The amorphous Zn biomineralization at Naracauli stream,Sardinia: electron microscopy and X-ray absorption spectroscopy

An amorphous Zn biomineralization (“white mud”), occurring at Naracauli stream, Sardinia, in association with cyanobacteria Leptolyngbya frigida and diatoms, was investigated by electron microscopy and X-ray absorption spectroscopy. Preliminary diffraction analysis shows that the precipitate sampled on Naracauli stream bed is mainly amorphous, with some peaks ascribable to quartz and phyllosilicates, plus few minor unattributed peaks. Scanning electron microscopy analysis shows that the white mud, precipitated in association with a seasonal biofilm, is made of sheaths rich in Zn, Si, and O, plus filaments likely made of organic matter. Transmission electron microscopy analysis shows that the sheaths are made of smaller units having a size in the range between 100 and 200 nm. X-ray absorption near-edge structure and extended X-ray absorption fine structure data collected at the Zn K-edge indicate that the biomineral has a local structure similar to hemimorphite, a zinc sorosilicate. The differences of this biomineral with respect to the hydrozincite biomineralization documented about 3 km upstream in the same Naracauli stream may be related to either variations in the physicochemical parameters and/or different metabolic behavior of the involved biota.     

Photodegradation of gaseous acetaldehyde and methylene blue in aqueous solution with titanium dioxide-loaded activated carbon fiber polymer materials and aquatic plant ecotoxicity tests

TiO₂-supported activated carbon felts (TiO₂–ACFTs) were prepared by dip coating of felts composed of activated carbon fibers (ACFs) with either polyester fibers (PS-A20) and/or a polyethylene pulp (PE-W15) in a TiO₂ aqueous suspension followed by calcination at 250 °C for 1 h. The as-prepared TiO₂–ACFTs with 29–35 wt.% TiO₂ were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), and N₂ adsorption. The TiO₂–ACFT(PS-A20) samples with 0 and 29 wt.% TiO₂ were microporous with specific surface areas (S _BET) of 996 and 738 m²/g, respectively, whereas the TiO₂–ACFT(PE-W15) samples with 0 and 35 wt.% TiO₂ were mesoporous with S _BET of 826 and 586 m²/g, respectively. Adsorption and photocatalytic activity of the as-prepared samples were evaluated by measuring adsorption in the dark and photodegradation of gaseous acetaldehyde (AcH) and methylene blue (MB) in aqueous solution under UV light. The TiO₂ loading caused a considerable decrease in the S _BET and MB adsorption capacity along with an increase in MB photodegradation and AcH mineralization. Lemna minor was chosen as a representative aquatic plant for ecotoxicity tests measuring detoxification of water obtained from the MB photodegradation reaction with the TiO₂–ACFT samples under UV light.     

Annual and weekly patterns of ozone and particulate matter in Jeddah,Saudi Arabia

Air pollution has been an increasing concern within the Kingdom of Saudi Arabia and other Middle Eastern countries. In this work the authors present an analysis of daily ozone (O₃), nitrogen oxide (NO_x), and particulate matter (<10 μm aerodynamic diameter; PM₁₀) concentrations for two years (2010 and 2011) at sites in and around the coastal city of Jeddah, as well as a remote background site for comparison. Monthly and weekly variations, along with their implications and consequences, were also examined. O₃ within Jeddah was remarkably low, and exhibited the so-called weekend effect—elevated O₃ levels on the weekends, despite reduced emissions of O₃ precursors on those days. Weekend O₃ increases averaged between 12% and 14% in the city, suggesting that NO_x/volatile organic compound (VOC) ratios within cities such as Jeddah may be exceptionally high. Sites upwind or far removed from Jeddah did not display this weekend effect. Based on these results, emission control strategies in and around Jeddah must carefully address NO_x/VOC ratios so as to reduce O₃ at downwind locations without increasing it within urban locations themselves. PM₁₀ concentrations within Jeddah were elevated compared with North American cites of similar climatology, though comparable to other large cities within the Middle East.

Implications:Daily concentrations of O₃, PM₁₀, and NO_x in and around the city of Jeddah, Saudi Arabia, are analyzed and compared with those of other reference cities. Extremely low O₃ levels, along with a significant urban weekend effect (higher weekend O₃, despite reduced NO_x concentrations), is apparent, along with high levels of PM₁₀ within the city. Urban O₃ in Jeddah was found to be lower than that of other comparable cities, but the strong weekend effect suggests that care must be taken to reduce downwind O₃ levels without increasing them within the city itself. Further research into the emissions and chemistry contributing to the reduced O₃ levels within the city is warranted.     

