Measured carbon monoxide concentrations from stock and reduced-emission prototype portable generators operated in an attached garage

There is concern about the hazard of acute residential CO exposures from portable gasoline-powered generators, which can result in death or serious adverse health effects in exposed individuals. To address this hazard, the U.S. Consumer Product Safety Commission has developed low CO emission prototype generators by adapting off-the-shelf emission control technologies onto commercially available generators. A series of tests was conducted to characterize the indoor CO concentrations resulting from portable generators operating in the attached garage of a research house under seven different test house/garage configurations. The tested generators include both unmodified and modified low CO emission prototypes. It was found that CO concentrations varied widely, with peak house CO concentrations ranging from under 10 ppm to over 10,000 ppm. The highest concentrations in the house resulted from operation of the unmodified generator in the garage with the garage bay door closed and the house access door open. The lowest concentrations resulted from operation of a modified low CO emission prototype in the garage with the garage bay door open and the house access door closed. These tests documented reductions of up to 98% in CO concentrations due to emissions from two low CO emission portable generators compared to a stock generator.

Implications: Improper portable generator use has caused 800 U.S. deaths in the past 14 years. Generators operated in attached garages can cause CO to quickly reach deadly levels. Two low-emission prototypes generators were tested and had CO emissions reduced by up to 98%. Low-emission generators can reduce the risk of consumer poisonings and deaths.     

Overview of surface measurements and spatial characterization of submicrometer particulate matter during the DISCOVER-AQ 2013 campaign in Houston,TX

The sources of submicrometer particulate matter (PM₁) remain poorly characterized in the industrialized city of Houston, TX. A mobile sampling approach was used to characterize PM₁ composition and concentration across Houston based on high-time-resolution measurements of nonrefractory PM₁ and trace gases during the DISCOVER-AQ Texas 2013 campaign. Two pollution zones with marked differences in PM₁ levels, character, and dynamics were established based on cluster analysis of organic aerosol mass loadings sampled at 16 sites. The highest PM₁ mass concentrations (average 11.6 ± 5.7 µg/m³) were observed to the northwest of Houston (zone 1), dominated by secondary organic aerosol (SOA) mass likely driven by nighttime biogenic organonitrate formation. Zone 2, an industrial/urban area south/east of Houston, exhibited lower concentrations of PM₁ (average 4.4 ± 3.3 µg/m³), significant organic aerosol (OA) aging, and evidence of primary sulfate emissions. Diurnal patterns and backward-trajectory analyses enable the classification of airmass clusters characterized by distinct PM sources: biogenic SOA, photochemical aged SOA, and primary sulfate emissions from the Houston Ship Channel. Principal component analysis (PCA) indicates that secondary biogenic organonitrates primarily related with monoterpenes are predominant in zone 1 (accounting for 34% of the variability in the data set). The relevance of photochemical processes and industrial and traffic emission sources in zone 2 also is highlighted by PCA, which identifies three factors related with these processes/sources (~50% of the aerosol/trace gas concentration variability). PCA reveals a relatively minor contribution of isoprene to SOA formation in zone 1 and the absence of isoprene-derived aerosol in zone 2. The relevance of industrial amine emissions and the likely contribution of chloride-displaced sea salt aerosol to the observed variability in pollution levels in zone 2 also are captured by PCA.

Implications: This article describes an urban-scale mobile study to characterize spatial variations in submicrometer particulate matter (PM₁) in greater Houston. The data set indicates substantial spatial variations in PM₁ sources/chemistry and elucidates the importance of photochemistry and nighttime oxidant chemistry in producing secondary PM₁. These results emphasize the potential benefits of effective control strategies throughout the region, not only to reduce primary emissions of PM₁ from automobiles and industry but also to reduce the emissions of important secondary PM₁ precursors, including sulfur oxides, nitrogen oxides, ammonia, and volatile organic compounds. Such efforts also could aid in efforts to reduce mixing ratios of ozone.     

Seasonal ecophysiology of an endangered coastal species,the yellow-horned poppy (Glaucium flavum Crantz)

Glaucium flavum Crantz. is a short-lived perennial herb distributed in coastal zones from the Black Sea to southern, western and north-western Europe. Despite its diminishing area of distribution and potential pharmacological value, little is known about the ecophysiological features of this coastal species. We investigated the photosynthetic performance of G. flavum by measuring gas exchange, chlorophyll fluorescence, photosynthetic pigment concentration and leaf water content over the space of a year in a coastal habitat of SW Spain. We also measured the variation in total concentrations of nitrogen, phosphorus, sulphur, potassium, calcium and magnesium, in the leaves and soil, throughout the study period. G. flavum showed a high resistance to summer drought conditions which appeared to be due to the high degree of stomatal control. The potential photochemical efficiency of photosystem II showed minimum values during the winter, indicating that low temperatures can produce negative effects within the photosynthetic apparatus. However, the marked decline in net photosynthesis during the winter seems to be mainly related to a loss of metabolic activity. Although leaf nutrient concentrations were, in general, within the normal ranges, phosphorus availability seems to be limited by the high calcium concentrations detected in the soil of the study site. Our study points out the efficiency of the different physiological adaptations of this rare and endangered coastal species in coping with the strong seasonal variability of the Mediterranean climate.     

