White spruce response to co-composted hydrocarbon-contaminated drilling waste: effects of compost age and nitrogen fertilization

There are growing interests to use co-composted drilling wastes contaminated with hydrocarbons as growth media for planting in land reclamation. However, such use of the compost may have potential problems such as inherent toxicity of residual hydrocarbon and microbial N immobilization due to high compost C to N ratios. We investigated the growth, biomass production, N uptake, and foliar delta13C of white spruce (Picea glauca [Moench] Voss) seedlings in a pot experiment using 1-, 2-, 3-, and 4-yr-old composts (with different hydrocarbon concentrations and C to N ratios) and a local noncontaminated soil with (200 kg N ha(-1)) or without N fertilization. Growth and N content of seedlings (particularly N content in roots) were lower when grown in the compost media as compared with those grown in the soil. Within the compost treatments seedling growth was affected by compost age, but the magnitude of growth reduction was not linearly proportional to hydrocarbon concentrations. Plant N uptake increased with compost age, which corresponds with an increase in indigenous mineral N concentration. Effects of N fertilization on N uptake were curtailed by the presence of indigenous mineral N (e.g., in the 4-yr-old compost) and by fertilization-induced stimulation of microbial activities (e.g., in the 1-yr-old compost). The differences in foliar delta13C values between seedlings grown in compost and soil (P < 0.05) suggest that limitations on water uptake caused by the residual hydrocarbon might have been the predominant factor limiting seedling growth in the compost media. This study suggests that water stress caused by residual hydrocarbons may be a critical factor for the successful use of co-composted drilling wastes as a growth medium.     

Predicting Water Quality Impaired Stream Segments using Landscape-Scale Data and a Regional Geostatistical Model: A Case Study in Maryland

In the United States, probability-based water quality surveys are typically used to meet the requirements of Section 305(b) of the Clean Water Act. The survey design allows an inference to be generated concerning regional stream condition, but it cannot be used to identify water quality impaired stream segments. Therefore, a rapid and cost-efficient method is needed to locate potentially impaired stream segments throughout large areas. We fit a set of geostatistical models to 312 samples of dissolved organic carbon (DOC) collected in 1996 for the Maryland Biological Stream Survey using coarse-scale watershed characteristics. The models were developed using two distance measures, straight-line distance (SLD) and weighted asymmetric hydrologic distance (WAHD). We used the Corrected Spatial Akaike Information Criterion and the mean square prediction error to compare models. The SLD models predicted more variability in DOC than models based on WAHD for every autocovariance model except the spherical model. The SLD model based on the Mariah autocovariance model showed the best fit (r² = 0.72). DOC demonstrated a positive relationship with the watershed attributes percent water, percent wetlands, and mean minimum temperature, but was negatively correlated to percent felsic rock type. We used universal kriging to generate predictions and prediction variances for 3083 stream segments throughout Maryland. The model predicted that 90.2% of stream kilometers had DOC values less than 5 mg/l, 6.7% were between 5 and 8 mg/l, and 3.1% of streams produced values greater than 8 mg/l. The geostatistical model generated more accurate DOC predictions than previous models, but did not fit the data equally well throughout the state. Consequently, it may be necessary to develop more than one geostatistical model to predict stream DOC throughout Maryland. Our methodology is an improvement over previous methods because additional field sampling is not necessary, inferences about regional stream condition can be made, and it can be used to locate potentially impaired stream segments. Further, the model results can be displayed visually, which allows results to be presented to a wide variety of audiences easily.     

Using a process-based model to understand dynamics of Chinese agricultural and water technology development from 8000 bc to 1911 ad

Advancements in technology are inextricably bound to our society and the natural environment. However, how the development process of a technology system interacts with both remains unclear. We propose a process model to understand the complex dynamics among technology, society, and the environment via seven interactive elements: technologies, actors, receiving bodies, natural contexts, social contexts, temporal–spatial contexts, and outcomes. The model was applied to agricultural and water technology development in China from 8000 bc to 1911 ad. Our findings show that these elements did not play equally important roles in different periods of the development in ancient China, with social contexts most dominating during the earlier periods and both social and environmental concerns arising towards the later periods. The proposed model, by identifying the elements in the technology development that should be strengthened, can act as an analysis device to assist in reconfiguring a more sustainable socio-technological system.Electronic supplementary materialThe online version of this article (10.1007/s13280-020-01424-7) contains supplementary material, which is available to authorized users.     

