Waste Management in Guangdong Cities: The Waste Management Literacy and Waste Reduction Preferences of Domestic Waste Generators

A questionnaire survey was conducted in 2002 on 1365 households in two prefectural-level cities in the Pearl River Delta, Jiangmen and Zhongshan. Three groups of issues are covered in this paper: 1) waste management literacy, concerns, and public participation; 2) waste recycling practices and the potential for waste avoidance; and 3) public environmental literacy. This study confirms findings from previous surveys and provides new information on important issues such as imposing monetary charges on waste and environmental activities, littering, source separation programs (SSPs), and public participation and expectations in local waste management. Saving up recyclable materials for redemption in waste depots is commonly practiced in mainland China regardless of the level of development of a city, although at the household level, high-income families tend to place less value on the revenues to be gained from redemption than lower income groups do. Data from the previous and the present studies indicate that such voluntary but largely economically driven waste recovery behavior diverts at least 10% of the household waste from the waste stream. Although uncompensated SSP is less appealing in the two cities than compensated SSP, it was found that when the median per capita income of a city reaches RMB2000 per month, a high participation rate for uncompensated waste recovery is more likely to occur. Education and income levels are the chief factors affecting littering behavior and the potential for waste avoidance. Contrary to general belief, the local Chinese community is active in microwaste management. The concern, however, is over the inability of the grassroots bureaucracy to deal with rising expectations for waste collection services and neighborhood cleanliness.     

Dairy manure treatment, digestion and nutrient recovery as a phosphate fertilizer

A combined approach of biological treatment, solids digestion and nutrient recovery was tested on dairy manure. A sequencing batch reactor (SBR) was operated in three modes, in order to optimize nutrient (nitrogen and phosphorus) removals. The highest average removal efficiencies of 91% for NH4-N, 59% for PO4-P and 80% for total chemical oxygen demand (COD) were achieved. Staining experiments suggested the coexistence of glycogen and phosphorus accumulating organisms. Anaerobic digestion of wasted bio-solids was able to produce a PO4-P concentration of 70 mgL-1 in the supernatant. A pilot-scale experiment, designed to recover phosphorus in the supernatant as struvite (magnesium ammonium phosphate), was able to remove 82% of soluble PO4-P.     

MIE determination and thermal degradation study of PA12 polymer powder used for laser sintering

Pulverized materials such as metallic or polymer powders play a considerable role in many industrial processes. Their use requires the introduction of preventive safeguards to control the plant's safety.PA12 polymer powder processing by laser sintering is characteristic of this tendency. The present work concerns PA12 powder (bimodal particle size distribution: 10 μm and 55 μm) and relates to explosion sensitivity and the thermal degradation of this powder, which can occur during laser sintering. Minimum Ignition Energy is determined using a modified Hartmann tube combined with the Langlie method developed in the PRISME Laboratory. This study shows the influence of parameters such as distance between the electrodes, powder concentration and arc power on MIE values. Theses parameters vary in the range of 3–6 A for the current intensity of the spark and the electrode gap in the range of 2.5–4 mm. The MIE is obtained for a spark gap of 3 mm and current intensity of the 4 A spark in our device. It shows that the MIE is less than 40 mJ for concentrations approaching 1000 g/m³. At lower concentrations (under 150 g/m³) the MIE increases but discrepancies in measurements appear, probably because of the static electricity that creates strong irregularities in dust dispersion. The second part of this study concerns the thermal degradation of the PA12 which is performed by thermogravimetric experiments coupled with mass spectrometric (MS) analysis for gas investigation. The mass loss measurement combined with the gas analysis allows the principal stages of degradation to be determined so as to calculate the kinetics parameter PA12. Experiments have been performed for different heating rates between 1 and 30 K min^?1 and the reproducibility of experiments has been verified. The activation energy is determined using two methods: Freidman and KAS. For a reaction rate of between 0.2 and 0.6, the activation energy is nearly constant. The KAS method gives a value of E_a = 250 kJ mol^?1 and the Friedman method gives E_a = 300 kJ mol^?1. The gas analysis by MS shows that oxidation begins at over 350 °C and finishes at under 650 °C with the formation of CO₂ and H₂O. Other major peaks with an m/z ratio of 29, 28 and 30 are noticed in this range of temperature. They show the presence of intermediate species such as C₂H₆, NO or CH₂O. The presence of HCN is also detected (m/z ratio of 27).     