Pathways of rural change: an integrated assessment of metabolic patterns in emerging ruralities

While rural transformations are nothing new in human history, current processes of rural change occur under multiple forces at an unprecedented pace, involving profound and unexpected changes in land use and users, and rapid transformations in the metabolic patterns of rural systems. The present special section aims to shed light on current drivers and pathways of rural change by analyzing, under a common conceptual and theoretical framework, examples of new ruralities that are emerging as responses across different world regions. Within this context, this introduction presents: (1) common research questions of the six presented cases of rural change; (2) the general theoretical and methodological framework of integrated assessment of societal metabolism adopted to analyze rural systems and (3) the main contributions and conclusions that could be drawn from six context-specific case studies from Asia, Latin America and Europe.     

Ecosystem services in coupled social–ecological systems: Closing the cycle of service provision and societal feedback

Both the ‘cascade model’ of ecosystem service provision and the Driver-Pressure-State-Impact-Response framework individually contribute to the understanding of human–nature interactions in social–ecological systems (SES). Yet, as several points of criticism show, they are limited analytical tools when it comes to reproducing complex cause–effect relationships in such systems. However, in this paper, we point out that by merging the two models, they can mutually enhance their comprehensiveness and overcome their individual conceptual deficits. Therefore we closed a cycle of ecosystem service provision and societal feedback by rethinking and reassembling the core elements of both models. That way, we established a causal sequence apt to describe the causes of change to SES, their effects and their consequences. Finally, to illustrate its functioning we exemplified and discussed our approach based on a case study conducted in the Alpujarra de la Sierra in southern Spain.

Electronic supplementary material

The online version of this article (doi:10.1007/s13280-015-0651-y) contains supplementary material, which is available to authorized users.     

The New Zealand experience of varroa invasion highlights research opportunities for Australia

The Varroa mite (Varroa destructor) is implicated as a major disease factor in honey bee (Apis mellifera) populations worldwide. Honey bees are extensively relied upon for pollination services, and in countries such as New Zealand and Australia where honey bees have been introduced specifically for commercial pollinator services, the economic effects of any decline in honey bee numbers are predicted to be profound. V. destructor established in New Zealand in 2000 but as yet, Australia remains Varroa-free. Here we analyze the history of V. destructor invasion and spread in New Zealand and discuss the likely long-term impacts. When the mite was discovered in New Zealand, it was considered too well established for eradication to be feasible. Despite control efforts, V. destructor has since spread throughout the country. Today, assessing the impacts of the arrival of V. destructor in this country is compromised by a paucity of data on pollinator communities as they existed prior to invasion. Australia’s Varroa-free status provides a rare and likely brief window of opportunity for the global bee research community to gain understanding of honey bee-native pollinator community dynamics prior to Varroa invasion.     

In vitro approaches to assess bioavailability and human gastrointestinal mobilization of food-borne polychlorinated biphenyls (PCBs)

This study reports on the potential for gastrointestinal (GI) mobilization and bioavailability of food-borne PCBs in humans. The development and validation of a GI simulator and operational protocols, developed in compliance with the requirements of German DIN 19738 risk assessment test procedure, are presented. Food, naturally contaminated with PCBs, was homogenized with simulated saliva fluid and shaken in the GI simulator with simulated gastric fluids (containing pepsin, mucine) for 2 h at 37°C. Afterwards, the simulated intestinal fluids (containing pepsin, mucine, trypsin, pancreatin, bile) were added and the mixture shaken for a further 6 h prior to centrifugation and filtration using Buchner funnels to separate the undigested GI residues from GI fluids. PCBs were recovered from GI residues and fluids by Soxhlet and liquid-liquid extraction respectively, cleaned up using silica-SFE, and analyzed by gas chromatography mass spectrometry detection (GC-MSD). Detailed studies with fish indicate variations in mobilization and bioavailability of Σ PCBs (28, 52, 101, 118, 153, 138 and 180). For example, the bioavailable fractions (fractions mobilized) in mackerel, salmon, crab and prawn were 0.77, 0.60, 0.54, and 0.72 respectively of the Σ PCBs initially present in these food samples. The bioavailable fraction was dependent on the physicochemical characteristics of the PCBs. In mackerel bioavailable fractions for individual PCB congeners ranged from 0.47–0.82, from 0.30–0.70 in salmon, 0.44–0.64 in crab and in prawn from 0.47–0.77. Future studies will focus on understanding better, the variability in bioavailable fractions to be expected for different foodstuffs, in addition to tissue culture techniques using human gut cell lines to investigate a simultaneous mobilization and absorption of food-borne PCBs.     

Effect of Refractory on the Thermal Stability of SF6

The thermal decomposition of SF₆ is known to be oxygen-independent. Nevertheless, because of its high stability, the use of SF6 as a "conservative" surrogate in incinerator performance evaluation has been advocated and researched. This paper shows that refractory decreases markedly the stability of SF₆. The resulting increase in SF₆ decomposition was from 0 percent to 95 percent at 900°C, and the temperatures at which 90-99 percent decomposition occurred were lowered by 300-150°C. Refractory also decreased the stability of CCl₄ and C₂Cl₄, but to a lesser extent. The difference between the decompositions of C₂Cl₄ and SF₆ was reduced from several orders of magnitude to a factor of 2-4. Such a drastic and adverse change in relative stability could render SF₆ unsuitable as a "conservative" surrogate. The requirements for a "conservative" surrogate and the need for caution in its use are discussed, and further research areas are indicated.     

Use of inorganic and organic wastes for in situ immobilisation of Pb and Zn in a contaminated alkaline soil

Purpose  

This study aims to examine whether addition of immobilising agents to a sandy, alkaline (pH = 8.1) soil, which had been contaminated with Pb and Zn by airborne particles from a Pb/Zn smelter, would substantially reduce metal bioavailability.