Use of Tracer Gas for Direct Calibration of Emission-Factor Measurements in a Traffic Tunnel

ABSTRACT

Pollutant measurements in traffic tunnels have been used to estimate motor-vehicle emissions for several decades. The objective in this type of study is to use the traffic tunnel as a tool for characterizing motor vehicles rather than seeking a tunnel design with acceptably low pollutant concentrations. In the past, very simple aerodynamic models have been used to relate measured concentrations to vehicle emissions. Typically, it is assumed that velocities and concentrations are uniform across the tunnel cross section. In the present work, a vehicle emitting a known amount of sulfur hexafluoride (SF₆) was driven repeatedly through a 730-m-long traffic tunnel in Vancouver, Canada. Comparing the measured SF₆ concentrations to the known emission rates, it is possible to directly assess the accuracy of the simple tunnel aerodynamic models typically used to interpret tunnel data. Correction factors derived from this procedure were then applied to measurements of carbon monoxide and other pollutants to obtain gram-per-kilometer emission factors for vehicles. Although the specific correction factors measured here are valid only for the tunnel tested, the magnitude of the factors (up to two or more) suggests that the phenomena observed here should be considered when interpreting data from other tunnels.     

Mate replacement in experimentally widowed collared flycatchers (Ficedula albicollis): determinants and outcomes

There is increasing evidence that sexual selection may be intense even in socially monogamous birds, resulting from both mate choice and sperm competition. We studied these two modes of sexual selection experimentally by removing paired male collared flycatchers, Ficedula albicollis, from their mates for 2 days and investigating the factors that influenced the likelihood of a replacement male appearing and how the removals influenced paternity. Replacement males (usually neighbouring males) appeared at 81% (n = 37) of nests where males were removed. The likelihood of this appearance was unaffected by the probable reproductive value of the female's clutch to the replacing male. A replacement was, however, less likely when the original male had a large forehead patch, a trait previously shown to be subject to sexual selection in this population. Experimental removal of males increased the level of sperm competition: 74% of experimental broods were multiply sired, compared to 29% of unmanipulated broods in a previous study. Only two factors predicted how paternity was shared between males: removed males fathered more young if removed closer to laying, and if they had larger forehead patches. The former result is consistent with last-male sperm precedence determining paternity, whereas the latter adds to other evidence that forehead patch size is the target of female preference in this species. Our results suggest that females exert some control over male replacement, and also that they may influence the fertilisation success of males by behavioural means. Received: 15 July 1998 / Received in revised form: 16 March 1999 / Accepted: 28 March 1999     

Promoting internalized motivation for environmentally responsible behavior: A prospective study of environmental goals

We used a prospective design and structural equation modeling procedures to examine the processes by which people internalize the doing of new environmental behaviors. As predicted by self-determination theory (Deci & Ryan, 1985: Intrinsic Motivation and Self-determination in Human Behaviour, Plenum, New York; Deci & Ryan, 2000: Psychol. Inquiry 11, 227), participants who perceived the experimenter as autonomy-supportive evidenced greater internalized motivation regarding a set of self-selected environmental goals. Internalized motivation in turn predicted goal performance during the following week, which in turn predicted intentions to keep on striving after the study was over. Implications for the question of how to motivate people to engage in more environmentally responsible behavior are discussed.     

Heterologous expression of <Emphasis Type="Italic">LamA</Emphasis> gene encoded endo-β-1,3-glucanase and CO<Subscript>2</Subscript> fixation by bioengineered <Emphasis Type="Italic">Synechococcus</Emphasis> sp. PCC 7002