Autotrophic denitrification using hydrogen oxidizing bacteria in continuous flow biofilm reactor

Autotrophic denitrification was investigated in five bench‐scale upflow attached growth reactors using hydrogen oxidizing bacteria under anoxic conditions. The performance of sand, granular activated carbon (GAC), crushed pumice, crushed volcanic rock, and plastic media were evaluated as the support material. The reactors were inoculated with acclimated cultures obtained from domestic sewage treatment plant. A synthetic solution containing nitrate was used as the influent. The reactor performance was evaluated by measuring influent and effluent nitrate concentration. The design parameters demonstrated that the effectiveness of autotrophic denitrification is comparable to that of the heterotrophic process and may be utilized economically for drinking water treatment either as the main process or as a supplemental process for ion exchange regenerant treatment.     

Global pilot study for persistent organic pollutants (POPs) using PUF disk passive air samplers

Polyurethane foam (PUF) disks were deployed at global background sites, to test logistical issues associated with a global monitoring network for persistent organic pollutants (POPs). alpha-HCH, exhibited relatively high and uniform concentrations (17-150 pg/m3) at temperate and arctic sites with elevated concentrations associated with trans-Pacific inflow. Concentrations were much lower (<5 pg/m3) in Bermuda, Chile and Cape Grim. Concentrations for gamma-HCH, the main component of lindane, were spatially similar to the alpha-HCH pattern but lower in magnitude (typically, <10 pg/m3). Chlordane concentrations (sum of cis-chlordane, trans-chlordane and trans-nonachlor) were also low (<10 pg/m3). Dieldrin concentrations were in the range 2-25 pg/m3 at most sites but elevated in Bermuda. Back trajectories suggest that advection from Africa and the US may contribute. Endosulfan, a popular current-use pesticide, exhibited highest concentrations ranging from tens to hundreds of pg/m3. There was good agreement between duplicate samplers at each site and PUF disk-derived air concentrations agreed with high volume data. Few logistical/analytical problems were encountered in this pilot study.     

Co-injection of air and steam for the prevention of the downward migration of DNAPLs during steam enhanced extraction: an experimental evaluation of optimum injection ratio predictions

When steam is injected into soil containing a dense volatile non-aqueous phase liquid contaminant, the DNAPL vaporized within the heated soil region condenses and accumulates ahead of the steam condensation front. If enough DNAPL accumulates, gravitational forces can overcome trapping forces allowing the liquid contaminant to flow downward. By injecting air with steam, a portion of the DNAPL vapor remains suspended in equilibrium with the air, decreasing liquid contaminant accumulation ahead of the steam condensation front, and thus reducing the possibility of downward migration. In a previous work, a theoretical model was developed to predict the optimum injection ratio of air to steam that would eliminate accumulation of DNAPL ahead of the temperature front and thus minimize the potential for downward migration. In this work, the theoretical model is summarized, and an experiment is presented in order to evaluate the optimum injection ratio prediction. In the experiment, a two-dimensional water saturated sand pack is contaminated with a known mass of TCE (DNAPL). The system is then remediated by co-injecting air and steam at the predicted optimum injection ratio, calculated based on the average contaminant soil concentration in the sand pack. Results for the co-injection of air and steam are compared to results for the injection of pure steam or pure air. Injection at the predicted optimum injection ratio for a volumetric average NAPL saturation, reduced accumulation of the contaminant ahead of the condensation front by over 90%, as compared to steam injection alone. This indicates that the optimum injection ratio prediction is a valuable tool for limiting the spreading of DNAPL during steam-enhanced extraction. Injection at the optimum injection ratio resulted in earlier recovery of contaminant than for steam injection alone. Co-injection of steam and air is also shown to result in much higher recovery rates than air injection alone.     

Assessing Landscape Condition Relative to Water Resources in the Western United States: A Strategic Approach

The Environmental Monitoring and Assessment Program (EMAP) is proposing an ambitious agenda to assess the status of streams and estuaries in a 12-State area of the western United States by the end of 2003. Additionally, EMAP is proposing to access landscape conditions as they relate to stream and estuary conditions across the west. The goal of this landscape project is to develop a landscape model that can be used to identify the relative risks of streams and estuaries to potential declines due to watershed-scale, landscape conditions across the west. To do so, requires an understanding of quantitative relationships between landscape composition and pattern metrics and parameters of stream and estuary conditions. This paper describes a strategic approach for evaluating the degree to which landscape composition and pattern influence stream and estuary condition, and the development and implementation of a spatially-distributed, landscape analysis approach.     

