在线pH曲线控制曝气时间,成功实现了短程生物脱氮过程,并考察了不同进水方式下SBR运行性能及N2O产量。结果表明,分段进水能够有效降低短程生物脱氮过程中外加碳源投加量。在原水进水碳氮比较低时,采用递增进水量的进水方式,能够有效降低生物脱氮过程中NO-2积累量,从而降低系统N2O产量。1次进水、2次等量进水和2次递增进水方式下,生物脱氮过程中N2O产量分别为11.1、8.86和5.04 mg/L。硝化过程中NO-2-N的积累是导致系统N2O产生的主要原因。部分氨氧化菌(AOB)在限氧条件下以NH+4-N作为电子供体,NO-2-N作为电子受体进行反硝化,最终产物是N2O。     

聚二甲基二烯丙基氯化铵-聚合硫酸铁复合絮凝剂对污泥的脱水性能

研究了聚二甲基二烯丙基氯化铵-聚合硫酸铁复合絮凝剂(PDMDAAC-PFS)对活性污泥的脱水性能,考察了投加量、配比和PDMDAAC的特性粘数等对污泥比阻降低和滤液浊度与COD去除的影响,并与PFS、PDMDAAC、PFS与PD-MDAAC联用(分开加入)、聚丙烯酰胺(PAM)、阳离子型聚丙烯酰胺(CPF130)和KHYC型絮凝剂的脱水效果进行了比较.结果表明,PDMDAAC-PFS对污泥比阻的降低和滤液浊度与COD的去除效果最好,但产生絮团的大小和强度比CPF130差,而其中PDMDAAC和PFS的用量分别比单独使用PDMDAAC和PFS减少了一半以上;PDMDAAC与PFS复配,增加了絮凝剂分子聚集体体积,利于在污泥粒子群间吸附架桥.