The gene for the catalytic domain of thermostable endo-β-1,3-glucanase (laminarinase) LamA was cloned from Thermotoga maritima MSB8 and heterologously expressed in a bioengineered Synechococcus sp. PCC 7002. The mutant strain was cultured in a photobioreactor to assess biomass yield, recombinant laminarinase activity, and CO₂ uptake. The maximum enzyme activity was observed at a pH of 8.0 and a temperature of 70°C. At a CO₂ concentration of 5%, we obtained a maximum specific growth rate of 0.083 h^–1, a biomass productivity of 0.42 g?L^–1?d^–1, a biomass concentration of 3.697 g?L^–1, and a specific enzyme activity of the mutant strain of 4.325 U?mg^–1 dry mass. All parameters decreased as CO₂ concentration increased from 5% to 10% and further to 15% CO₂, except enzyme activity, which increased from 5% to 10% CO₂. However, the mutant culture still grew at 15% CO₂ concentration, as reflected by the biomass productivity (0.26 g?L^–1?d^–1), biomass concentration (2.416 g?L^–1), and specific enzyme activity (3.247 U?mg^–1 dry mass).

Open image in new window

     

Contents and leachability of heavy metals (Pb, Cu, Sb, Zn, As) in soil at the Pantex firing range, Amarillo, Texas.

Pantex firing range soil samples were analyzed for Pb, Cu, Sb, Zn, and As. One hundred ninety-seven samples were collected from the firing range and vicinity area. There was a lack of knowledge about the distribution of Pb in the firing range, so a random sampling with proportional allocation was chosen. Concentration levels of Pb and Cu in the firing range were found to be in the range of 11-4675 and 13-359 mg/kg, respectively. Concentration levels of Sb were found to be in the range of 1-517 mg/kg. However, the Zn and As concentration levels were close to average soil background levels. The Sn concentration level was expected to be higher in the Pantex firing range soil samples. However, it was found to be below the neutron activation analysis (NAA) detection limit of 75 mg/kg. Enrichment factor analysis showed that Pb and Sb were highly enriched in the firing range with average magnitudes of 55 and 90, respectively. Cu was enriched approximately 6 times more than the usual soil concentration levels. Toxicity characteristic leaching procedure (TCLP) was carried out on size-fractionated homogeneous soil samples. The concentration levels of Pb in leachates were found to be approximately 12 times higher than the U.S. Environmental Protection Agency (EPA) regulatory concentration level of 5 mg/L. Sequential extraction (SE) was also performed to characterize Pb and other trace elements into five different fractions. The highest Pb fraction was found with organic matter in the soil.     

The Use of Certified Reference Materials in Environmental and Ecological Elemental Analysis

In the last decade the growth of environmental and ecological analytical chemistry has increased at an unprecedented rate. This can be witnessed by the numerous journals which have appeared covering all aspects of environmental pollution analysis in many interdisciplinary fields. Certainly, a lot of the analytical activity has been spurred by the everincreasing awareness and concern of pollution, be it of the air, natural waters, marine or soil environments. As a result of this governments in almost all countries in the world have invested a lot of time, money and human resources to its various agencies and universities in trying to identify and control these pollutants.     

Gas-Particle Distribution Factors for Organic and Other Pollutants in the Los Angeles Atmosphere

The distribution of organic pollutants between the gas and particu-late phases was measured for 6 days Including one with the highest ozone level observed in Pasadena In 1973 (7/25). Gas phase pollutants were monitored continuously while particulates were sampled over a one hour interval by filtration. The filters were extracted using a polar and a non-polar solvent; particulate organic carbon was determined using a carbon analyzer, and chemical analysis carried out by fractionation, gas chromatography, infrared, and CHON analysis.

The organic carbon fraction (OCF) was always large, up to 43% of the total particulates (TP). Most of the organics were oxygenated compounds of photochemical origin. There was a linear relation between O₃, OCF, and the infrared carbonyl band intensities of the extracts. Hourly variations of OCF and TP are discussed with respect to the gas phase pollutants and conversion processes.