Copper extraction effectiveness and soil dissolution issues of EDTA-flushing of artificially contaminated soils

Ethylenediaminetetraacetic acid (EDTA) was used as a reference chelating agent in column experiments to investigate the effectiveness of chelant-enhanced flushing of soils artificially contaminated under various conditions (low/high Cu loading, and aging). The associated soil dissolution issues were of particular concern. Dissolution of indigenous Fe/Al oxides, Ca carbonates and organic matter was monitored over the course of flushing. Regardless of contamination condition, above 85% extraction efficiency could be accomplished by 10(-2) and 10(-3)M EDTA-flushing, but not 10(-4)M. The Cu extraction kinetics positively correlated to EDTA concentration but inversely to Cu loading in soils. In addition to extraction from weakly sorbed fractions, a large portion of Cu was extracted from oxide, organic matter and residual fractions, which appears to derive from soil dissolution. Cumulative dissolved amounts of Fe, Al, and Ca were found to reach as high as hundreds of mgkg(-1), which were comparable to Cu contamination. Soil organic matter, which is known to strongly interact with Fe and Al oxides, was also mobilized. The rate and extent of these soil dissolutions were also positively correlated to EDTA concentration. Therefore, the co-extraction of soil minerals and organic matter during chelant-enhanced flushing, which would alter both physical structure and chemical properties of the soils, is detrimental to future land use and deserves greater attention. The concentration of chelating agent is the most crucial factor for an effective soil flushing with minimal damage.     

Influence of salinity and temperature on the activity of biosurfactants by polychaete-associated isolates

Influence of different parameters on biosurfactant (BS) activity was carried out on strains that were isolated from the polychaetes Megalomma claparedei, Sabella spallanzanii and Branchiomma luctuosum and additional 30 strains that were previously identified as potential BS producers from crude oil enrichments of the same polychaete specimens. The selection of BS-producing strains from polychaete natural samples was carried out by using standard screening tests. The BS activity by each isolate was evaluated for the effect of salinity and temperature on emulsion production and surface tension reduction, during incubation in mineral medium supplemented with tetradecane or diesel oil. All isolates showed a similar time course of BS activity, and the latter was more influenced by salinity rather than temperature. Some of the BS producers belonged to genera that have not (i.e. Citricoccus, Cellulophaga, Tenacibaculum and Maribacter) or have poorly been (Psychrobacter, Vibrio, and Pseudoalteromonas) reported as able to produce BSs. This is remarkable as some of them have previously been detected in hydrocarbon-enriched samples. Results confirm that filter-feeding polychaetes are an efficient source for the isolation of BS producers.     

The development of new environmental policies and processes in response to a crisis: the case of the multiple barrier approach for safe drinking water

While new environmental policies and procedures often are developed incrementally, they can also result from crises or other significant events. In situations where policies and procedures are introduced in response to a crisis, questions about the strengths and weaknesses of existing mechanisms, and the extent to which they can be used to address concerns, may be ignored. This paper explores the complexities of introducing new policies and processes where planning systems and procedures already exist. Drinking water source protection policies that are being developed in response to the tragic events in Walkerton, Ontario, Canada serve as the context for the inquiry. Three case study watersheds were selected to reflect the diversity of municipal jurisdictions and water supply systems in Ontario. A content analysis was undertaken on regulatory and non-regulatory policy documents to determine the extent to which they addressed elements of the multi-barrier approach for drinking water safety. Findings from the research reveal considerable evidence of the multi-barrier approach in the policy and guiding documents analyzed. Policy development in response to a crisis can advance progress on the issue of drinking water safety and coincide with emerging governance strategies. Policy effectiveness may be enhanced by considering existing policies as well as contextual and jurisdictional differences.     

Natural resource industry involvement in collaboration for water governance: influence on processes and outcomes in Canada

Natural resource industries are increasingly significant actors in environmental decision-making. Possessing vast institutional and technical capacity, firms have an important role to play in ‘new’ governance strategies such as collaboration. These strategies are often based upon assumptions of equitable influence. This paper investigates the nature of resource industry participation in collaborative water governance in Canada, and the potential consequences of that participation as investigated using power theory. The study used comparative cases to reveal that resource industries are able to shape collaboration, and the issues collaborated upon, at multiple analytical levels both internal and external to the collaborative process in ways not available to other actors. Analysis also revealed that resource industry participation in collaboration did not reflect a commitment to engage in shared learning and the reexamination of values and interests as presupposed by collaborative theory. Collaboration is thus challenged in producing equitable, representative outcomes when resource industries participate.