Water quality effects of clearcut harvesting and forest fertilization with best management practices

Nine small (2.5 ha) and four large (70-135 ha) watersheds were instrumented in 1999 to evaluate the effects of silvicultural practices with application of best management practices (BMPs) on stream water quality in East Texas, USA. Two management regimes were implemented in 2002: (i) conventional, with clearcutting, herbicide site preparation, and BMPs and (ii) intensive, which added subsoiling, aerial broadcast fertilization, and an additional herbicide application. Watershed effects were compared with results from a study on the same small watersheds in 1981, in which two combinations of harvesting and mechanical site preparation without BMPs or fertilization were evaluated. Clearcutting with conventional site preparation resulted in increased nitrogen losses on the small watersheds by about 1 additional kg ha(-1) each of total Kjeldahl nitrogen (TKN) and nitrate-nitrogen (NO(3)-N) in 2003. First-year losses were not significantly increased on the large watershed with a conventional site preparation with BMPs. Fertilization resulted in increased runoff losses in 2003 on the intensive small watersheds by an additional 0.77, 2.33, and 0.36 kg ha(-1) for NO(3)-N, TKN, and total phosphorus, respectively. Total loss rates of ammonia nitrogen (NH(4)-N) and NO(3)-N were low overall and accounted for only approximately 7% of the applied N. Mean loss rates from treated watersheds were much lower than rainfall inputs of about 5 kg ha(-1) TKN and NO(3)-N in 2003. Aerial fertilization of the 5-yr-old stand on another large watershed did not increase nutrient losses. Intensive silvicultural practices with BMPs did not significantly impair surface water quality with N and P.     

Effect of some heavy metals and soil humic substances on the phytochelatin production in wild plants from silver mine areas of Guanajuato, Mexico

Phytochelatins (PCs) were determined in the wild plants, focusing on their relationship with the levels of heavy metals and humic substances (HS) in soil. Ricinus communis and Tithonia diversifolia were collected from several sites in Guanajuato city (Mexico), which had long been the silver and gold mining center. The analysis of PCs in root extracts was carried out by liquid chromatography (derivatization with monobromobimane). Total Ag, Cd, Cu and Pb in plant roots and in soil samples, as well as soil HS were determined. The association of metals with HS in soils was evaluated by size exclusion chromatography (SEC) with UV and ICP-MS detection. The results obtained revealed the induction of PCs in R. communis but not in T. diversifolia. The levels of Cd and Pb in plant roots presented strong positive correlation with PC-2 (r = 0.9395, p = 0.005; r = 0.9573, p = 0.003, respectively), indicating that these two metals promote PCs induction in R. communis. On the other hand, the inverse correlation was found between soil HS and metal levels in roots of R. communis (Cu > Pb > Cd > Ag), in agreement with the decreasing affinity of these metals to HS. Importantly, the inverse correlation between soil HS and plant PC-2 was observed (r = −0.7825, p = 0.066). These results suggest that metals strongly bound to HS could be less bioavailable to plants, which in turn would limit their role in the induction of PCs. Indeed, the SEC elution profiles showed Pb but not Cd association with HS and the correlation between metal in soil and PC-2 in plant was statistically significant only for Cd (r = 0.7857, p = 0.064). Based on these results it is proposed that the role of heavy metals in PCs induction would depend on their uptake by R. communis, which apparently is controlled by the association of metals with soil HS. This work provides further evidence on the role of environmental conditions in the accumulation of heavy metals and phytochelatin production in plants.     

Ozonation of oil sands process water removes naphthenic acids and toxicity

Naphthenic acids are naturally-occurring, aliphatic or alicyclic carboxylic acids found in petroleum. Water used to extract bitumen from the Athabasca oil sands becomes toxic to various organisms due to the presence of naphthenic acids released from the bitumen. Natural biodegradation was expected to be the most cost-effective method for reducing the toxicity of the oil sands process water (OSPW). However, naphthenic acids are poorly biodegraded in the holding ponds located on properties leased by the oil sands companies. In the present study, chemical oxidation using ozone was investigated as an option for mitigation of this toxicity. Ozonation of sediment-free OSPW was conducted using proprietary technology manufactured by Seair Diffusion Systems Inc. Ozonation for 50min generated a non-toxic effluent (based on the Microtox bioassay) and decreased the naphthenic acids concentration by approximately 70%. After 130min of ozonation, the residual naphthenic acids concentration was 2mgl(-1): <5% of the initial concentration in the filtered OSPW. Total organic carbon did not change with 130min of ozonation, whereas chemical oxygen demand decreased by approximately 50% and 5-d biochemical oxygen demand increased from an initial value of 2mgl(-1) to a final value of 15mgl(-1). GC-MS analysis showed that ozonation resulted in an overall decrease in the proportion of high molecular weight naphthenic acids (n> or = 22).