Although secondary pollutant concentrations were found in the order: organics > nitrates > sulfates, nitrates were more efficient than organics in visibility degradation, based on a statistical evaluation of the data. The secondary aerosol contribution varied with O₃, accounting for up to 95% of TP when the O₃ peaked. The unusual nitrate peak observed for 7/25 is discussed with the atmospheric chemistry of other nitrogen compounds.

We define an organic carbon distribution factor: f_c = particulate organic carbon (POC, μg/m³C)/[POC + gas phase reactive hydrocarbons (μg/m³C)]. The gas-particle distribution factors for organics (f_c), nitrates (f_N) and sulfates (f_s) are in inverse order of their aerosol concentrations: f_c < f_N < f_s . The measured f_c are low: average 2–3%, highest value 6% for 7/25, and correspond to a conversion rate ≤2% hour^?1. Ambient f_c are much lower than f_c measured for certain specific hydrocarbon precursors.     

The Influence of Human Activity Patterns on Personal PM Exposure: A Comparative Analysis of Filter-Based and Continuous Particle Measurements

ABSTRACT

Particulate matter (PM) exposure data from the U.S. Environmental Protection Agency (EPA)-sponsored 1998 Baltimore and 1999 Fresno PM exposure studies were analyzed to identify important microenvironments and activities that may lead to increased particle exposure for select elderly (>65 years old) subjects. Integrated 24-hr filter-based PM_2.5 or PM₁₀ mass measurements [using Personal Environmental Monitors(PEMs)] included personal measurements, indoor and outdoor residential measurements, and measurements at a central indoor site and a community monitoring site. A subset of the participants in each study wore passive nephelometers that continuously measured (1-min averaging time) particles ranging in size from 0.1 to ~10 um. Significant activities and locations were identified by a statistical mixed model (p < 0.01) for each study population based on the measured PM_2.5 or PM₁₀ mass and time activity data. Elevated PM concentrations were associated with traveling (car or bus), commercial locations (store, office, mall, etc.), restaurants, and working.

The modeled results were compared to continuous PM concentrations determined by the nephelometers while participants were in these locations. Overall, the nephelometer data agreed within 6% of the modeled PM_2.5 results for the Baltimore participants and within ~20% for the Fresno participants (variability was due to zero drift associated with the nephelometer). The nephelom-eter did not agree as well with the PM₁₀ mass measurements, most likely because the nephelometer optimally responds to fine particles (0.3–2 um). Approximately one-half (54 ± 31%; mean ± standard deviation from both studies) of the average daily PM_2.5 exposure occurred inside residences, where the participants spent an average of 83 ± 10% of their time. These data also showed that a significant portion of PM_2.5 exposure occurred in locations where participants spent only 4–13% of their time.     

Use of a continuous nephelometer to measure personal exposure to particles during the U.S. Environmental Protection Agency Baltimore and Fresno Panel studies

In population exposure studies, personal exposure to PM is typically measured as a 12- to 24-hr integrated mass concentration. To better understand short-term variation in personal PM exposure, continuous (1-min averaging time) nephelometers were worn by 15 participants as part of two U.S. Environmental Protection Agency (EPA) longitudinal PM exposure studies conducted in Baltimore County, MD, and Fresno, CA. Participants also wore inertial impactor samplers (24-hr integrated filter samples) and recorded their daily activities in 15-min intervals. In Baltimore, the nephelometers correlated well (R2 = 0.66) with the PM2.5 impactors. Time-series plots of personal nephelometer data showed each participant's PM exposure to consist of a series of peaks of relatively short duration. Activities corresponding to a significant instrument response included cooking, outdoor activities, transportation, laundry, cleaning, shopping, gardening, moving between microenvironments, and removing/putting on the instrument. On average, 63-66% of the daily PM exposure occurred indoors at home (about 2/3 of which occurred during waking hours), primarily due to the large amount of time spent in that location (an average of 72-77%). Although not a reference method for measuring mass concentration, the nephelometer did help identify PM sources and the relative contribution of those sources to an individual's personal exposure.