Multiple comparisons of organic,microbial, and fine particulate pollutants in typical indoor environments: Diurnal and seasonal variations

This study was performed to investigate the possible sources as well as seasonal and diurnal variations of indoor air pollutants in widely used four different environments (house, office, kindergarten, and primary school) in which people spend most of their time. Bioaerosol levels and species, volatile organic compound (VOC) levels, and PM_2.5 (particulate matter with an aerodynamic diameter ≤2.5 μm) levels were determined in different parts of these environments in parallel with outdoor sampling. Air pollution samplings were carried out in each microenvironment during five subsequent days in both winter and summer in Ankara, Turkey. The results indicated that bioaerosol, VOC, and PM_2.5 levels were higher in the winter than in the summer. Moreover, PM_2.5 and bioaerosol levels showed remarkable daily and diurnal variations, whereas a good correlation was found between the VOC levels measured in the morning and in the afternoon. Bacteria levels were, in general, higher than fungi levels. Among the VOCs, toluene was the most predominant, whereas elevated n-hexane levels were also observed in the kindergarten and the primary school, probably due to the frequent wet cleaning during school days. According to factor analysis, several factors were found to be significantly influencing the indoor air quality (IAQ), and amongst them, VOC-based products used indoors ranked first. The overall results indicate that grab sampling in naturally ventilated places may overestimate or underestimate the IAQ due to the inhomogeneous composition of indoor air caused by irregular exchanges with the outdoor air according to the season and/or occupants' habits.

Implications Seasonal and diurnal variations of VOCs, PM_2.5, bioaerosols in house, office, and schools were observed, in which PM_2.5 and bioaeorosols showed marked both intra- and interday variability, but VOCs did not. VOC-containing products were the most common source of air pollutants affecting the indoor air quality. External factors affecting the indoor air quality were season and indirectly ventilation. A grab sample cannot be representative in evaluating the air quality of a naturally ventilated environment precisely.     

Petroleum hydrocarbon contamination of the Southern Black Sea Shelf, Turkey

Introduction  

In this study, total petroleum hydrocarbon (TPH) contents and some aliphatic and aromatic hydrocarbon concentrations were analysed in coastal sediments of hot points collected from along the Southern Black Sea Shelf.     

Detection of transfluthrin and metofluthrin genotoxicity in the ST cross of the Drosophila Wing Spot Test

In this study, different concentrations of transfluthrin and metofluthrin have been assayed for genotoxicity by using the Wing Spot Test on Drosophila melanogaster. Standard cross was used in the experiment. Third-instar larvae that were trans-heterozygous for the two genetic markers mwh and flr³ were treated at different concentrations (0.0103 mg mL⁻¹, 0.103 mg mL⁻¹ for transfluthrin and 6 μg mL⁻¹, 60 μg mL⁻¹ for metofluthrin) of the test compounds. Feeding ended with pupation of the surviving larvae and the genetic changes induced in somatic cells of the wing’s imaginal discs lead to the formation of mutant clones on the wing blade. Results indicated that two experimental concentrations of transfluthrin and 60 μg mL⁻¹ metofluthrin showed mutagenic and recombinogenic effects in both the marker-heterozygous (MH) flies and the balancer-heterozygous (BH) flies.     

Solid waste management practices in Turkey

As an economically developing country, Turkey has very well operated integrated solid waste management applications structured on modern facilities, besides over 2,000 scattered open dump areas in the country. Integrated waste management applications seem eligible for the metropolitan cities like Istanbul and Izmit (Kocaeli). Attempts have not been encouraging for the scattered regional settlements using central storage sites due to financial shortages and received rejections from nearby settlements. Small-scale compact solid waste management systems with materials recycling and composting can be more suitable alternatives in the small-scale regional settlements. The major constituents of municipal solid waste are organic in nature and approximately a quarter of municipal solid waste is recyclable. Although paper, including cardboard, is the main constituent, the composition of recyclable waste varies strongly by the source or the type of collection point. Solid wastes need primary treatment in order to be suitable for incineration and composting. Turkey needs to give more emphasis on the usage of modern solid waste removal technologies to overcome the overgrowing solid waste disposal problems.     

Scope for growth of Mytilus?galloprovincialis (Lmk., 1819) in oligotrophic coastal waters (Southern Tyrrhenian Sea, Italy)

The ‘scope for growth’ (SFG) tool was used to study the growth performance of cultivated populations of Mytilus galloprovincialis (Lmk., 1819) in an oligotrophic area of the Southern Mediterranean Sea. The study was carried out between 1993 and 1996 by using data from four seasonal oceanographic cruises and from growth experiments. Water samples were collected and analysed for total suspended matter (TSM), particulate organic carbon (POC) and nitrogen (PON), particulate lipids, proteins and carbohydrates and chloropigments. The sum of the carbon equivalents of carbohydrates, proteins and lipids is indicated as the total biopolymeric particulate organic carbon (BPC) and was converted into a unit of energy in order to calculate the SFG of a theoretical mussel of 5 cm length. In order to test the performance of mussel growth at two depths (5 and 15 m water depth), mussel body size [as ash free dry weight (AFDW)] and the actual concentrations of BPC were used to calculate the monthly SFG using the physiological energetic relationships suggested in the current literature. Data from the field cruises led us to characterise the study site as ultra-oligotrophic (annual average of chloropigment concentration approximately 0.5 μg L⁻¹). SFG calculations allowed us to identify a site where mussels grown successively were found to reach a commercial size in approximately 12 months. The good agreement obtained between energetic response and subsequent production response suggests that the available energy from particulate food could be fully available for organic production for maintaining “proportionate” growth trajectories, even in a ultra-oligotrophic system.     