Forensic Evaluation of Metals (Cr,Cu, Pb,Zn), Isotopes (δ13C and δ15N), and C:N Ratios in Freshwater Sediment

A forensic approach was used to evaluate sediments from Portão Stream, including analysis of metals, carbon (C) and nitrogen (N) stable isotopes, and C:N ratios. Samples collected at various points located along the stream were tested in order to investigate a possible illegal leachate input. The studied stream is heavily impacted by sewage and industrial discharges from two cities along its course. Among the metals analyzed, chromium (Cr) was noticeably the main pollutant, showing the highest levels, above regulatory limits, downstream from some potential sources of effluents enriched with this metal. Isotope analyses revealed a general trend of depletion in the heavier isotope along the stream for C and N. The exception was one point near a hazardous waste landfill, where relatively more enriched δ¹³C and δ¹⁵N values were found. The isotope and metal analysis results indicated that this site was affected by a particular source, demonstrating the combination of these parameters could be used for the discrimination of sources in a heavily polluted stream. Nevertheless, further investigations are necessary to provide a comprehensive evaluation of the biogeochemical processes involved in the incorporation of leachate in sediments to use this analysis as evidence for the illegal leachate discharge.     

Optimization-Based Atmospheric Plume Source Identification

This work applies optimization and an Eulerian inversion approach presented by Bagtzoglou and Baun in 2005 in order to reconstruct contaminant plume time histories and to identify the likely source of atmospheric contamination using data from a real test site for the first time. Present-day distribution of an atmospheric contaminant plume as well as data points reflecting the plume history allow the reconstruction and provide the plume velocity, distribution, and probable source. The method was tested to a hypothetical case and with data from the Forest Atmosphere Transfer and Storage (FACTS) experiment in the Duke experimental forest site. In the scenarios presented herein, as well as in numerous cases tested for verification purposes, the model conserved mass, successfully located the peak of the plume, and managed to capture the motion of the plume well but underestimated the contaminant peak.     

PM10 concentration levels at an urban and background site in Cyprus: The impact of urban sources and dust storms

Air quality in Cyprus is influenced by both local and transported pollution, including desert dust storms. We examined PM₁₀ concentration data collected in Nicosia (urban representative) from April 1, 1993, through December 11, 2008, and in Ayia Marina (rural background representative) from January 1, 1999, through December 31, 2008. Measurements were conducted using a Tapered Element Oscillating Micro-balance (TEOM). PM₁₀ concentrations, meteorological records, and satellite data were used to identify dust storm days. We investigated long-term trends using a Generalized Additive Model (GAM) after controlling for day of week, month, temperature, wind speed, and relative humidity. In Nicosia, annual PM₁₀ concentrations ranged from 50.4 to 63.8 μg/m³ and exceeded the EU annual standard limit enacted in 2005 of 40 μg/m³ every year. A large, statistically significant impact of urban sources (defined as the difference between urban and background levels) was seen in Nicosia over the period 2000–2008, and was highest during traffic hours, weekdays, cold months, and low wind conditions. Our estimate of the mean (standard error) contribution of urban sources to the daily ambient PM₁₀ was 24.0 (0.4) μg/m³. The study of yearly trends showed that PM₁₀ levels in Nicosia decreased from 59.4 μg/m³ in 1993 to 49.0 μg/m³ in 2008, probably in part as a result of traffic emission control policies in Cyprus. In Ayia Marina, annual concentrations ranged from 27.3 to 35.6 μg/m³, and no obvious time trends were observed. The levels measured at the Cyprus background site are comparable to background concentrations reported in other Eastern Mediterranean countries. Average daily PM₁₀ concentrations during desert dust storms were around 100 μg/m³ since 2000 and much higher in earlier years. Despite the large impact of dust storms and their increasing frequency over time, dust storms were responsible for a small fraction of the exceedances of the daily PM₁₀ limit.

ImplicationsThis paper examines PM₁₀ concentrations in Nicosia, Cyprus, from 1993 to 2008. The decrease in PM₁₀ levels in Nicosia suggests that the implementation of traffic emission control policies in Cyprus has been effective. However, particle levels still exceeded the European Union annual standard, and dust storms were responsible for a small fraction of the daily PM₁₀ limit exceedances. Other natural particles that are not assessed in this study, such as resuspended soil and sea salt, may be responsible in part for the high particle levels.     