Preparation, Thermal Properties and Thermal Reliability of Form-Stable Paraffin/Polypropylene Composite for Thermal Energy Storage

This study is focused on the preparation, characterization, and determination of thermal properties and thermal reliability of paraffin/polypropylene (PP) composite as a novel form-stable phase change material (PCM) for thermal energy storage applications. In the composite, paraffin acts as a PCM when PP is operated as supporting material. The composites prepared at different mass fractions of paraffin (50, 60, 70, 80, and 90 w/w%) by solution casting method were subjected to leakage test by heating the composites over the melting temperature of the PCM. The paraffin/PP composite (70/30 w/w%) is found as the maximum paraffin containing composite and was characterized using Fourier transform infrared spectroscopy, optic microscopy, differential scanning calorimetry (DSC), and thermal gravimetric analysis (TGA) techniques. DSC analysis indicated that the form-stable paraffin/PP composite melts at 44.77–45.52 °C and crystallizes at 53.55–54.80 °C. It has latent heats of 136.16 and −136.59 J/g for melting and crystallization, respectively. These thermal properties make it potential PCM for latent heat thermal energy storage (LHTES) purposes such as solar space heating applications. Accelerated thermal cycling tests indicated that the form-stable PCM had good thermal reliability. TGA also showed that the form-stable PCM degrades in two distinguishable steps and had good chemical stability.     

Effects of Alkali Treatment on the Properties of Short Flax Fiber–Poly(Lactic Acid) Eco-Composites

In this study, the influence of alkali (NaOH) treatment on the mechanical, thermal and morphological properties of eco-composites of short flax fiber/poly(lactic acid) (PLA) was investigated. SEM analysis conducted on alkali treated flax fibers showed that the packed structure of the fibrils was deformed by the removal non-cellulosic materials. The fibrils were separated from each other and the surface roughness of the alkali treated flax fibers was improved. The mechanical tests indicated that the modulus of the untreated fiber/PLA composites was higher than that of PLA; on the other hand the modulus of alkali treated flax fiber/PLA was lower than PLA. Thermal properties of the PLA in the treated flax fiber composites were also affected. T_g values of treated flax fiber composites were lowered by nearly 10 °C for 10% NaOH treatment and 15 °C for 30% NaOH treatment. A bimodal melting behavior was observed for treated fiber composites different than both of neat PLA and untreated fiber composites. Furthermore, wide angle X-ray diffraction analysis showed that the crystalline structure of cellulose of flax fibers changed from cellulose-I structure to cellulose-II.     

Amygdalin in bitter and sweet seeds of apricots

Hydrogen cyanide (HCN) poisoning due to amygdalin (AMY) in apricot seeds is one of the public health issues in Turkey. The aim of this study was to investigate the AMY content of 13 different apricot seeds including bitter and sweet ones, and which are either sulfurized or roasted. The AMY content was determined by a high-performance liquid chromatography. Release of HCN was predicted and total amount of seeds which can cause poisoning was calculated. The mean AMY content of bitter seeds was 26 ± 14 mg g^?1 and that of sweet seeds was 0.16 ± 0.09 mg g^?1. The consumption of small amounts of bitter seeds may cause cyanide poisoning.     

Integrated model for renewable energy planning in Turkey

All economic sectors are associated with energy use; therefore, government organizations aim to supply sustainable energy for human needs and economic growth. In particular, increased environmental concerns of the public in Turkey have impacted policymaking for renewable energy (RE) management in Turkey. The primary objective for RE sources of the Turkish Ministry of Energy is to ensure that 30% of the share of electricity production is from RE resources in 2023. In this paper, the integrated multi-objective, multi-period linear programming model is presented to determine effective allocation of RE supply for seven different geographical regions in Turkey for the period of 2017 to 2024. The integrated model consists of two different stages. The first stage involves qualitative evaluations of RE sources for seven geographical regions. Analytical Hierarchy Process (AHP) is applied to determine criteria priorities and overall ratings of geographical regions across determined criteria for RE sources are computed. The second stage of the integrated model consists of a multi-objective, multi-period linear programming model. The proposed multi-objective linear programming model is coded in MPL (Mathematical Programming Language) and solved using the GUROBI 5.1.0 solver. The output of the integrated model presents the total supply amount of RE sources for geographical regions in planning period. The ε-constraints method is applied to compute the total supply amount of RE from geographical regions for the period of 2017 to 2024. In this study, a systematic decision-making model is generated to allocate renewable energy sources to the geographical regions. The presented model integrates qualitative evaluations and quantitative parameters of different geographical regions to determine the optimal supply amount of RE. The obtained results are consistent with the potential quantities of RE alternatives in geographical regions, regional specifications, and social requirements.