A hybrid biological process of indoor air treatment for toluene removal

Bioprocesses, such as biofiltration, are commonly used to treat industrial effluents containing volatile organic compounds (VOCs) at low concentrations. Nevertheless, the use of biofiltration for indoor air pollution (IAP) treatment requires adjustments depending on specific indoor environments. Therefore, this study focuses on the convenience of a hybrid biological process for IAP treatment. A biofiltration reactor using a green waste compost was combined with an adsorption column filled with activated carbon (AC). This system treated a toluene-micropolluted effluent (concentration between 17 and 52 µg/m³), exhibiting concentration peaks close to 733 µg/m³ for a few hours per day. High removal efficiency was obtained despite changes in toluene inlet load (from 4.2 × 10^?3 to 0.20 g/m³/hr), which proves the hybrid system’s effectiveness. In fact, during unexpected concentration changes, the efficiency of the biofilter is greatly decreased, but the adsorption column maintains the high efficiency of the entire process (removal efficiency [RE] close to 100%). Moreover, the adsorption column after biofiltration is able to deal with the problem of the emission of particles and/or microorganisms from the biofilter.

ImplicationsIndoor air pollution is nowadays recognized as a major environmental and health issue. This original study investigates the performance of a hybrid biological process combining a biofilter and an adsorption column for removal of indoor VOCs, specifically toluene.     

Model projected heat extremes and air pollution in the eastern Mediterranean and Middle East in the twenty-first century

The eastern Mediterranean and Middle East, a region with diverse socioeconomic and cultural identities, is exposed to strong climatic gradients between its temperate north and arid south. Model projections of the twenty-first century indicate increasing hot weather extremes and decreasing rainfall. We present model results, which suggest that across the Balkan Peninsula and Turkey climate change is particularly rapid, and especially summer temperatures are expected to increase strongly. Temperature rise can be amplified by the depletion of soil moisture, which limits evaporative cooling, prompted by the waning of large-scale weather systems that generate rain. Very hot summers that occurred only rarely in the recent past are projected to become common by the middle and the end of the century. Throughout the region, the annual number of heat wave days may increase drastically. Furthermore, conditions in the region are conducive for photochemical air pollution. Our model projections suggest strongly increasing ozone formation, a confounding health risk factor particularly in urban areas. This adds to the high concentrations of aerosol particles from natural (desert dust) and anthropogenic sources. The heat extremes may have strong impacts, especially in the Middle East where environmental stresses are plentiful.     

Nutrient and enzymatic changes of hydrolysed tannery solid waste treated with epigeic earthworm Eudrilus eugeniae and phytotoxicity assessment on selected commercial crops

Animal fleshing (ANFL) is the predominant proteinaceous solid waste generated during processing of leather and it is confronting disposal problems. The aim of this study was to assess the potential of epigeic earthworm Eudrilus eugeniae to utilize and transform the fermented ANFL in the solid state (SSF) and submerged state (SmF) into a value added product along a low residence period (25 days). A total of six treatment units containing different waste mixture compositions were established. Fifty healthy and non-clitellated earthworms were introduced in three different treatment containers: control, SSF, and SmF (+worm). Another set of treatment mixtures (control, SSF, SmF) was established without earthworms (?worm) to compare the results. The products were characterized for physico-chemical, enzymatic analysis and seedling growth parameters to compare the differences in the process with and without earthworms. The changes observed in the analytical parameters were in the following order: SSF > SmF > control mixtures (p?<?0.05). The vermicompost showed a significant reduction in heavy metals, total organic carbon and an increase in total Kjeldhal nitrogen as compared to the product untreated by earthworms. The maximum enzymatic activities were observed after 21 days of vermicomposting. The relative seed germination of vermicompost extracts were in the order of tomato (Lycopersicon esculentum) > green gram (Vigna radiata) > cucumber (Cucumis sativus) > bottle gourd (Lagenaria siceraria (Mol.) Standl.) and showed no phytotoxicity effects. The results indicated that the combination of both ANFL hydrolysis through fermentation and vermicomposting is a good alternative to the management of this kind of waste.     

Revisions to the derivation of the Australian and New Zealand guidelines for toxicants in fresh and marine waters

The Australian and New Zealand Guidelines for Fresh and Marine Water Quality are a key document in the Australian National Water Quality Management Strategy. These guidelines released in 2000 are currently being reviewed and updated. The revision is being co-ordinated by the Australian Department of Sustainability, Environment, Water, Population and Communities, while technical matters are dealt with by a series of Working Groups. The revision will be evolutionary in nature reflecting the latest scientific developments and a range of stakeholder desires. Key changes will be: increasing the types and sources of data that can be used; working collaboratively with industry to permit the use of commercial-in-confidence data; increasing the minimum data requirements; including a measure of the uncertainty of the trigger value; improving the software used to calculate trigger values; increasing the rigour of site-specific trigger values; improving the method for assessing the reliability of the trigger values; and providing guidance of measures of toxicity and toxicological endpoints that may, in the near future, be appropriate for trigger value derivation. These changes will markedly improve the number and quality of the trigger values that can be derived and will increase end-users’ ability to understand and implement the guidelines in a scientifically rigorous manner.